scholarly journals Laboratory investigation of self-healing properties on geosynthetic clay liners with flaw

2015 ◽  
Vol 41 (1) ◽  
pp. 53-58 ◽  
Author(s):  
Guang-Wei Zhang ◽  
Hu-Yuan Zhang ◽  
Jin-Fang Wang ◽  
Lang Zhou ◽  
Ping Liu ◽  
...  
Keyword(s):  
Hydraulic Conductivity ◽  
The Self ◽  
Distilled Water ◽  
Self Healing ◽  
Test Results ◽  
Geosynthetic Clay Liners ◽  
Clay Liners ◽  
Order Of Magnitude ◽  
Flexible Wall ◽  
Research Findings

Abstract The objective of this paper is to evaluate the self- healing properties of a commercially-available geosynthetic clay liner (GCL) using flexible-wall permeameter. The GCLs are produced by the same factory, but the contents of bentonite are different. Also the hydraulic conductivities (HC) of GCLs with no defect are different. In this study, specimens were completely saturated under the backpressure of 20 kPa before the test. Permeability tests were performed on GCL specimens with penetrating flaw and also on specimens permeated with distilled water and CaCl2 solutions. The test results were presented and discussed. Experimental results showed that the GCL with penetrating flaw did not exhibit complete self-healing in the case of flaw. After 120 days, the hydraulic conductivity increased by approximately an order of magnitude. In addition, CaCl2 solutions had a significant influence on the hydraulic conductivity. The research findings might be of interest to researchers and engineers who design liners for landfills and other liquid containment facilities

scholarly journals Insights into Desiccation and Self-Healing of Bentonite in Geosynthetic Clay Liners under Thermal Loads

2019 ◽  
Vol 92 ◽  
pp. 03006
Author(s):  
Abbas El-Zein ◽  
Bowei Yu ◽  
Ali Ghavam-Nasiri
Keyword(s):  
Hydraulic Conductivity ◽  
Mechanical Model ◽  
Thermal Gradients ◽  
Self Healing ◽  
Transient Phase ◽  
Geosynthetic Clay Liners ◽  
Clay Liners ◽  
Sodium Bentonite ◽  
Mechanical Loads ◽  
Numerical Investigations

Geosynthetic Clay Liners (GCLs) are widely used for protecting groundwater from pollution sources at the surface, including applications in which they are subject to significant thermal gradients. Hence, sodium bentonite in the GCL may undergo significant dehydration and cracking, and the GCL might fail as a result. The paper presents outcomes of a set of recent experimental and numerical investigations exploring the propensity of bentonite to desiccate and self-heal, as well as means of mitigating the effect of thermal gradients on the hydraulic conductivity of GCLs. An elasto-plastic thermo-hydro-mechanical model was found to yield reasonable predictions of experimental behaviour, except for the transient phase of pre-heating hydration. Introducing an airgap between the GCL and the heat source can reduce the extent of desiccation and its effects on hydraulic conductivity. However, the effectiveness of the solution will depend on other factors including subgrade, magnitude of thermal and mechanical loads and type of GCL.

Fluid loss as a quick method to evaluate hydraulic conductivity of geosynthetic clay liners under acidic conditions

2014 ◽  
Vol 51 (2) ◽  
pp. 158-163 ◽  
Author(s):  
Yang Liu ◽  
Will P. Gates ◽  
Abdelmalek Bouazza ◽  
R. Kerry Rowe
Keyword(s):  
Hydraulic Conductivity ◽  
Fluid Loss ◽  
Geosynthetic Clay Liners ◽  
Clay Liners ◽  
Quick Method ◽  
High Acid ◽  
Flexible Wall ◽  
Acidic Conditions

This study investigates the performance of bentonite components of geosynthetic clay liners (GCLs) when exposed to aggressive leachates using the fluid loss test and provides a possible quick method for estimating the effect of acidic conditions on hydraulic conductivity. Fluid loss generally increases with increasing acid concentrations. Hydraulic conductivity values back-calculated from the fluid loss tests (kFL) are compared with the values measured using a flexible-wall permeameter (kTri). Generally, the predicted hydraulic conductivity values are conservative (kFL/kTri > 1) under water and low acid concentrations (≤0.015 mol/L). However, the back-calculated hydraulic conductivity is shown to be nonconservative (kFL/kTri < 1) at high acid concentrations (≥0.125 mol/L).

scholarly journals Kaolin based protective barrier in municipal landfills against adverse chemo-mechanical loadings

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Partha Das ◽  
Tadikonda Venkata Bharat
Keyword(s):  
Ionic Strength ◽  
High Ionic Strength ◽  
The Self ◽  
Design Parameters ◽  
Layered System ◽  
Geosynthetic Clay Liners ◽  
Clay Liners ◽  
Landfill Liner ◽  
First Time ◽  
Applied Stresses

AbstractIn this work, we assess the self-sealing and swelling ability of the compacted granular bentonite (GB) under an inorganic salt environment and induced overburden stresses from the landfill waste. The laboratory permeation tests with high ionic strength salt solutions reveal that the GB fails to seal and exhibits a significant mechanical collapse under different applied stresses. The applicability of GB in the form of geosynthetic clay liners as the bottom liner facilities in landfills that produce high ionic strength salt leachates, therefore, remains a serious concern. We propose an additional barrier system based on kaolin, for the first time, to address this problem. The proposed kaolin-GB layered system performs satisfactorily in terms of its sealing and swelling ability even in adverse saline conditions and low overburden stresses. The kaolin improves the osmotic efficiency of the self and also helps the underlying GB layer to seal the inter-granular voids. The estimated design parameters by through-diffusion test suggest that the kaolin-GB layered system effectively attenuates the permeant flux and suitable as a landfill liner.

Effect of incineration ash leachates on the hydraulic conductivity of bentonite-polymer composite geosynthetic clay liners

2022 ◽  
Vol 139 ◽  
pp. 25-38
Author(s):  
Christian Wireko ◽  
Tarek Abichou ◽  
Kuo Tian ◽  
Binte Zainab ◽  
Zhiming Zhang
Keyword(s):  
Hydraulic Conductivity ◽  
Polymer Composite ◽  
Geosynthetic Clay Liners ◽  
Clay Liners

Towards a more rational approach to chemical compatibility testing of clay

2002 ◽  
Vol 39 (3) ◽  
pp. 597-607 ◽  
Author(s):  
J K Kodikara ◽  
F Rahman ◽  
S L Barbour
Keyword(s):  
Boundary Condition ◽  
Hydraulic Conductivity ◽  
Rigid Wall ◽  
New Technique ◽  
Rational Approach ◽  
Lateral Strain ◽  
Test Results ◽  
Chemical Compatibility ◽  
Test Technique ◽  
Flexible Wall

Chemical compatibility tests using hydraulic conductivity testing with chemical permeants are normally undertaken to assess the integrity of compacted clayey liners used for waste containment. This paper highlights the fact that current routine methods of flexible wall and rigid wall testing techniques fail to represent the zero lateral strain boundary condition that is required to realistically represent the field situation. The test results indicate that flexible wall permeameters underestimate the likely increases in hydraulic conductivity due to chemicals, while the rigid wall permeameters can severely overestimate these effects. A new test technique, which incorporates the zero lateral strain condition in a simple manner, is presented. This technique involves the use of a rigid wall concept in a flexible wall permeameter. A split rigid mould is used to encase the soil specimen that is glued to the internal surfaces of the mould, to apply the zero lateral strain boundary condition. The new technique is shown to be suitable for both chemical compatibility and desiccation testing. The tests were undertaken with varying concentrations of saline water, methanol, and landfill leachate. The test results indicate that the new technique produces results that fall between the results obtained from flexible wall and rigid wall permeameters. It is argued that the new test technique provides a more rational approach for chemical compatibility testing than the current rigid wall and flexible wall techniques.Key words: soil, hydraulic conductivity, chemical compatibility, landfill, permeameter, boundary condition.

Insight into hydraulic conductivity testing of geosynthetic clay liners (GCLs) exhumed after 5 and 7 years in a cover

2017 ◽  
Vol 54 (8) ◽  
pp. 1118-1138 ◽  
Author(s):  
R.K. Rowe ◽  
R.W.I. Brachman ◽  
M.S. Hosney ◽  
W.A. Take ◽  
D.N. Arnepalli
Keyword(s):  
Hydraulic Conductivity ◽  
Unit Area ◽  
Divalent Cations ◽  
Hydraulic Gradient ◽  
Silty Sand ◽  
Geosynthetic Clay Liners ◽  
Clay Liners ◽  
Percentage Area ◽  
Bundle Size ◽  
Insight Into

Four geosynthetic clay liners (GCLs) serving as single liners were exhumed from below 0.7 m of silty sand on a 3:1 (horizontal:vertical) north-facing slope at the QUELTS site in Godfrey, Ontario, after 5 and 7 years. The 300 mm GCL overlaps with 0.4 kg/m supplemental bentonite were all physically intact. The exchangeable bound sodium was completely replaced with divalent cations. The GCL with the smallest needle-punched bundle size (average of 0.7 mm) and percentage area covered by bundles (4%) maintained low hydraulic conductivity (k) when tested under 0.07–1.2 m head with 10 mmol/L CaCl2 solution as the permeant. For GCLs with larger bundles (1.1–1.6 mm) and higher percentage area covered by bundles (9%–14%), k was low when the head was low (0.07 m). Once the applied head increased, k increased by 1–4 orders of magnitude depending on the (i) hydraulic gradient, (ii) size and number of the needle-punched bundles, and (iii) structure and mass of the bentonite per unit area. The results suggest that the GCLs can perform effectively as a single hydraulic barrier in covers providing that the head above the GCL is kept low (e.g., by a suitable drainage layer above the GCL).

Sign in / Sign up

Export Citation Format

Share Document