The Image Analysis of Dancer Perceived by General Public

2014 ◽  
Vol 32 (1) ◽  
pp. 95-114
Author(s):  
SunghanBae ◽  
이윤혜
Keyword(s):  
Image Analysis ◽  
General Public

Automated Image Analysis Of Nuclear And Cytoplasmic Changes In Exfoliated Cells From Tracheas Treated With Carcinogen

1977 ◽  
Vol 35 ◽  
pp. 220-221
Author(s):  
S.F. Stinson ◽  
J.C. Lilga ◽  
M.B. Sporn
Keyword(s):  
Image Analysis ◽  
Pattern Analysis ◽  
Relative Proportion ◽  
Automated Image Analysis ◽  
Image Analyzer ◽  
Cross Sectional ◽  
Exfoliated Cells ◽  
Neoplastic Lesions ◽  
Analysis System ◽  
Morphologic Criterion

Increased nuclear size, resulting in an increase in the relative proportion of nuclear to cytoplasmic sizes, is an important morphologic criterion for the evaluation of neoplastic and pre-neoplastic cells. This paper describes investigations into the suitability of automated image analysis for quantitating changes in nuclear and cytoplasmic cross-sectional areas in exfoliated cells from tracheas treated with carcinogen.Neoplastic and pre-neoplastic lesions were induced in the tracheas of Syrian hamsters with the carcinogen N-methyl-N-nitrosourea. Cytology samples were collected intra-tracheally with a specially designed catheter (1) and stained by a modified Papanicolaou technique. Three cytology specimens were selected from animals with normal tracheas, 3 from animals with dysplastic changes, and 3 from animals with epidermoid carcinoma. One hundred randomly selected cells on each slide were analyzed with a Bausch and Lomb Pattern Analysis System automated image analyzer.

Progress In The Practical Application Of Automated Image Analysis To Tem Negatives

1977 ◽  
Vol 35 ◽  
pp. 214-217
Author(s):  
F. A. Heckman ◽  
E. Redman ◽  
J.E. Connolly
Keyword(s):  
Image Analysis ◽  
Image Quality ◽  
Exposure Time ◽  
Image Contrast ◽  
Automated Image Analysis ◽  
Practical Application ◽  
Factors Affecting ◽  
High Image Quality ◽  
Qualitative Evidence ◽  
Comprehensive Study

In our initial publication on this subject1) we reported results demonstrating that contrast is the most important factor in producing the high image quality required for reliable image analysis. We also listed the factors which enhance contrast in order of the experimentally determined magnitude of their effect. The two most powerful factors affecting image contrast attainable with sheet film are beam intensity and KV. At that time we had only qualitative evidence for the ranking of enhancing factors. Later we carried out the densitometric measurements which led to the results outlined below.Meaningful evaluations of the cause-effect relationships among the considerable number of variables in preparing EM negatives depend on doing things in a systematic way, varying only one parameter at a time. Unless otherwise noted, we adhered to the following procedure evolved during our comprehensive study:Philips EM-300; 30μ objective aperature; magnification 7000- 12000X, exposure time 1 second, anti-contamination device operating.

A New System For Optomanual Semiautomatic Quantitative Image Analysis

1977 ◽  
Vol 35 ◽  
pp. 210-211
Author(s):  
H.P. Rohr
Keyword(s):  
Image Analysis ◽  
Volume Density ◽  
List Type ◽  
Distribution Analysis ◽  
Type Number ◽  
Point Counting ◽  
Human Eye ◽  
Quantitative Image ◽  
Point Density ◽  
Electronic Counting

Today, in image analysis the broadest possible rationalization and economization have become desirable. Basically, there are two approaches for image analysis: The image analysis through the so-called scanning methods which are usually performed without the human eye and the systems of optical semiautomatic analysis completely relying on the human eye.The new MOP AM 01 opto-manual system (fig.) represents one of the very promising approaches in this field. The instrument consists of an electronic counting and storing unit, which incorporates a microprocessor and a keyboard for choice of measuring parameters, well designed for easy use.Using the MOP AM 01 there are three possibilities of image analysis:the manual point counting,the opto-manual point counting andthe measurement of absolute areas and/or length (size distribution analysis included).To determine a point density for the calculation of the corresponding volume density the intercepts lying within the structure are scanned with the light pen.

Application of Modified Bloch Waves to Image Analysis of Extended Linear Defects

1974 ◽  
Vol 32 ◽  
pp. 402-403
Author(s):  
S. Nakahara ◽  
D. M. Maher
Keyword(s):  
Image Analysis ◽  
Computational Approach ◽  
Dislocation Loops ◽  
Plane Wave Expansion ◽  
Dynamical Equations ◽  
Bloch Waves ◽  
Linear Defects ◽  
Imperfect Crystal ◽  
Localized Defects ◽  
Defective Crystals

Since Head first demonstrated the advantages of computer displayed theoretical intensities from defective crystals, computer display techniques have become important in image analysis. However the computational methods employed resort largely to numerical integration of the dynamical equations of electron diffraction. As a consequence, the interpretation of the results in terms of the defect displacement field and diffracting variables is difficult to follow in detail. In contrast to this type of computational approach which is based on a plane-wave expansion of the excited waves within the crystal (i.e. Darwin representation ), Wilkens assumed scattering of modified Bloch waves by an imperfect crystal. For localized defects, the wave amplitudes can be described analytically and this formulation has been used successfully to predict the black-white symmetry of images arising from small dislocation loops.

Interfacing of a TEM/STEM System to a Computer

1981 ◽  
Vol 39 ◽  
pp. 250-251
Author(s):  
P. Hagemann
Keyword(s):  
Image Analysis ◽  
Transmission Rate ◽  
Analytical Electron Microscopy ◽  
Signal Beam ◽  
Automated Image Analysis ◽  
Beam Deflection ◽  
External Control ◽  
Computer Input ◽  
Instrument Control ◽  
Data Acquisition And Processing

The use of computers in the analytical electron microscopy today shows three different trends (1) automated image analysis with dedicated computer systems, (2) instrument control by microprocessors and (3) data acquisition and processing e.g. X-ray or EEL Spectroscopy.While image analysis in the T.E.M. usually needs a television chain to get a sequential transmission suitable as computer input, the STEM system already has this necessary facility. For the EM400T-STEM system therefore an interface was developed, that allows external control of the beam deflection in TEM as well as the control of the STEM probe and video signal/beam brightness on the STEM screen.The interface sends and receives analogue signals so that the transmission rate is determined by the convertors in the actual computer periphery.

Biodegradable polyester neuroprostheses promote the reconnection of separated peripheral nerve stubs

1992 ◽  
Vol 50 (2) ◽  
pp. 1094-1095
Author(s):  
Beverly L. Giammara ◽  
Jennifer S. Stevenson ◽  
Peggy E. Yates ◽  
Robert H. Gunderson ◽  
Jacob S. Hanker
Keyword(s):  
Image Analysis ◽  
Basement Membrane ◽  
Periodic Acid ◽  
Light And Electron Microscopy ◽  
Computer Assisted ◽  
Type Iii Collagen ◽  
Image Analysis System ◽  
Biodegradable Polyester ◽  
Adult Rats ◽  
Type Iv

An 11mm length of sciatic nerve was removed from 10 anesthetized adult rats and replaced by a biodegradable polyester Vicryl™ mesh sleeve which was then injected with the basement membrane gel, Matrigel™. It was noted that leg sensation and movement were much improved after 30 to 45 days and upon sacrifice nerve reconnection was noted in all animals. Epoxy sections of the repaired nerves were compared with those of the excised segments by the use of a variation of the PAS reaction, the PATS reaction, developed in our laboratories for light and electron microscopy. This microwave-accelerated technique employs periodic acid, thiocarbohydrazide and silver methenamine. It stains basement membrane or Type IV collagen brown and type III collagen (reticulin), axons, Schwann cells, endoneurium and perineurium black. Epoxy sections of repaired and excised nerves were also compared by toluidine blue (tb) staining. Comparison of the sections of control and repaired nerves was done by computer-assisted microscopic image analysis using an Olympus CUE-2 Image Analysis System.

Chemical Classification and Particle Sizing of Foundry Sands

1985 ◽  
Vol 43 ◽  
pp. 388-389
Author(s):  
D.S. DeMiglio
Keyword(s):  
Image Analysis ◽  
Energy Dispersive Spectrometer ◽  
Image Analysis System ◽  
Representative Sampling ◽  
Foundry Sands ◽  
Large Atomic Number ◽  
Backscattered Electron ◽  
Sand Particles ◽  
Analysis System ◽  
Reclamation System

Much progress has been made in recent years towards the development of closed-loop foundry sand reclamation systems. However, virtually all work to date has determined the effectiveness of these systems to remove surface clay and metal oxide scales by a qualitative inspection of a representative sampling of sand particles. In this investigation, particles from a series of foundry sands were sized and chemically classified by a Lemont image analysis system (which was interfaced with an SEM and an X-ray energy dispersive spectrometer) in order to statistically document the effectiveness of a reclamation system developed by The Pangborn Company - a subsidiary of SOHIO.The following samples were submitted: unreclaimed sand; calcined sand; calcined & mechanically scrubbed sand and unused sand. Prior to analysis, each sample was sprinkled onto a carbon mount and coated with an evaporated film of carbon. A backscattered electron photomicrograph of a field of scale-covered particles is shown in Figure 1. Due to a large atomic number difference between sand particles and the carbon mount, the backscattered electron signal was used for image analysis since it had a uniform contrast over the shape of each particle.

Algorithms for automated montage synthesis of images from laser-scanning confocal microscopes

1995 ◽  
Vol 53 ◽  
pp. 650-651
Author(s):  
D. E. Becker
Keyword(s):  
Image Analysis ◽  
High Resolution ◽  
Laser Scanning ◽  
Cell Counting ◽  
Wide Area ◽  
Data Set ◽  
Computational Synthesis ◽  
Automated Cell Counting ◽  
Partial View ◽  
The Individual

An efficient, robust, and widely-applicable technique is presented for computational synthesis of high-resolution, wide-area images of a specimen from a series of overlapping partial views. This technique can also be used to combine the results of various forms of image analysis, such as segmentation, automated cell counting, deblurring, and neuron tracing, to generate representations that are equivalent to processing the large wide-area image, rather than the individual partial views. This can be a first step towards quantitation of the higher-level tissue architecture. The computational approach overcomes mechanical limitations, such as hysterisis and backlash, of microscope stages. It also automates a procedure that is currently done manually. One application is the high-resolution visualization and/or quantitation of large batches of specimens that are much wider than the field of view of the microscope.The automated montage synthesis begins by computing a concise set of landmark points for each partial view. The type of landmarks used can vary greatly depending on the images of interest. In many cases, image analysis performed on each data set can provide useful landmarks. Even when no such “natural” landmarks are available, image processing can often provide useful landmarks.

Sign in / Sign up

Export Citation Format

Share Document