scholarly journals Dependance of isoprene emission flux on leaf mass per area of Phyllostachys pubescens (moso bamboo)

2022 ◽  
Vol 78 (1) ◽  
pp. 1-7
Author(s):  
Ting-Wei CHANG ◽  
Yoshiko KOSUGI ◽  
Tomonori KUME ◽  
Ayumi KATAYAMA ◽  
Motonori OKUMURA ◽  
...  
2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Min Liao ◽  
Xuexiang Ren ◽  
Quan Gao ◽  
Niuniu Liu ◽  
Feng Tang ◽  
...  

AbstractMoso bamboo (Phyllostachys pubescens, Gramineae) is a well-known medicinal and edible plant found in China with various bioactivities, but few systematic studies address the utilization of its anti-fungal activity. The extract of moso bamboo leaf showed good anti-fungal activity to Phytophthora capsici, Fusarium graminearum, Valsa mali Miyabe et Yamada, Botryosphaeria dothidea, Venturia nashicola, and Botrytis cinerea Pers, with inhibitory rate of 100.00%, 75.12%, 60.66%, 57.24%, 44.62%, and 30.16%, respectively. Anti-fungal activity was different by the difference of samples picking time and location. The extract showed good synergistic effects with carbendazim at the ratios of 9:1 and 15:1 (extract : carbendazim), and the co-toxicity coefficients were 124.4 and 139.95. Compound 2 was isolated and identified as the main active component, with the EC50 value of 11.02 mg L−1. Then, the extract was formulated as a 10% emulsion in water, which was stable and had no acute toxic effects. Moreover, a field trial about this formulation was assayed to control pepper phytophthora blight, with the control effect of 85.60%. These data provided a better understanding of the anti-fungal activity and relevant active component of moso bamboo leaf extract. Taken together, our findings illustrated that bamboo leaf extract could be developed and utilized as a botanical fungicide or fungicide adjuvant.


Polymers ◽  
2021 ◽  
Vol 13 (8) ◽  
pp. 1264
Author(s):  
Teng-Chun Yang ◽  
Tung-Lin Wu ◽  
Chin-Hao Yeh

The influence of heat treatment on the physico-mechanical properties, water resistance, and creep behavior of moso bamboo (Phyllostachys pubescens) was determined in this study. The results revealed that the density, moisture content, and flexural properties showed negative relationships with the heat treatment temperature, while an improvement in the dimensional stability (anti-swelling efficiency and anti-water absorption efficiency) of heat-treated samples was observed during water absorption tests. Additionally, the creep master curves of the untreated and heat-treated samples were successfully constructed using the stepped isostress method (SSM) at a series of elevated stresses. Furthermore, the SSM-predicted creep compliance curves fit well with the 90-day full-scale experimental data. When the heat treatment temperature increased to 180 °C, the degradation ratio of the creep resistance (rd) significantly increased over all periods. However, the rd of the tested bamboo decreased as the heat treatment temperature increased up to 220 °C.


2019 ◽  
Vol 27 (01) ◽  
pp. 1950090
Author(s):  
HAIXIA YU ◽  
XIN PAN ◽  
WEIMING YANG ◽  
WENFU ZHANG ◽  
XIAOWEI ZHUANG

Bamboo material is widely used in outdoor applications. However, they are easily degraded when exposed to sunlight, their smooth surface will gradually turn to rough, and small cracks will appear and finally develop to large cracks. The paper presents a first-time investigation on the microstructure changes in the tangential section of Moso bamboo (Phyllostachys pubescens Mazel) radiated by artificial UV light. The results showed that the cracks mainly appeared at intercellular spaces of fibers where lignin content was high, the parenchyma cell walls and neighbor pits where the cell wall was very thin and more vulnerable than the other parts. In addition, the part of raised area and pit cavity tended to absorb more UV light radiation and showed more and larger cracks than the otherwhere. Cracks at the intercellular spaces of fibers were larger and bigger than those on the parenchyma cell walls. The cracks on the pits of the parenchyma cell walls normally appeared at one pit and then extended to the several surrounding pits. Bordered pits cavity showed more and larger cracks than the pits on the thin wall cells. The simple pits on the thick wall cells and the fiber cells were unaffected by UV radiation.


Sign in / Sign up

Export Citation Format

Share Document