Refined palm oil fractions: Effect of skim milk powder and maltodextrin on emulsion properties and microencapsulation by spray drying

2021 ◽  
Author(s):  
K. Cevik ◽  
H. Yalcin
Keyword(s):  
Spray Drying ◽  
Palm Oil ◽  
Palm Olein ◽  
Milk Powder ◽  
Skim Milk ◽  
Palm Stearin ◽  
Skim Milk Powder ◽  
Solid Content ◽  
Coating Materials ◽  
Oil Fractions

Abstract The aim of this study was to investigate microencapsulation of palm oil fractions (palm olein (POL) and 90% palm olein+10% palm stearin (POS)) using skim milk powder (SMP) and maltodextrin (MD) by spray drying. Twenty-seven emulsions with POL were prepared to determine appropriate solid content (SC) and oil/coating material ratio (O/CM) of the emulsions to be fed into the spray dryer. Emulsion properties, such as viscosity and stability, were affected by SC and coating materials. The effects of coating materials used in microencapsulation of POL and POS were also tested by using different ratios of SMP and MD. The microencapsulation efficiency (69.28–84.97%), the microencapsulation yield (14.50–31.79%), and the peroxide value (4.12–7.07 meq O2/kg oil) of the powders were affected by the coating materials (P < 0.05).

scholarly journals Wall deposition experiments in a new spray dryer

2018 ◽  
Author(s):  
Timothy A. G. Langrish ◽  
Xing Huang ◽  
Chao Zhong
Keyword(s):  
Spray Drying ◽  
Salt Solution ◽  
Milk Powder ◽  
Skim Milk ◽  
Skim Milk Powder ◽  
Solid Content ◽  
Operating Conditions ◽  
Spray Dryer ◽  
Wall Deposition

Wall deposition tests have been conducted on a new spray-drying sytem. Solutions of salt and skim milk powder have been dried with different inlet temperatures (170 °C and 230 °C) and solid contents (8.8 wt% and 30 wt%). The experiment showed that increasing the temperature caused an decrease in the amount of deposition for salt solution, but an increase for skim milk. The experiments also showed that a higher solid content caused an increase in deposition. The trends agreed with the studies using a conventional spray dryer, but the amount of deposition appeared to be lower in the new spray dryer at the same operating conditions Keywords: Spray drying; wall deposition

scholarly journals Staphylococcal Food Poisoning Associated with Spray-Dried Milk

1955 ◽  
Vol 53 (4) ◽  
pp. 387-397 ◽  
Author(s):  
P. H. R. Anderson ◽  
Doris M. Stone
Keyword(s):  
Spray Drying ◽  
Clinical Features ◽  
Milk Powder ◽  
Food Poisoning ◽  
Skim Milk ◽  
Skim Milk Powder ◽  
Large Numbers ◽  
Heat Treated ◽  
Drying Chamber ◽  
Spray Dried

SummaryEight explosive outbreaks of food poisoning, occurring in school canteens in England during 1953 and affecting 1190 known cases, are described. The clinical features were characteristic of the toxin type of illness. No deaths occurred.The food causing all of these outbreaks was prepared from spray-dried skim milk powder. It was not subsequently heat-treated and was usually consumed 3–4 hr. after preparation.The spray-dried milk powder proved to contain a high content of bacteria, including large numbers of Staph. aureus, of a phage pattern often associated with food poisoning. The assumption was therefore made that these outbreaks were caused by staphylococcal enterotoxin.Because the food was often consumed within 3–4 hr. of reconstitution of the milk powder—before, in fact, the staphylococci had had time to grow—it is concluded that the poisoning must have been due mainly to pre-formed toxin.Consideration is given to the opportunities for the formation of toxin in a spray-drying plant, and reasons are brought forward for believing that it is formed mainly in the balance tank where the warm milk is kept, sometimes for several hours, before passing into the final drying chamber.The processing of the milk and the precautions for preventing contamination of the finished product are discussed.

scholarly journals Food Uses of Palm Oil in Japan

1994 ◽  
Vol 15 (2) ◽  
pp. 1-4 ◽  
Author(s):  
Hiroyuki Mori ◽  
Takashi Kaneda
Keyword(s):  
Palm Oil ◽  
Food Industry ◽  
Palm Olein ◽  
Palm Stearin ◽  
Food Products ◽  
Deep Frying ◽  
Oil Consumption ◽  
Official Statistics ◽  
Snack Foods ◽  
Oil Fractions

Palm oil has many advantageous properties that make it well suited for manufacturing and processing food products in Japan. Its principal uses are in making margarine and shortening, and for deep frying instant noodles, tempura, and snack foods. Palm oil now enjoys a 22% share of all oils and fats used in preparing these foods. In addition, palm oil fractions such as palm olein, palm stearin, and palm midfraction are used increasingly in a variety of other food products, ranging from vegetable ghee and hard butter to chocolate and ice cream. According to official statistics, palm oil consumption in Japan has now increased to around 320,000 tons per year, and the indications are that its use in the food industry will continue to increase despite the fact that liquid oils remain the major oils in domestic cooking.

Changes in Concentration of Aflatoxin M1 during Manufacture and Storage of Skim Milk Powder

2006 ◽  
Vol 69 (3) ◽  
pp. 682-685 ◽  
Author(s):  
ORGUN DEVECİ ◽  
EMEL SEZGİN
Keyword(s):  
Spray Drying ◽  
Milk Powder ◽  
Skim Milk ◽  
Skim Milk Powder ◽  
Aflatoxin M1 ◽  
Weight Changes ◽  
Sample Weight ◽  
Powder Samples ◽  
And Storage ◽  
Different Levels

In this study, skim milk powder was produced from cow's milk contaminated artificially with aflatoxin M1 (AFM1) at two different levels, 1.5 and 3.5 μg/liter (ppb), and the effects of process stages on the AFM1 contents were investigated. Pasteurization, concentration, and spray drying caused losses of about 16, 40, and 68%, respectively, in AFM1 content of the milk contaminated with 1.5 μg/liter AFM1, and losses of 12, 35, and 59%, respectively, in the milk contaminated with 3.5 μg/liter AFM1. These losses were found to be statisticially significant at the level of P &lt; 0.01. After 3- and 6-month storage periods, AFM1 content of the skim milk powder produced from milk with 1.5 μg/liter AFM1 decreased by 2 and 5%, respectively, whereas these rates were 2 and 4%, respectively, for the skim milk powders made from milk with 3.5 μg/liter AFM1 (after adjustment for sample weight). Changes in AFM1 content of milk powder samples were found statistically insignificant (P &gt; 0.05 and P &gt; 0.01) for 3- and 6-month storage periods.

Denaturation, aggregation and heat stability of milk protein during the manufacture of skim milk powder

1991 ◽  
Vol 58 (3) ◽  
pp. 269-283 ◽  
Author(s):  
Harjinder Singh ◽  
Lawrence K. Creamer
Keyword(s):  
Spray Drying ◽  
Milk Powder ◽  
Skim Milk ◽  
Heat Stability ◽  
Skim Milk Powder ◽  
Casein Micelle ◽  
Commercial Plant ◽  
Preheat Treatment ◽  
Solids Content ◽  
Time Required

SummaryThe effect of preheat treatment, evaporation and drying in a commercial plant on the denaturation of βlactoglobulin and α-lactalbumin, their incorporation into the casein micelle and the heat stability characteristics of the milks and powders were determined. Preheat treatments between 110 °C for 2 min and 120 °C for 3 min denatured between 80 and 91% of β-lactoglobulin and between 33 and 45% of α-lactalbumin. Evaporation increased the extent of denaturation but spray drying did not increase it further. The incorporation of α-lactalbumin and βlactoglobulin into the micelles was markedly less than the amount that denatured and was not a constant ratio to it. Heat coagulation times at 140 °C of milks, concentrates and powders diluted to the original milk concentration were measured as a function of pH. In general, the greater the collective heat treatment, the shorter the time required to achieve coagulation. Spray drying shifted the peak positions in the pH-heat coagulation time profiles. In contrast, heat coagulation times (measured at 120 °C) of concentrates and powders diluted to 20% total solids content increased with the severity of the preheat treatment. Surprisingly, spray drying markedly increased the heat coagulation times of the diluted concentrates.

Application of reverse osmosis to the manufacture of dried whole milk and skim-milk

1979 ◽  
Vol 46 (4) ◽  
pp. 663-672 ◽  
Author(s):  
James Abbot ◽  
Frank A. Glover ◽  
Donald D. Muir ◽  
Paul J. Skudder
Keyword(s):  
Reverse Osmosis ◽  
Spray Drying ◽  
Milk Production ◽  
Protein Denaturation ◽  
Milk Powder ◽  
Skim Milk ◽  
Bacterial Count ◽  
Skim Milk Powder ◽  
Powder Morphology ◽  
Whole Milk

SummaryPowders were prepared from whole and skim-milk using reverse osmosis (RO) as a first stage followed by either evaporation and spray drying or spray drying alone. They were compared with powders made by the conventional method of evaporation and spray drying. Measurements were made of powder solubility, free fat content, whey protein denaturation, vitamin content, powder morphology and bacterial count. The free fat contents of powders prepared from whole milk concentrated by RO were high; otherwise, there were no significant differences in the properties of powders made from milks concentrated initially by RO and those prepared by conventional evaporation. The results indicate that it is feasible to use RO for the manufacture of skim-milk powder and for dried whole milk production where higher free fat levels are not detrimental.

scholarly journals Development and Characterization of Carob Flour Based Functional Spread for Increasing Use as Nutritious Snack for Children

2017 ◽  
Vol 2017 ◽  
pp. 1-7 ◽  
Author(s):  
Sema Aydın ◽  
Yüksel Özdemir
Keyword(s):  
Palm Oil ◽  
Milk Powder ◽  
Skim Milk ◽  
Skim Milk Powder ◽  
Market Potential ◽  
Overall Acceptability ◽  
Chocolate Spread ◽  
Work Done ◽  
To Receive

Carob flour enriched functional spread was developed and textural, sensory, colour, and some nutritional properties of the product were investigated. Spread samples were prepared with major ingredients for optimisation and minor ingredients for improving texture and aroma. Major ingredients were carob flour and hydrogenated palm oil (HPO) and minor ingredients were commercial skim milk powder, soya flour, lecithin, and hazelnut puree. The ratio of major ingredients was optimised using sensory scores and instrumental texture values to produce a carob spread that most closely resembles commercial chocolate spread (control), in both spreadability and overall acceptability. The amounts of minor ingredients (milk powder, 10%; soybean flour, 5%; lecithin, 1%; hazelnut puree, 4%) were kept in constant ratio (20%). Addition of hydrogenated palm oil (HPO) decreased the hardness and hardness work done (HWD) values in contrast to carob flour. Higher rates of carob flour were linked to lower lightness, greenness, and yellowness values. Spread was optimised at 38 g carob flour/100 g spread and 42 g hydrogenated palm oil/100 g spread level and the formulation tended to receive the highest sensory scores compared to other spreads and presented closer instrumental spreadability values to control samples. This indicates a strong market potential for optimised carob spreads.

scholarly journals Dehumidified-Air-Assisted Spray Drying of Buckwheat Honey with Maltodextrin and Skim Milk Powder as Carriers

2021 ◽  
Vol 11 (7) ◽  
pp. 3150
Author(s):  
Alicja Barańska ◽  
Aleksandra Jedlińska ◽  
Katarzyna Samborska
Keyword(s):  
Energy Consumption ◽  
Spray Drying ◽  
Industrial Application ◽  
Milk Powder ◽  
Skim Milk ◽  
High Viscosity ◽  
Skim Milk Powder ◽  
Physiochemical Properties ◽  
Drying Temperature ◽  
Innovative Method

Buckwheat honey is proven to demonstrate health beneficial properties; however, its application in the industry is limited due to its high viscosity and syrupy-like consistency. The paper aimed to investigate process performance and physiochemical properties of carrier-reduced buckwheat honey. Honey was spray dried conventionally (inlet/outlet drying temperature: 180 °C/80 °C) and at low drying temperature with dehumidified air application (inlet/outlet drying temperature: 80 °C/45 °C) with maltodextrin as traditional carrier and alternatively with skim milk powder. The results of this study indicate that lowering the humidity of drying air enabled a decrease in carrier content of up to 25% (w/w solids), following powder recovery over 87%, which has not been recorded before for buckwheat honey powders. The results for the physicochemical properties proved that the application of the dehumidified air and skim milk powder as a carrier ameliorated their physiochemical properties and the antioxidant activity. Furthermore, the energy consumption of dehumidified-air-assisted spray drying was investigated as a basis for potential industrial application of this innovative method, which has not been studied in the literature before. The industrial application of this method must be carefully analyzed with regard to its advantages, as the energy consumption is significantly higher than in conventional spray drying.

Sign in / Sign up

Export Citation Format

Share Document