scholarly journals Patterns of Dwelling Types, Location, and Spaciousness of Living in Norway. Critical Remarks on the Practice of Measuring Energy Performance per Floor Area Only

Buildings ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 394
Author(s):  
Lillian Sve Rokseth ◽  
Bendik Manum

For decades, energy efficiency has been a key issue in the Norwegian building sector, and energy standards are strict in order to reduce net delivered energy to buildings. Formally, requirements on energy use of dwellings are set by kWh per m2 heated GIA per year, a unit not accounting for dwelling size or number of persons in the households. This study, examining spaciousness of living in relation to dwelling types on an urban scale, shows that dwelling area per resident differs a lot across location and dwelling types. This implies that buildings formally performing the same in terms of following the legislation equally, in reality, may have a very different energy demand per person. When comparing dwelling types, energy demand per floor area and floor area per person is considerably higher for detached dwellings than for apartments. For both dwelling types, the energy demand of the dwellings in use is higher than what is stated in the requirements, and this difference is highest for detached houses. The current practice of measuring energy demand only per floor area is therefore insufficient. To realistically model energy performance of dwellings, measures accounting for dwelling size and number of residents should be included.

2018 ◽  
Vol 7 (4) ◽  
pp. 124
Author(s):  
Kawar T. Salih

The power shortage is one of the major problems in developing countries. Kurdistan Region of Iraq suffers from this issue, like other developing countries. Especially, after the economy crises that has started in 2014. However, all its efforts for tackling this challenge has been in providing more energy supply stations and more fuel provision. Few studies have been found in the region that seek the relation between the quality of buildings and energy consumption. It is questioned if the building sector in Kurdistan is well managed and environmentally sufficient to consume minimum amount of energy since it is the largest energy consuming sector. This research will seek an alternative to decrease the energy demand in buildings instead of expanding the energy sector. This could be achieved by evaluating the quality of building sector environmentally and improving it. Providing guidelines for building’s thermal regulations, passive building design and increasing the energy efficiency of buildings by renewal means could be alternative strategies for lowering the energy consumption. Theoretical and numerical research approach have been taken in to account for finding the answer through a case study and comparative analysis. A variation of 21-29% of power consumption can be observed between buildings that have not considered energy efficiency criteria in their design and those who reflected them more in the design.


2019 ◽  
Vol 887 ◽  
pp. 335-343
Author(s):  
Nazanin Moazzen ◽  
Mustafa Erkan Karaguler ◽  
Touraj Ashrafian

Energy efficiency has become a crucial part of human life, which has an adverse impact on the social and economic development of any country. In Turkey, it is a critical issue especially in the construction sector due to increase in the dependency on the fuel demands. The energy consumption, which is used during the life cycle of a building, is a huge amount affected by the energy demand for material and building construction, HVAC and lighting systems, maintenance, equipment, and demolition. In general, the Life Cycle Energy (LCE) needs of the building can be summarised as the operational and embodied energy together with the energy use for demolition and recycling processes.Besides, schools alone are responsible for about 15% of the total energy consumption of the commercial building sector. To reduce the energy use and CO2 emission, the operational and embodied energy of the buildings must be minimised. Overall, it seems that choosing proper architectural measures for the envelope and using low emitting material can be a logical step for reducing operational and embodied energy consumptions.This paper is concentrated on the operating and embodied energy consumptions resulting from the application of different architectural measures through the building envelope. It proposes an educational building with low CO2 emission and proper energy performance in Turkey. To illustrate the method of the approach, this contribution illustrates a case study, which was performed on a representative schoold building in Istanbul, Turkey. Energy used for HVAC and lighting in the operating phase and the energy used for the manufacture of the materials are the most significant parts of embodied energy in the LCE analyses. This case study building’s primary energy consumption was calculated with the help of dynamic simulation tools, EnergyPlus and DesignBuilder. Then, different architectural energy efficiency measures were applied to the envelope of the case study building. Then, the influence of proposed actions on LCE consumption and Life Cycle CO2 (LCCO2) emissions were assessed according to the Life Cycle Assessment (LCA) method.


Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3311
Author(s):  
Víctor Pérez-Andreu ◽  
Carolina Aparicio-Fernández ◽  
José-Luis Vivancos ◽  
Javier Cárcel-Carrasco

The number of buildings renovated following the introduction of European energy-efficiency policy represents a small number of buildings in Spain. So, the main Spanish building stock needs an urgent energy renovation. Using passive strategies is essential, and thermal characterization and predictive tests of the energy-efficiency improvements achieving acceptable levels of comfort for their users are urgently necessary. This study analyzes the energy performance and thermal comfort of the users in a typical Mediterranean dwelling house. A transient simulation has been used to acquire the scope of Spanish standards for its energy rehabilitation, taking into account standard comfort conditions. The work is based on thermal monitoring of the building and a numerical validated model developed in TRNSYS. Energy demands for different models have been calculated considering different passive constructive measures combined with real wind site conditions and the behavior of users related to natural ventilation. This methodology has given us the necessary information to decide the best solution in relation to energy demand and facility of implementation. The thermal comfort for different models is not directly related to energy demand and has allowed checking when and where the measures need to be done.


2014 ◽  
Vol 3 (2) ◽  
pp. 132-152 ◽  
Author(s):  
Karin Regina de Casas Castro Marins

Purpose – Energy use in urban areas has turned a subject of local and worldwide interest over the last few years, especially emphasized by the correlated greenhouse gases emissions. The purpose of this paper is to analyse the overall energy efficiency potential and emissions resulting from integrated solutions in urban energy planning, in the scale of districts and neighbourhoods in Brazil. Design/methodology/approach – The approach is based on the description and the application of a method to analyse energy performance of urban areas and support their planning. It is a quantitative bottom-up method and involves urban morphology, urban mobility, buildings and energy supply systems. Procedures are applied to the case study of Agua Branca urban development area, located in Sao Paulo, Brazil. Findings – In the case of Agua Branca area, energy efficiency measures in buildings have shown to be very important mostly for the buildings economies themselves. For the area as a whole, strategies in promoting public transport are more effective in terms of energy efficiency and also to decrease pollutant emissions. Originality/value – Literature review has shown there is a lack of approaches and procedures able to support urban energy planning at a community scale. The bottom-up method presented in this paper integrates a plenty of disaggregated and multisectoral parameters at the same stage in urban planning and shows that is possible to identify the most promising actions by building overall performance indexes.


2021 ◽  
Vol 13 (0) ◽  
pp. 1-6
Author(s):  
Rasa Džiugaitė-Tumėnienė ◽  
Domas Madeikis

The high share of global energy costs to create an indoor climate has been of increasing interest to the global community for several decades and is increasingly the focus of policy. This paper analyses the energy performance gap between actual energy consumption and energy demand obtained during the dynamic energy simulation and building certification. To identify the energy performance gap, an existing office of energy efficiency class B was selected as a case study. The simulation program IDA Indoor Climate and Energy was used to create a dynamic energy model, based on the designed documentation and the actual indoor climate parameters recorded by the building management system. The results of the case study showed that the accuracy and reliability of the results presented by the dynamic energy model of the building directly depend on the assumptions. The correct values of the internal heat gains, indoor climate parameters, human behavior, air quality levels at different times of the day and season, HVAC system operation parameters and operation modes, specific fan powers of ventilation systems, the seasonal energy efficiency of cooling equipment and characteristics of sun protection measures have to be selected.


2014 ◽  
Vol 39 (2) ◽  
pp. 78-83
Author(s):  
Henk Visscher ◽  
Dasa Majcen ◽  
Laure Itard

The energy saving potential of the building stock is large and considered to be the most cost efficient to contribute to the CO2 reduction ambitions. Severe governmental policies steering on reducing the energy use seem essential to stimulate and enforce the improvement of the energy performance of buildings with a focus on reducing the heating and cooling energy demand. In Europe the Energy Performance of Buildings Directive is a driving force for member states to develop and strengthen energy performance regulations for new buildings and energy certificates for the building stock. The goals are to build net zero energy new buildings in 2020 and to reach a neutral energy situation in the whole stock by 2050. More and more research projects deliver insight that the expected impact of stricter regulations for newly built houses is limited and the actual effects of energy savings through housing renovations stay behind the expectations. Theoretical energy use calculated on base of the design standard for new houses and assessment standards for Energy Performance Certificates of existing dwellings differ largely from the measured actual energy use. The paper uses the findings of some Post Occupancy Evaluation research projects. Is the energy saving potential of the housing stock smaller than expected and should we therefore change the policies?


Energies ◽  
2020 ◽  
Vol 13 (6) ◽  
pp. 1309 ◽  
Author(s):  
Tomasz Szul ◽  
Stanisław Kokoszka

In many regions, the heat used for space heating is a basic item in the energy balance of a building and significantly affects its operating costs. The accuracy of the assessment of heat consumption in an existing building and the determination of the main components of heat loss depends to a large extent on whether the energy efficiency improvement targets set in the thermal upgrading project are achieved. A frequent problem in the case of energy calculations is the lack of complete architectural and construction documentation of the analyzed objects. Therefore, there is a need to search for methods that will be suitable for a quick technical analysis of measures taken to improve energy efficiency in existing buildings. These methods should have satisfactory results in predicting energy consumption where the input is limited, inaccurate, or uncertain. Therefore, the aim of this work was to test the usefulness of a model based on Rough Set Theory (RST) for estimating the thermal energy consumption of buildings undergoing an energy renovation. The research was carried out on a group of 109 thermally improved residential buildings, for which energy performance was based on actual energy consumption before and after thermal modernization. Specific sets of important variables characterizing the examined buildings were distinguished. The groups of variables were used to estimate energy consumption in such a way as to obtain a compromise between the effort of obtaining them and the quality of the forecast. This has allowed the construction of a prediction model that allows the use of a fast, relatively simple procedure to estimate the final energy demand rate for heating buildings.


Author(s):  
Owen Betharte ◽  
Hamidreza Najafi ◽  
Troy Nguyen

The growing world-wide energy demand and environmental considerations have attracted immense attention in building energy efficiency. Climate zone plays a major role in the process of decision making for energy efficiency projects. In the present paper, an office building located in Melbourne, FL is considered. The building is built in 1961 and the goal is to identify and prioritize the potential energy saving opportunities and retrofit the existing building into a Net-Zero Energy Building (NZEB). An energy assessment is performed and a baseline model is developed using eQUEST to simulate the energy performance of the building. Several possible energy efficiency improvement scenarios are considered and assessed through simulation including improving insulation on the walls and roof, replacing HVAC units and upgrade their control strategies, use of high efficiency lighting, and more. Selected energy efficiency improvement recommendations are implemented on the building model to achieve the lowest energy consumption. It is considered that photovoltaic (PV) panels will be used to supply the energy demand of the building. Simulations are also performed to determine the number of required PV panels and associated cost of the system is estimated. The results from this paper can help with the decision making regarding retrofit projects for NZEB in humid subtropical climate.


2018 ◽  
Vol 10 (11) ◽  
pp. 4297 ◽  
Author(s):  
Hyunjoo Lee ◽  
Misuk Lee ◽  
Sesil Lim

Disclosing the energy performance information for buildings has been expected to become an important policy for controlling energy demand and reducing CO2 emissions, but its effectiveness remains controversial. This study investigates the effect of energy performance information on consumer residential choice by using a discrete choice experiment in South Korea. The estimation results confirmed that the energy efficiency level of the given housing has a significant effect on consumer residential choice when the related information is actually delivered. Combined with evidence from the simulation study, we suggest that obligating the owners to provide energy performance information to potential buyers/tenants would be necessary for enhancing the use of the information during the consumer decision-making process. Additionally, the simulation result implies that the effectiveness of the policy can be underestimated by the price premium related to energy efficiency. Therefore, we suggest that the government should control the price premium for high-efficiency buildings at the early stage so that the policy related to disclosing the energy performance can be on track.


Energies ◽  
2019 ◽  
Vol 12 (19) ◽  
pp. 3804 ◽  
Author(s):  
Chia-Nan Wang ◽  
Thi-Duong Nguyen ◽  
Min-Chun Yu

Despite the many benefits that energy consumption brings to the economy, consuming energy also leads nations to expend more resources on environmental pollution. Therefore, energy efficiency has been proposed as a solution to improve national economic competitiveness and sustainability. However, the growth in energy demand is accelerating while policy efforts to boost energy efficiency are slowing. To solve this problem, the efficiency gains in countries where energy consumption efficiency is of the greatest concern such as China, India, the United States, and Europe, especially, emerging economies, is central. Additionally, governments must take greater policy actions. Therefore, this paper studied 25 countries from Asia, the Americas, and Europe to develop a method combining the grey method (GM) and data envelopment analysis (DEA) slack-based measure model (SMB) to measure and forecast the energy efficiency, so that detailed energy efficiency evaluation can be made from the past to the future; moreover, this method can be extended to more countries around the world. The results of this study reveal that European countries have a higher energy efficiency than countries in Americas (except the United States) and Asian countries. Our findings also show that an excess of total energy consumption is the main reason causing the energy inefficiency in most countries. This study contributes to policymaking and strategy makers by sharing the understanding of the status of energy efficiency and providing insights for the future.


Sign in / Sign up

Export Citation Format

Share Document