scholarly journals A Theoretical Model of Thermal Bar Movement in a Circular Lake

1993 ◽  
Vol 24 (1) ◽  
pp. 13-30 ◽  
Author(s):  
S. S. Zilitinkevich ◽  
J. G. B. Malm

The present paper concentrates on the movement of the spring thermal bar with time, and a simple theoretical model is derived for the case of an axisymmetric circular lake. The lake is considered to consist of three different zones: 1) a nearshore stably stratified warm water zone, 2) the thermal bar zone of descending water with temperature approximately equal to that of maximum density, and 3) an offshore cold unstably stratified zone. The basis for the model is the heat budget equation, where horizontal dynamical heat exchange in the vicinity of the bar zone is taken into account. In comparison with a previous model (Zilitinkevich et al. 1991), describing an infinite wedge of water, the present model is more general and takes into account the effect of shore-line curvature. This effect is characterized by a non-dimensional number and causes a marked increase in the displacement rate of the bar at the final stage of its existence. Model predictions are also compared with field data taken from the literature.

1992 ◽  
Vol 236 ◽  
pp. 27-42 ◽  
Author(s):  
S. S. Zilitinkevich ◽  
K. D. Kreiman ◽  
A. Yu. Terzhevik

A simple theoretical model of the thermal bar is derived on the basis of heat budget equations for the following three zones of a wedge-shaped water basin warmed from above: (i) stably stratified shallow warm-water zone; (ii) vicinity of the bar; (iii) convectively mixed deep cold zone. In contrast to the traditional approach, advective warming of the vicinity of the bar and associated facilitating of the thermal bar propagation are taken into account. Theoretical predictions are compared with the data of lacustrine and laboratory measurements taken from current literature. New laboratory experiments have been carried out to examine the laminar regime of the thermal bar.


2015 ◽  
Vol 29 (27) ◽  
pp. 1550161 ◽  
Author(s):  
Kuldeep Kholiya ◽  
Jeewan Chandra

On the basis of the thermal equation-of-state a simple theoretical model is developed to study the pressure dependence of melting temperature. The model is then applied to compute the high pressure melting curve of 10 metals (Cu, Mg, Pb, Al, In, Cd, Zn, Au, Ag and Mn). It is found that the melting temperature is not linear with pressure and the slope [Formula: see text] of the melting curve decreases continuously with the increase in pressure. The results obtained with the present model are also compared with the previous theoretical and experimental data. A good agreement between theoretical and experimental result supports the validity of the present model.


1990 ◽  
Vol 112 (1) ◽  
pp. 5-9 ◽  
Author(s):  
Won Soon Chang

A simple theoretical model based on combined series and parallel conduction for the effective thermal conductivity of fluid-saturated screens has been developed. The present model has been compared with the existing correlations and experimental data available in literature, and it has been found that the model is effective in predicting thermal conductivity. The study also demonstrates that it is important to include the actual thickness of the wire screen in order to calculate the porosity accurately.


2014 ◽  
Vol 2014 ◽  
pp. 1-5 ◽  
Author(s):  
Kuldeep Kholiya ◽  
Jeewan Chandra ◽  
Swati Verma

A simple theoretical model is developed to study the high pressure behavior of solids and is applied to evaluate the pressure for MgO in case of large compression along with Shanker, Tait, Vinet, and Birch-Murnaghan equation of states (EOSs). These EOSs are also tested for the basic requirements revealed from the fundamental thermodynamics for solids in the limit of extreme compressions, as given by Stacey. It is found that for the high pressure compression behavior of MgO the present model, Tait, Vinet, and Birch-Murnaghan EOSs give the results compatible with the experimental data. It has also been found that in the regime of ultrahigh pressure the present model and Birch-Murnaghan EOS satisfy the Stacey criterion.


2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Riccardo Camboni ◽  
Paola Valbonesi

AbstractWe empirically investigate incumbents’ and entrants’ bids on an original dataset of 192 scoring rule auctions for canteen services in Italy. Our findings show that winning rebates are lower (i.e., prices paid by the public buyer are higher) when the contract is awarded to the incumbent supplier. This result is not explained by the observable characteristics of the auction or the service awarded. We develop a simple theoretical model showing that the result is consistent with a setting in which the buyer exploits specific information on the incumbent supplier’s production cost.


Entropy ◽  
2021 ◽  
Vol 23 (8) ◽  
pp. 1007
Author(s):  
Michał Ramsza

The present paper reports simulation results for a simple model of reference group influence on market choices, e.g., brand selection. The model was simulated on three types of random graphs, Erdos–Renyi, Barabasi–Albert, and Watts–Strogatz. The estimates of equilibria based on the simulation results were compared to the equilibria of the theoretical model. It was verified that the simulations exhibited the same qualitative behavior as the theoretical model, and for graphs with high connectivity and low clustering, the quantitative predictions offered a viable approximation. These results allowed extending the results from the simple theoretical model to networks. Thus, by increasing the positive response towards the reference group, the third party may create a bistable situation with two equilibria at which respective brands dominate the market. This task is easier for large reference groups.


1990 ◽  
Vol 47 (1) ◽  
pp. 41-48 ◽  
Author(s):  
Molly O. Ahlgren

The ash-free dry mass (AFDM) of detritus, invertebrates, and algae in the diet of juvenile white sucker (Catostomus commersoni) was determined by quantitative microscopy. Fish were collected from a northern Michigan pond from January through October 1986 and their seasonal diet was compared with benthc invertebrate abundance. The quantity of detritus in sucker foreguts was inversely related to benthic microcrustacean densities. In July, microcrustacean densities were high and they comprised 95% of the AFDM in foregut contents. By October, microcrustacean densities had declined to 13% of their maximum density and detritus comprised over 90% of the sucker's diet AFDM. In laboratory aquaria, sucker that were fed detritus mixed with four different densities of Artemia ingested significantly more detritus from diets that provided lower Artemia densities. In the presence of high Artemia densities, sucker completely rejected detritus and ingested only Artemia, The fact that juvenile sucker can separate detritus from invertebrates that they swallow demonstrates that detritus is not ingested incidentally. Both laboratory and field data support the hypothesis that detritus is ingested intentionally when preferred invertebrate prey are scarce.


2013 ◽  
Vol 10 (8) ◽  
pp. 13097-13128 ◽  
Author(s):  
F. Hartig ◽  
C. Dislich ◽  
T. Wiegand ◽  
A. Huth

Abstract. Inverse parameter estimation of process-based models is a long-standing problem in ecology and evolution. A key problem of inverse parameter estimation is to define a metric that quantifies how well model predictions fit to the data. Such a metric can be expressed by general cost or objective functions, but statistical inversion approaches are based on a particular metric, the probability of observing the data given the model, known as the likelihood. Deriving likelihoods for dynamic models requires making assumptions about the probability for observations to deviate from mean model predictions. For technical reasons, these assumptions are usually derived without explicit consideration of the processes in the simulation. Only in recent years have new methods become available that allow generating likelihoods directly from stochastic simulations. Previous applications of these approximate Bayesian methods have concentrated on relatively simple models. Here, we report on the application of a simulation-based likelihood approximation for FORMIND, a parameter-rich individual-based model of tropical forest dynamics. We show that approximate Bayesian inference, based on a parametric likelihood approximation placed in a conventional MCMC, performs well in retrieving known parameter values from virtual field data generated by the forest model. We analyze the results of the parameter estimation, examine the sensitivity towards the choice and aggregation of model outputs and observed data (summary statistics), and show results from using this method to fit the FORMIND model to field data from an Ecuadorian tropical forest. Finally, we discuss differences of this approach to Approximate Bayesian Computing (ABC), another commonly used method to generate simulation-based likelihood approximations. Our results demonstrate that simulation-based inference, which offers considerable conceptual advantages over more traditional methods for inverse parameter estimation, can successfully be applied to process-based models of high complexity. The methodology is particularly suited to heterogeneous and complex data structures and can easily be adjusted to other model types, including most stochastic population and individual-based models. Our study therefore provides a blueprint for a fairly general approach to parameter estimation of stochastic process-based models in ecology and evolution.


Sign in / Sign up

Export Citation Format

Share Document