Probe Feed Multi-Element Multi-Segment Triangular Dielectric Resonator Antenna with RCS Analysis

2019 ◽  
Vol 28 (12) ◽  
pp. 1950208
Author(s):  
Pinku Ranjan ◽  
Ravi Kumar Gangwar

The aim of the paper is to propose a design and analysis of multi-element multi-segment triangular dielectric resonator antenna (MEMS TDRA) with Radar Cross-Section (RCS). The proposed antenna has been excited through coaxial probe feed. The coaxial probe feed excites TM[Formula: see text] dominant mode fields within the TDR elements. A general guideline for wide bandwidth and high gain has been prepared for designing of MEMS TDRA. The model of the proposed MEMS TDRA has been studied through simulation (Ansoft HFSS software) and fabricated for measurement. The simulated antenna performance has good agreement with the measured one. The proposed MEMS TDRA performance has been compared with some similar type of previously published structure and found wider bandwidth and higher gain. The proposed MEMS TDRA provides monopole-like radiation pattern with nearly 39% bandwidth ([Formula: see text] dB). The average gain of 6.0 dBi has been found over the entire bandwidth. The RCS analysis has been performed for monostatic and bistatic modes at different frequencies and angles. The proposed antenna is appropriate for WLAN and WiMAX applications.

2015 ◽  
Vol 9 (2) ◽  
pp. 411-418 ◽  
Author(s):  
Ravi Kumar Gangwar ◽  
Pinku Ranjan ◽  
Abhishek Aigal

In this paper, a wideband two-segmented four-element triangular dielectric resonator antenna (TDRA) with coaxial probe feed has been proposed. The proposed antenna has been analyzed, optimized, and studied through Ansoft HFSS simulation software. The prototype of the proposed antenna has been fabricated and its input characteristics are measured with the help of R&S Vector Network Analyzer. Good agreement has been obtained between simulated and measured results. The proposed design has been compared with two segments TDRA and found wider bandwidth with lower resonant frequency. The proposed antenna provides monopole-like radiation pattern over the entire bandwidth with nearly 33% bandwidth (return loss ≥10 dB) at a resonant frequency 6.9 GHz and 4.93 dBi peak gain. The proposed antenna is suitable for application of C-band microwave frequencies.


2020 ◽  
Vol 10 (24) ◽  
pp. 8826
Author(s):  
Luigi Melchiorre ◽  
Ilaria Marasco ◽  
Giovanni Niro ◽  
Vito Basile ◽  
Valeria Marrocco ◽  
...  

Through the years, inspiration from nature has taken the lead for technological development and improvement. This concept firmly applies to the design of the antennas, whose performances receive a relevant boost due to the implementation of bio-inspired geometries. In particular, this idea holds in the present scenario, where antennas working in the higher frequency range (5G and mm-wave), require wide bandwidth and high gain; nonetheless, ease of fabrication and rapid production still have their importance. To this aim, polymer-based 3D antennas, such as Dielectric Resonator Antennas (DRAs) have been considered as suitable for fulfilling antenna performance and fabrication requirements. Differently from numerous works related to planar-metal-based antenna development, bio-inspired DRAs for 5G and mm-wave applications are at their beginning. In this scenario, the present paper proposes the analysis and optimization of a bio-inspired Spiral shell DRA (SsDRA) implemented by means of Gielis’ superformula, with the goal of boosting the antenna bandwidth. The optimized SsDRA geometrical parameters were also determined and discussed based on its fabrication feasibility exploiting Additive Manufacturing technologies. The results proved that the SsDRA provides relevant bandwidth, about 2 GHz wide, and satisfactory gain (3.7 dBi and 5 dBi, respectively) at two different frequencies, 3.5 GHz and 5.5 GHz.


2015 ◽  
Vol 9 (1) ◽  
pp. 113-119 ◽  
Author(s):  
Ravi Kumar Gangwar ◽  
Pinku Ranjan ◽  
Abhishek Aigal

A wideband four element triangular dielectric resonator antenna (TDRA) has been designed and fabricated by using 50 Ω coaxial probe feed. The input and radiation characteristics of the proposed antenna have been extracted through Ansoft HFSS and CST Microwave Studio simulation software and compared with the experimental results. The simulated results have been in good agreement with the experimental results. The proposed antenna characteristics have also been compared with the same dimensions of the single element TDRA, and found enhancement in bandwidth with lower resonant frequency. Its performance has also been compared with same area (equal to proposed antenna) of single element TDRA. The proposed antenna provides nearly 37% bandwidth (|S11| < −10 dB) at a resonant frequency of 5.45 GHz with 4.76 dBi peak gain. The symmetry and uniformity in the radiation patterns is obtained consistently for the entire operating bandwidth. The proposed antenna shows consistently symmetric monopole type radiation pattern with low cross polarization for WLAN (IEEE 802.16) and WiMAX applications. The performance of the proposed antenna has been compared with some similar type of dielectric resonator antenna (DRA) shapes and it has been observed that TDRA is taking very less radiation area for giving better performance than other DRA shapes.


2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Yacouba Coulibaly ◽  
Mourad Nedil ◽  
Larbi Talbi ◽  
Tayeb A. Denidni

A new broadband and high gain dielectric resonator antenna for millimeter wave is presented. The investigated antenna configuration consists of a periodic square ring frequency selective surfaces on a superstrate, an aperture-coupled scheme feed, an intermediate substrate, and a cylindrical dielectric resonator. This antenna is designed to cover the ISM frequency band at 60 GHz (57 GHz–64 GHz). It was numerically designed using CST microwave Studio simulation software package. Another prototype with a plain dielectric superstrate is also studied for comparison purposes. A bandwidth of 13.56% at the centered frequency of 61.34 GHz and a gain of 11 dB over the entire ISM band have been achieved. A maximum gain of 14.26 dB is obtained at 60 GHz. This is an enhancement of 9 dB compared to a single DRA. HFSS is used to validate our antenna designs. Good agreement between the results of the two softwares is obtained. With these performances, these antennas promise to be useful in the design of future wireless underground communication systems operating in the unlicensed 60 GHz frequency band.


Frequenz ◽  
2017 ◽  
Vol 72 (1-2) ◽  
Author(s):  
Pinku Ranjan ◽  
Ravi Kumar Gangwar

AbstractA novel design and analysis of quarter cylindrical dielectric resonator antenna (q-CDRA) with multi-element and multi-segment (MEMS) approach has been presented. The MEMS q-CDRA has been designed by splitting four identical quarters from a solid cylinder and then multi-segmentation approach has been utilized to design q-CDRA. The proposed antenna has been designed for enhancement in bandwidth as well as for high gain. For bandwidth enhancement, multi-segmentation method has been explained for the selection of dielectric constant of materials. The performance of the proposed MEMS q-CDRA has been demonstrated with design guideline of MEMS approach. To validate the antenna performance, three segments q-CDRA has been fabricated and analyzed practically. The simulated results have been in good agreement with measured one. The MEMS q-CDRA has wide impedance bandwidth (|S


2019 ◽  
Vol 18 (1) ◽  
pp. 128-132 ◽  
Author(s):  
Byung Kuon Ahn ◽  
Hye-Won Jo ◽  
Jong-Sang Yoo ◽  
Jong-Won Yu ◽  
Han Lim Lee

2010 ◽  
Vol 15 ◽  
pp. 201-210 ◽  
Author(s):  
Mohd Fadzil Ain ◽  
Yazeed Mohammad Qasaymeh ◽  
Zainal Arrifin Ahmad ◽  
Mohammad Azman Zakariya ◽  
Mohamad Ariff Othman ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document