scholarly journals Parent Nested Optimizing Structure for Vibration Reduction in Floating Wind Turbine Structures

2020 ◽  
Vol 8 (11) ◽  
pp. 876
Author(s):  
Gwanghee Park ◽  
Ki-Yong Oh ◽  
Woochul Nam
Keyword(s):  
Global Minimum ◽  
Optimization Method ◽  
Offshore Wind ◽  
Design Parameters ◽  
Optimization Approach ◽  
Offshore Wind Turbines ◽  
Swarm Algorithms ◽  
Floating Offshore Wind Turbines ◽  
Artificial Fish Swarm ◽  
Computationally Intensive

A tuned mass damper (TMD) is a system that effectively reduces the vibrations of floating offshore wind turbines (FOWTs). To maximize the performance of TMDs, it is necessary to optimize their design parameters (i.e., stiffness, damping, and installation location). However, this optimization process is challenging because of the existence of multiple local minima. Although various methods have been proposed to determine the global minimum (e.g., exhaustive search, genetic algorithms, and artificial fish swarm algorithms), they are computationally intensive. To address this issue, a novel optimization approach based on a parent nested optimizing structure and approximative search is proposed in this paper. The approximative search determines an initial parameter set (close to the optimal set) with fewer calculations. Then, the global minimum can be rapidly determined using the nested and parent optimizers. The effectiveness of this approach was verified with an FOWT exposed to stochastic winds. The results show that this approach is 30–55 times faster than a conventional global optimization method.

Design Requirements for Floating Offshore Wind Turbines

2013 ◽  
Author(s):  
Xiaohong Chen ◽  
Qing Yu
Keyword(s):  
Wind Turbine ◽  
Case Studies ◽  
Wind Turbines ◽  
Offshore Wind ◽  
Design Parameters ◽  
Offshore Wind Turbine ◽  
Support Structure ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Design Requirements

This paper presents the research in support of the development of design requirements for floating offshore wind turbines (FOWTs). An overview of technical challenges in the design of FOWTs is discussed, followed by a summary of the case studies using representative FOWT concepts. Three design concepts, including a Spar-type, a TLP-type and a Semisubmersible-type floating support structure carrying a 5-MW offshore wind turbine, are selected for the case studies. Both operational and extreme storm conditions on the US Outer Continental Shelf (OCS) are considered. A state-of-the-art simulation technique is employed to perform fully coupled aero-hydro-servo-elastic analysis using the integrated FOWT model. This technique can take into account dynamic interactions among the turbine Rotor-Nacelle Assembly (RNA), turbine control system, floating support structure and stationkeeping system. The relative importance of various design parameters and their impact on the development of design criteria are evaluated through parametric analyses. The paper also introduces the design requirements put forward in the recently published ABS Guide for Building and Classing Floating Offshore Wind Turbine Installations (ABS, 2013).

scholarly journals Optimization of Floating Offshore Wind Turbine Platforms With a Self-Tuning Controller

2017 ◽  
Author(s):  
Frank Lemmer ◽  
Kolja Müller ◽  
Wei Yu ◽  
David Schlipf ◽  
Po Wen Cheng
Keyword(s):  
Wind Turbine ◽  
Offshore Wind ◽  
Design Parameters ◽  
Offshore Wind Turbine ◽  
Wave Loads ◽  
Offshore Wind Turbines ◽  
Material Costs ◽  
Floating Offshore Wind Turbines ◽  
Self Tuning ◽  
Cost Efficient

The dynamic response of floating offshore wind turbines is complex and requires numerous design iterations in order to converge at a cost-efficient hull shape with reduced responses to wind and waves. In this article, a framework is presented, which allows the optimization of design parameters with respect to user-defined criteria such as load reduction and material costs. The optimization uses a simplified nonlinear model of the floating wind turbine and a self-tuning model-based controller. The results are shown for a concrete three-column semi-submersible and a 10 MW wind turbine, for which a reduction of the fluctuating wind and wave loads is possible through the optimization. However, this happens at increased material costs for the platform due to voluminous heave plates or increased column spacing.

Comparison of Weathervane Performance Between Two Types of FOWT Systems Moored to SPM

2015 ◽  
Author(s):  
Kazuhiro Iijima ◽  
Yuiko Kuroda ◽  
Yasunori Nihei ◽  
Motohiko Murai
Keyword(s):  
Wind Wave ◽  
Single Point ◽  
Equations Of Motion ◽  
Offshore Wind ◽  
Design Parameters ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Turning Motion ◽  
Motion Performance ◽  
The Stability

This paper addresses the weathervane performance of Floating Offshore Wind Turbines (FOWTs) moored to single-point mooring (SPM) systems. A system of equations of motion to describe the motions in horizontal plane around the mooring point in the combined environmental conditions is derived. Wind, wave and current loads are considered. Two types of SPM-FOWT systems proposed by the present authors are considered for comparison. It is found out that the weathervane performance of the SPM-FOWT systems is acceptable in a point that the power generation efficiency does not reduce significantly. The stability is also checked based on the eigenvalue analysis for the linearized equations of motion around the equilibrium point. The stability and the responsivity are discussed in comparison between the two systems. Sensitivity of the stability and responsivity to design parameters such as length between the buoy and the main floater to the turning motion performance is discussed, too.

Pitch Angle Control of Floating Offshore Wind Turbines by H∞ Control

2014 ◽  
Vol 134 (8) ◽  
pp. 1096-1103 ◽  
Author(s):  
Sho Tsujimoto ◽  
Ségolène Dessort ◽  
Naoyuki Hara ◽  
Keiji Konishi
Keyword(s):  
Wind Turbines ◽  
Pitch Angle ◽  
Offshore Wind ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines

scholarly journals Effect of Roughness of Mussels on Cylinder Forces from a Realistic Shape Modelling

2021 ◽  
Vol 9 (6) ◽  
pp. 598
Author(s):  
Antoine Marty ◽  
Franck Schoefs ◽  
Thomas Soulard ◽  
Christian Berhault ◽  
Jean-Valery Facq ◽  
...  
Keyword(s):  
Marine Species ◽  
Offshore Structures ◽  
Offshore Wind ◽  
Mooring Lines ◽  
Shape Modelling ◽  
Offshore Wind Turbines ◽  
Specific Effects ◽  
Hydrodynamic Loading ◽  
Floating Offshore Wind Turbines ◽  
Realistic Shape

After a few weeks, underwater components of offshore structures are colonized by marine species and after few years this marine growth can be significant. It has been shown that it affects the hydrodynamic loading of cylinder components such as legs and braces for jackets, risers and mooring lines for floating units. Over a decade, the development of Floating Offshore Wind Turbines highlighted specific effects due to the smaller size of their components. The effect of the roughness of hard marine growth on cylinders with smaller diameter increased and the shape should be representative of a real pattern. This paper first describes the two realistic shapes of a mature colonization by mussels and then presents the tests of these roughnesses in a hydrodynamic tank where three conditions are analyzed: current, wave and current with wave. Results are compared to the literature with a similar roughness and other shapes. The results highlight the fact that, for these realistic roughnesses, the behavior of the rough cylinders is mainly governed by the flow and not by their motions.

scholarly journals Impact of Typhoons on Floating Offshore Wind Turbines: A Case Study of Typhoon Mangkhut

2021 ◽  
Vol 9 (5) ◽  
pp. 543
Author(s):  
Jiawen Li ◽  
Jingyu Bian ◽  
Yuxiang Ma ◽  
Yichen Jiang
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Safety Evaluation ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Motion Response ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Coupling Motion

A typhoon is a restrictive factor in the development of floating wind power in China. However, the influences of multistage typhoon wind and waves on offshore wind turbines have not yet been studied. Based on Typhoon Mangkhut, in this study, the characteristics of the motion response and structural loads of an offshore wind turbine are investigated during the travel process. For this purpose, a framework is established and verified for investigating the typhoon-induced effects of offshore wind turbines, including a multistage typhoon wave field and a coupled dynamic model of offshore wind turbines. On this basis, the motion response and structural loads of different stages are calculated and analyzed systematically. The results show that the maximum response does not exactly correspond to the maximum wave or wind stage. Considering only the maximum wave height or wind speed may underestimate the motion response during the traveling process of the typhoon, which has problems in guiding the anti-typhoon design of offshore wind turbines. In addition, the coupling motion between the floating foundation and turbine should be considered in the safety evaluation of the floating offshore wind turbine under typhoon conditions.

scholarly journals Performance Analysis on the Use of Oscillating Water Column in Barge-Based Floating Offshore Wind Turbines

Mathematics ◽  
2021 ◽  
Vol 9 (5) ◽  
pp. 475
Author(s):  
Payam Aboutalebi ◽  
Fares M’zoughi ◽  
Izaskun Garrido ◽  
Aitor J. Garrido
Keyword(s):  
Wind Turbines ◽  
Positive Impact ◽  
Offshore Wind ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Water Columns ◽  
Numerical Tools ◽  
Oscillating Water Columns ◽  
The Given ◽  
The Waves

Undesired motions in Floating Offshore Wind Turbines (FOWT) lead to reduction of system efficiency, the system’s lifespan, wind and wave energy mitigation and increment of stress on the system and maintenance costs. In this article, a new barge platform structure for a FOWT has been proposed with the objective of reducing these undesired platform motions. The newly proposed barge structure aims to reduce the tower displacements and platform’s oscillations, particularly in rotational movements. This is achieved by installing Oscillating Water Columns (OWC) within the barge to oppose the oscillatory motion of the waves. Response Amplitude Operator (RAO) is used to predict the motions of the system exposed to different wave frequencies. From the RAOs analysis, the system’s performance has been evaluated for representative regular wave periods. Simulations using numerical tools show the positive impact of the added OWCs on the system’s stability. The results prove that the proposed platform presents better performance by decreasing the oscillations for the given range of wave frequencies, compared to the traditional barge platform.

scholarly journals Switching Control Strategy for Oscillating Water Columns Based on Response Amplitude Operators for Floating Offshore Wind Turbines Stabilization

2021 ◽  
Vol 11 (11) ◽  
pp. 5249
Author(s):  
Payam Aboutalebi ◽  
Fares M’zoughi ◽  
Itziar Martija ◽  
Izaskun Garrido ◽  
Aitor J. Garrido
Keyword(s):  
Switching Control ◽  
Response Amplitude ◽  
Offshore Wind ◽  
Oscillating Water Column ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Water Columns ◽  
Switching Control Strategy ◽  
Response Amplitude Operators ◽  
Oscillating Water Columns

In this article, a new strategy for switching control has been proposed with the aim of reducing oscillations in floating offshore wind turbines. Such oscillations lead to a shortage in the system’s efficiency, lifespan and harvesting capability of wind and wave energies. In order to study the decreasing of undesired oscillations in the system, particularly in pitch and top tower fore-aft movements, a square-shaped platform barge equipped with four symmetric oscillating water columns has been considered. The oscillating water columns’ air flux valves allow to operate the air columns so that to control the barge movements caused by oscillatory motion of the waves. In order to design the control scheme, response amplitude operators have been used to evaluate the performance of the system for a range of wave frequency profiles. These response amplitude operators analysis makes it possible to implement a switching control strategy to adequately regulate the valves opening/closing transition. The obtained results show that the proposed controlled oscillating water column-based barge present a better performance compared to the traditional barge one. In the case study with the period of 10 s, the results indicate the significant oscillation reduction for the controlled oscillating water column-based system compared to the standard barge system by 30.8% in pitch angle and 25% in fore-aft displacement.

Sign in / Sign up

Export Citation Format

Share Document