scholarly journals A Perturbation-Based Methodology to Estimate the Equivalent Inertia of an Area Monitored by PMUs

Energies ◽  
2021 ◽  
Vol 14 (24) ◽  
pp. 8477
Author(s):  
Guido Rossetto Rossetto Moraes ◽  
Valentin Ilea ◽  
Alberto Berizzi ◽  
Cosimo Pisani ◽  
Giorgio Giannuzzi ◽  
...  
Keyword(s):  
Least Squares Method ◽  
Mechanical Power ◽  
Total Power ◽  
Power Imbalance ◽  
Quality Of Results ◽  
Different Types ◽  
Measurement Units ◽  
Equivalent Load ◽  
Load Behavior

This paper proposes a novel methodology to estimate equivalent inertia of an area, observed from its boundary buses where Phasor Measurement Units (PMUs) are assumed to be installed. The areas are divided according to the measurement points, and the methodology proposed can obtain the equivalent dynamic response of the area dependent of or independent of coherency of the generators inside, which is the first contribution of this paper. The methodology is divided in three parts: estimating the frequency response, estimating the power imbalance and estimating inertia through the solution of the swing equation by Least-Squares Method (LSM). The estimation of the power imbalance is the second contribution of this paper, enabling the study of areas that contain perturbations and attending the limitation of methods of the literature that rely on assumptions of slow mechanical power. It can be further divided in three steps: accounting the total power injected, estimating an equivalent load behavior and estimating an equivalent mechanical power. The quality of results is proved with test systems of different sizes, simulating different types of perturbations.

scholarly journals A Novel Net Weighting Algorithm for Power and Timing-Driven Placement

VLSI Design ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-9 ◽  
Author(s):  
Mohamed Chentouf ◽  
Zine El Abidine Alaoui Ismaili
Keyword(s):  
Integrated Circuits ◽  
Power Consumption ◽  
Total Power ◽  
Power Budget ◽  
Quality Of Results ◽  
Timing Closure ◽  
A Minor ◽  
Global Placement ◽  
Design Power

Nowadays, many new low power ASICs applications have emerged. This new market trend made the designer’s task of meeting the timing and routability requirements within the power budget more challenging. One of the major sources of power consumption in modern integrated circuits (ICs) is the Interconnect. In this paper, we present a novel Power and Timing-Driven global Placement (PTDP) algorithm. Its principle is to wrap a commercial timing-driven placer with a nets weighting mechanism to calculate the nets weights based on their timing and power consumption. The new calculated weight is used to drive the placement engine to place the cells connected by the critical power or timing nets close to each other and hence reduce the parasitic capacitances of the interconnects and, by consequence, improve the timing and power consumption of the design. This approach not only improves the design power consumption but facilitates also the routability with only a minor impact on the timing closure of a few designs. The experiments carried on 40 industrial designs of different nodes, sizes, and complexities and demonstrate that the proposed algorithm is able to achieve significant improvements on Quality of Results (QoR) compared with a commercial timing driven placement flow. We effectively reduce the interconnect power by an average of 11.5% that leads to a total power improvement of 5.4%, a timing improvement of 9.4%, 13.7%, and of 3.2% in Worst Negative Slack (WNS), Total Negative Slack (TNS), and total wirelength reduction, respectively.

scholarly journals K-means Clustering Algorithm Based on E-Commerce Big Data

2019 ◽  
Vol 8 (11) ◽  
pp. 1910-1914 ◽  
Keyword(s):  
Big Data ◽  
Clustering Algorithm ◽  
Geographical Location ◽  
Similar Data ◽  
Clustering Method ◽  
Quality Of Results ◽  
Identification Number ◽  
Different Types ◽  
Clustering Data

As the technology improving, huge volumes of different types of data is being generated rapidly. Mining such data is a challenging task. One of the important tasks of mining is to group similar objects or similar data into cluster which is very much useful for analysis and prediction. K-means clustering method is a popular partition based approach for clustering data as it leads to good quality of results. This paper focuses on K-means clustering algorithm by analyzing the E-commerce big data. In this research, geographical location and unique identification number of the customer are considered as constraints for clustering

Resistance Monitor and Control for Vacuum Evaporation of Metals and Carbon

1976 ◽  
Vol 34 ◽  
pp. 572-573
Author(s):  
Russell L. Steere ◽  
Eric F. Erbe ◽  
J. Michael Moseley
Keyword(s):  
Electronic Device ◽  
Point Sources ◽  
High Contrast ◽  
Variable Resistor ◽  
Quality Of Results ◽  
Low Contrast ◽  
Evaporation Source ◽  
And Control ◽  
At Will

We have designed and built an electronic device which compares the resistance of a defined area of vacuum evaporated material with a variable resistor. When the two resistances are matched, the device automatically disconnects the primary side of the substrate transformer and stops further evaporation.This approach to controlled evaporation in conjunction with the modified guns and evaporation source permits reliably reproducible multiple Pt shadow films from a single Pt wrapped carbon point source. The reproducibility from consecutive C point sources is also reliable. Furthermore, the device we have developed permits us to select a predetermined resistance so that low contrast high-resolution shadows, heavy high contrast shadows, or any grade in between can be selected at will. The reproducibility and quality of results are demonstrated in Figures 1-4 which represent evaporations at various settings of the variable resistor.

Enumeration of Cryptosporidium oocysts from surface water concentrates by laser-scanning cytometry

2000 ◽  
Vol 41 (7) ◽  
pp. 197-202 ◽  
Author(s):  
F. Zanelli ◽  
B. Compagnon ◽  
J. C. Joret ◽  
M. R. de Roubin
Keyword(s):  
Surface Water ◽  
Water Samples ◽  
Laser Scanning ◽  
Immunomagnetic Separation ◽  
Entire Surface ◽  
Cryptosporidium Oocysts ◽  
Different Types ◽  
Laser Scanning Cytometry ◽  
Direct Microscopic Observation

The utilization of the ChemScan® RDI was tested for different types of water concentrates. Concentrates were prepared by cartridge filtration or flocculation, and analysed either without purification, or after Immunomagnetic separation (IMS) or flotation on percoll-sucrose gradients. Theenumeration of the oocysts was subsequently performed using the ChemScan® RDI Cryptosporidium application. Enumeration by direct microscopic observation of the entire surface of the membrane was carried out as a control, and recoveries were calculated as a ratio between the ChemScan® RDI result and the result obtained with direct microscopic enumeration. The Chemscan enumeration technique proved reliable, with recoveries yielding close to 100% in most cases (average 125%, range from 86 to 467%) for all the concentration/purification techniques tested. The quality of the antibodies was shown to be critical, with antibodies from some suppliers yielding recoveries a low as 10% in some cases. This difficulty could, however, be overcome by the utilization of the antibody provided by Chemunex. These data conclusively prove that laser scanning cytometry, which greatly facilitates the microscopic enumeration of Cryptosporidium oocysts from water samples and decreases the time of observation by four to six times, can be successfully applied to water concentrates prepared from a variety of concentration/purification techniques.

Different Types of Auricular Keloids and Treatment by Intralesional Cryosurgery: Best Practice for Obtaining Long-Lasting Clinical Results

Dermatology ◽  
2021 ◽  
pp. 1-10
Author(s):  
Yaron Har-Shai ◽  
Lior Har-Shai ◽  
Viktor A. Zouboulis ◽  
Christos C. Zouboulis
Keyword(s):  
Quality Of Life ◽  
Body Image ◽  
Recurrence Rate ◽  
Best Practice ◽  
Clinical Results ◽  
Psychosocial Impact ◽  
Aesthetic Outcome ◽  
The Past ◽  
Different Types

<b><i>Background:</i></b> Auricular keloids belong to the most perplexing medical conditions, which have significant psychosocial impact on the patient’s body image and quality of life. <b><i>Summary:</i></b> The article is purposed to provide dermatologists and plastic surgeons with the best proven practice using intralesional cryosurgery for the treatment of the different auricular keloid types in order to obtain superior clinical results by minimizing the probability of recurrence. In the past 20 years, the authors have developed novel procedures in order to increase the effectiveness of intralesional cryosurgery on auricular keloids, including hydrodissection, warm gauze technique, and excision of dangling skin. Long-lasting clinical results with a low recurrence rate and a satisfactory aesthetic outcome are achieved with no deformation of the ear framework.

scholarly journals Analysis of ergonomic and unergonomic human lifting behaviors by using Inertial Measurement Units

2017 ◽  
Vol 3 (1) ◽  
pp. 7-10 ◽  
Author(s):  
Jan Kuschan ◽  
Henning Schmidt ◽  
Jörg Krüger
Keyword(s):  
Quality Of Life ◽  
Machine Learning ◽  
Angular Velocity ◽  
Musculoskeletal System ◽  
Occupational Diseases ◽  
Inertial Measurement Units ◽  
Inertial Measurement ◽  
Measurement Units ◽  
Main Components

Abstract:This paper presents an analysis of two distinct human lifting movements regarding acceleration and angular velocity. For the first movement, the ergonomic one, the test persons produced the lifting power by squatting down, bending at the hips and knees only. Whereas performing the unergonomic one they bent forward lifting the box mainly with their backs. The measurements were taken by using a vest equipped with five Inertial Measurement Units (IMU) with 9 Dimensions of Freedom (DOF) each. In the following the IMU data captured for these two movements will be evaluated using statistics and visualized. It will also be discussed with respect to their suitability as features for further machine learning classifications. The reason for observing these movements is that occupational diseases of the musculoskeletal system lead to a reduction of the workers’ quality of life and extra costs for companies. Therefore, a vest, called CareJack, was designed to give the worker a real-time feedback about his ergonomic state while working. The CareJack is an approach to reduce the risk of spinal and back diseases. This paper will also present the idea behind it as well as its main components.

scholarly journals Threat or Corrective? Assessing the Impact of Populist Parties in Government on the Qualities of Democracy: A 19-Country Comparison

2021 ◽  
pp. 1-21
Author(s):  
Davide Vittori
Keyword(s):  
Negative Impact ◽  
Quality Of Democracy ◽  
Clear Cut ◽  
Liberal Democratic ◽  
Country Comparison ◽  
Democratic Regimes ◽  
Different Types ◽  
The Impact

Abstract Scholars have long debated whether populism harms or improves the quality of democracy. This article contributes to this debate by focusing on the impact of populist parties in government. In particular, it inquires: (1) whether populists in government are more likely than non-populists to negatively affect the quality of democracies; (2) whether the role of populists in government matters; and (3) which type of populism is expected to negatively affect the quality of liberal-democratic regimes. The results find strong evidence that the role of populists in government affects several qualities of democracy. While robust, the findings related to (2) are less clear-cut than those pertaining to (1). Finally, regardless of their role in government, different types of populism have different impacts on the qualities of democracy. The results show that exclusionary populist parties in government tend to have more of a negative impact than other forms of populism.

Sign in / Sign up

Export Citation Format

Share Document