Особенности лазерно-виброметрического неразрушающего контроля полимерных композиционных материалов с использованием воздушно-связанных ультразвуковых преобразователей

2021 ◽  
pp. 26-38
Author(s):  
Д.А. Дерусова ◽  
В.П. Вавилов ◽  
В.О. Нехорошев ◽  
В.Ю. Шпильной ◽  
Н.В. Дружинин

Laser doppler vibrometry is being increasingly used in nondestructive testing (NDT) of polymer composites materials (PCM) and investigation of amplitude-frequency characteristics of acoustic transducers in a wide range of frequencies. The use of air-coupled transducers allows non- contact NDT thus expanding inspection potentials and simplifying, in some cases, test procedures, as well as reducing the environmental impact on test results, to compare to traditional techniques of acoustic NDT, which mainly implement contact stimulation of objects to be tested. In this study, the peculiarities of non-contact ultrasonic stimulation in application to NDT are analyzed by using scanning laser vibrometry. The results of NDT of impact damage in PCM are presented by using some types of air-coupled acoustic transducers, namely, magnetostrictive, piezoelectric and gas discharge.

Author(s):  
Patricia Llana ◽  
Karina Jacobsen ◽  
Richard Stringfellow

Research to develop new technologies for increasing the safety of passengers and crew in rail equipment is being directed by the Federal Railroad Administration’s (FRA’s) Office of Research, Development, and Technology. Crash energy management (CEM) components which can be integrated into the end structure of a locomotive have been developed: a push-back coupler and a deformable anti-climber. These components are designed to inhibit override in the event of a collision. The results of vehicle-to-vehicle override, where the strong underframe of one vehicle, typically a locomotive, impacts the weaker superstructure of the other vehicle, can be devastating. These components are designed to improve crashworthiness for equipped locomotives in a wide range of potential collisions, including collisions with conventional locomotives, conventional cab cars, and freight equipment. Concerns have been raised in discussions with industry that push-back couplers may trigger prematurely, and may require replacement due to unintentional activation as a result of loads experienced during service and coupling. Push-back couplers (PBCs) are designed with trigger loads meant to exceed the expected maximum service and coupling loads experienced by conventional couplers. Analytical models are typically used to determine these trigger loads. Two sets of coupling tests have been conducted that validate these models, one with a conventional locomotive equipped with conventional draft gear and coupler, and another with a conventional locomotive retrofit with a PBC. These tests allow a performance comparison of a conventional locomotive with a CEM-equipped locomotive during coupling, as well as confirmation that the PBC does not trigger at speeds below typical coupling speeds. In addition to the two sets of coupling tests, car-to-car compatibility tests of CEM-equipped locomotives, as well as a train-to-train test are also planned. This arrangement of tests allows for evaluation of the CEM-equipped locomotive performance, as well as comparison of measured with simulated locomotive performance in the car-to-car and train-to-train tests. The conventional coupling tests and the CEM coupling tests have been conducted, the results of which compared favorably with their pre-test predictions. In the CEM coupling tests, the PBC triggered at a speed well above typical coupling speeds. This paper provides a comparison of the conventional coupling test results with the CEM coupling test results. The next test in the research program is a vehicle-to-vehicle impact test. This paper describes the test preparation, test requirements, and analysis predictions for the vehicle-to-vehicle test. The equipment to be tested, track conditions, test procedures, and measurements to be made are described. A model for predicting the behavior of the impacting vehicles and the CEM system has been developed, along with preliminary predictions for the vehicle-to-vehicle test.


Author(s):  
Toshimi Kobayashi ◽  
Toru Izaki ◽  
Junichi Kusumoto ◽  
Akihiro Kanaya

The small punch creep (SPC) test is possible to predict residual creep life at a high accuracy. But, the results of SPC tests cannot be compared with uniaxial creep or internal pressure creep results directly. In this report, the relationship between SPC test results and uniaxial creep test results in ASME A335 P11 (1.25Cr-0.5Mo Steel) was studied. The obtained relationship between SPC load and equivalent uniaxial creep stress formed a simple linear equation under the wide range of test temperature and test period. Then, the SPC results can be compared with uniaxial results by converting SPC loads to the equivalent uniaxial creep stresses. The relationship between SPC test results and internal pressure creep tests results was also studied. The internal creep life of as-received P11 pipe was almost same as SPC result when the hoop stress was converted to the SPC load. The creep lives of internal pressure creep influenced materials also showed good correspondence with SPC results. Therefore SPC can estimate the residual life of internal pressure creep influenced materials.


2000 ◽  
Vol 37 (3) ◽  
pp. 712-722 ◽  
Author(s):  
A Sridharan ◽  
H B Nagaraj

Correlating engineering properties with index properties has assumed greater significance in the recent past in the field of geotechnical engineering. Although attempts have been made in the past to correlate compressibility with various index properties individually, all the properties affecting compressibility behaviour have not been considered together in any single study to examine which index property of the soil correlates best with compressibility behaviour, especially within a set of test results. In the present study, 10 soils covering a sufficiently wide range of liquid limit, plastic limit, and shrinkage limit were selected and conventional consolidation tests were carried out starting with their initial water contents almost equal to their respective liquid limits. The compressibility behaviour is vastly different for pairs of soils having nearly the same liquid limit, but different plasticity characteristics. The relationship between void ratio and consolidation pressure is more closely related to the shrinkage index (shrinkage index = liquid limit - shrinkage limit) than to the plasticity index. Wide variations are seen with the liquid limit. For the soils investigated, the compression index relates better with the shrinkage index than with the plasticity index or liquid limit.Key words: Atterberg limits, classification, clays, compressibility, laboratory tests.


1991 ◽  
Vol 66 (4) ◽  
pp. 1156-1165 ◽  
Author(s):  
V. L. Smith-Swintosky ◽  
C. R. Plata-Salaman ◽  
T. R. Scott

1. Extracellular action potentials were recorded from 50 single neurons in the insular-opercular cortex of two alert cynomolgus monkeys during gustatory stimulation of the tongue and palate. 2. Sixteen stimuli, including salts, sugars, acids, alkaloids, monosodium glutamate, and aspartame, were chosen to represent a wide range of taste qualities. Concentrations were selected to elicit a moderate gustatory response, as determined by reference to previous electrophysiological data or to the human psychophysical literature. 3. The cortical region over which taste-evoked activity could be recorded included the frontal operculum and anterior insula, an area of approximately 75 mm3. Taste-responsive cells constituted 50 (2.7%) of the 1,863 neurons tested. Nongustatory cells responded to mouth movement (20.7%), somatosensory stimulation of the tongue (9.6%), stimulus approach or anticipation (1.7%), and tongue extension (0.6%). The sensitivities of 64.6% of these cortical neurons could not be identified by our stimulation techniques. 4. Taste cells had low spontaneous activity levels (3.7 +/- 3.0 spikes/s, mean +/- SD) and showed little inhibition. They were moderately broadly tuned, with a mean entropy coefficient of 0.76 +/- 0.17. Excitatory responses were typically not robust. 5. Hierarchical cluster analysis was used to determine whether neurons could be divided into discrete types, as defined by their response profiles to the entire stimulus array. There was an apparent division of response profiles into four general categories, with primary sensitivities to sodium (n = 18), glucose (n = 15), quinine (n = 12), and acid (n = 5). However, these categories were not statistically independent. Therefore the notion of functionally distinct neuron types was not supported by an analysis of the distribution of response profiles. It was the case, however, that neurons in the sodium category could be distinguished from other neurons by their relative specificity. 6. The similarity among the taste qualities represented by this stimulus array was assessed by calculating correlations between the activity profiles they elicited from these 50 neurons. The results generally confirmed expectations derived from human psychophysical studies. In a multidimensional representation of stimulus similarity, there were groups that contained acids, sodium salts, and chemicals that humans label bitter and sweet. 7. The small proportion of insular-opercular neurons that are taste sensitive and the low discharge rates that taste stimuli are able to evoke from them suggest a wider role for this cortical area than just gustatory coding.(ABSTRACT TRUNCATED AT 400 WORDS)


2006 ◽  
Vol 3 (3) ◽  
pp. 226-233 ◽  
Author(s):  
Andrea Baratella ◽  
Roberto Bove ◽  
Piero Lunghi

Testing the performance of fuel cells is an important key for verifying technology improvements and for demonstrating their potential. However, due to the novelty of this technology, there is not a standardized procedure for testing fuel cell performance. In order to fully investigate fuel cell performance, the behavior must be known under a wide range of operational conditions. Furthermore, in order to compare results coming from different test teams, a set of procedures and parameters to evaluate single cell performance should be defined. The research group of the Fuel Cell Laboratory of the University of Perugia is conducting performance tests on single cells, focusing on defining test procedures to find effective parameters to be used to compare tests performed by different teams. This work demonstrates how the testing parameters developed by the team allow one to perform advanced control on test procedures, to understand test results, and to compare them with tests carried out under different operational conditions. The entire analysis is easily conducted by using a single parameter variation hyperspace approach. The experimental results obtained on single fuel cells are reported.


1970 ◽  
Vol 185 (1) ◽  
pp. 407-424 ◽  
Author(s):  
H. R. M. Craig ◽  
H. J. A. Cox

A comprehensive method of estimating the performance of axial flow steam and gas turbines is presented, based on analysis of linear cascade tests on blading, on a number of turbine test results, and on air tests of model casings. The validity of the use of such data is briefly considered. Data are presented to allow performance estimation of actual machines over a wide range of Reynolds number, Mach number, aspect ratio and other relevant variables. The use of the method in connection with three-dimensional methods of flow estimation is considered, and data presented showing encouraging agreement between estimates and available test results. Finally ‘carpets’ are presented showing the trends in efficiencies that are attainable in turbines designed over a wide range of loading, axial velocity/blade speed ratio, Reynolds number and aspect ratio.


1995 ◽  
Vol 15 (8) ◽  
pp. 4648-4656 ◽  
Author(s):  
M H Paalman ◽  
S L Henderson ◽  
B Sollner-Webb

We show that the mouse ribosomal DNA (rDNA) spacer promoter acts in vivo to stimulate transcription from a downstream rRNA gene promoter. This augmentation of mammalian RNA polymerase I transcription is observed in transient-transfection experiments with three different rodent cell lines, under noncompetitive as well as competitive transcription conditions, over a wide range of template concentrations, whether or not the enhancer repeats alone stimulate or repress expression from the downstream gene promoter. Stimulation of gene promoter transcription by the spacer promoter requires the rDNA enhancer sequences to be present between the spacer promoter and gene promoter and to be oriented as in native rDNA. Stimulation also requires that the spacer promoter be oriented toward the enhancer and gene promoter. However, stimulation does not correlate with transcription from the spacer promoter because the level of stimulation is not altered by either insertion of a functional mouse RNA polymerase I transcriptional terminator between the spacer promoter and enhancer or replacement with a much more active heterologous polymerase I promoter. Further analysis with a series of mutated spacer promoters indicates that the stimulatory activity does not reside in the major promoter domains but requires the central region of the promoter that has been correlated with enhancer responsiveness in vivo.


2017 ◽  
Vol 52 (14) ◽  
pp. 1847-1872 ◽  
Author(s):  
Bilal Khaled ◽  
Loukham Shyamsunder ◽  
Canio Hoffarth ◽  
Subramaniam D Rajan ◽  
Robert K Goldberg ◽  
...  

Test procedures for characterizing the orthotropic behavior of a unidirectional composite at room temperature and quasi-static loading conditions are developed and discussed. The resulting data consisting of 12 stress–strain curves and associated material parameters are used in a newly developed material model—an orthotropic elasto-plastic constitutive model that is driven by tabulated stress–strain curves and other material properties that allow for the elastic and inelastic deformation model to be combined with damage and failure models. A unidirectional composite—T800/F3900, commonly used in the aerospace industry, is used to illustrate how the experimental procedures are developed and used. The generated data are then used to model a dynamic impact test. Results show that the developed framework implemented into a special version of LS-DYNA yields reasonably accurate predictions of the structural behavior.


2015 ◽  
Vol 2015 ◽  
pp. 1-9 ◽  
Author(s):  
Francesca Martorana ◽  
Giulia Guidotti ◽  
Liliana Brambilla ◽  
Daniela Rossi

Several lines of evidence suggest that astrocytes play a key role in modulating the immune responses of the central nervous system (CNS) to infections, injuries, or pathologies. Yet, their contribution to these processes remains mostly elusive. Astroglia are endowed with a wide range of toll-like receptors (TLR) by which they can sense infectious agents as well as endogenous danger signals released by damaged cells. Here we demonstrate that the activation of astrocytic TLR4 by bacterial lipopolysaccharide (LPS) challenge can promote nuclear factorκB (NF-κB)-dependent induction of pro-inflammatory and stress response mediators, particularly Tumor Necrosis Factorα(TNFα), cyclooxygenase 2 (COX-2), and inducible nitric oxide synthase (iNOS). Since the steroid lactone Withaferin A was described to inhibit NF-κB activity in different cell types, we next determined the impact of this natural compound towards the identified astrocytic signalling pathway. Innate immune activation was induced by stimulation of the LPS/TLR4 axis in spinal cord astrocytes. We provide evidence that both pre-treating and post-treating the cells with Withaferin A attenuate astrocytic NF-κB activity as well as the consequent production of TNFα, COX-2, and iNOS induced by stimulation of the LPS/TLR4 pathway. This study suggests that Withaferin A may be an eligible candidate for the treatment of neuroinflammatory and stress conditions characterized by an important astrocytic input.


Sign in / Sign up

Export Citation Format

Share Document