scholarly journals Improvement of aqueous solution coexisting with arsenite and arsenate using iron mixed porous clay pellets in batch and fixed-bed column studies

2019 ◽  
Vol 19 (7) ◽  
pp. 1929-1937 ◽  
Author(s):  
Nguyen Chi Thanh ◽  
Boonchai Wichitsathian ◽  
Chatpet Yossapol ◽  
Watcharapol Wonglertarak ◽  
Borano Te
Keyword(s):  
Experimental Data ◽  
Aqueous Solution ◽  
Removal Rate ◽  
Fixed Bed ◽  
Polluted Water ◽  
Column Studies ◽  
Fixed Bed Column ◽  
Phosphate Ions ◽  
Pseudo Second Order ◽  
Clay Pellets

Abstract Arsenic-polluted water is a global concern and puts millions of people at risk of developing cancer. The improvement of aqueous solution coexisting with arsenite and arsenate using iron mixed porous clay pellets was investigated in batch and fixed-bed column systems. Batch studies showed that the removal rate occurred in two main phases with an equilibrium time of 52 h. The pseudo-second-order model well described the experimental data. Isotherm data were well fitted by the Langmuir–Freundlich model. The removal efficiency was significantly reduced in alkaline solution and the presence of phosphate ions. The column study revealed that the breakthrough time and saturation time increased with lower feeding flow rate, higher bed height, and lower initial adsorbate concentration. The Thomas model provided good performance for predicting the column experimental data.

Biochar caged zirconium ferrite nanocomposites for the adsorptive removal of Reactive Blue 19 dye in a batch and column reactors and conditions optimizaton

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Shazia Perveen ◽  
Raziya Nadeem ◽  
Shaukat Ali ◽  
Yasir Jamil
Keyword(s):  
Experimental Data ◽  
Low Dose ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Adsorption Efficiency ◽  
Fixed Bed Column ◽  
Flow Rates ◽  
Adsorptive Removal ◽  
Reactive Blue 19 ◽  
Pseudo Second Order

Abstract Biochar caged zirconium ferrite (BC-ZrFe2O5) nanocomposites were fabricated and their adsorption capacity for Reactive Blue 19 (RB19) dye was evaluated in a fixed-bed column and batch sorption mode. The adsorption of dye onto BC-ZrFe2O5 NCs followed pseudo-second-order kinetics (R 2 = 0.998) and among isotherms, the experimental data was best fitted to Sips model as compared to Freundlich and Langmuir isotherms models. The influence of flow-rate (3–5 mL min−1), inlet RB19 dye concentration (20–100 mg L−1) and quantity of BC-ZrFe2O5 NCs (0.5–1.5 g) on fixed-bed sorption was elucidated by Box-Behnken experimental design. The saturation times (C t /C o  = 0.95) and breakthrough (C t /C o  = 0.05) were higher at lower flow-rates and higher dose of BC-ZrFe2O5 NCs. The saturation times decreased, but breakthrough was increased with the initial RB19 dye concentration. The treated volume was higher at low sorbent dose and influent concentration. Fractional bed utilization (FBU) increased with RB19 dye concentration and flow rates at low dose of BC-ZrFe2O5 NCs. Yan model was fitted best to breakthrough curves data as compared to Bohart-Adams and Thomas models. Results revealed that BC-ZrFe2O5 nanocomposite has promising adsorption efficiency and could be used for the adsorption of dyes from textile effluents.

Continuous biosorption of nickel from aqueous solution using Chrysanthemum indicum derived biochar in a fixed-bed column

2017 ◽  
Vol 76 (7) ◽  
pp. 1895-1906 ◽  
Author(s):  
Sowmya Vilvanathan ◽  
S. Shanthakumar
Keyword(s):  
Aqueous Solution ◽  
Metal Ion ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Ion Concentration ◽  
Column Studies ◽  
Nickel Ion ◽  
Fixed Bed Column ◽  
Nickel Ions ◽  
Chrysanthemum Indicum

The biosorption capability of Chrysanthemum indicum to remove nickel ions from aqueous solution in a fixed-bed column was examined in this study. Native C. indicum flower waste was improved for its biosorptive potential by pyrolysis to obtain its biochar form and, thereby, both raw (CIF-R) and biochar (CIF-BC) forms of the flower were used for Ni(II) removal. Fixed bed column studies were conducted to examine the influence of bed height (1.0–3.0 cm), flow rate (1.0–5.0 mL min−1) and initial metal ion concentration (25–75 mg L−1). The breakthrough curves (Cout/Cin vs time) were modelled using different dynamic adsorption models, viz. Adams-Bohart, Thomas and Yoon-Nelson model. Interpretation of the data revealed a favorable correlation with the Thomas model with higher R2 values and closer model-predicted and experimental biosorption capacity values. The equilibrium uptake capacity of CIF-R and CIF-BC for Ni(II) were found to be 14.02 and 29.44 mg g−1, respectively. Further, the column was regenerated using HCl as eluent, to desorb the adsorbed Ni(II) ions. The experimental results implied and affirmed the suitability of the biosorbents for nickel ion biosorption with its nature being favorable, efficient, and environmentally friendly.

scholarly journals Adsorption of cationic dye onto fly ash-based geopolymer: Batch and fixed bed column studies

2018 ◽  
Vol 149 ◽  
pp. 02088 ◽  
Author(s):  
Marouane El Alouani ◽  
Saliha Alehyen ◽  
Mohammed El Achouri ◽  
M’hamed Taibi
Keyword(s):  
Fly Ash ◽  
Kinetic Models ◽  
Adsorption Process ◽  
Fixed Bed ◽  
Dye Adsorption ◽  
Second Order ◽  
Cationic Dye ◽  
Column Studies ◽  
Fixed Bed Column ◽  
Pseudo Second Order

Cationic dye adsorption from aqueous solution onto synthesized geopolymer was investigated by batch and fixed bed column experiments. The geopolymer material was elaborated by alkali solution and fly ash supplied by Jorf Lasfar power plant of Morocco. Physical and chemical characteristics of samples were determined by FX, DRX, SEM, 29Si MAS NMR and Zeta potential methods. The Brunauer, Emmett and Teller (BET) technique is used to determine the surface area. The Barrett-Joyner-Halenda (BJH) method was performed to obtain pore size distribution curves and average pore diameter. Kinetics data were analyzed using pseudo-first-order, pseudo-second-order and intraparticle diffusion models. To predict the breakthrough curves and determine the main fixed bed column parameters, three kinetic models; Tomas, Bohart–Adams and Yoon-Nelson models are applied to fitting the experimental data. The kinetic study showed that the pseudo-second-order can be used to describe the methylene blue (MB) adsorption process on the geopolymer matrix. The kinetic models of the adsorption in dynamic column are suitable to describe the continuous adsorption process of dyestuff by the geopolymer. The results of this study indicated that geopolymer derived from fly ash can be used as a low cost effective adsorbent for cationic dye removal from industrial aqueous effluent.

Sign in / Sign up

Export Citation Format

Share Document