scholarly journals Expected Range of Cooperation Between Transmission System Operators and Distribution System Operators After Implementation of ENTSO-E Grid Codes

Author(s):  
Tomasz Pakulski ◽  
Jarosław Klucznik
1987 ◽  
Vol 20 (1) ◽  
pp. 18-25
Author(s):  
P Gilbert

The transmission and distribution system operated by British Gas plc is the largest integrated pipeline system in Europe. The whole system comprises a national transmission system which carries gas from five terminals to the twelve gas regions. Each region in turn carries the gas through a regional transmission system into a distribution grid and thence onto its customers. The national, regional and distribution system all present the instrument engineer with different technical challenges because of the way in which they have been built and are operated, however, it is simplest to characterise them by their process conditions. The operating pressure is highest in the national transmission system being up to 75 bar, in the regional transmission system the pressure is usually less than 37 bar, and in the distribution grid it is less than 7 bar. In general, the pipe diameters decrease from the national system downwards, and the measured flowrates are lowest in the distribution grids. This paper is concerned only with instrumentation on the national transmission system. The discussion will cover current technology which is typical of that being installed at present, and concentrates on the more commonly found instrumentation. The paper begins with a brief history of development of the national transmission system and a description of how it is operated. This is followed by a discussion on the application of computers to the control of unmanned installations. A section concerning the measurement of pressure and its application to the control of the system comes next. The main part of the paper contains an analysis of high accuracy flowmetering and the paper concludes with some comments on developments in instrumentation and their application to changing operation of the national transmission system.


Energies ◽  
2019 ◽  
Vol 12 (3) ◽  
pp. 419
Author(s):  
Mads Nannestad ◽  
Zhe Zhang ◽  
Jundi Jia ◽  
Emil Jensen ◽  
Peter Randewijk

This paper investigates the reactive power balance of the Zealand side of the Danish transmission system (DK2) by using QV-curves. The study is performed in cooperation with Energinet, who is the Danish transmission system operator (TSO). Firstly, this paper aims to map the reactive power balance with the current challenges in the system, which appears due to a decision of changing overhead lines in the scenic area to cables. Secondly, a method is derived for obtaining a comprehensive overview of the impacts that future projects might have on the system. By dividing the transmission system into smaller areas, it is possible to analyze how the reactive power will affect the voltage; moreover, it is favorable to analyze and handle the challenges in the reactive power balance locally. This helps the TSO to quickly determine the lack of reactive power devices and issues that might occur in future expansions of the system. For this paper, a full-scale model of DK2 and SCADA-data has been utilized. It covers the period from 01-01-2016 to 20-08-2017 between the TSO and the Distribution System Operator (DSO). The studies have shown how the location of the wind production will create issues in the reactive power balance.


Author(s):  
William Kwasi Gboney ◽  
John Cubbin ◽  
Xeni Dassiou

This paper is based on a research study which was carried out, to empirically assess the impact of power sector reforms, comprising privatization, competition and regulatory reforms in 29 African countries, for the period 1988–2005. The list of countries in the research sample is shown in Appendix 1. The main findings for the generation sector is that, in Africa, though energy sector regulation backed by sector law can bring about favorable outcomes, better results are likely to be achieved if the regulatory agency has been in existence for at least 3 years, and it co-exists with either competition ‘for’ the market or private sector participation. On private sector participation, the presence of Independent Power Producers, management contracts and private shareholding in generation assets, can enhance generation sector performance. The results on the transmission system seem to indicate that though the establishment of a regulatory agency can reduce transmission system loss level, this outcome is likely to be achieved if the regulatory agency has been existence for at least 3 years. On distribution system loss, it emerged that the sole existence of a regulatory agency may not be enough to influence a downward trend in distribution system loss level, unless the market, permits the co-existence of competition ‘for’ the market, with a regulatory agency.


Author(s):  
Puneet K. Srivastava ◽  
Amar N. Tiwari ◽  
Sri N. Singh

Background: This paper reviews the requirements imposed by Transmission System Operators (TSOs) in their grid codes to address intolerable implications of integrating large Wind Power Plants (WPPs) to the grid. Besides the common objectives, terminologies used by different TSOs were distinct. Therefore, developing a harmonized grid code is imperative. Introduction: On the recommendation of the European Commission, European Network of Transmission System Operators for Electricity (ENTSO-E) has made concerted efforts in the direction of developing a harmonized grid code, and published its document in March 2013. Method: Several TSOs have updated their grid codes in accordance with the increasing wind energy penetration. We have made an effort to present a comparison between different integration requirements specified by different grid codes. The outcomes presented will certainly be beneficial to the countries, which are in the process of enacting their own grid code. Result: We have reviewed different grid codes in terms of Low Voltage Ride-Through (LVRT) requirement, operating voltage and frequency range, active power control (frequency regulation) and reactive power support (voltage regulation). Conclusion: The present study envisages helping wind turbine manufacturers and WPP developers, as it would provide them a clear insight into the regulations imposed on WPPs as included/ updated in different grid codes.


Energies ◽  
2020 ◽  
Vol 13 (13) ◽  
pp. 3367
Author(s):  
Victor Widiputra ◽  
Junhyuk Kong ◽  
Yejin Yang ◽  
Jaesung Jung ◽  
Robert Broadwater

Intermittent power generated from renewable distributed energy resource (DER) can create voltage stability problems in the system during peak power production in the low demand period. Thus, the existing standard for operation and management of the distribution system limits the penetration level of the DER and the amount of load in a power system. In this standard, the hosting capacity of the DER is limited to each feeder at a level where the voltage problem does not occur. South Korea applied this standard, thereby making it hard to achieve its DER target. However, by analyzing the voltage stability of an integrated system, the hosting capacity of DER can be increased. Therefore, in this study, the maximum hosting capacity of DER is determined by analyzing an integrated transmission and distribution system. Moreover, the fast voltage stability index (FVSI) is used to verify the determined hosting capacity of DER. For this, the existing interconnection standard of DER at a feeder, distribution system, and transmission system level is investigated. Subsequently, a Monte Carlo simulation is performed to determine the maximum penetration of the DER at a feeder level, while varying the load according to the standard test system in South Korea. The actual load generation profile is used to simulate system conditions in order to determine the maximum DER hosting capacity.


2013 ◽  
Vol 446-447 ◽  
pp. 837-841
Author(s):  
Hashmi Murtaza ◽  
Alanen Raili ◽  
Hänninen Seppo

In this paper, a new simulation model is developed to be able to simulate diesel genset smart grid interconnection by keeping in view future requirements of the grids and grid codes. The simulations are carried out in Matlab/Simulink environment. An example case is based on 1200 kW variable speed diesel genset with permanent magnet synchronous generator (PMSG). The simulations are carried out for various dynamic behaviours of PMSG and their protection and control facilities, which are necessary in normal operating conditions and in a range of disturbed operating conditions in order to preserve or to re-establish system security. Various faults (e.g. disturbances) have been induced in the distribution system and the robustness of the network has been analysed to make sure continuous supply of electricity to the consumers in the future smart grid environment.


Sign in / Sign up

Export Citation Format

Share Document