Spectral Characteristics of Daily to Seasonal Ground Motion at the Piñon Flats Observatory from Coherence of Seismic Data

2019 ◽  
Vol 109 (5) ◽  
pp. 1948-1967 ◽  
Author(s):  
Lei Qin ◽  
Frank L. Vernon ◽  
Christopher W. Johnson ◽  
Yehuda Ben‐Zion

Abstract We investigate coherences of seismic data recorded during three years (2015–2017) at the Piñon Flats Observatory (PY) array and a collocated 148 m deep borehole station B084, along with oceanic data from a buoy southwest of the PY array. Seismic and barometric recordings at PY stations are analyzed with a multitaper spectral technique. The coherence of signals from seismic sources is >0.6 at 0.05–8 Hz between closely spaced (<65  m) surface stations and decreases to ∼0.2 in frequency bands in which the wavelengths are smaller than interstation distances. There are several local coherence increases at 1–8 Hz between nearby (<65  m) surface stations, whereas large coherence values between a surface and 148 m deep borehole stations are only present at the secondary microseism (∼0.14  Hz). These points to significant modification of seismic recordings in the top crust, and those continual near‐surface failures might produce shallow rapidly attenuating signals at surface stations. Incoherent local atmospheric effects induce incoherent seismic signals in low‐ and high‐frequency ranges through different coupling mechanisms. Between 0.003 and 0.05 Hz, atmospheric loadings generate ground tilts that contaminate the two horizontal seismic recordings and decrease their coherence, whereas the vertical component is less affected. At 1–8 Hz, coupling of atmospheric pressure with surface structures transmits incoherent signals into the ground, degrading the seismic coherence in all three components. The two horizontal coherences show seasonal variations with extended coherent frequency bands in winter and spring, likely to be produced by seasonal variations in microseisms and local ground tilts. The coherences also contain high anomalies between 2 and 4 Hz resulting from anthropogenic activities. The results provide useful information on instrument characteristics and variations in the shallow crustal response to earthquakes, seasonal and ambient sources of seismic energy, along with atmospheric pressure–temperature changes and anthropogenic activities.

Author(s):  
J. M. Pasachoff ◽  
M. A. Peñaloza-Murillo ◽  
A. L. Carter ◽  
M. T. Roman

This article reports on the near-surface atmospheric response at the High Arctic site of Svalbard, latitude 78° N, as a result of abrupt changes in solar insolation during the 20 March 2015 equinox total solar eclipse and notifies the atmospheric science community of the availability of a rare dataset. Svalbard was central in the path of totality, and had completely clear skies. Measurements of shaded air temperature and atmospheric pressure show only weak, if any, responses to the reduced insolation. A minimum in the air temperature at 1.5 m above the ground occurred starting 2 min following the end of totality, though this drop was only slightly beyond the observed variability for the midday period. Eclipse-produced variations in surface pressure, if present, were less than 0.3 hPa. This article is part of the themed issue ‘Atmospheric effects of solar eclipses stimulated by the 2015 UK eclipse’.


2006 ◽  
Vol 6 (4) ◽  
pp. 6613-6626 ◽  
Author(s):  
E. A. Kasatkina ◽  
O. I. Shumilov ◽  
Y. A. Vinogradov ◽  
A. N. Vasilyev

Abstract. The time-dependent relationships between atmospheric parameters (electric field, positive and negative conductivity, variations of atmospheric pressure) and different meteorological phenomena (rain, fogs, snowstorms, thunderstorms) were investigated through spectral analysis. These parameters were measured with help of a high-latitude computer-aided complex installed at Apatity (66.5 N, 33.4 E). The complex consists of three spaced microbarographs for measurements of atmospheric pressure variations in the range of periods from 1 s to 40 min, an instrument measuring the vertical component of the electric field, and instrument used for measurements of air conductivity and surface ozone. A computer-aided data-gathering system makes it possible to obtain information in the frequency range between 1 and 0.0001 Hz. The time-dependent frequency analysis showed that the spectral characteristics of both electric field and atmospheric pressure variations changed synchronously during severe weather conditions.


1986 ◽  
Vol 47 (C8) ◽  
pp. C8-159-C8-162 ◽  
Author(s):  
K. I. PANDYA ◽  
K. YANG ◽  
R. W. HOFFMAN ◽  
W. E. O'GRADY ◽  
D. E. SAYERS

Geophysics ◽  
2006 ◽  
Vol 71 (5) ◽  
pp. U67-U76 ◽  
Author(s):  
Robert J. Ferguson

The possibility of improving regularization/datuming of seismic data is investigated by treating wavefield extrapolation as an inversion problem. Weighted, damped least squares is then used to produce the regularized/datumed wavefield. Regularization/datuming is extremely costly because of computing the Hessian, so an efficient approximation is introduced. Approximation is achieved by computing a limited number of diagonals in the operators involved. Real and synthetic data examples demonstrate the utility of this approach. For synthetic data, regularization/datuming is demonstrated for large extrapolation distances using a highly irregular recording array. Without approximation, regularization/datuming returns a regularized wavefield with reduced operator artifacts when compared to a nonregularizing method such as generalized phase shift plus interpolation (PSPI). Approximate regularization/datuming returns a regularized wavefield for approximately two orders of magnitude less in cost; but it is dip limited, though in a controllable way, compared to the full method. The Foothills structural data set, a freely available data set from the Rocky Mountains of Canada, demonstrates application to real data. The data have highly irregular sampling along the shot coordinate, and they suffer from significant near-surface effects. Approximate regularization/datuming returns common receiver data that are superior in appearance compared to conventional datuming.


2013 ◽  
Vol 32 (3) ◽  
pp. 308-314
Author(s):  
Phil Sirles ◽  
Jacob Sheehan ◽  
Nicole Pendrigh
Keyword(s):  

2013 ◽  
Vol 664 ◽  
pp. 94-98
Author(s):  
Guang De Zhang

Following deepened exploration and development in Shengli exploration area, seismic data requirements are also getting higher and higher. However, in recent years the difference of Xiaoqing river on both sides have made us know that the importance of this problem. In view of the above, this task is aimed at quaternary shallow of old river course within Xiaoqing River. Our analysis of lithology and sedimentary characteristics are using static cone penetration test and rock core exploration method, and we want to reappear near surface deposition of old river course within Xiaoqing River. The research is close combined with the exploration demand and theoretical study, so it has important theoretical and practical significance.


Geophysics ◽  
1988 ◽  
Vol 53 (7) ◽  
pp. 894-902 ◽  
Author(s):  
Ruhi Saatçilar ◽  
Nezihi Canitez

Amplitude‐ and frequency‐modulated wave motion constitute the ground‐roll noise in seismic reflection prospecting. Hence, it is possible to eliminate ground roll by applying one‐dimensional, linear frequency‐modulated matched filters. These filters effectively attenuate the ground‐roll energy without damaging the signal wavelet inside or outside the ground roll’s frequency interval. When the frequency bands of seismic reflections and ground roll overlap, the new filters eliminate the ground roll more effectively than conventional frequency and multichannel filters without affecting the vertical resolution of the seismic data.


1996 ◽  
Vol 86 (1A) ◽  
pp. 221-231 ◽  
Author(s):  
Gregory S. Wagner ◽  
Thomas J. Owens

Abstract We outline a simple signal detection approach for multi-channel seismic data. Our approach is based on the premise that the wave-field spatial coherence increases when a signal is present. A measure of spatial coherence is provided by the largest eigenvalue of the multi-channel data's sample covariance matrix. The primary advantages of this approach are its speed and simplicity. For three-component data, this approach provides a more robust statistic than particle motion polarization. For array data, this approach provides beamforming-like signal detection results without the need to form beams. This approach allows several options for the use of three-component array data. Detection statistics for three-component, vertical-component array, and three different three-component array approaches are compared to conventional and minimum-variance vertical-component beamforming. Problems inherent in principal-component analysis (PCA) in general and PCA of high-frequency seismic data in particular are also discussed. Multi-channel beamforming and the differences between principal component and factor analysis are discussed in the appendix.


Sign in / Sign up

Export Citation Format

Share Document