INFLUENCE OF MACRO AND MICRO DEFLECTIONS ON LOADING CAPACITY, FLOW RATE AND ENERGY CHARACTERISTICS OF FLUID FRICTION BEARINGS

Author(s):  
S.V. MAYOROV ◽  
A.V. GORIN ◽  
I.V. RODICHEVA ◽  
I.G. USIKOVA

The influence of technological deviations on the performance of fluid friction bearings is considered. A mathematical model of a hydrodynamic sliding bearing is presented, based on a joint numerical solution of the Reynolds equation and additional relations to take into account the microroughness of the bearing surfaces. Analysis of the numerical results made it possible to assess the effect of roughness on the bearing capacity, consumption and energy characteristics of fluid friction bearings.

2016 ◽  
Vol 68 (5) ◽  
pp. 521-529 ◽  
Author(s):  
Zichao Liu ◽  
Wei Pan ◽  
Changhou Lu ◽  
Yongtao Zhang

Purpose This paper aims to establish an accurate mathematical model of a piezoelectric membrane restrictor that can be applied to control the shaft’s centerline orbit. Design/methodology/approach The methodology uses three coupled equations to establish a mathematical model of the piezoelectric membrane restrictor – Reynolds equation, the membrane deformation equation and the flow rate equation. A data identification method is used to propose the flow rate formulas for the piezoelectric membrane restrictor. Findings It has been found that the structural parameters, the membrane center deformation and the inlet and outlet pressures of the piezoelectric membrane restrictor have an effect on the static performance of the restrictor. The identified flow rate result of the piezoelectric membrane restrictor is consistent with the models. Originality/value The paper provides an accurate mathematical model of the piezoelectric membrane restrictor which can also be applied to other membrane restrictors.


Author(s):  
Yuchuan Zhu ◽  
Chang Liu ◽  
Yunze Song ◽  
Long Chen ◽  
Yulei Jiang ◽  
...  

In this paper, an electro-hydrostatic actuator driven by dual axial-mounted magnetostrictive material rods-based pumps (MMPs) with a new type of active rectification valve is designed in the current study. Based on flow distribution of the active rectification valve and driving energy provided by two MMPs, the actuator can output continuous and bidirectional displacement. By establishing a mathematical model of the actuating system, using simulation techniques, the change rule of hydraulic cylinder’s motion state caused by different driving signals are studied and analyzed. Test equipment platform is constructed in the laboratory to test the output characteristics and confirm the feasibility of the new concept. The experimental results indicate that the maximum flow rate can reach approximately 2.7 L·min−1, while the operating frequency is 180 Hz.


Symmetry ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 705
Author(s):  
Fatemeh Rasouli ◽  
Kyle B. Reed

Dynamic models, such as double pendulums, can generate similar dynamics as human limbs. They are versatile tools for simulating and analyzing the human walking cycle and performance under various conditions. They include multiple links, hinges, and masses that represent physical parameters of a limb or an assistive device. This study develops a mathematical model of dissimilar double pendulums that mimics human walking with unilateral gait impairment and establishes identical dynamics between asymmetric limbs. It introduces new coefficients that create biomechanical equivalence between two sides of an asymmetric gait. The numerical solution demonstrates that dissimilar double pendulums can have symmetric kinematic and kinetic outcomes. Parallel solutions with different physical parameters but similar biomechanical coefficients enable interchangeable designs that could be incorporated into gait rehabilitation treatments or alternative prosthetic and ambulatory assistive devices.


1976 ◽  
Vol 98 (1) ◽  
pp. 111-116 ◽  
Author(s):  
A. Gu ◽  
L. Cziglenyi

Analysis and method of numerical solution for evaluating the performance of hydrostatic spherical gas gyro bearings at any gimbal angle and at any eccentricity have been developed. Performance data on load capacity, gas flow rate, drag torque, and error torque over some ranges of gimbal angle and eccentricity are presented. Comparison has been made between the equatorially vented and nonvented bearings of fixed bearing angles.


2011 ◽  
Vol 8 (3-4) ◽  
pp. 309-321 ◽  
Author(s):  
S. K. Pandey ◽  
Dharmendra Tripathi

This model investigates particularly the impact of an integral and a non-integral number of waves on the swallowing of food stuff such as jelly, tomato puree, soup, concentrated fruits juices and honey transported peristaltically through the oesophagus. The fluid is considered as a Casson fluid. Emphasis is on the study of the dependence of local pressure distribution on space and time. Mechanical efficiency, reflux limit and trapping are also discussed. The effect of Casson fluid vis-à-vis Newtonian fluid is investigated analytically and numerically too. The result is physically interpreted as that the oesophagus makes more efforts to swallow fluids with higher concentration. It is observed that the pressure is uniformly distributed when an integral number of waves is there in the oesophagus; but it is non-uniform when a non-integral number of waves is present therein. It is further observed that as the plug flow region widens, the pressure difference increases, which indicates that the averaged flow rate will reduce for a Casson fluid. It is also concluded that Casson fluids are more prone to reflux.


Author(s):  
Мурсалим Мухутдинович Гареев ◽  
Марат Иозифович Валиев ◽  
Филипп А. Карпов

Путевая деградация противотурбулентных присадок (ПТП) может стать причиной изменения основных параметров режима магистрального трубопровода - давления и расхода - относительно установившихся значений и осложнить контроль их отклонений от нормативных показателей. При этом до настоящего момента отсутствовала методика расчета режимов перекачки при использовании ПТП с учетом деградации. Авторами была поставлена цель по разработке методики для математического описания распределения давления в трубопроводе с учетом путевой деградации присадки, а также при различных концентрациях ПТП. Для достижения указанной цели предлагается дополнить уравнение баланса напоров с учетом эмпирической зависимости эффективности присадки от длины трубопровода. При расчетах давления в промежуточных точках трассы предлагается использовать данные опытно-промышленных испытаний по изменению эффективности ПТП. Для иллюстрации применения методики рассматриваются примеры перекачки нефти и нефтепродуктов с добавлением присадок в различных концентрациях. На основании экспериментальных данных получена адекватная математическая модель снижения эффективности ПТП по длине магистрального трубопровода для различных концентраций вводимой присадки. Path degradation of drug reducing agents (DRA) can cause changes in the main mode parameters of the main pipeline; pressure and flow rate, relative to the stable values, and complicate the adjustment of their deviations from the standard indicators. At the same time, up until now there has been no methodology for calculating pumping modes when using DRA that takes degradation into account. The authors set a goal to develop a methodology to mathematically describe the pressure distribution in the pipeline, taking into account the path degradation of the agent, as well as the parameters at different DRA concentrations. To achieve this goal, it is proposed to supplement the equation of the pressure head balance with the empirical dependency of agent efficiency on the length of the pipeline. When calculating the pressure at intermediate points of the route, it is proposed to use the pilot run data on the change in the DRA efficiency. To illustrate the application of the methodology, examples of pumping oil and petroleum products with added agents in various concentrations are discussed. On the basis of the experimental data, an adequate mathematical model of the DRA efficiency reduction along the length of the main pipeline for different concentrations of introduced agent was obtained.


Sign in / Sign up

Export Citation Format

Share Document