scholarly journals Synergetic approach to machining control of lathe group machines

2019 ◽  
Vol 2019 (11) ◽  
pp. 29-38
Author(s):  
Вилор Заковоротный ◽  
Vilor Zakovorotny ◽  
Валерия Гвинджилия ◽  
Valeriya Gvindzhiliya
Keyword(s):  
Optimization Problem ◽  
Pass Band ◽  
Frequency Structure ◽  
Machining Control ◽  
Synergetic Theory ◽  
Executive Elements

Regulations are generalized on the synergetic theory of control for the case when the paths of shaping motions have a frequency structure exceeding considerably a pass band of servomotors which control a motion of executive elements. There is shown a simulator of the system and a dual optimization problem is under solution which is based on minimization of costs shown for manufacturing parts and for their accuracy support.

Amplitude Distributions of Cochlear Microphonic Response to an Acoustic Sinusoid in Noise

1968 ◽  
Vol 11 (1) ◽  
pp. 63-76
Author(s):  
Donald C. Teas ◽  
Gretchen B. Henry
Keyword(s):  
Small Amplitude ◽  
Basilar Membrane ◽  
Spectral Composition ◽  
Pass Band ◽  
Cochlear Microphonic ◽  
Filter Output ◽  
Electronic Filter ◽  
Low Pass ◽  
Band Pass ◽  
Instantaneous Voltage

The distributions of instantaneous voltage amplitudes in the cochlear microphonic response recorded from a small segment along the basilar membrane are described by computing amplitude histograms. Comparisons are made between the distributions for noise and for those after the addition to the noise of successively stronger sinusoids. The amplitudes of the cochlear microphonic response to 5000 Hz low-pass noise are normally distributed in both Turn I and Turn III of the guinea pig’s cochlea. The spectral composition of the microphonic from Turn I and from Turn III resembles the output of band-pass filters set at about 4000 Hz, and about 500 Hz, respectively. The normal distribution of cochlear microphonic amplitudes for noise is systematically altered by increasing the strength of the added sinusoid. A decrease of three percent in the number of small amplitude events (±1 standard deviation) in the cochlear microphonic from Turn III is seen when the rms voltage of a 500 Hz sinusoid is at −18 dB re the rms voltage of the noise (at the earphone). When the rms of the sinusoid and noise are equal, the decrease in small voltages is about 25%, but there is also an increase in the number of large voltage amplitudes. Histograms were also computed for the output of an electronic filter with a pass-band similar to Turn III of the cochlea. Strong 500 Hz sinusoids showed a greater proportion of large amplitudes in the filter output than in CM III . The data are interpreted in terms of an anatomical substrate.

Exergy and sensibility analysis of each individual effect in a kraft multiple effect evaporator

TAPPI Journal ◽  
2019 ◽  
Vol 18 (10) ◽  
pp. 607-618
Author(s):  
JÉSSICA MOREIRA ◽  
BRUNO LACERDA DE OLIVEIRA CAMPOS ◽  
ESLY FERREIRA DA COSTA JUNIOR ◽  
ANDRÉA OLIVEIRA SOUZA DA COSTA
Keyword(s):  
Optimization Problem ◽  
Real Data ◽  
Kraft Pulping ◽  
Steam Temperature ◽  
Input Flow ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Multiple Effect ◽  
Sensibility Analysis ◽  
Exergetic Analysis

The multiple effect evaporator (MEE) is an energy intensive step in the kraft pulping process. The exergetic analysis can be useful for locating irreversibilities in the process and pointing out which equipment is less efficient, and it could also be the object of optimization studies. In the present work, each evaporator of a real kraft system has been individually described using mass balance and thermodynamics principles (the first and the second laws). Real data from a kraft MEE were collected from a Brazilian plant and were used for the estimation of heat transfer coefficients in a nonlinear optimization problem, as well as for the validation of the model. An exergetic analysis was made for each effect individually, which resulted in effects 1A and 1B being the least efficient, and therefore having the greatest potential for improvement. A sensibility analysis was also performed, showing that steam temperature and liquor input flow rate are sensible parameters.

Imaging through Scattering Media with a Learning Based Prior

2020 ◽  
Vol 2020 (14) ◽  
pp. 306-1-306-6
Author(s):  
Florian Schiffers ◽  
Lionel Fiske ◽  
Pablo Ruiz ◽  
Aggelos K. Katsaggelos ◽  
Oliver Cossairt
Keyword(s):  
Optimization Problem ◽  
Autonomous Driving ◽  
Scattering Media ◽  
Photon Scattering ◽  
Point Spread ◽  
Spread Function ◽  
Radiative Transport Equation ◽  
Spatio Temporal ◽  
Transient Imaging

Imaging through scattering media finds applications in diverse fields from biomedicine to autonomous driving. However, interpreting the resulting images is difficult due to blur caused by the scattering of photons within the medium. Transient information, captured with fast temporal sensors, can be used to significantly improve the quality of images acquired in scattering conditions. Photon scattering, within a highly scattering media, is well modeled by the diffusion approximation of the Radiative Transport Equation (RTE). Its solution is easily derived which can be interpreted as a Spatio-Temporal Point Spread Function (STPSF). In this paper, we first discuss the properties of the ST-PSF and subsequently use this knowledge to simulate transient imaging through highly scattering media. We then propose a framework to invert the forward model, which assumes Poisson noise, to recover a noise-free, unblurred image by solving an optimization problem.

Synergetic Theory of Document in Evolution of Document Science

2018 ◽  
pp. 1060-1068
Author(s):  
Galina A. Dvoenosova ◽  
Keyword(s):  
Social Role ◽  
Scientific Study ◽  
Self Organization ◽  
Universal Theory ◽  
Social Self ◽  
Social Goal ◽  
The Social ◽  
Synergetic Theory ◽  
First Time

The article assesses synergetic theory of document as a new development in document science. In information society the social role of document grows, as information involves all members of society in the process of documentation. The transformation of document under the influence of modern information technologies increases its interest to representatives of different sciences. Interdisciplinary nature of document as an object of research leads to an ambiguous interpretation of its nature and social role. The article expresses and contends the author's views on this issue. In her opinion, social role of document is incidental to its being a main social tool regulating the life of civilized society. Thus, the study aims to create a scientific theory of document, explaining its nature and social role as a tool of social (goal-oriented) action and social self-organization. Substantiation of this idea is based on application of synergetics (i.e., universal theory of self-organization) to scientific study of document. In the synergetic paradigm, social and historical development is seen as the change of phases of chaos and order, and document is considered a main tool that regulates social relations. Unlike other theories of document, synergetic theory studies document not as a carrier and means of information transfer, but as a unique social phenomenon and universal social tool. For the first time, the study of document steps out of traditional frameworks of office, archive, and library. The document is placed on the scales with society as a global social system with its functional subsystems of politics, economy, culture, and personality. For the first time, the methods of social sciences and modern sociological theories are applied to scientific study of document. This methodology provided a basis for theoretical vindication of nature and social role of document as a tool of social (goal-oriented) action and social self-organization. The study frames a synergetic theory of document with methodological foundations and basic concepts, synergetic model of document, laws of development and effectiveness of document in the social continuum. At the present stage of development of science, it can be considered the highest form of theoretical knowledge of document and its scientific explanatory theory.

Shape Optimization of Hydraulic Structures: an Example of an Optimum Design of a Fish Passage

10.29007/2k64 ◽  
2018 ◽  
Author(s):  
Pat Prodanovic ◽  
Cedric Goeury ◽  
Fabrice Zaoui ◽  
Riadh Ata ◽  
Jacques Fontaine ◽  
...  
Keyword(s):  
Numerical Model ◽  
Shape Optimization ◽  
Objective Function ◽  
Optimum Design ◽  
Optimization Problem ◽  
A Priori ◽  
Coupled System ◽  
Fish Passage ◽  
Hydraulic Structures ◽  
Design Variables

This paper presents a practical methodology developed for shape optimization studies of hydraulic structures using environmental numerical modelling codes. The methodology starts by defining the optimization problem and identifying relevant problem constraints. Design variables in shape optimization studies are configuration of structures (such as length or spacing of groins, orientation and layout of breakwaters, etc.) whose optimal orientation is not known a priori. The optimization problem is solved numerically by coupling an optimization algorithm to a numerical model. The coupled system is able to define, test and evaluate a multitude of new shapes, which are internally generated and then simulated using a numerical model. The developed methodology is tested using an example of an optimum design of a fish passage, where the design variables are the length and the position of slots. In this paper an objective function is defined where a target is specified and the numerical optimizer is asked to retrieve the target solution. Such a definition of the objective function is used to validate the developed tool chain. This work uses the numerical model TELEMAC- 2Dfrom the TELEMAC-MASCARET suite of numerical solvers for the solution of shallow water equations, coupled with various numerical optimization algorithms available in the literature.

Sign in / Sign up

Export Citation Format

Share Document