DenseGATs: A Graph-Attention-Based Network for Nonlinear Character Deformation

Author(s):  
Tianxing Li ◽  
Rui Shi ◽  
Takashi Kanai
1986 ◽  
Vol 108 (2) ◽  
pp. 250-254
Author(s):  
V. Venkatraman ◽  
R. W. Mayne

The first of these papers considering a hydraulically actuated mechanism presents the common oscillating cylinder arrangement and sets of equations which describe the dynamic system. It then defines dimensionless groups that characterize the actuator-mechanism and explores the quasi-linear behavior of the system. This present paper focuses on the nonlinear nature of the system. Effects of transmission angle, mechanism geometry and loading are considered as well as the range of operation in which the small perturbation behavior provides an adequate description of the dynamic response. The paper closes by identifying a new parameter which plays an important role in characterizing the dependence of the system transient response on mechanism geometry.


1965 ◽  
Vol 38 (3) ◽  
pp. 461-471 ◽  
Author(s):  
G. S. Srinivasa Murthy ◽  
B. S. Ramakrishna
Keyword(s):  

2018 ◽  
Vol 18 (11) ◽  
pp. 3145-3151 ◽  
Author(s):  
Andrin Caviezel ◽  
Werner Gerber

Abstract. Rockfall trajectories are primarily influenced by ground contacts, causing changes in acceleration and rock rotation. The duration of contacts and its influence on the rock kinematics are highly variable and generally unknown. The lack of knowledge hinders the development and calibration of physics-based rockfall trajectory models needed for hazard mitigation. To address this problem we placed three-axis gyroscopes and accelerometers in rocks of various sizes and shapes with the goal of quantifying rock deceleration in natural terrain. Short ground contacts range between 8 and 15 ms, longer contacts between 50 and 70 ms, totalling to only 6 % of the runtime. Our results underscore the highly nonlinear character of rock–ground interactions.


2017 ◽  
Vol 57 (1) ◽  
pp. 71-77
Author(s):  
Vladimir Yuferov ◽  
Sergey Shariy ◽  
Tetiana Tkachova ◽  
Vyacheslav Katrechko ◽  
Alexander Svichkar ◽  
...  

Calculated trajectories of ions with different masses, indicating the possibility of a mixture separation, are obtained. Comparative experiments for plasma of monatomic and polyatomic gases (Ar, N<sub>2</sub>, CO<sub>2</sub>), upon combination of pulsed discharge with a stationary one with incandescent cathode, are carried out. The oscillograms of discharge current and voltage at low emission currents and a constant energy input show that energy is spent on other processes different from ionization. With an increase of emission current, the nonlinear character of the discharge current and voltage, which may be indicative of the role of dissociation and vibrational levels in energy consumption, is observed. In addition, there is connection between the number of atoms in molecule and the values of maximum discharge current and the pressure of injected gas.


2019 ◽  
Vol 23 (3) ◽  
pp. 101-114
Author(s):  
Katarzyna Szwedziak ◽  
Igor Stadnyk ◽  
Sergey Golyachuk ◽  
Żaneta Grzywacz

AbstractIt is justified thatproblems related to the changes in structural and mechanical properties of plastic material and influence of structural elements of equipment and modes of implementation of the for-mation process on them are considered detail, taking into account empirical data, theoretical dependencies and results of physical experiments. It was established that during the mechanical influence of rollers with grooves on a structured dispersion plastic material in the node of injection of the molding machine, internal shear, and shearing deformation have a preponderant value. Accordingly, the productivity of machines is determined mainly by the structural parameters of the working bodies geometry, kinematics, and contact area. It is shown that increasing the pressure in the plastic material causes a decrease in its volume, but the relationship between pressure and volume has a nonlinear character. It has been established that regardless the variety of flour from which the plastic material was prepared for bagels, its moisture content and the duration of fermentation reduced viscosity of the effective plastic material along with the increase of the shear stress. The paper describes the refined rheological model of the Bingham body deformation, which develops instantaneously, and the velocity of the common elastic deformation in the dough is a simultaneous function of stresses and temperatures, which are close to exponential ones.


2019 ◽  
pp. 30-33
Author(s):  
Liudmyla PETRENKO ◽  
Larysa IVANOVA

One of main problems of modern society there is complex safety of the difficult systems of different nature. Today the problems of creation of the difficult nonlinear dynamic reliable systems go out on the first plan. It stipulates exceptional theoretical and practical meaningfulness of the use of methods of synergetics in a management the systems. An improvement of the existent theoretical and methodological going is near organization of control system by economic security of enterprise from position of sinergistical approach. An increase of multi-variant approach of development of the economic systems is reason of change of methodology of economic researches and a nonlinear economic theory comes on changing to the traditional economic theory. Invariants, non-linearity, coherentness and factorable synthesis, are the base concepts of sinergistical theory of management. Any socio-economic system presents by a soba complex of functional subsystems, that is bound by inter se the processes of intensive dynamic cooperation, exchange information. Application of synergetics showed in researches of economy, that most cases have an evolution direction of that through nonlinear character of connections in the system is determined by the action of insignificant factors basic direction of motion of the socio-economic systems, as a rule, informative, that prove in bifurcational processes. The condition of development and viability of any enterprise are maintenances of dynamic equilibrium, that are the aim of the system of economic security of enterprise — it’s attractor. By principles of management of enterprise economic security from positions sinergistical approaches are: complication, non-linearity, dynamic. The system of economic security of enterprise is base on principle of feed-back. Leaning on sinergistical approach, set forth raising of sinergistical synthesis of nonlinear control system by economic security. Exactly sinergistical effects that are characterized as management results in the systems cause the change of quality, and are the adequate instrument of providing of economic security.


2014 ◽  
Vol 2014 ◽  
pp. 1-5 ◽  
Author(s):  
M. J. Plotnikov ◽  
A. V. Kulikov ◽  
V. E. Strigalev ◽  
I. K. Meshkovsky

The dependence of the dynamic range of the phase generated carrier (PGC) technique on low-pass filters passbands is investigated using a simulation model. A nonlinear character of this dependence, which could lead to dynamic range limitations or measurement uncertainty, is presented for the first time. A detailed theoretical analysis is provided to verify the simulation results and these results are consistent with performed calculations. The method for the calculation of low-pass filters passbands according to the required dynamic range upper limit is proposed.


2015 ◽  
Vol 34 (7) ◽  
pp. 99-109 ◽  
Author(s):  
Naoya Iwamoto ◽  
Hubert P. H. Shum ◽  
Longzhi Yang ◽  
Shigeo Morishima

Sign in / Sign up

Export Citation Format

Share Document