scholarly journals Dielectric Properties of Electrical Insulating Liquids for High Voltage Electric Devices in a Time-Varying Electric Field

Energies ◽  
2022 ◽  
Vol 15 (1) ◽  
pp. 391
Author(s):  
Peter Havran ◽  
Roman Cimbala ◽  
Juraj Kurimský ◽  
Bystrík Dolník ◽  
Iraida Kolcunová ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Electric Field ◽  
Electric Power ◽  
Mineral Oil ◽  
Dielectric Losses ◽  
Time Varying ◽  
Power Equipment ◽  
Debye Relaxation ◽  
Insulating Liquids ◽  
Hydrocarbon Oil

The motivation to improve components in electric power equipment brings new proposals from world-renowned scientists to strengthen them in operation. An essential part of every electric power equipment is its insulation system, which must have the best possible parameters. The current problem with mineral oil replacement is investigating and testing other alternative electrical insulating liquids. In this paper, we present a comparison of mineral and hydrocarbon oil (liquefied gas) in terms of conductivity and relaxation mechanisms in the complex plane of the Cole-Cole diagram and dielectric losses. We perform the comparison using the method of dielectric relaxation spectroscopy in the frequency domain at different intensities of the time-varying electric field 0.5 kV/m, 5 kV/m, and 50 kV/m. With the increasing intensity of the time-varying electric field, there is a better approximation of the Debye behavior in all captured polarization processes of the investigated oils. By comparing the distribution of relaxation times, mineral oil shows closer characteristics to Debye relaxation. From the point of view of dielectric losses at the main frequency, hydrocarbon oil achieves better dielectric properties at all applied intensities of the time-varying electric field, which is very important for practical use.

scholarly journals Investigation of the Lightning Impulse Breakdown Voltage of Mineral Oil based Fe3O4 Nanofluids

Coatings ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 799 ◽  
Author(s):  
Víctor A. Primo ◽  
Belén García ◽  
Juan Carlos Burgos ◽  
Daniel Pérez-Rosa
Keyword(s):  
Dielectric Properties ◽  
Breakdown Voltage ◽  
Mineral Oil ◽  
Power Transformers ◽  
Experimental Conditions ◽  
Insulating Materials ◽  
Recent Interest ◽  
Insulating Liquids ◽  
Lightning Impulse ◽  
Transformer Design

The recent interest in the development of nanomaterials has led researchers to the study of their electrical properties and the applications that they may have as insulating materials. One of these applications is the use of nanofluids as electrical insulation of power transformers. It has been reported that the dielectric properties of insulating liquids in which small amounts of nanoparticles have been dispersed are, in some cases, superior to those of the base fluids. Although these materials are promising, and their application could lead to advantages for the transformer design and reliability in the future, more research is necessary to evaluate different combination of materials under a wider range of experimental conditions. In this paper, a research on the lightning impulse breakdown voltage of mineral oil and several Fe3O4-based nanofluids is presented. Fluids prepared with different concentrations of nanoparticles were subjected to impulse lightning voltages considering both positive and negative polarities. As shown in this work the positive impulse breakdown voltage of the liquids showed improvements of up to 50%; in the case of the negative impulses not significant improvements were obtained.

scholarly journals Low Cycle Fatigue Characteristics of Oxygen-Free Copper for Electric Power Equipment

Materials ◽  
2021 ◽  
Vol 14 (15) ◽  
pp. 4237
Author(s):  
Takuma Tanaka ◽  
Togo Sugioka ◽  
Tatsuya Kobayashi ◽  
Ikuo Shohji ◽  
Yuya Shimada ◽  
...  
Keyword(s):  
Heat Treatment ◽  
Electric Power ◽  
Stress Amplitude ◽  
Low Cycle Fatigue ◽  
Ebsd Analysis ◽  
Fatigue Properties ◽  
Power Equipment ◽  
Cycle Fatigue ◽  
Fracture Surfaces ◽  
Heat Treated

The effect of heat treatment on tensile and low cycle fatigue properties of the oxygen-free copper for electric power equipment was investigated. The heat treatment at 850 °C for 20 min, which corresponds to the vacuum brazing process, caused the grain growth and relaxation of strain by recrystallization, and thus, the residual stress in the oxygen-free copper was reduced. The tensile strength and 0.2% proof stress were decreased, and elongation was increased by the heat treatment accompanying recrystallization. The plastic strain in the heat-treated specimen was increased compared with that in the untreated specimen under the same stress amplitude condition, and thus, the low cycle fatigue life of the oxygen-free copper was degraded by the heat treatment. Striation was observed in the crack initiation area of the fractured surface in the case of the stress amplitude less than 100 MPa regardless of the presence of the heat treatment. With an increase in the stress amplitude, the river pattern and the quasicleavage fracture were mainly observed in the fracture surfaces of the untreated specimens, and they were observed with striations in the fracture surfaces of the heat-treated ones. The result of the electron backscattered diffraction (EBSD) analysis showed that the grain reference orientation deviation (GROD) map was confirmed to be effective to investigate the fatigue damage degree in the grain by low cycle fatigue. In addition, the EBSD analysis revealed that the grains were deformed, and the GROD value reached approximately 28° in the fractured areas of heat-treated specimens after the low cycle fatigue test.

Electrostatic Forces on Particles Floating Within the Interface Between Two Immiscible Fluids

2007 ◽  
Author(s):  
Nadine Aubry ◽  
Pushpendra Singh
Keyword(s):  
Dielectric Properties ◽  
Field Strength ◽  
Electric Field ◽  
Electric Field Strength ◽  
External Electric Field ◽  
Capillary Force ◽  
Electrostatic Force ◽  
Immiscible Fluids ◽  
Electrostatic Forces ◽  
Dipole Interactions

The objective of this paper is to study the dependence of the electrostatic force that act on a particle within the interface between two immiscible fluids on the parameters such as the dielectric properties of the fluids and particles, the particle’s position within the interface, and the electric field strength. It is shown that the component of electrostatic force normal to the interface varies as a2, where a is the particle radius, and since in equilibrium it is balanced by the vertical capillary force, the interfacial deformation caused by the particle changes when an external electric field is applied. In addition, there are lateral electrostatic forces among the particles due to the dipole-dipole interactions which, when the distance between two particles is O(a), vary as a2, and remain significant for submicron sized particles.

Sign in / Sign up

Export Citation Format

Share Document