Isotope Identification Mechanisms Enabled by Swept-Wavelength Raman Spectroscopy

2019 ◽  
Vol 74 (1) ◽  
pp. 97-107
Author(s):  
Calvin Zulick ◽  
Nagapratima Kunapareddy ◽  
Jacob Grun
Keyword(s):  
Raman Spectroscopy ◽  
Acetic Acid ◽  
Raman Peak ◽  
Visible Range ◽  
Raman Signal ◽  
Isotopic Substitution ◽  
Two Dimensional ◽  
Peak Energy ◽  
Isotope Identification ◽  
Identification Techniques

Swept-wavelength Raman signatures have been measured for isotopic variants of polyethylene, acetic acid, and potassium sulfates. The swept-wavelength measurements produce two-dimensional Raman signatures which enable identification techniques based on changes in Raman peak amplitudes as a function of wavelength. In addition to the typical Raman peak energy shifts, which results from the change in isotope mass, three wavelength dependent mechanisms for isotope identification have been identified. Changes in the shape of the Raman signal, the presence and absence of Raman peaks over specific wavelength ranges, and changes in absorption of the Raman signal were observed as a result of isotopic substitution. These features provide additional specificity in the isotopic Raman signatures which suggests swept-wavelength Raman signatures will facilitate the identification of isotopes in complex and dirty mixtures. Measurements in the visible range suggest that the identification mechanisms are primarily evident in the ultraviolet, or resonance Raman, region.

Surface-Enhanced Raman Spectroscopy of Two-Dimensional Tin Diselenide Nanoplates

2018 ◽  
Vol 72 (11) ◽  
pp. 1613-1620 ◽  
Author(s):  
Mei Liu ◽  
Ying Shi ◽  
Guangping Zhang ◽  
Yongheng Zhang ◽  
Meimei Wu ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Charge Transfer ◽  
Optoelectronic Device ◽  
Surface Enhanced Raman Spectroscopy ◽  
Raman Signal ◽  
Two Dimensional ◽  
Raman Enhancement ◽  
Surface Enhanced ◽  
Device Integration ◽  
Surface Enhanced Raman

Surface-enhanced Raman spectroscopy (SERS) is a powerful spectroscopy technique to detect and characterize molecules at a very low concentration level. The two-dimensional (2D) semi-conductor layered material, tin diselenide (SnSe2), is used as a new substrate for enhancing the Raman signals of adsorbed molecules. Three kinds of molecules—Rhodamine 6G (R6G), crystal violet (CV), and methylene blue (MB)—are used as probe molecules to evaluate the SERS performance of SnSe2. The Raman signals of different molecules can be enhanced by SnSe2 nanoplates (NPs). The distinguishable Raman signal of R6G molecules can be obtained for adsorbent concentrations as low as 10−17 mol/L. Based on a detailed analysis of the bandgap structure and opto-electrical properties of SnSe2 NPs, we discuss the process of charge transfer and the Raman enhancement mechanism of SnSe2 NP. The high Raman sensitivity of SnSe2 NPs is related to the charge transfer between molecules and SnSe2, 2D layered structure, and indirect bandgap of few-layered SnSe2. The research results will help to expand the application of SnSe2 in microanalysis, improve the measurement accuracy of SERS, and possibly find use in optoelectronic device integration.

First-Principles Evaluation of the Potential of Borophene as a Monolayer Transparent Conductor

2017 ◽  
Author(s):  
Lyudmyla Adamska ◽  
Sridhar Sadasivam ◽  
Jonathan J. Foley ◽  
Pierre Darancet ◽  
Sahar Sharifzadeh
Keyword(s):  
First Principles ◽  
Density Functional ◽  
State Of The Art ◽  
Transparent Electrode ◽  
Visible Range ◽  
Two Dimensional ◽  
Transparent Conductor ◽  
Many Body ◽  
Functional Theory ◽  
Many Body Perturbation Theory

Two-dimensional boron is promising as a tunable monolayer metal for nano-optoelectronics. We study the optoelectronic properties of two likely allotropes of two-dimensional boron using first-principles density functional theory and many-body perturbation theory. We find that both systems are anisotropic metals, with strong energy- and thickness-dependent optical transparency and a weak (<1%) absorbance in the visible range. Additionally, using state-of-the-art methods for the description of the electron-phonon and electron-electron interactions, we show that the electrical conductivity is limited by electron-phonon interactions. Our results indicate that both structures are suitable as a transparent electrode.

scholarly journals Rapid uropathogen identification using surface enhanced Raman spectroscopy active filters

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Simon D. Dryden ◽  
Salzitsa Anastasova ◽  
Giovanni Satta ◽  
Alex J. Thompson ◽  
Daniel R. Leff ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Bacterial Infections ◽  
Surface Enhanced Raman Spectroscopy ◽  
Active Filters ◽  
Raman Signal ◽  
Rapid Diagnostics ◽  
Bacterial Classification ◽  
Surface Enhanced ◽  
Surface Enhanced Raman

AbstractUrinary tract infection is one of the most common bacterial infections leading to increased morbidity, mortality and societal costs. Current diagnostics exacerbate this problem due to an inability to provide timely pathogen identification. Surface enhanced Raman spectroscopy (SERS) has the potential to overcome these issues by providing immediate bacterial classification. To date, achieving accurate classification has required technically complicated processes to capture pathogens, which has precluded the integration of SERS into rapid diagnostics. This work demonstrates that gold-coated membrane filters capture and aggregate bacteria, separating them from urine, while also providing Raman signal enhancement. An optimal gold coating thickness of 50 nm was demonstrated, and the diagnostic performance of the SERS-active filters was assessed using phantom urine infection samples at clinically relevant concentrations (105 CFU/ml). Infected and uninfected (control) samples were identified with an accuracy of 91.1%. Amongst infected samples only, classification of three bacteria (Escherichia coli, Enterococcus faecalis, Klebsiella pneumoniae) was achieved at a rate of 91.6%.

scholarly journals Fabrication-friendly polarization-sensitive plasmonic grating for optimal surface-enhanced Raman spectroscopy

2020 ◽  
Vol 16 (1) ◽  
Author(s):  
Arpan Dutta ◽  
Tarmo Nuutinen ◽  
Khairul Alam ◽  
Antti Matikainen ◽  
Peng Li ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Fill Factor ◽  
Surface Enhanced Raman Spectroscopy ◽  
Transverse Magnetic ◽  
Raman Signal ◽  
Optical Resonance ◽  
Excitation Light ◽  
Surface Enhanced ◽  
Surface Enhanced Raman ◽  
Plasmonic Gratings

Abstract Plasmonic nanostructures are widely utilized in surface-enhanced Raman spectroscopy (SERS) from ultraviolet to near-infrared applications. Periodic nanoplasmonic systems such as plasmonic gratings are of great interest as SERS-active substrates due to their strong polarization dependence and ease of fabrication. In this work, we modelled a silver grating that manifests a subradiant plasmonic resonance as a dip in its reflectivity with significant near-field enhancement only for transverse-magnetic (TM) polarization of light. We investigated the role of its fill factor, commonly defined as a ratio between the width of the grating groove and the grating period, on the SERS enhancement. We designed multiple gratings having different fill factors using finite-difference time-domain (FDTD) simulations to incorporate different degrees of spectral detunings in their reflection dips from our Raman excitation (488 nm). Our numerical studies suggested that by tuning the spectral position of the optical resonance of the grating, via modifying their fill factor, we could optimize the achievable SERS enhancement. Moreover, by changing the polarization of the excitation light from transverse-magnetic to transverse-electric, we can disable the optical resonance of the gratings resulting in negligible SERS performance. To verify this, we fabricated and optically characterized the modelled gratings and ensured the presence of the desired detunings in their optical responses. Our Raman analysis on riboflavin confirmed that the higher overlap between the grating resonance and the intended Raman excitation yields stronger Raman enhancement only for TM polarized light. Our findings provide insight on the development of fabrication-friendly plasmonic gratings for optimal intensification of the Raman signal with an extra degree of control through the polarization of the excitation light. This feature enables studying Raman signal of exactly the same molecules with and without electromagnetic SERS enhancements, just by changing the polarization of the excitation, and thereby permits detailed studies on the selection rules and the chemical enhancements possibly involved in SERS.

Radiative Recombination between Two Dimensional Electron Gas and Photoexcited Holes in Modulation-doped AlxGa1−xN/GaN Heterostructures

1999 ◽  
Vol 595 ◽  
Author(s):  
B. Shen ◽  
T. Someya ◽  
O. Moriwaki ◽  
Y. Arakawa
Keyword(s):  
Radiative Recombination ◽  
Electron Gas ◽  
Excitation Intensity ◽  
Energy Separation ◽  
Two Dimensional ◽  
Dimensional Electron ◽  
Electron Gases ◽  
Peak Energy ◽  
Dimensional Electron Gas ◽  
Increasing Temperature

AbstractPhotoluminescence (PL) of modulation-doped Al0.22Ga0.78N/GaN heterostructures was investigated. The PL peak related to recombination between the two-dimensional electron gases (2DEG) and photoexcited holes is located at 3.448 eV at 40 K, which is 45 meV below the free excitons (FE) emission in GaN. The peak can be observed at temperatures as high as 80 K. The intensity of the 2DEG PL peak is enhanced significantly by incorporating a thin Al0.12Ga0.88N layer into the GaN layer near the heterointerface to suppress the diffusion of photoexcited holes. The energy separation of the 2DEG peak and the GaN FE emission decreases with increasing temperature. Meanwhile, the 2DEG peak energy increases with increasing excitation intensity. These results are attributed to the screening effect of electrons on the bending of the conduction band at the heterointerface, which becomes stronger when temperature or excitation intensity is increased.

scholarly journals Laser Raman Spectroscopy with Different Excitation Sources and Extension to Surface Enhanced Raman Spectroscopy

2015 ◽  
Vol 2015 ◽  
pp. 1-8 ◽  
Author(s):  
Md. Wahadoszamen ◽  
Arifur Rahaman ◽  
Nabil Md. Rakinul Hoque ◽  
Aminul I Talukder ◽  
Kazi Monowar Abedin ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Silver Nanoparticles ◽  
Rhodamine 6G ◽  
Detection Efficiency ◽  
Colloidal Suspension ◽  
Surface Enhanced Raman Spectroscopy ◽  
Laser Raman Spectroscopy ◽  
Raman Signal ◽  
Fluorescence Signal ◽  
Present System

A dispersive Raman spectrometer was used with three different excitation sources (Argon-ion, He-Ne, and Diode lasers operating at 514.5 nm, 633 nm, and 782 nm, resp.). The system was employed to a variety of Raman active compounds. Many of the compounds exhibit very strong fluorescence while being excited with a laser emitting at UV-VIS region, hereby imposing severe limitation to the detection efficiency of the particular Raman system. The Raman system with variable excitation laser sources provided us with a desired flexibility toward the suppression of unwanted fluorescence signal. With this Raman system, we could detect and specify the different vibrational modes of various hazardous organic compounds and some typical dyes (both fluorescent and nonfluorescent). We then compared those results with the ones reported in literature and found the deviation within the range of ±2 cm−1, which indicates reasonable accuracy and usability of the Raman system. Then, the surface enhancement technique of Raman spectrum was employed to the present system. To this end, we used chemically prepared colloidal suspension of silver nanoparticles as substrate and Rhodamine 6G as probe. We could observe significant enhancement of Raman signal from Rhodamine 6G using the colloidal solution of silver nanoparticles the average magnitude of which is estimated to be 103.

scholarly journals Study of Thermometry in Two-Dimensional Sb2Te3 from Temperature-Dependent Raman Spectroscopy

2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Manavendra P. Singh ◽  
Manab Mandal ◽  
K. Sethupathi ◽  
M. S. Ramachandra Rao ◽  
Pramoda K. Nayak
Keyword(s):  
Thermal Conductivity ◽  
Raman Spectroscopy ◽  
Temperature Coefficient ◽  
Heat Dissipation ◽  
Peak Position ◽  
Two Dimensional ◽  
Phonon Modes ◽  
Temperature Dependent ◽  
Excellent Candidate ◽  
High Figure

AbstractDiscovery of two-dimensional (2D) topological insulators (TIs) demonstrates tremendous potential in the field of thermoelectric since the last decade. Here, we have synthesized 2D TI, Sb2Te3 of various thicknesses in the range 65–400 nm using mechanical exfoliation and studied temperature coefficient in the range 100–300 K using micro-Raman spectroscopy. The temperature dependence of the peak position and line width of phonon modes have been analyzed to determine the temperature coefficient, which is found to be in the order of 10–2 cm−1/K, and it decreases with a decrease in Sb2Te3 thickness. Such low-temperature coefficient would favor to achieve a high figure of merit (ZT) and pave the way to use this material as an excellent candidate for thermoelectric materials. We have estimated the thermal conductivity of Sb2Te3 flake with the thickness of 115 nm supported on 300-nm SiO2/Si substrate which is found to be ~ 10 W/m–K. The slightly higher thermal conductivity value suggests that the supporting substrate significantly affects the heat dissipation of the Sb2Te3 flake.

Sign in / Sign up

Export Citation Format

Share Document