scholarly journals Watermarking Java application programs using the WaterRpg dynamic model

2013 ◽  
Author(s):  
Ioannis Chionis ◽  
Maria Chroni ◽  
Stavros D. Nikolopoulos
Keyword(s):  
Dynamic Model ◽  
Java Application ◽  
Application Programs

Design and Evaluation of Automated Scoring

2015 ◽  
Vol 3 (4) ◽  
pp. 18-32 ◽  
Author(s):  
Yuki Akahane ◽  
Hiroki Kitaya ◽  
Ushio Inoue
Keyword(s):  
Test Results ◽  
Automated Scoring ◽  
Web Based ◽  
Main Method ◽  
Java Programming ◽  
Java Application ◽  
Programming Skills ◽  
Automatic Scoring ◽  
Programming Courses ◽  
Application Programs

This paper presents a web-based automatic scoring system for Java programming assignments, and reports evaluation results in an actual programming course. The system receives Java application programs submitted by students and returns the test results immediately. The test consists of compiler check, JUnit test, and result test. The result test is very useful for assignments in elementary programming courses, because a typical program is composed of only a main method that reads/writes data from/to the standard input/output devices. The system was used and evaluated in an actual course of our university. The authors confirmed that the system is very helpful for students to improve their programming skills. Especially, many students noticed and corrected their mistakes by repeating submission of their programs again several times.

Short-term volume and turgor regulation in yeast

2008 ◽  
Vol 45 ◽  
pp. 147-160 ◽  
Author(s):  
Jörg Schaber ◽  
Edda Klipp
Keyword(s):  
Dynamic Model ◽  
Volume Change ◽  
Volume Regulation ◽  
Time Course ◽  
Osmotic Shock ◽  
Intracellular Concentration ◽  
Short Term ◽  
Hydrodynamic Property ◽  
Turgor Regulation ◽  
Thermodynamic Framework

Volume is a highly regulated property of cells, because it critically affects intracellular concentration. In the present chapter, we focus on the short-term volume regulation in yeast as a consequence of a shift in extracellular osmotic conditions. We review a basic thermodynamic framework to model volume and solute flows. In addition, we try to select a model for turgor, which is an important hydrodynamic property, especially in walled cells. Finally, we demonstrate the validity of the presented approach by fitting the dynamic model to a time course of volume change upon osmotic shock in yeast.

THE STATISTICAL GEOMETRY OF THE STRUCTURE OF THE MOLECULAR DYNAMIC MODEL OF LIQUID AND AMORPHOUS ALUMINIUM

1980 ◽  
Vol 41 (C8) ◽  
pp. C8-284-C8-288 ◽  
Author(s):  
V. A. Poluchin ◽  
M. M. Dzugutov ◽  
V. F. Uchov ◽  
R. A. Vatolin
Keyword(s):  
Molecular Dynamic ◽  
Dynamic Model ◽  
Statistical Geometry ◽  
Molecular Dynamic Model

Study of the dynamics of ТПА 350 automatic mill working stand elements

2020 ◽  
Vol 76 (8) ◽  
pp. 830-840
Author(s):  
S. R. Rakhmanov ◽  
V. V. Povorotnii
Keyword(s):  
Mechanical System ◽  
Dynamic Model ◽  
Maximum Amplitude ◽  
Calculation Scheme ◽  
Dynamic Loads ◽  
Forced Oscillations ◽  
Mass Model ◽  
Automatic Mill ◽  
Hollow Billet ◽  
Oscillation Movement

To form a necessary geometry of a hollow billet to be rolled at a pipe rolling line, stable dynamics of the base equipment of the automatic mill working stand has a practical meaning. Among the forces, acting on its parts and elements, significant by value short-time dynamic loads are the least studied phenomena. These dynamic loads arise during transient interaction of the hollow billet, rollers, mandrel and other mill parts at the forced grip of the hollow billet. Basing of the calculation scheme and dynamic model of the mechanical system of the ТПА 350 automatic mill working stand was accomplished. A mathematical model of dynamics of the system “hollow billet (pipe) – working stand” within accepted calculation scheme and dynamic model of the mechanical system elaborated. Influence of technological load of the rolled hollow billet variation in time was accounted, as well as variation of the mechanical system mass, and rigidity of the ТПА 350 automatic mill working stand. Differential equations of oscillation movement for four-mass model of forked sub-systems of the automatic mill working stand were made up, results of their digital calculation quoted. Dynamic displacement of the stand elements in the inter-roller gap obtained, which enabled to estimate the results of amplitude and frequency characteristics of the branches of the mill rollers setting. It was defined by calculation, that the maximum amplitude of the forced oscillations of elements of the ТПА 350 automatic mill working stand within the inter-roller gap does not exceed 2 mm. It is much higher than the accepted value of adjusting parameters of the deformation center of the ТПА 350 automatic mill. A scheme of comprehensive modernization of the rollers setting in the ТПА 350 automatic mill working stand was proposed. It was shown, that increase of rigidity of rollers setting in the ТПА 350 automatic mill working stand enables to stabilize the amplitude of forced oscillations of the working stand elements within the inter-rollers gap and considerably decrease the induced nonuniform hollow billet wall thickness and increase quality of the rolled pipes at ТПА 350.

New algorithms and formulas for calculation the volume of a ball and its surface area for the development of students' creative thinking and practical application

2020 ◽  
pp. 32-41
Author(s):  
V. P. Zudin
Keyword(s):  
Surface Area ◽  
Creative Thinking ◽  
Economic Effect ◽  
Educational Institutions ◽  
Practical Application ◽  
Microsoft Word ◽  
Ball Surface ◽  
Visual Basic For Application ◽  
Application Programs ◽  
Development Of Students

The article presents new, more accurate algorithms and formulas for calculating the area of a circle, volume of a ball, surface area of a ball. To prove these algorithms and formulas and their practical application, programs have been developed in the Visual Basic for Application in Microsoft Word. These algorithms and formulas should be studied and applied in all educational institutions, as they are closer to the truth. From a more accurate calculation using these formulas, you can get an economic effect when calculating trajectories of movements in space, on the surface of the globe, in the construction and maintenance of products in the form of a circle or a ball. The study of this material in informatics lessons contributes to the development of students' creative thinking, increasing their motivation to study informatics and IT.

J. Tobin's Monetary Dynamic Model and the Analysis of Russian Economy

2009 ◽  
pp. 70-93
Author(s):  
V. Manevich
Keyword(s):  
Dynamic Model ◽  
Economic Thought ◽  
Financial Policies ◽  
Russian Economy ◽  
Q Theory ◽  
Keynesian Economic ◽  
The Relationship ◽  
Monetary Assets

The paper considers the monetary dynamic model developed by J. Tobin, the leader of Keynesian economic thought in 1970-1990. Particularly, the author examines q-theory of investment proposed by Tobin which allows to expose the relationship between supply of monetary assets and investment in real capital. Application of various tools of monetary and financial policies is also considered in its different forms. The author aspires to use Tobin's model for the analysis of processes existing in the Russian economy and to test theoretical propositions and relationships elaborated by Tobin on Russian statistics.

Sign in / Sign up

Export Citation Format

Share Document