scholarly journals Carbon Dioxide Recuperation Using a Ranque-Hilsch Vortex Tube for Refrigerated Food Processing

Author(s):  
Tamaz Isakadze ◽  
◽  
Givi Gugulashvili ◽  

The disadvantage of the technological process of freezing food products using carbon dioxide is the irrational use of its waste vapors. From the authors’ point of view, it is desirable to use carbon dioxide not only directly on the line for freezing and cooling food raw materials. Cooling of carbon dioxide vapors after processing on freezing lines with further use for refrigeration looks promising, for example, for freezing food materials, for which the freezing temperature according to the technological instructions can be higher than the boiling point of carbon dioxide -78 ℃. An innovative refrigeration machine based on a Ranque-Hilsch vortex tube has been developed for cooling waste carbon dioxide for further use in the refrigeration processing of food products. It is based on carbon dioxide recovery technology.

2020 ◽  
Vol 99 (11) ◽  
pp. 1308-1314
Author(s):  
Irina V. May ◽  
Svetlana A. Vekovshinina ◽  
Svetlana V. Kleyn ◽  
Nadejda V. Nikiforova

Introduction. In conditions of the high density of urban development, efficient use of municipal lands is of particular relevance. Food production facilities make up a significant sector of many cities’ economy, including centers of ferrous and non-ferrous metallurgy, chemistry, petrochemistry, mining, etc., i.e., settlements where significant areas are limited in use by sanitary protection zones. Resolution of the Government of the Russian Federation dated March 3, 2018, No. However, such a justification is a scientific and methodological problem since there is no regulatory consolidation of the procedure. The purpose of the study was to develop and practically test methodological approaches to justification the admissibility (inadmissibility) of placing a food production facility in the sanitary protection zone of enterprises in other line of the industry. Material and methods. Design and technical documentation were studied on sources of data on air quality at the industrial site and indoors, and the quality of food products. Authors performed hygienic assessment of the safety and quality of air, raw materials, water, and manufactured food products for compliance with sanitary requirements and standards. When analyzing potential threats to contamination of food products, a mechanism was used to isolate critical points of the technological process. Results. An algorithm for the formation of the evidence base of the absence (presence) of the negative impact on food quality, the fact of the location of the production facility in the sanitary protection zone of a large industrial enterprise on the quality of food products is proposed. On the example of the production of juices from natural concentrated products, each step of the algorithm has been worked out: analysis of the technological process of production; hazard identification, instrumental measurements of the quality of environmental objects and raw materials and products. Conclusion. The proposed algorithm allows creating a reliable evidence base for deciding on the admissibility (inadmissibility) of the location of the food production facility in the sanitary protection zone of the enterprise with a different type of activity, tested in real conditions of a large industrial unit. The algorithm can be used as a base for the widespread use and further improvement.


2010 ◽  
Vol 1 (1) ◽  
pp. 87-111 ◽  
Author(s):  
Jan A. Delcour ◽  
Charlotte Bruneel ◽  
Liesbeth J. Derde ◽  
Sara V. Gomand ◽  
Bram Pareyt ◽  
...  

2017 ◽  
pp. 171-184 ◽  
Author(s):  
Александр (Aleksandr) Григорьевич (Grigor'evich) Топаж (Topazh) ◽  
Владимир (Vladimir) Александрович (Aleksandrovich) Вигонт (Vigont) ◽  
Любовь (Ljubov') Анатольевна (Anatol'evna) Хворова (Hvorova)

Article is devoted to the description and the analysis of the system-dynamic model of technological process of biogas production from multicomponent vegetable raw materials. A research objective – optimization of biogas production process from vegetable raw materials by methods of imitating modeling, finding of the optimal regimes of the simulated production cycle – the best ratio from the economic point of view between an exit of biomethane and rates of giving/replacement of the initial substratum depending on the composition of raw materials.In article models with a discrete and continuous cycle of production are considered, the description of the similar realization executed in the environment of multiapproach modeling of AnyLogic for model of technological process of anaerobic digestion of non-uniform multicomponent vegetable biomass is provided.The known stoichiometric model of production of biomethane is taken as a basis, her modification is made for a case of multicomponent raw materials (percentage division into conditional components – sugar, lignin and cellulose). Possibilities of modern software shells and environments of modeling in tasks of the complex analysis and optimization of the studied process are shown.During the conducted researches a row of non-trivial results on a choice of optimum parameters of an operation mode of the model bioreactor is received. For a case of the discrete process of up-dating of contents as parameters of optimization the frequency and a level of up-dating, and for the continuous flowing system – channel speed were selected.It is shown that the optimal values of the parameters from the point of view of the integrated output of the biomethane lie close to the cloud of critical acidification, which leads to the stoppage of the process. If the economic indicators are chosen as an optimization criterion, then we obtain optimal values of the parameters lying within the region of stable functioning of the model bioreactor.


2018 ◽  
Vol 4 ◽  
pp. 42-49
Author(s):  
Alexandra Niemirich ◽  
Oksana Vasheka ◽  
Oksana Petrusha ◽  
Nikolay Pogozhikh

One of the resource-saving methods of drying, from the point of view of preserving food and biological value, providing the appropriate recovery properties of dried food products (DFP) and energy intensity of the process, is drying with mixed heat supply (MHS drying). The scientific concept of work on the formation of a universal and DFP stable functional and technological potential is formulated, which is the basis for modeling and designing the formulation composition and technology of food products by groups and types with its use or interchangeability. As the subject of research for the formation of quality indicators of cereals, white cabbage is selected, as it is a typical vegetable for Ukraine and accordingly has a high degree of assimilation of natural micronutrients in the human body. Structural studies have shown the predominantly crystalline structure of polysaccharides, that is, less than their transformation under conditions of MHS drying, as compared with convective conditions. The effect of MHS drying on the formation of DFP quality indicators is determined by the method of recording IR spectra with Fourier transform. For studies of the violation of total internal reflection, it has been established that the process of DFP reduction leads to an increase in the availability of organic substances in the solvent, which will facilitate the extraction of extractives in the recovery of raw materials. It is established by the number of aroma, the more aromatic-forming substances are contained in the MHS drying samples irrespective of the process temperature, less in the dried samples of the convective method. This is due to the reduction of thermal and thermal effects during MHS drying, which slows down chemical transformations and removes aromatic substances. It is proved by the tensometric method, with the convective method due to shrinkage during dehydration, the changes during sorption and desorption are insignificant. When MHS drying, such changes are expressed: during the sorption of vapors, DFP is well restored, the capillaries swell, so the differential distribution function of the pores expands, the average radius of the capillaries increases 4 ... 6 times. The research results make it possible to form the functional and technological parameters of cabbage powder, to simulate the formulation of new food products with this ingredient and to optimize the production technology.


2011 ◽  
Vol 57 (No. 9) ◽  
pp. 422-435 ◽  
Author(s):  
J. Vološin ◽  
L. Smutka ◽  
R. Selby

The agrarian sector has a non-substitutable position in most world economics – including the CR. From the viewpoint of functioning of own agrarian trade it can be stated that the CR is roughly self-sufficient by 70–80% in products of a competitive nature. In case of products of a non-competitive nature, the CR shows almost zero self-sufficiency. It means that agrarian foreign trade occupies a non-substitutable position in the CR economy (at least from the export point of view). In the light of our own trade flows, the CR performs as an active exporter and importer (about 100 billion and 130 billion CZK respectively, in 2009). However, together with the still growing needs of the national economy and the inhabitants’ requirements for a varied composition of agri‑food products, the CR does not succeed in the long term to decrease the negative balance of the agrarian foreign trade. It is, however, indisputable that if a serious discussion should be held about the competitiveness of Czech agriculture in confrontation with foreign producers or suppliers of agricultural and food products, the priority task to reach a balanced agrarian foreign trade balance can be accepted only for the competitive products segment. The complexity of a greater participation of the basic Czech agricultural and food products on the EU unified market deepens simultaneously with the acceleration of the liberalisation process on this market. The gradual process of the world agrarian market liberalisation then means that the cost and price relationships are determined by such world producers as are able to offer agrarian products for the most advantageous prices, or offer goods of exceptional quality, with a high added value, brand products, national specialties and so on. Potentially, the space for improvement of the active balance of agrarian foreign trade (AFT) is given to us in much the same way as to our competitors, but actually, our possibilities are limited. The stagnation or even growth of the negative AFT balance was, and is influenced by non-substitutable imports of non-competitive food raw materials and foodstuff products and many other raw materials required by the non-agricultural sectors of the national economy.


2020 ◽  
pp. 64-70
Author(s):  
Mariya Y. Medvedevskikh ◽  
Anna S. Sergeeva

The article raises the problem of ensuring metrological traceability of the measurement results of indicators of quality and nutritional value for food products and food raw materials: water (moisture), nitrogen (protein, crude protein), fat, ash and carbohydrates. The problem under consideration can be solved by applying reference materials of food composition, traceable to state primary measurement standards GET 173-2017 and GET 176-2019 and primary reference measurement procedures (PRMP), for attestation of measurement procedures and accuracy checking of measurement results. The article discusses the results of the PRMP development of mass fraction of fat, ash and carbohydrates in food products and food raw materials, as well as mass fraction of crude fat (oil content) in oil crops seeds and products based on them. The paper also presents metrological characteristics of reference materials of composition of dry dairy products, grain-milk dry porridges for nutrition of babies, grain dry porridges for nutrition of babies, egg powder, freeze-dried meat products, animal feed. The results of the work allow for building a chain of metrological traceability from GET 173-2017, GET 176-2019 and PRMP to routine measurement procedures, thereby ensuring the uniformity of measurements of nutritional value of food products.


2008 ◽  
Vol 59 (2) ◽  
pp. 129-134
Author(s):  
Ion Teoreanu ◽  
Roxana Lucia Dumitrache ◽  
Stefania Stoleriu

Any change of the raw material sources for glazes, economically, ecologically motivated, and also from the glaze quality point of view, is conditioned by the molecular formula rationalization and by the variation limits of the molecular formula, respectively. The proper glaze compositions are placed within their limit variation intervals with optimized processing and utilization properties. For this purpose, the rationalization criteria and procedures of molecular formulas are summarized in the present paper, as well as the results referring to their rationalization obtained in the authors� previous work. Thus, one starts from a base of raw materials that are selected, usable and also accessible for the design and producing of the glazes. On these bases the groundwork and the design equation for the glaze recipes are developed, exemplified for a single glaze. For an easy access to results, computer programs are used for an easy access to results.


2017 ◽  
Vol 73 (12) ◽  
Author(s):  
Nadezhda Pavlovna Shevchenko ◽  
Marina Vasilevna Kaledina ◽  
Lyudmila Viktorovna Voloschenko ◽  
Alexander Ivanovich Shevchenko ◽  
Inna Alekseevna Baidina

Sign in / Sign up

Export Citation Format

Share Document