Study on the field strength and the output power of the dual Halbach magnet array-based linear generator using mix calculation methods

2021 ◽  
Vol 9 (3) ◽  
pp. 174
Author(s):  
Huy Diep Do ◽  
Xuan Quynh Nguyen ◽  
The Ba Dang
Agriculture ◽  
2021 ◽  
Vol 11 (10) ◽  
pp. 933
Author(s):  
Xiaohe Sun ◽  
Changyuan Zhai ◽  
Shuo Yang ◽  
Haolin Ma ◽  
Chunjiang Zhao

Microwave treatment is a green and pollution-free soil disinfection method. The application of microwaves to disinfect soil before cultivation is highly important to increase crop yields and protect the ecological environment. The electromagnetic field is an important parameter influencing the soil temperature field in the process of microwave soil treatment, and the change in soil temperature directly affects soil disinfection. Therefore, this article carried out research on the heating pattern in North China loess due to microwave treatment. First, COMSOL software was employed to simulate the microwave soil treatment process to analyze microwave penetration into soil. Second, with the application of microwaves at the designed frequency produced with a 2.45-GHz tunable microwave generating microdevice, soil with water contents of 0%, 10%, 20%, and 30% was treated for 10~60 s (at 10-s time intervals), and experiments on the influence of the microwave output power, treatment time, and soil moisture content on the soil temperature were performed via the controlled variable method. The simulation results indicate that with increasing soil moisture content, the microwave frequency inside the soil model increases, and the electric field intensity value decreases in the model at the same depth. After microwaves traverse through the 20-cm soil model, the incident field strength is three orders of magnitude lower than the outgoing field strength. The results of the microwave soil treatment experiment reveal that: (1) Compared to microwave output power levels of 1.8 and 1.6 kW, a level of 2 kW is more suitable for microwave soil disinfection. (2) After treatment, the highest temperature occurs on the soil surface, not within the soil. (3) The location of the highest soil internal temperature after microwave treatment increasingly approaches the soil surface with increasing soil moisture content, and the microwave output power does not affect the location of the highest soil internal temperature. Combining the electromagnetic field simulation and microwave soil treatment experiment results, it was found that the higher the field strength is, the higher the temperature value, and the highest soil internal temperature after microwave treatment often occurs at the first electromagnetic wave peak.


Energies ◽  
2018 ◽  
Vol 11 (1) ◽  
pp. 135 ◽  
Author(s):  
Chi Zhang ◽  
Feixue Chen ◽  
Long Li ◽  
Zhaoping Xu ◽  
Liang Liu ◽  
...  

2004 ◽  
Vol 124 (10) ◽  
pp. 1029-1035 ◽  
Author(s):  
Takayuki Kashiwagi ◽  
Toshiaki Murai ◽  
Takamitsu Yamamoto ◽  
Hitoshi Hasegawa ◽  
Takashi Sano ◽  
...  

Author(s):  
Mikael Eriksson ◽  
Karin Thorburn ◽  
Hans Bernhoff ◽  
Mats Leijon

A concept is presented where the piston of a seabed based linear generator is directly driven by a buoy on the water surface. A spring is connected to the other end of the piston. Thereby the buoy absorbs energy in two ways. A large number of poles are used as an “electromagnetic gearbox” which gives a high rate of flux change in the stator despite the slow piston motion. The damping force is a function of the velocity and the electric output power. In the studied concept the power from the generator is rectified with a diode bridge. The results of theoretical studies of output power and its interaction with the dynamics of the equation of motion are presented. It is shown that the DC voltage can be tuned to optimize the power production for each wave climate.


1976 ◽  
Vol 32 ◽  
pp. 613-622
Author(s):  
I.A. Aslanov ◽  
Yu.S. Rustamov

SummaryMeasurements of the radial velocities and magnetic field strength of β CrB were carried out. It is shown that there is a variability with the rotation period different for various elements. The curve of the magnetic field variation measured from lines of 5 different elements: FeI, CrI, CrII, TiII, ScII and CaI has a complex shape specific for each element. This may be due to the presence of magnetic spots on the stellar surface. A comparison with the radial velocity curves suggests the presence of a least 4 spots of Ti and Cr coinciding with magnetic spots. A change of the magnetic field with optical depth is shown. The curve of the Heffvariation with the rotation period is given. A possibility of secular variations of the magnetic field is shown.


Author(s):  
Richard L. McConville

A second generation twin lens has been developed. This symmetrical lens with a wider bore, yet superior values of chromatic and spherical aberration for a given focal length, retains both eucentric ± 60° tilt movement and 20°x ray detector take-off angle at 90° to the tilt axis. Adjust able tilt axis height, as well as specimen height, now ensures almost invariant objective lens strengths for both TEM (parallel beam conditions) and STEM or nano probe (focused small probe) modes.These modes are selected through use of an auxiliary lens situ ated above the objective. When this lens is on the specimen is illuminated with a parallel beam of electrons, and when it is off the specimen is illuminated with a focused probe of dimensions governed by the excitation of the condenser 1 lens. Thus TEM/STEM operation is controlled by a lens which is independent of the objective lens field strength.


Author(s):  
W. Engel ◽  
M. Kordesch ◽  
A. M. Bradshaw ◽  
E. Zeitler

Photoelectron microscopy is as old as electron microscopy itself. Electrons liberated from the object surface by photons are utilized to form an image that is a map of the object's emissivity. This physical property is a function of many parameters, some depending on the physical features of the objects and others on the conditions of the instrument rendering the image.The electron-optical situation is tricky, since the lateral resolution increases with the electric field strength at the object's surface. This, in turn, leads to small distances between the electrodes, restricting the photon flux that should be high for the sake of resolution.The electron-optical development came to fruition in the sixties. Figure 1a shows a typical photoelectron image of a polycrystalline tantalum sample irradiated by the UV light of a high-pressure mercury lamp.


Sign in / Sign up

Export Citation Format

Share Document