Effect of Plasticizer and Cross-Linking Agent on the Physical Properties of Protein Films

2005 ◽  
Vol 10 (1) ◽  
pp. 88-91 ◽  
Author(s):  
Myoung-Suk Lee ◽  
Se-Hee Lee ◽  
Yu-Hyun Ma ◽  
Sang-Kyu Park ◽  
Dong-Ho Bae ◽  
...  
1993 ◽  
Vol 66 (2) ◽  
pp. 117-123 ◽  
Author(s):  
Hideo NAKAUCHI ◽  
Sakae INOUE ◽  
Kazuo NAITO

2017 ◽  
Vol 2017 ◽  
pp. 1-6 ◽  
Author(s):  
Markus Schmid ◽  
Tobias Konrad Prinz ◽  
Kerstin Müller ◽  
Andreas Haas

Casted whey protein films exposed to ultraviolet irradiation were analyzed for their cross-linking properties and mechanical and barrier performance. Expected mechanical and barrier improvements are discussed with regard to quantification of the cross-linking in the UV-treated whey protein films. Swelling tests were used to determine the degree of swelling, degree of cross-linking, and cross-linking density. When the UV radiation dosage was raised, a significant increase of the tensile strength as well as an increase in Young’s modulus was observed. No significant changes in water vapor and oxygen barrier properties between the UV-treated films and an untreated reference sample could be observed. The cross-linking density and the degree of cross-linking significantly increased due to UV radiation. Combined results indicate a disordered protein network in cast films showing locally free volume and therefore only minor mechanical and barrier improvements.


Soft Matter ◽  
2016 ◽  
Vol 12 (9) ◽  
pp. 2537-2541 ◽  
Author(s):  
Xi Wei ◽  
Qian Zhu ◽  
Jin Qian ◽  
Yuan Lin ◽  
V. B. Shenoy

1953 ◽  
Vol 26 (3) ◽  
pp. 643-654 ◽  
Author(s):  
J. Reid Shelton ◽  
William L. Cox

Abstract The over-all rate of deterioration of physical properties increases with the oxygen concentration, as would be expected from the increased rate of oxygen absorption: The nature of the deterioration resulting from a given amount of oxygen absorbed is influenced also by changes in the partial pressure of oxygen in the aging atmosphere. It appears that chain scission is favored at higher oxygen concentrations, while cross-linking becomes of greater relative importance at lower oxygen concentrations. These data suggest that R⋅ radicals are more effective than RO2⋅ radicals in reacting with double bonds to form crosslinks. Heat aging in the absence of oxygen, as observed by heating a vulcanizate in lamp-grade nitrogen, results in considerable stiffening, particularly in the case of a GR-S black stock. This effect is observed primarily in the first few hours of heating, and may account for some of the erratic behavior observed in the early stages of aging when changes in physical properties are compared on the basis of amount of oxygen absorbed. Higher oxygen concentration brings about a more rapid oxidation, and also results in a higher proportion of chain scission compared to cross-linking for a given amount of oxygen absorbed. As tensile decay is the most evident sign of deterioration of Hevea stocks, it follows that the aging behavior of natural rubber in air at normal storage temperatures will be better than that predicted by high temperature testing in oxygen. In the case of GR-S stocks, on the other hand, oxidative hardening is the most serious result of aging, and consequently, the aging behavior of GR-S stocks in air at normal storage temperatures is poorer than would be expected on the basis of comparative tests in oxygen at higher temperatures.


1939 ◽  
Vol 12 (2) ◽  
pp. 191-199
Author(s):  
I. Williams

Abstract No direct evidence exists to support the sulfide linkage theory of vulcanization, which assumes that cross-linking of the molecules with sulfur would retain the elasticity and decrease the plasticity of the rubber. The following facts do not favor the sulfide linkage theory of vulcanization : (1) Vulcanized rubber can be peptized under conditions which do not appear to rupture a sulfide linkage. (2) No direct relation exists between the physical properties of vulcanized rubber and the amount of combined sulfur. (3) No direct relation exists between the ease of peptization and the physical properties of the vulcanizate. (4) Combined sulfur appears to assist the solvation of rubber. Rubber vulcanized with thiuram disulfides in the absence of free sulfur has poor physical properties but peptizes with difficulty. An increase in combined sulfur without a corresponding improvement in physical properties assists solvation. (5) Rubber having the best physical properties is also the most heterogeneous with respect to sulfur. The sulfide linkage theory would suggest that an even distribution of sulfur would produce the best physical properties. (6) Fractions of peptized vulcanizates, on evaporation of their solutions, leave insoluble vulcanized films, which shows that linkage by means of primary forces is unnecessary for producing the vulcanized condition.


2016 ◽  
Vol 82 (1) ◽  
pp. 108-117 ◽  
Author(s):  
Chieh-Ting Chen ◽  
Kuan-I Chen ◽  
Hsin-Han Chiang ◽  
Yu-Kuo Chen ◽  
Kuan-Chen Cheng

Sign in / Sign up

Export Citation Format

Share Document