Convective heat transfer over surfaces is generally presented in the form of the heat-transfer coefficient (h) or its nondimensional form, the Nusselt number (Nu). Both require the specification of the free-stream temperature (Too) or the bulk (Tb) temperature, which are clearly defined only for simple configurations. For complicated configurations with flow separation and multiple temperature streams, the physical significance of Too and Tb becomes unclear. In addition, their use could cause the local h to approach positive or negative infinity if Too or Tb is nearly the same as the local wall temperature (Twall). In this paper, a new Nusselt number, referred to as the SCS number, is proposed, that provides information on the local heat flux but does not use h and hence by-passes the need to define Too or Tb. CFD analysis based on steady RANS with the shear-stress transport model is used to compare and contrast the SCS number with Nu for two test problems: (1) compressible flow and heat transfer in a straight duct with a circular cross section and (2) compressible flow and heat transfer in a high-aspect ratio rectangular duct with a staggered array of pin fins. Parameters examined include: Reynolds number at the duct inlet (3,000 to 15,000 for the circular duct and 15,000 and 150,000 for the rectangular duct), wall temperature (Twall = 373 K to 1473 K for the circular duct and 313 K and 1,173 K for the rectangular duct), and distance from of the inlet of the duct (up to 100D for the circular duct and up to 156D for the rectangular duct). For the circular duct, Nu was found to decrease rapidly from the duct inlet until reaching a minimum and then to rise until reaching a nearly constant value in the “fully” developed region if the wall is heating the gas. If the wall is cooling the gas, then Nu has a constant positive slope in the “fully” developed region. The location of the minimum in Nu and where Nu becomes nearly constant in value or in slope are strong functions of Twall. For the SCS number, the decrease from the duct inlet is monotonic with a negative slope, whether the wall is heating or cooling the gas. Also, different SCS curves for different Twall approach each other as the distance from the inlet increases. For the rectangular duct, Nu tends to oscillate about a constant value in the pin-fin region, whereas SCS tends to oscillate about a line with a negative slope. For both test problems, the variation of SCS is not more complicated than Nu, but SCS yields the local heat flux without need for Tb, a parameter that is hard to define and measure for complicated problems.
Effects of injection pressure and impingement distance on flat-wall impinging spray flame and its heat flux under diesel engine-like condition
