Influence of donor density in ZnO on ZnO–PrCoOx thin-film junctions: Role of O2 and Al dopant in varistors

1994 ◽  
Vol 9 (3) ◽  
pp. 669-673 ◽  
Author(s):  
Yoshihiko Yano ◽  
Yukihiko Shirakawa ◽  
Hisao Morooka

ZnO/PrCoOx and ZnO/PrCoOx/ZnO junctions have been fabricated by sputtering as a model of a single grain boundary in a ceramic ZnO varistor. The relations between barrier parameters and varistor characteristics were investigated using voltage-current (V-I) capacitance-voltage (C-V), and deep-level transient spectroscopy (DLTS) measurements. The varistor voltage of the junctions increases as the donor density (ND) of the ZnO film decreases. The interface states vary according to the method of ZnO sputtering. A clear correlation has been established between the α value and the interface states. The highest α value is obtained when ND is ≃ 1018 cm−3, the interface level is 0.70 eV, and the breakdown voltage is 3–4 V. Oxygen is effective on control of ND in ZnO and the interface states. Al added as a dopant is also effective in terms of its ability to increase ND in ZnO. However, Al doping was found to degrade the interface states and increase the leakage current.

2003 ◽  
Vol 784 ◽  
Author(s):  
P. Victor ◽  
S. Saha ◽  
S. B. Krupanidhi

ABSTRACTBaTiO3 and Ba0.9Ca0.1TiO3 thin films were deposited on the p – type Si substrate by pulsed excimer laser ablation technique. The Capacitance – Voltage (C-V) measurement measured at 1 MHz exhibited a clockwise rotating hysteresis loop with a wide memory window for the Metal – Ferroelectric – Semiconductor (MFS) capacitor confirming the ferroelectric nature. The low frequency C – V measurements exhibited the response of the minority carriers in the inversion region while at 1 MHz the C – V is of a high frequency type with minimum capacitance in the inversion region. The interface states of both the MFS structures were calculated from the Castagne – Vaipaille method (High – low frequency C – V curve). Deep Level Transient Spectroscopy (DLTS) was used to analyze the interface traps and capture cross section present in the MFS capacitor. There were distinct peaks present in the DLTS spectrum and these peaks were attributed to the presence of the discrete interface states present at the semiconductor – ferroelectric interface. The distribution of calculated interface states were mapped with the silicon energy band gap for both the undoped and Ca doped BaTiO3 thin films using both the C – V and DLTS method. The interface states of the Ca doped BaTiO3 thin films were found to be higher than the pure BaTiO3 thin films.


1994 ◽  
Vol 9 (1) ◽  
pp. 112-118 ◽  
Author(s):  
Yoshihiko Yano ◽  
Yoshizo Takai ◽  
Hisao Morooka

The interface states in ZnO with impurities of transition-metals, Mn, Co, and Cu, were investigated by the DLTS (deep-level transient spectroscopy) measurements in ZnO/PrCoOx/ZnO junctions as model systems of ZnO ceramic varistors and by the SCF-Xα-SW molecular orbital calculations using simplified cluster models. The DLTS signals, correlated to the doping of Mn and Co, are obtained with ZnO/PrCox/ZnO junctions. The signals correspond to the interface states due to the transition-metal doping. Xα calculations indicate that the interface states attributed to the doping of transition-metals, Mn, Co, and Cu, in ZnO are created between the valence band and the conduction band, which consist of transition-metals 3d character. The impurities of transition-metals affect interface states as well as the adsorbed excess oxygen.


Open Physics ◽  
2011 ◽  
Vol 9 (1) ◽  
Author(s):  
Peter Hockicko ◽  
Peter Bury ◽  
Peter Sidor ◽  
Hikaru Kobayashi ◽  
Masao Takahashi ◽  
...  

AbstractA set of MOS structures with thin SiO2 layers prepared by nitric acid oxidation (NAOS) method was investigated using acoustic deep level transient spectroscopy (A-DLTS) to explain the role of annealing treatment (post-oxidation annealing (POA) and post-metallization annealing (PMA)) at different conditions on the distribution of interface states. The activation energies of interface states and the corresponding capture cross-section were calculated both from Arrhenius plots constructed for individual peaks of the A-DLTS spectra and applying the method of modeling of measured acoustic spectra. The energy distribution of the interface states was determined also from the dependence of acoustoelectric response signal (ARS) on the external bias voltage (U ac - V G curves). By comparing the A-DLTS spectra, U ac - V G characteristics and some electrical measurements (G-V, I-V curves) of investigated MOS structures with no treatment with those treated with POA and/or PMA, the role of individual treatments was observed. The definite decrease of the interface states in the structures with the PMA treatment in comparison with the POA treatment was confirmed too.


2008 ◽  
Vol 1108 ◽  
Author(s):  
Junjiroh Kikawa ◽  
Yuki Horiuchi ◽  
Eiji Shibata ◽  
Masamitsu Kaneko ◽  
Hirotaka Otake ◽  
...  

AbstractInterface states produced at the interface between an insulator and GaN semiconductor determine the performance of GaN metal-insulator-semiconductor (MIS) field effect transistors. Therefore, it is important to know details of interface states characteristics to improve device performances. For above purpose, we have fabricated GaN MIS capacitors, then carried out capacitance-voltage (CV) and deep level transient spectroscopy (DLTS) measurements, and analyzed the obtained results in detail.Wafers used in this study were n-type GaN grown on sapphire substrates by metal organic chemical vapor deposition. A film of SiN was deposited as an insulating layer using electron-cyclotron-resonance plasma-assisted deposition at room temperature, then samples were annealed at 400, 600 or 800°C in N2 atmosphere for 10 min.CV measurements were performed for all the samples at various frequencies and bias sweep rates in the dark condition. CV curves of all the samples exhibited ledges in the curves. Here, ledge indicates a region of which capacitance is independent of applied bias. Although each sample was annealed at each different temperature, it was observed at the same surface potential for all the samples. This result indicates that the Fermi level of the GaN/SiN interface is pinned by a particular trap. In addition, the shape of the CV curve depended on both frequency and bias sweep rate, and it was not observed in the results obtained by a quasi-static capacitance voltage measurement. This can be explained that the shape of ledge is determined by the quasi-equilibrium between a filling rate of traps and a bias sweep rate or test frequency.In the positive bias region of the ledge, a hysteresis window of the CV curve had some dependence on frequency but little dependence on bias sweep rate. On the other hand, in the negative bias region of the ledge, it had little dependence on frequency but obvious dependence on bias sweep rate. These dependences indicate two different traps and related to the ledge formation. The trap energy level related to the sweep rate dependence is estimated to be 0.34 eV by the temperature dependence of the width of hysteresis window.Deep level transient spectroscopy measurements were carried out to characterize the trap levels observed in the CV curves. Trap levels with activation energies of 0.32 and 0.78 eV were observed [1]. The former is almost equal to 0.34 eV obtained from the temperature dependence of the width of hysteresis window. The latter is similar to the interface trap reported by Nakano et al., which is considered to be originated from the complexes of Si and surface defect [2].[1] E. Shibata et al., Ext. Abstracts 2008 IMFEDK, Osaka, pp.69-70. (2008).[2] Y. Nakano and T. Jimbo, Appl. Phys. Lett. 80, 4756 (2002).


Author(s):  
М.М. Соболев ◽  
Ф.Ю. Солдатенков

The results of experimental studies of capacitance– voltage characteristics, spectra of deep-level transient spectroscopy of graded high-voltage GaAs p+−p0−i−n0 diodes fabricated by liquid-phase epitaxy at a crystallization temperature of 900C from one solution–melt due to autodoping with background impurities, in a hydrogen or argon ambient, before and after irradiation with neutrons. After neutron irradiation, deep-level transient spectroscopy spectra revealed wide zones of defect clusters with acceptor-like negatively charged traps in the n0-layer, which arise as a result of electron emission from states located above the middle of the band gap. It was found that the differences in capacitance–voltage characteristics of the structures grown in hydrogen or argon ambient after irradiation are due to different doses of irradiation of GaAs p+−p0−i−n0 structures and different degrees of compensation of shallow donor impurities by deep traps in the layers.


2011 ◽  
Vol 109 (6) ◽  
pp. 064514 ◽  
Author(s):  
A. F. Basile ◽  
J. Rozen ◽  
J. R. Williams ◽  
L. C. Feldman ◽  
P. M. Mooney

2005 ◽  
Vol 483-485 ◽  
pp. 425-428 ◽  
Author(s):  
R.R Ciechonski ◽  
Samuele Porro ◽  
Mikael Syväjärvi ◽  
Rositza Yakimova

Specific on-resistance Ron estimated from current density-voltage characteristics of Schottky diodes on thick layers exhibits variations from tens of mW.cm2 to tens of W.cm2 for different doping levels. In order to understand the occurrence of high on-state resistance, Schottky barrier heights were first estimated for both forward and reverse bias with the application of thermionic emission theory and were in agreement with a literature reported values. Decrease in mobility with the temperature was observed and its dependencies of T–1.3 and T–2.0 for moderately doped and low doped samples respectively were estimated. From deep level measurements by Minority Carrier Transient Spectroscopy, an influence of shallow boron related levels and D-center on dependence of on-state resistance was observed, being more pronounced in low doped samples. Similar tendency was observed in depth profiling of Ron. This suggests a major role of boron in a compensation mechanism thus resulting in high Ron.


2000 ◽  
Vol 5 (S1) ◽  
pp. 922-928
Author(s):  
A. Hierro ◽  
D. Kwon ◽  
S. A. Ringel ◽  
M. Hansen ◽  
U. K. Mishra ◽  
...  

The deep level spectra in both p+-n homojunction and n-type Schottky GaN diodes are studied by deep level transient spectroscopy (DLTS) in order to compare the role of the junction configuration on the defects found within the n-GaN layer. Both majority and minority carrier DLTS measurements are performed on the diodes allowing the observation of both electron and hole traps in n-GaN. An electron level at Ec−Et=0.58 and 0.62 V is observed in the p+-n and Schottky diodes, respectively, with a concentration of ∼3−4×1014 cm−3 and a capture cross section of ∼1−5×10−15 cm2. The similar Arrhenius behavior indicates that both emissions are related to the same defect. The shift in activation energy is correlated to the electric field enhanced-emission in the p+-n diode, where the junction barrier is much larger. The p+-n diode configuration allows the observation of a hole trap at Et−Ev=0.87 eV in the n-GaN which is very likely related to the yellow luminescence band.


1988 ◽  
Vol 63 (11) ◽  
pp. 5375-5379 ◽  
Author(s):  
A. Rohatgi ◽  
S. K. Pang ◽  
T. K. Gupta ◽  
W. D. Straub

Sign in / Sign up

Export Citation Format

Share Document