CFD Visualization of Drop Generation From a Nozzle

2003 ◽  
Author(s):  
Haruhisa Honda
Keyword(s):  
Stokes Equations ◽  
Experimental Result ◽  
Numerical Code ◽  
Navier Stokes ◽  
Small Satellite ◽  
Navier Stokes Equations ◽  
Tracking Method ◽  
Front Tracking Method ◽  
Interfacial Motion ◽  
Good Agreement

Drop generation from a single nozzle is visualized by direct numerical simulations. Navier-Stokes equations are solved on cylindrical axisymmetric coordinates, and interfacial motion is traced by a Front-Tracking method. To validate the numerical code, the numerical results for two modes, dripping and jetting, are compared with experimental results, and they show good agreement. The experimental result that shows a formation of a small satellite, in particular, is successfully visualized. It is shown that the formation of the satellite is due to the strong back flow arising from the large interfacial tension at the cusp behind the primary drop.

Numerical Modeling of Evolution of Boundary Between Incompressible Gas and Liquid in Two-Dimensional Region

2006 ◽  
Vol 4 ◽  
pp. 224-236
Author(s):  
A.S. Topolnikov
Keyword(s):  
Numerical Modeling ◽  
Interphase Boundary ◽  
Incompressible Liquid ◽  
Stokes Equations ◽  
Numerical Code ◽  
Navier Stokes ◽  
Two Phase ◽  
Navier Stokes Equations ◽  
Incompressible Media ◽  
Good Agreement

The paper is devoted to numerical modeling of Navier–Stokes equations for incompressible media in the case, when there exist gas and liquid inside the rectangular calculation region, which are separated by interphase boundary. The set of equations for incompressible liquid accounting for viscous, gravitational and surface (capillary) forces is solved by finite-difference scheme on the spaced grid, for description of interphase boundary the ideology of Level Set Method is used. By developed numerical code the set of hydrodynamic problems is solved, which describe the motion of two-phase incompressible media with interphase boundary. As a result of numerical simulation the solutions are obtained, which are in good agreement with existing analytical and experimental solutions.

Numerical Simulation of a Pouring Flow From a Beverage Can

2019 ◽  
Author(s):  
Yu Nishio ◽  
Keiji Niwa ◽  
Takanobu Ogawa
Keyword(s):  
Numerical Simulation ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Angular Speed ◽  
Experimental Result ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Numerical Result ◽  
Liquid Flows ◽  
Good Agreement

Abstract Motion of liquid pouring from a beverage can is numerically studied. A liquid is poured from a can which is rotated at a prescribed angular speed. The flow is simulated by solving the unsteady three-dimensional Navier-Stokes equations. An experiment under the same condition is also carried out to validate the computational result. The result shows that, when the can is tipped, the liquid flows over the lid of the can and is once obstructed by the rim of the lid. The numerical result is in good agreement with the experimental result. The effect of condensation formed on a can surface is also considered. The effect of condensation is taken into account by adjusting a contact angle. The liquid pouring from a can trickles down along the can body. The computation reproduces these experimental observations.

Simulation of Unsteady Flow Around a Cylinder

2015 ◽  
Vol 3 (2) ◽  
pp. 28-49
Author(s):  
Ridha Alwan Ahmed
Keyword(s):  
Stokes Equations ◽  
Lift Coefficient ◽  
Reynolds Numbers ◽  
Mean Value ◽  
Navier Stokes ◽  
Cylinder Surface ◽  
Navier Stokes Equations ◽  
Flow Around A Cylinder ◽  
Numerical Grid ◽  
Good Agreement

       In this paper, the phenomena of vortex shedding from the circular cylinder surface has been studied at several Reynolds Numbers (40≤Re≤ 300).The 2D, unsteady, incompressible, Laminar flow, continuity and Navier Stokes equations have been solved numerically by using CFD Package FLUENT. In this package PISO algorithm is used in the pressure-velocity coupling.        The numerical grid is generated by using Gambit program. The velocity and pressure fields are obtained upstream and downstream of the cylinder at each time and it is also calculated the mean value of drag coefficient and value of lift coefficient .The results showed that the flow is strongly unsteady and unsymmetrical at Re>60. The results have been compared with the available experiments and a good agreement has been found between them

On the Flow Fields of Inertial Impactors

1974 ◽  
Vol 96 (4) ◽  
pp. 394-400 ◽  
Author(s):  
V. A. Marple ◽  
B. Y. H. Liu ◽  
K. T. Whitby
Keyword(s):  
Flow Field ◽  
Stokes Equations ◽  
Relaxation Method ◽  
Water Model ◽  
Navier Stokes ◽  
Visualization Technique ◽  
Navier Stokes Equations ◽  
Theoretical Results ◽  
Plate Distance ◽  
Good Agreement

The flow field in an inertial impactor was studied experimentally with a water model by means of a flow visualization technique. The influence of such parameters as Reynolds number and jet-to-plate distance on the flow field was determined. The Navier-Stokes equations describing the laminar flow field in the impactor were solved numerically by means of a finite difference relaxation method. The theoretical results were found to be in good agreement with the empirical observations made with the water model.

Numerical Prediction of Turbulent Wakes Behind a Square Cylinder

1998 ◽  
Vol 14 (1) ◽  
pp. 23-29
Author(s):  
Robert R. Hwang ◽  
Sheng-Yuh Jaw
Keyword(s):  
Stokes Equations ◽  
Numerical Study ◽  
Navier Stokes ◽  
Wall Region ◽  
Square Cylinder ◽  
Mean Velocity ◽  
Navier Stokes Equations ◽  
Turbulent Vortex Shedding ◽  
Model Equations ◽  
Good Agreement

ABSTRACTThis paper presents a numerical study on turbulent vortex shedding flows past a square cylinder. The 2D unsteady periodic shedding motion was resolved in the calculation and the superimposed turbulent fluctuations were simulated with a second-order Reynolds-stress closure model. The calculations were carried out by solving numerically the fully elliptic ensemble-averaged Navier-Stokes equations coupled with the turbulence model equations together with the two-layer approach in the treatment of the near-wall region. The performance of the computations was evaluated by comparing the numerical results with data from available experiments. Results indicate that the present study gives good agreement in the shedding frequency and mean drag as well as in some phase profiles of the mean velocity.

scholarly journals Simulations of Depth-Averaged Streamwise Velocity of Meandering Compound Channel using TELEMAC Modules

2018 ◽  
Vol 65 ◽  
pp. 07001
Author(s):  
Abdul Haslim Abdul Shukor Lim ◽  
Zulhilmi Ismai ◽  
Mohamad Hidayat Jama ◽  
Md. Ridzuan Makhtar
Keyword(s):  
Stokes Equations ◽  
Computing Time ◽  
Streamwise Velocity ◽  
Main Channel ◽  
Navier Stokes ◽  
Relative Depth ◽  
Compound Channel ◽  
Navier Stokes Equations ◽  
Numerical Tools ◽  
Good Agreement

Capabilities of numerical tools to simulate fluid problems significantly depend on its methods to solve for the Navier-Stokes equations. Different dimensional computing tools using the same horizontal meshes were used to simulate flow conditions inside non- and vegetation meandering compound channel. Both tools give good agreement for simulations of depth-averaged streamwise velocity inside the main channel, but its capabilities vary significantly for simulations on floodplains. Lower relative depth recorded a higher percentage of errors than flow with higher relative depth. Vegetation along the main channel increased the flows complexity especially in the area near the vegetation thus reducing the simulation capabilities of the computing tools. Simulations work by TELEMAC-3D significantly better in the areas with highly dimensional and turbulence conditions. TELEMAC-2D is still useful because of its simplicity and lower computing time and resources required.

Numerical Modelling of Circulation in Lake Sperillen, Norway

2000 ◽  
Vol 31 (1) ◽  
pp. 57-72 ◽  
Author(s):  
N. R. B. Olsen ◽  
D. K. Lysne
Keyword(s):  
Numerical Model ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Field Measurements ◽  
Navier Stokes ◽  
Water Current ◽  
Simple Method ◽  
Vertical Temperature Profile ◽  
Navier Stokes Equations ◽  
Good Agreement

A three-dimensional numerical model was used to model water circulation and spatial variation of temperature in Lake Sperillen in Norway. A winter situation was simulated, with thermal stratification and ice cover. The numerical model solved the Navier-Stokes equations on a 3D unstructured non-orthogonal grid with hexahedral cells. The SIMPLE method was used for the pressure coupling and the k-ε model was used to model turbulence, with a modification for density stratification due to the vertical temperature profile. The results were compared with field measurements of the temperature in the lake, indicating the location of the water current. Reasonably good agreement was found.

scholarly journals Effects of surfactant on propagation and rupture of a liquid plug in a tube

2019 ◽  
Vol 872 ◽  
pp. 407-437 ◽  
Author(s):  
M. Muradoglu ◽  
F. Romanò ◽  
H. Fujioka ◽  
J. B. Grotberg
Keyword(s):  
Shear Stress ◽  
Evolution Equations ◽  
Stokes Equations ◽  
Thin Liquid Film ◽  
Front Tracking ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Liquid Plug ◽  
Front Tracking Method ◽  
Airway Walls

Surfactant-laden liquid plug propagation and rupture occurring in lower lung airways are studied computationally using a front-tracking method. The plug is driven by an applied constant pressure in a rigid axisymmetric tube whose inner surface is coated by a thin liquid film. The evolution equations of the interfacial and bulk surfactant concentrations coupled with the incompressible Navier–Stokes equations are solved in the front-tracking framework. The numerical method is first validated for a surfactant-free case and the results are found to be in good agreement with the earlier simulations of Fujioka et al. (Phys. Fluids, vol. 20, 2008, 062104) and Hassan et al. (Intl J. Numer. Meth. Fluids, vol. 67, 2011, pp. 1373–1392). Then extensive simulations are performed to investigate the effects of surfactant on the mechanical stresses that could be injurious to epithelial cells, such as pressure and shear stress. It is found that the liquid plug ruptures violently to induce large pressure and shear stress on airway walls and even a tiny amount of surfactant significantly reduces the pressure and shear stress and thus improves cell survivability. However, addition of surfactant also delays the plug rupture and thus airway reopening.

Numerical Investigation of Unsteady Incompressible 3D Turbulent Flow and Torque Transmission in Fluid Couplings

1994 ◽  
Author(s):  
L. Bal ◽  
A. Kost ◽  
M. Fiebig ◽  
N. K. Mitra
Keyword(s):  
Stokes Equations ◽  
Navier Stokes ◽  
Flow Structures ◽  
Optimized Design ◽  
Navier Stokes Equations ◽  
Reference Flow ◽  
Torque Transmission ◽  
Adequate Understanding ◽  
Volume Method ◽  
Good Agreement

The adequate understanding of the flow structure in fluid couplings is necessary for the optimized design of such devices. Up to now, empiricism plays an important role in design. Detailed studies of the unsteady 3D flow and torque transmission in fluid couplings were rarely carried out. In this paper the unsteady Reynolds time-averaged Navier-Stokes equations coupled with the k-ε model have been solved by a finite-volume method. The calculations were done by using boundary-fitted grids with non-staggered variable arrangement for a rotating frame of reference. Flow structures in fluid couplings were obtained. The results give insights into the physical process of torque transmission. A comparsion of the calculated torque transimission with the experimental measurements in the literature shows good agreement for low slip.

Numerical Modeling of Flow Over a Dam Spillway

2006 ◽  
Author(s):  
Iraj Saeedpanah ◽  
M. Shayanfar ◽  
E. Jabbari ◽  
Mohammad Haji Mohammadi
Keyword(s):  
Free Surface ◽  
Stokes Equations ◽  
Iterative Solution ◽  
Free Surface Flows ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Continuity Equations ◽  
Water Jets ◽  
Pressure Fields ◽  
Good Agreement

Free surface flows are frequently encountered in hydraulic engineering problems including water jets, weirs and around gates. An iterative solution to the incompressible two-dimensional vertical steady Navier-Stokes equations, comprising momentum and continuity equations, is used to solve for the priori unknown free surface, the velocity and the pressure fields. The entire water body is covered by a unstructured finite element grid which is locally refined. The dynamic boundary condition is imposed for the free surface where the pressure vanishes. This procedure is done continuously until the normal velocities components vanish. To overcome numerical errors and oscillations encountering in convection terms, the SUPG (streamline upwinding Petrov-Galerkin) method is applied. The solution method is tested for different discharges onto a standard spillway geometries. The results shows good agreement with available experimental data.

Sign in / Sign up

Export Citation Format

Share Document