scholarly journals Design a control system for observing vibration and temperature of turbines

Author(s):  
Omar Farhan Al-Hardanee ◽  
İlyas Çankaya ◽  
Abdulmuttalib A. Muhsen ◽  
Huseyin Canbolat

The core of a typical hydroelectric power plant is the turbine. Vibration and overheating in a turbine occur when water flows through it, and with increased vibration and high temperature, it will cause the turbine blade to break. In this study, the control and monitoring system is designed to predict and avoid any error before it occurs. This process is achieved by measuring vibration and temperature using sensors and sending signals through the Arduino to the graphical user interfaces (GUI), the system compares the signals taken from the sensors with the permissible limits, and when the permissible limits are exceeded, the processor takes appropriate measures to open and close the turbine gates, where the data is displayed in matrix laboratory graphical user interfaces (MATLAB’s GUI) screen. In this way, monitoring is done, and the appropriate action are taken to avoid mistakes.

Author(s):  
Kuniyoshi Takamatsu ◽  
Kazuhiro Sawa

The High-Temperature Engineering Test Reactor (HTTR) is the first High-Temperature Gas-cooled Reactor (HTGR) with a thermal power of 30 MW and a maximum reactor outlet coolant temperature of 950 °C; it was built at the Oarai Research and Development Center of JAEA. At present, test studies are being conducted using the HTTR to improve HTGR technologies in collaboration with domestic industries that also contribute to foreign projects for the acceleration of HTGR development worldwide. To improve HTGR technologies, advanced analysis techniques are currently under development using data obtained with the HTTR, which include reactor kinetics, thermal hydraulics, safety evaluation, and fuel performance evaluation data (including the behavior of fission products). In this study, a three gas circulator trip test and a vessel cooling system (VCS) stop test were performed as a loss of forced cooling (LOFC) test to demonstrate the inherent safety features of HTGR. The VCS stop test involved stopping the VCS located outside the reactor pressure vessel to remove the residual heat of the reactor core as soon as the three gas circulators are tripped. All three gas circulators were tripped at 9, 24 and 30 MW. The primary coolant flow rate was reduced from the rated 45 t/h to 0 t/h. Control rods (CRs) were not inserted into the core and the reactor power control system was not operational. In fact, the three gas circulator tripping test at 9 MW has already been performed in a previous study. However, the results cannot be disclosed to the public because of a confidentiality agreement. Therefore, we cannot refer to the difference between the analytical and test results. We determined that the reactor power immediately decreases to the decay heat level owing to the negative reactivity feedback effect of the core, although the reactor shutdown system was not operational. Moreover, the temperature distribution in the core changes slowly because of the high heat capacity due to the large amount of core graphite. Core dynamics analysis of the LOFC test for the HTTR was performed. The relationship among the reactivities (namely, Doppler, moderator temperature, and xenon reactivities) affecting recriticality time and reactor peak power level as well as total reactivity was addressed. Furthermore, the analytical results for a reactor transient of hundred hours are presented. Based on the results, emergency operating procedures can be developed for the case of a loss of coolant accident in HTGR when the CRs are not inserted into the core and the reactor power control system is not operational. The analytical results will be used in the design and construction of the Kazakhstan High-Temperature Reactor and the realization of commercial Very High-Temperature Reactor systems.


2021 ◽  
Vol 4 (2) ◽  
pp. 383-397
Author(s):  
Dwi Pratiwi Wulandari ◽  
Endah Trihayuningtyas ◽  
Wisi Wulandari

Waduk Jatiluhur is in Jatiluhur Subdistrict, Purwakarta Regency, West Java Province. Now Perum Jasa Tirta II as a manager has been developing Waduk Jatiluhur as an integrated tourism area through Tourism Division with the aim of improving development effectiveness. Based on the results of the study can be concluded that the main of supporting factors is the beautiful natural panorama, the extent of Waduk Jatiluhur area and the atmosphere of tourism objects that provide comfort for visitors. However, the pattern of land use in Waduk Jatiluhur area that is considered to have supported the tourism activities does not have a zoning system so that the activity of tourism and hydropower activities have not had a clear division of zones. In supporting the development of tourism in Waduk Jatiluhur, zoning area is needed to separate the core activities of the Dam River Basin and Hydroelectric Power Plant with tourism activities or with community ponds to avoid errors in the land use so that the development of tourism can provide maximal contribution.


2020 ◽  
Vol 245 ◽  
pp. 01016
Author(s):  
Luís Granado Cardoso ◽  
Clara Gaspar ◽  
João Viana Barbosa ◽  
Federico Alessio ◽  
Beat Jost ◽  
...  

LHCb is one of the 4 experiments at the LHC accelerator at CERN. During the upgrade phase of the experiment, several new electronic boards and Front End chips that perform the data acquisition for the experiment will be added by the different sub-detectors. These new devices will be controlled and monitored via a system composed of GigaBit Transceiver (GBT) chips that manage the bi-directional slow control traffic to the Slow Control Adapter(s) (SCA) chips. The SCA chips provide multiple field buses to interface the new electronics devices (I2C, GPIO, etc). These devices will need to be integrated in the Experiment Control System (ECS) that drives LHCb. A set of tools was developed that provide an easy integration of the control and monitoring of the devices in the ECS. A server (GbtServ) provides the low level communication layer with the devices via the several user buses in the GBT-SCA chip and exposes an interface for control to the experiment SCADA (WinCC OA), the fwGbt component provides the interface between the SCADA and the GbtServ and the fwHw component, a tool that allows the abstraction of the devices models into the ECS. Using the graphical User Interfaces or XML files describing the structure and registers of the devices it creates the necessary model of the hardware as a data structure in the SCADA. It allows then the control and monitoring of the defined registers using their name, without the need to know the details of the hardware behind. The fwHw tool also provides the facility of defining and applying recipes named sets of configurations which can be used to easily configure the hardware according to specific needs.


2016 ◽  
Vol 841 ◽  
pp. 122-129
Author(s):  
Vlad Mureşan ◽  
Mihail Abrudean ◽  
Tiberiu Coloşi ◽  
Iulia Clitan ◽  
Cristian Bondici ◽  
...  

This paper presents a solution for the real power control, generated by a synchronous generator belonging to a small hydroelectric power plant. The proposed control system is based on the simple feedback structure which contains also, a frequency correction loop. The mathematical models of all the elements from the control structure are detailed. Also, starting from these models, the real power controller (of Proportional – Integral – Derivative type) tuning procedure is presented. In the end of the paper, the simulations results of the control system are presented highlighting the obtained control performances. The proposed solution is a general one and it can be adapted with relative minor changes to any hydroelectric power plant.


2020 ◽  
pp. 561-578
Author(s):  
H. A. Barker ◽  
M. Chen ◽  
P. W. Grant ◽  
C. P. Jobling ◽  
P. Townsend

2014 ◽  
Vol 610 ◽  
pp. 497-500
Author(s):  
Ming Gang Zheng ◽  
Nan Wei

High-temperature flue gas in the factory has three features: high flow, strong corrosive and high temperature. It must be cooled to the rated temperature of different working conditions. There are nonlinear, time-varying issues and difficult to establish accurate mathematical model in the control of pump water quantity. We put PLC as the core to design the cooling control system which adjusts the pump water quantity by frequency changer based on fuzzy control theory.


Author(s):  
P.P.K. Smith

Grains of pigeonite, a calcium-poor silicate mineral of the pyroxene group, from the Whin Sill dolerite have been ion-thinned and examined by TEM. The pigeonite is strongly zoned chemically from the composition Wo8En64FS28 in the core to Wo13En34FS53 at the rim. Two phase transformations have occurred during the cooling of this pigeonite:- exsolution of augite, a more calcic pyroxene, and inversion of the pigeonite from the high- temperature C face-centred form to the low-temperature primitive form, with the formation of antiphase boundaries (APB's). Different sequences of these exsolution and inversion reactions, together with different nucleation mechanisms of the augite, have created three distinct microstructures depending on the position in the grain.In the core of the grains small platelets of augite about 0.02μm thick have farmed parallel to the (001) plane (Fig. 1). These are thought to have exsolved by homogeneous nucleation. Subsequently the inversion of the pigeonite has led to the creation of APB's.


2002 ◽  
Vol 122 (6) ◽  
pp. 989-994
Author(s):  
Shinichiro Endo ◽  
Masami Konishi ◽  
Hirosuke Imabayashi ◽  
Hayami Sugiyama

Sign in / Sign up

Export Citation Format

Share Document