Unsteady Flow of Power Law Fluids With Wall Slip in Microducts

2019 ◽  
Vol 141 (8) ◽  
Author(s):  
F. Talay Akyildiz ◽  
Dennis A. Siginer ◽  
M'hamed Boutaous
Keyword(s):  
Power Law ◽  
Nonlinear Partial Differential Equation ◽  
Slip Flow ◽  
Wall Slip ◽  
Nonlinear Boundary Conditions ◽  
Velocity Profiles ◽  
Momentum Balance ◽  
Power Law Fluids ◽  
Power Law Index ◽  
Pseudo Spectral

Unsteady laminar nonlinear slip flow of power law fluids in a microchannel is investigated. The nonlinear partial differential equation resulting from the momentum balance is solved with linear as well as nonlinear boundary conditions at the channel wall. We prove the existence of the weak solution, develop a semi-analytical solution based on the pseudo-spectral-Galerkin and Tau methods, and discuss the influence and effect of the slip coefficient and power law index on the time-dependent velocity profiles. Larger slip at the wall generates increased velocity profiles, and this effect is further enhanced by increasing the power law index. Comparatively, the velocity of the Newtonian fluid is larger and smaller than that of the power law fluid for the same value of the slippage coefficient if the power index is smaller and larger, respectively, than one.

scholarly journals On power-law fluids with the power-law index proportional to the pressure

2016 ◽  
Vol 62 ◽  
pp. 118-123 ◽  
Author(s):  
J. Málek ◽  
K.R. Rajagopal ◽  
J. Žabenský
Keyword(s):  
Power Law ◽  
Power Law Fluids ◽  
Power Law Index

Numerical Simulation for Heat Transfer of Nanofluid in a Rotating Circular Groove Using a Continuous Finite Element Scheme

2014 ◽  
Vol 1081 ◽  
pp. 175-179 ◽  
Author(s):  
Yong Yue Jiang ◽  
Ping Lin ◽  
Bo Tong Li ◽  
Lin Li
Keyword(s):  
Heat Transfer ◽  
Finite Element ◽  
Power Law ◽  
Initial Time ◽  
The Finite Element Method ◽  
Finite Element Scheme ◽  
Element Scheme ◽  
Circular Groove ◽  
Power Law Fluids ◽  
Power Law Index

In this paper, we investigate the heat transfer of the power-law-fluids-based nanofluids in a rotating circular groove. The circular groove rotates with a constant speed and the temperature on the wall of the groove is different from the temperature inside in the initial time. The effects of thermophoresis and Brownian are considered. The thermal conductivity of the nanofluids is taken as a constant. We solve the model with the finite element method directly and discretize them using a continuous finite element scheme in space and a modified midpoint scheme in time. From the results we can find that the heat transfer enhancement of the nanofluids increases as the power law index of the base fluid decreases.

scholarly journals Pipe rheology of microfibrillated cellulose suspensions

Cellulose ◽  
2019 ◽  
Vol 27 (1) ◽  
pp. 141-156 ◽  
Author(s):  
Tuomas Turpeinen ◽  
Ari Jäsberg ◽  
Sanna Haavisto ◽  
Johanna Liukkonen ◽  
Juha Salmela ◽  
...  
Keyword(s):  
Shear Stress ◽  
Wall Shear Stress ◽  
Yield Stress ◽  
Power Law ◽  
Slip Flow ◽  
Microfibrillated Cellulose ◽  
Flow Index ◽  
Shear Rheology ◽  
Power Law Fluids ◽  
Wall Shear

Abstract The shear rheology of two mechanically manufactured microfibrillated cellulose (MFC) suspensions was studied in a consistency range of 0.2–2.0% with a pipe rheometer combined with ultrasound velocity profiling. The MFC suspensions behaved at all consistencies as shear thinning power law fluids. Despite their significantly different particle size, the viscous behavior of the suspensions was quantitatively similar. For both suspensions, the dependence of yield stress and the consistency index on consistency was a power law with an exponent of 2.4, similar to some pulp suspensions. The dependence of flow index on consistency was also a power law, with an exponent of − 0.36. The slip flow was very strong for both MFCs and contributed up to 95% to the flow rate. When wall shear stress exceeded two times the yield stress, slip flow caused drag reduction with consistencies higher than 0.8%. When inspecting the slip velocities of both suspensions as a function of wall shear stress scaled with the yield stress, a good data collapse was obtained. The observed similarities in the shear rheology of both the MFC suspensions and the similar behavior of some pulp fiber suspensions suggests that the shear rheology of MFC suspensions might be more universal than has previously been realized.

scholarly journals Finite Volume Simulation of Natural Convection for Power-Law Fluids with Temperature-Dependent Viscosity in a Square Cavity with a Localized Heat Source

2021 ◽  
Vol 39 (5) ◽  
pp. 1405-1416
Author(s):  
Hamza Daghab ◽  
Mourad Kaddiri ◽  
Said Raghay ◽  
Ismail Arroub ◽  
Mohamed Lamsaadi ◽  
...  
Keyword(s):  
Natural Convection ◽  
Heat Source ◽  
Finite Volume ◽  
Power Law ◽  
Numerical Study ◽  
Staggered Grid ◽  
Cooling Performance ◽  
Coupled Equations ◽  
Power Law Fluids ◽  
Power Law Index

In this paper, numerical study on natural convection heat transfer for confined thermo-dependent power-law fluids is conducted. The geometry of interest is a fluid-filled square enclosure where a uniform flux heating element embedded on its lower wall is cooled from the vertical walls while the remaining parts of the cavity are insulated, without slipping conditions at all the solid boundaries. The governing partial differential equations written in terms of non-dimensional velocities, pressure and temperature formulation with the corresponding boundary conditions are discretized using a finite volume method in a staggered grid system. Coupled equations of conservation are solved through iterative Semi Implicit Method for Pressure Linked Equation (SIMPLE) algorithm. The effects of pertinent parameters, which are Rayleigh number (103 ≤ Ra ≤ 106), power-law index (0.6 ≤ n ≤ 1.4), Pearson number (0 ≤ m ≤ 20) and length of the heat source (0.2 ≤ W ≤ 0.8) on the cooling performance are investigated. The results indicate that the cooling performance of the enclosure is improved with increasing Pearson and Rayleigh numbers as well as with decreasing power-law index and heat source length.

Unsteady Forced Convection Heat Transfer for Power Law Fluids in a Pipe

2010 ◽  
Author(s):  
Botong Li ◽  
Liancun Zheng ◽  
Xinxin Zhang
Keyword(s):  
Heat Transfer ◽  
Forced Convection ◽  
Power Law ◽  
Control Volume ◽  
Convection Heat Transfer ◽  
Inlet Temperature ◽  
Convection Heat ◽  
Forced Convection Heat Transfer ◽  
Power Law Fluids ◽  
Power Law Index

This paper studied the problem of forced convection heat transfer for power law fluids in a pipe which was affected by the varying inlet temperature. The fluid flow was hydrodynamically fully-developed and laminar while the effects of viscous dissipation and the power law kinematic viscosity on heat transfer were considered. A control volume technique based on the finite difference model coupled with the LU decomposition method was adopted and the least squares polynomial was introduced to approximate the non-linear items. The results show that the heat transfer behaviors are strongly depending on the value of the power law index. It is found that the thermal wave of the inlet temperature has less penetration with the increasing axial coordinate, and the effect of heat transfer is dominant away from the wall. The temperature profile is flatter as the power law index increases, which is implies that the shear-thickening non-Newtonian flows are affected easier by the inlet temperature than the shear-thinning fluids.

Non-Newtonian Power-Law Flows around Circular Cylinder under Aiding/Opposing Thermal Buoyancy

2018 ◽  
Vol 16 ◽  
pp. 45-56
Author(s):  
Houssem Laidoudi ◽  
Mohamed Bouzit
Keyword(s):  
Heat Transfer ◽  
Circular Cylinder ◽  
Power Law ◽  
Flow Separation ◽  
Vertical Channel ◽  
Buoyancy Effect ◽  
Thermal Buoyancy ◽  
Power Law Fluids ◽  
Recirculation Length ◽  
Power Law Index

This paper presents a comprehensive computational work on hydrodynamic and thermal phenomena of upward flow separation around a confined circular cylinder by aiding/opposing thermal buoyancy. For that purpose, let us consider a confined flow of Non-Newtonian power-law fluid around a heated/cooled circular cylinder in a two-dimensional vertical channel. The effects of thermal buoyancy and power-Law index on the flow separation and the average Nusselt number are studied for the conditions: (10 ≤ Re ≤ 40), (0.4≤ n ≤ 1.2), (-0.5 ≤ Ri ≤ 0.8), Pr = 50 and blockage ratio β = 0.2. In the steady flow regime the results show that the augmentation of the power-law index in the absence of thermal buoyancy causes a separation to grow. The adding buoyancy effect delays the separation in different power-law indices gradually and at some critical value of the buoyancy parameter it completely disappears resulting a stuck flow around a cylinder, whereas the opposing buoyancy effect causes an earlier wake behind cylinder. Moreover, the recirculation length is calculated to support the above finding. The decrease in the power-Law index increases the heat transfer rate. The Nusselt numbers are computed to predict the heat transfer rates of power-law fluids under the aiding/opposing thermal buoyancy condition.

scholarly journals Numerical Analysis and Entropy Generation of Electrokinetic Flow of Power-Law Fluid in a Microtriangular Prism

2020 ◽  
Vol 2020 ◽  
pp. 1-15
Author(s):  
Fehaid Salem Alshammari
Keyword(s):  
Nusselt Number ◽  
Entropy Generation ◽  
Power Law ◽  
Second Law Of Thermodynamics ◽  
Physical Parameters ◽  
Electrokinetic Flow ◽  
Power Law Fluids ◽  
Transfer Equations ◽  
Constant Wall Heat Flux ◽  
Power Law Index

This research aims to study the characteristics of thermal transport and analyse the entropy generation of electroosmotic flow of power-law fluids in a microtriangular prism in the presence of pressure gradient. Considering a fully developed flow subject to constant wall heat flux, the nonlinear electric potential, momentum, and linear heat transfer equations are solved numerically by developing an iterative finite difference method with a nonuniform grid. The thermal efficiency of the model is explored under the light of the second law of thermodynamics. Effect/impact of governing physical parameters on velocity, temperature, Nusselt number, and entropy distributions is studied, and the results are demonstrated graphically; we found that the Nusselt number decreases with the increase of power-law index, and average entropy generation increases with power-law index. We believe that the obtained result in the present study shall be useful for design of energy efficient microsystems which utilize the dual electrokinetic and centrifugal pumping effects.

scholarly journals Slip-Flow and Heat Transfer in a Porous Microchannel Saturated with Power-Law Fluid

2013 ◽  
Vol 2013 ◽  
pp. 1-9 ◽  
Author(s):  
Yazan Taamneh ◽  
Reyad Omari
Keyword(s):  
Heat Transfer ◽  
Nusselt Number ◽  
Skin Friction ◽  
Knudsen Number ◽  
Power Law ◽  
Slip Flow ◽  
Darcy Number ◽  
Power Law Fluid ◽  
Flow And Heat Transfer ◽  
Power Law Index

This study aims to numerically examine the fluid flow and heat transfer in a porous microchannel saturated with power-law fluid. The governing momentum and energy equations are solved by using the finite difference technique. The present study focuses on the slip flow regime, and the flow in porous media is modeled using the modified Darcy-Brinkman-Forchheimer model for power-law fluids. Parametric studies are conducted to examine the effects of Knudsen number, Darcy number, power law index, and inertia parameter. Results are given in terms of skin friction and Nusselt number. It is found that when the Knudsen number and the power law index decrease, the skin friction on the walls decreases. This effect is reduced slowly while the Darcy number decreases until it reaches the Darcy regime. Consequently, with a very low permeability the effect of power law index vanishes. The numerical results indicated also that when the power law index decreases the fully-developed Nusselt number increases considerably especially, in the limit of high permeability, that is, nonDarcy regime. As far as Darcy regime is concerned the effects of the Knudsen number and the power law index of the fully-developed Nusselt number is very little.

Sign in / Sign up

Export Citation Format

Share Document