scholarly journals A system of two infinite beams separated by an elastic core under moving load

2018 ◽  
Vol 19 (12) ◽  
pp. 285-288
Author(s):  
Magdalena Ataman ◽  
Wacław Szcześniak
Keyword(s):  
Differential Equations ◽  
Moving Load ◽  
Fourier Integral ◽  
Winkler Foundation ◽  
Eighth Order ◽  
Concentrated Force ◽  
Moving Force ◽  
Elastic Core ◽  
Lower Beam ◽  
Extensive List

The paper discussed the analytical solution of a dynamic problem of a system of two infinite beams separated by an elastic core. The beams’ system rests on the Winkler foundation and is loaded with a moving concentrated force. Because the problem is stationary for an observer moving with the load, partial differential equations, describing the vibrations of the system, were transformed into ordinary differential equations in the coordinate system related to the moving force. The system of equations was transformed to one differential equation of an eighth order. The equation defines deflection of the lower beam. The solution of the problem was resulted to the simple infinite Fourier integral. An extensive list of publications on the related literature is presented in the paper [1-45].

A Steadily Moving Load on an Elastic Beam Resting on a Tensionless Winkler Foundation

1979 ◽  
Vol 46 (1) ◽  
pp. 175-180 ◽  
Author(s):  
J. Choros ◽  
G. G. Adams
Keyword(s):  
Moving Load ◽  
Elastic Beam ◽  
Energy Criterion ◽  
Winkler Foundation ◽  
Coordinate Systems ◽  
Bernoulli Beam ◽  
Concentrated Force ◽  
Closed Form Solutions ◽  
Euler Bernoulli Beam ◽  
Steady State Solutions

An infinitely long Euler-Bernoulli beam resting on a tensionless Winkler foundation is considered. Steady-state solutions are obtained for a downward directed concentrated force moving with constant speed. First, the critical load necessary to initiate separation of the beam from the foundation is determined for a range of speed. For loads greater than critical, one or more regions of noncontact can be expected to occur. Closed-form solutions of the differential equations are obtained in terms of local coordinate systems which significantly reduces the coupling among the various regions. The extent and location of the noncontact regions, as well as the corresponding beam deflections, are then determined for a range of force and speed. The results show that many solutions are possible and the final determination is based on an energy criterion.

scholarly journals Amplification Factors in the Case of Beam Under Moving Force – Theoretical Analysis

2019 ◽  
Vol 65 (1) ◽  
pp. 83-96
Author(s):  
M. Ataman
Keyword(s):  
Moving Load ◽  
Resonance Phenomenon ◽  
Winkler Foundation ◽  
Bending Moments ◽  
Shear Forces ◽  
Engineering Structures ◽  
Amplification Factors ◽  
Moving Force ◽  
Dynamic Amplification ◽  
The Impact

AbstractThe impact of a moving load speed on the dynamic overload of beams, assuming that the track of the load has no unevenness, is examined. First the problem of a visco-elastic beam on a Winkler foundation subjected to a force moving at a constant speed will be solved. Using the Bubnov-Galerkin method, the deflections of the beam, and then the bending moments and shear forces will be determined. The solution of the problem will be obtained both for the case of a forced vibration and the case of a free vibration after the moving force has left the beam. Using these solutions, dynamic amplification factors will be determined for the deflections, bending moments, and shear forces, which are different for the two cases.The magnitude of the amplification factors increases and decreases alternately as a function of the speed. In the case of a single force on a beam, the dynamic overloads are limited, and do not exceed 60%. There is no resonance phenomenon in the beam subjected to the single moving force. The dynamic amplification factors determined in this way can be used as correction coefficients when designing engineering structures subjected to moving loads by static methods.

Asymptotic derivation of a refined equation for an elastic beam resting on a Winkler foundation

2021 ◽  
pp. 108128652110238
Author(s):  
Barış Erbaş ◽  
Julius Kaplunov ◽  
Isaac Elishakoff
Keyword(s):  
Ad Hoc ◽  
Moving Load ◽  
Low Frequency ◽  
Elastic Beam ◽  
Winkler Foundation ◽  
One Dimensional ◽  
Beam Equations ◽  
Dimensional Equation ◽  
Phase And Group Velocities ◽  
Group Velocities

A two-dimensional mixed problem for a thin elastic strip resting on a Winkler foundation is considered within the framework of plane stress setup. The relative stiffness of the foundation is supposed to be small to ensure low-frequency vibrations. Asymptotic analysis at a higher order results in a one-dimensional equation of bending motion refining numerous ad hoc developments starting from Timoshenko-type beam equations. Two-term expansions through the foundation stiffness are presented for phase and group velocities, as well as for the critical velocity of a moving load. In addition, the formula for the longitudinal displacements of the beam due to its transverse compression is derived.

Analytical evaluation of track response in the vertical direction due to a moving load

2016 ◽  
Vol 23 (18) ◽  
pp. 2989-3006 ◽  
Author(s):  
Wlodzimierz Czyczula ◽  
Piotr Koziol ◽  
Dariusz Kudla ◽  
Sergiusz Lisowski
Keyword(s):  
Steady State ◽  
Moving Load ◽  
Vertical Direction ◽  
Vertical Displacement ◽  
Steady State Response ◽  
Concentrated Force ◽  
State Response ◽  
Weakly Coupled ◽  
Wide Range ◽  
Rail Deflection

In the literature, typical analytical track response models are composed of beams (which represent the rail) on viscoelastic or elastic foundations. The load is usually considered as a single concentrated force (constant or varying in time) moving with constant speed. Concentrated or distributed loads or multilayer track models have rarely been considered. One can find some interesting results concerning analysis of distributed loads and multilayer track structures that include both analytical and numerical approaches. However, there is a noticeable lack of sufficient comparison between track responses under concentrated or distributed load and between one and multilayer track models. One of the unique features of the present paper is a comparison of data obtained for a series of concentrated and distributed loads, which takes into account a wide range of track parameters and train speeds. One of the fundamental questions associated with the multilayer track model is the level of coupling between the rail and the vibrations of the sleepers. In this paper, it is proved that sleepers are weakly coupled with the rail if the track is without significant imperfections, and the steady-state response is analyzed for this case. In other words, sleeper vibrations do not influence the rail vibrations significantly. Therefore the track is analyzed by means of a two-stage model. The first step of this model determines rail vibration under a moving load, and then the sleeper vibration is calculated from previously obtained kinematic excitation. The model is verified by comparison of the obtained results with experimental data. Techniques based on Fourier series are applied to the solution of the steady-state track response. Another important problem associated with track response under moving loads arises from the analysis of the effect of longitudinal forces in rails on vertical displacement. It is shown that, in the case of the steady-state response, longitudinal forces do not influence rail displacements significantly and this observation remains correct for a wide range of track parameters and train speeds. The paper also analyzes the legitimacy of the statement that additional rail deflection between sleepers, compared to the continuous rail support, can be considered as a track imperfection.

scholarly journals Bending of an Infinite beam on a base with two parameters in the absence of a part of the base

2018 ◽  
Vol 33 ◽  
pp. 02074
Author(s):  
Maxim Aleksandrovskiy ◽  
Lidiya Zaharova
Keyword(s):  
Rapid Development ◽  
Fourier Integral ◽  
Infinite Length ◽  
Degenerate Kernel ◽  
Shift Parameter ◽  
Approximate Methods ◽  
Concentrated Force ◽  
High Rise ◽  
Two Parameters

Currently, in connection with the rapid development of high-rise construction and the improvement of joint operation of high-rise structures and bases models, the questions connected with the use of various calculation methods become topical. The rigor of analytical methods is capable of more detailed and accurate characterization of the structures behavior, which will affect the reliability of objects and can lead to a reduction in their cost. In the article, a model with two parameters is used as a computational model of the base that can effectively take into account the distributive properties of the base by varying the coefficient reflecting the shift parameter. The paper constructs the effective analytical solution of the problem of a beam of infinite length interacting with a two-parameter voided base. Using the Fourier integral equations, the original differential equation is reduced to the Fredholm integral equation of the second kind with a degenerate kernel, and all the integrals are solved analytically and explicitly, which leads to an increase in the accuracy of the computations in comparison with the approximate methods. The paper consider the solution of the problem of a beam loaded with a concentrated force applied at the point of origin with a fixed value of the length of the dip section. The paper gives the analysis of the obtained results values for various parameters of coefficient taking into account cohesion of the ground.

scholarly journals FORCED RESPONSE VIBRATION OF SIMPLY SUPPORTED BEAMS WITH AN ELASTIC PASTERNAK FOUNDATION UNDER A DISTRIBUTED MOVING LOAD

2020 ◽  
Vol 4 (2) ◽  
pp. 1-7
Author(s):  
Fatai Hammed ◽  
M. A. Usman ◽  
S. A. Onitilo ◽  
F. A. Alade ◽  
K. A. Omoteso
Keyword(s):  
Shear Modulus ◽  
Moving Load ◽  
Equations Of Motion ◽  
Beam Theory ◽  
Initial Boundary ◽  
Initial Boundary Value Problem ◽  
Forced Response ◽  
Dynamic Responses ◽  
Moving Force ◽  
Pasternak Elastic Foundation

In this study, the response of two homogeneous parallel beams with two-parameter Pasternak elastic foundation subjected to a constant uniform partially distributed moving force is considered. On the basis of Euler-Bernoulli beam theory, the fourth order partial differential equations of motion describing the behavior of the beams when subjected to a moving force were formulated. In order to solve the resulting initial-boundary value problem, finite Fourier sine integral technique and differential transform scheme were employed to obtain the analytical solution. The dynamic responses of the two beams obtained was investigated under moving force conditions using MATLAB. The effects of speed of the moving force, layer parameters such as stiffness (K_0) and shear modulus (G_0 ) have been conducted for the moving force. Various values of speed of the moving load, stiffness parameters and shear modulus were considered. The results obtained indicates that response amplitudes of both the upper and lower beams increases with increase in the speed of the moving load. Increasing the stiffness parameter is observed to cause a decrease in the response amplitudes of the beams. The response amplitudes decreases with increase in the shear modulus of the linear elastic layer.

scholarly journals The Krylov problem in the case of a beam on Vlasov inertial foundation

2018 ◽  
Vol 19 (6) ◽  
pp. 728-736
Author(s):  
Wacław Szcześniak ◽  
Magdalena Ataman
Keyword(s):  
Closed Form ◽  
Compressive Force ◽  
Elastic Beam ◽  
Forced Vibrations ◽  
Critical Force ◽  
Winkler Foundation ◽  
Static Deflection ◽  
Numerical Examples ◽  
Moving Force ◽  
Axial Forces

The paper deals with vibrations of the elastic beam caused by the moving force traveling with uniform speed. The function defining the pure forced vibrations (aperiodic vibrations) is presented in a closed form. Dynamic deflection of the beam caused by moving force is compared with the static deflection of the beam subjected to the force , and compressed by axial forces . Comparing equations (9) and (13), it can be concluded that the effect on the deflection of the speed of the moving force is the same as that of an additional compressive force . Selected problems of stability of the beam on the Winkler foundation and on the Vlasov inertial foundation are discussed. One can see that the critical force of the beam on Vlasov foundation is greater than in the case of Winkler's foundation. Numerical examples are presented in the paper

Closed-Form Representation of Beam Response to Moving Line Loads

2000 ◽  
Vol 68 (2) ◽  
pp. 348-350 ◽  
Author(s):  
Lu Sun
Keyword(s):  
Closed Form ◽  
Moving Load ◽  
Closed Form Solution ◽  
Form Solution ◽  
Winkler Foundation ◽  
Line Load ◽  
State Response ◽  
Form Representation ◽  
Mach Numbers ◽  
Moving Line

Fourier transform is used to solve the problem of steady-state response of a beam on an elastic Winkler foundation subject to a moving constant line load. Theorem of residue is employed to evaluate the convolution in terms of Green’s function. A closed-form solution is presented with respect to distinct Mach numbers. It is found that the response of the beam goes to unbounded as the load travels with the critical velocity. The maximal displacement response appears exactly under the moving load and travels at the same speed with the moving load in the case of Mach numbers being less than unity.

Sign in / Sign up

Export Citation Format

Share Document