scholarly journals Effect of Magnetic Water Treatment on Prevention of CaCO3 Scales

2013 ◽  
Vol 10 (1) ◽  
pp. 73-84
Author(s):  
Baghdad Science Journal
Keyword(s):  
Magnetic Field ◽  
Calcium Carbonate ◽  
Water Flow ◽  
Permanent Magnets ◽  
Thick Layer ◽  
Total Dissolved Solids ◽  
Magnetic Treatment ◽  
Magnetic Strength ◽  
Device Free ◽  
The Magnetic Field

Permanent magnets of different intensities were used to investigate the effect of a magnetic field in the process of preventing deposits of calcium carbonate. The magnets were fixed on the water line from the tap outside. Then heating a sample of this water in flasks and measuring the amount of sediment in a manner weighted differences. These experiments comprise to the change of the velocity of water flow, which amounted to (0.5, 0.75, 1) m/sec through the magnetic fields that are of magnetic strength (2200, 6000, 9250, 11000) Gauss, and conduct measurements, tests and compare them with those obtained from the use of ordinary water.The results showed the effectiveness of magnetic treatment in reducing the rate of deposition of calcium carbonate where up to 60% after treatment, and this percentage is increasing with increasing magnetic field strength where up to 85% when the intensity of the magnetic field 9250 and 11000 Gauss at the velocity of the water flow of 0.75 m/sec. This percentage of reducing was investigated with increasing the velocity of flow of water through a magnetic field. Also the results showed an increase in total dissolved solids (TDS) as well as electrical conductivity and a decrease in the value of surface tension as a result of magnetic treatment.Observation with the photograph pictures of the distillation apparatus oriented in several laboratories, that the amount of sediment formed a thick layer in the device-free magnetic treatment, but it was not dense and in the few quantity in the apparatus treated with magnetic intensity (8000, 9250) Gauss.

scholarly journals The effect of magnetic treatment on the effectiveness of inhibition in oilfields

2019 ◽  
Vol 121 ◽  
pp. 02006 ◽  
Author(s):  
I.A. Golubev ◽  
A.B. Laptev ◽  
E.L Alekseeva ◽  
N.O. Shaposhnikov ◽  
A.M. Povyshev ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Adsorption Capacity ◽  
Permanent Magnets ◽  
Magnetic Treatment ◽  
Chemical Reagents ◽  
The Magnetic Field

The article considers the possibility of increasing the efficiency of chemical reagents by treating inhibited solutions with a magnetic field. It is shown that a various method for generating the magnetic field has a different effect (Some positive some negative). The best results can be achieved with anti-scale magnetic treatment using permanent magnets. Modified inhibitors (after magnetic treatment) have enhanced protective effectby their adsorption capacity with respect to metal increases.

scholarly journals Effect of Magnetic Treatment on Temporary Hardness of Groundwater

2019 ◽  
Vol 31 (5) ◽  
pp. 1017-1021
Author(s):  
Abdulaziz Ali Alomari
Keyword(s):  
Magnetic Field ◽  
Surface Tension ◽  
Flow Rate ◽  
Research Effort ◽  
Magnetic Treatment ◽  
Before And After ◽  
Magnetic Strength ◽  
Xrd Patterns ◽  
The Magnetic Field ◽  
Shape And Size

The magnetic treatment devices for water have been in use for scale prevention several decades ago. Although, the effect of magnetic treatment on the chemical and physical properties of water is not fully understood and needs to make a lot of research effort to be clarified. This work aims to investigate the effect of the magnetic treatment on the temporary hardness of the groundwater. A sample of groundwater was passed twice under the influence of perpendicular magnetic strength 0.5 Tesla with a flow rate of 10 L/h. The temporary and permanent hardness as well as scale formation test were measured before and after the magnetic treatment. The scale was analyzed by XRD and SEM techniques. The temporary hardness and the weight of scales were reduced after the magnetic treatment by 39.1 and 22.3 %, respectively. The decrease of temporary hardness after the magnetic treatment of groundwater may be attributed to that the magnetic field reduces both the dissolved CO2 content and surface tension, both of which reduce the amount of temporary hardness. The SEM micrographs illustrate that the magnetic treatment modified the shape and size of crystals of CaCO3 scales to prevent its adhesion to the substrate forming hard scales. The XRD patterns prove that the magnetic treatment of groundwater enhances the crystallization of amorphous CaCO3 favouring the formation of calcite.

scholarly journals Design of a New 1D Halbach Magnet Array with Good Sinusoidal Magnetic Field by Analyzing the Curved Surface

Sensors ◽  
2021 ◽  
Vol 21 (7) ◽  
pp. 2522
Author(s):  
Guangdou Liu ◽  
Shiqin Hou ◽  
Xingping Xu ◽  
Wensheng Xiao
Keyword(s):  
Magnetic Field ◽  
Magnetic Flux ◽  
Permanent Magnet ◽  
Flux Density ◽  
Permanent Magnets ◽  
Air Gap ◽  
Curved Surface ◽  
Magnetic Flux Density ◽  
Sinusoidal Magnetic Field ◽  
The Magnetic Field

In the linear and planar motors, the 1D Halbach magnet array is extensively used. The sinusoidal property of the magnetic field deteriorates by analyzing the magnetic field at a small air gap. Therefore, a new 1D Halbach magnet array is proposed, in which the permanent magnet with a curved surface is applied. Based on the superposition of principle and Fourier series, the magnetic flux density distribution is derived. The optimized curved surface is obtained and fitted by a polynomial. The sinusoidal magnetic field is verified by comparing it with the magnetic flux density of the finite element model. Through the analysis of different dimensions of the permanent magnet array, the optimization result has good applicability. The force ripple can be significantly reduced by the new magnet array. The effect on the mass and air gap is investigated compared with a conventional magnet array with rectangular permanent magnets. In conclusion, the new magnet array design has the scalability to be extended to various sizes of motor and is especially suitable for small air gap applications.

scholarly journals A Feasibility Study of a Noncontact Torque Sensor with Multiple Hall Sensors

2015 ◽  
Vol 2015 ◽  
pp. 1-6 ◽  
Author(s):  
Kyungshik Lee ◽  
Chongdu Cho
Keyword(s):  
Magnetic Field ◽  
Permanent Magnets ◽  
Power Transmission ◽  
Magnetic Sensors ◽  
Torque Sensor ◽  
Torque Measurement ◽  
Test Range ◽  
Variable Power ◽  
Hall Sensors ◽  
The Magnetic Field

The feasibility of a noncontact sensor is investigated. This type of sensor can potentially be used for torque measurement in a speed-variable power transmission system. Torque can be read by examining the phase difference between two induction signals from respective magnetic sensors that detect the magnetic field intensity of permanent magnets mounted on the surface of a shaft in rotation. A real-time measuring algorithm that includes filtering and calibration is adopted to measure the torque magnitude. It is shown that this new torque sensor can perform well under rotation speeds ranging from 300 rpm to 500 rpm. As an interim report rather than a complete development, this work demonstrates the feasibility of noncontact torque measurement by monitoring a magnetic field. The result shows an error of less than 2% within the full test range, which is a sufficient competitive performance for commercial sensors. The price is very low compared to competitors in the marketplace, and the device does not require special handling of the shaft of the surface.

scholarly journals Magnetic Recording Method (MRM) for Nondestructive Evaluation of Ferromagnetic Materials

Materials ◽  
2022 ◽  
Vol 15 (2) ◽  
pp. 630
Author(s):  
Tomasz Chady ◽  
Ryszard D. Łukaszuk ◽  
Krzysztof Gorący ◽  
Marek J. Żwir
Keyword(s):  
Magnetic Field ◽  
Magnetic Recording ◽  
Permanent Magnets ◽  
Steel Structure ◽  
Standard Technique ◽  
Magnetic Field Measurement ◽  
Destructive Testing ◽  
Recording Method ◽  
Nondestructive Testing Method ◽  
The Magnetic Field

This paper proposes and experimentally investigates a novel nondestructive testing method for ferromagnetic elements monitoring, the Magnetic Recording Method (MRM). In this method, the inspected element must be magnetized in a strictly defined manner before operation. This can be achieved using an array of permanent magnets arranged to produce a quasi-sinusoidal magnetization path. The magnetic field caused by the original residual magnetization of the element is measured and stored for future reference. After the operation or loading, the magnetic field measurement is repeated. Analysis of relative changes in the magnetic field (for selected components) allows identifying applied stress. The proposed research methodology aims to provide information on the steel structure condition unambiguously and accurately. An interpretation of the results without referring to the original magnetization is also possible but could be less accurate. The method can be used as a standard technique for NDT (Non-Destructive Testing) or in structural health monitoring (SHM) systems.

The magnetic field about a three-dimensional block neodymium magnet

2021 ◽  
Vol 62 ◽  
pp. 386-405
Author(s):  
Graham John Weir ◽  
George Chisholm ◽  
Jerome Leveneur
Keyword(s):  
Magnetic Field ◽  
Permanent Magnets ◽  
Hard Disk Drives ◽  
Three Dimensional ◽  
Transverse Magnetic ◽  
Observation Point ◽  
Magnetization Direction ◽  
Potential Approach ◽  
Neodymium Magnet ◽  
The Magnetic Field

Neodymium magnets were independently discovered in 1984 by General Motors and Sumitomo. Today, they are the strongest type of permanent magnets commercially available. They are the most widely used industrial magnets with many applications, including in hard disk drives, cordless tools and magnetic fasteners. We use a vector potential approach, rather than the more usual magnetic potential approach, to derive the three-dimensional (3D) magnetic field for a neodymium magnet, assuming an idealized block geometry and uniform magnetization. For each field or observation point, the 3D solution involves 24 nondimensional quantities, arising from the eight vertex positions of the magnet and the three components of the magnetic field. The only unknown in the model is the value of magnetization, with all other model quantities defined in terms of field position and magnet location. The longitudinal magnetic field component in the direction of magnetization is bounded everywhere, but discontinuous across the magnet faces parallel to the magnetization direction. The transverse magnetic fields are logarithmically unbounded on approaching a vertex of the magnet.   doi:10.1017/S1446181120000097

Sign in / Sign up

Export Citation Format

Share Document