scholarly journals A New Coordinated Control of Hybrid Microgrids with Renewable Energy Resources Under Variable Loads and Generation Conditions

2020 ◽  
Vol 16 (2) ◽  
pp. 1-20 ◽  
Author(s):  
Bilal Alhasnawi ◽  
Basil Jasim

The hybrid AC/DC microgrid is considered to be more and more popular in power systems as increasing loads. In this study, it is presented that the hybrid AC/DC microgrid is modeled with some renewable energy sources (e.g. solar energy, wind energy) in the residential of the consumer in order to meet the demand. The power generation and consumption are undergoing a major transformation. One of the tendencies is to integrate microgridsinto the distribution network with high penetration ofrenewable energy resources. In this paper, a new distributed coordinated control is proposed for hybrid microgrid, which could apply to both grid-connected mode and islanded mode with hybrid energy resources and variable loads. The proposed system permits coordinated operation of distributed energy resources to concede necessary active power and additional service whenever required. Also, the maximum power point tracking technique is applied to both photovoltaic stations and wind turbines to extract the maximum power from the hybrid power system during the variation of the environmental conditions. Finally, a simulation model is built with a photovoltaic, wind turbine, hybrid microgrid as the paradigm, which can be applied to different scenarios, such as small-sized commercial and residential buildings. The simulation results have verified the effectiveness and feasibility of the introduced strategy for a hybrid microgrid operating in different modes.

Energies ◽  
2020 ◽  
Vol 13 (13) ◽  
pp. 3480 ◽  
Author(s):  
Bilal Naji Alhasnawi ◽  
Basil H. Jasim ◽  
Amjad Anvari-Moghaddam ◽  
Frede Blaabjerg

This research work puts forward a hybrid AC/DC microgrid with renewable energy sources pertaining to consumer’s residential area for meeting the demand. Currently, the power generation and consumption have experienced key transformations. One such tendency would be integration of microgrids into the distribution network that is characterized by high penetration of renewable energy resources as well as operations in parallel. Traditional droop control can be employed in order to get an accurate steady state averaged active power sharing amongst parallel inverters pertaining to hybrid AC/DC microgrid. It is presumed that there would be similar transient average power responses, and there would be no circulating current flowing between the units for identical inverters possessing the same droop gain. However, the instantaneous power could be affected by different line impedances considerably and thus resulting in variation in circulating power that flows amongst inverters, especially during unexpected disturbances like load changes. This power, if absorbed by the inverter, could result in sudden DC-link voltage rise and trip the inverter, which in turn causes performance degradation of the entire hybrid microgrid. When the hybrid generators act as unidirectional power source, the issue worsens further. In this research work, we have put forward a new distributed coordinated control pertaining to hybrid microgrid, which can be applied for both grid connected and islanded modes that include variable loads and hybrid energy resources. Also, in order to choose the most effective controller scheme, a participation factor analysis has been designed for binding the DC-link voltage as well as reducing the circulating power. Moreover, to both photovoltaic stations and wind turbines, maximum power point tracking (MPPT) techniques have been used in order to extract the maximum power from hybrid power system when there is discrepancy in environmental circumstances. Lastly, the feasibility and effectiveness pertaining to the introduced strategy for hybrid microgrid in various modes are confirmed via simulation results.


2020 ◽  
Vol 9 (2) ◽  
pp. 295-301
Author(s):  
Nabil Qachchachi ◽  
Hassane Mahmoudi ◽  
Abdennebi El Hassnaoui

The fluctuation of production of renewable energy resources (RESs) is a big problem for its installation and integration in isolated residential buildings. A hybrid AC/DC microgrid facilitates the good operation of RESs with a storage system in standalone mode and the possibilities of smart energy management. In this paper optimization research of the hybrid ac/dc microgrid in isolated mode of operation is presented. The power system is supplied by various Renewable Energy Resources (RESs), Photovoltaic arrays (PVA), a Wind Turbine Generator (WTG), Diesel Generator (DG) and supported by Batteries Storage System (BSS) for short term storage. The main objective of this study is to optimize power flow within a hybrid ac/dc microgrid with regards to reliability in islanded mode. First a mathematical model optimized by mixed integer linear programming and solved by CPLEX solver with JAVA language is developed for an islanded RES system and then, based on the developed model, the power system control is simulated for different cases of off-grid mode. Simulation results have shown that the management strategy can maintain power balancing while performing optimized control and give a controllable loads and batteries charging/discharging powers, even with unpredictability of RESs powers outputs and arbitrary energy tariffs. Finally, the proposed algorithm respects the optimization in real-time operation under various constraints.%.©2020. CBIORE-IJRED. All rights reserved


Author(s):  
Shabbier Ahmed Sydu , Et. al.

Electrical energy becomes necessary for human being. Generation of electrical energy mostly depends on fossils fuel, they are limited in nature and also responsible for environmental pollution. Renewable energy resources provides a better alternative for future. In comparison to conventional energy resources economical aspect is a major issue of renewable energy sources with the feasibility and efficiency. This paper investigates the performance analysis and control of Photovoltaic (PV)-wind hybrid system connected to electrical grid and feeds large plant with critical variable loads. The technique of extracting maximum power point is applied for the hybrid power system to capture maximum power under varying climatic conditions. Moreover, Control strategy for power flow is proposed to supply critical load demand of plant. The Dynamic performance of the proposed hybrid system is analyzed under different environmental conditions. The simulation results have proven the effectiveness of the proposed maximum power point tracking (MPPT) strategies in response to rapid variations of weather conditions during the day.


Author(s):  
S. G. Obukhov ◽  
I. A. Plotnikov ◽  
V. G. Masolov

The paper presents the results of the comparative analysis of operation modes of an autonomous hybrid power complex with/without the energy store. We offere the technique which defines the power characteristics of the main components of a hybrid power complex: the consumers of the electric power, wind power and photo-electric installations (the last ones have been constructed). The paper establishes that, in order to compensate the seasonal fluctuations of power in autonomous power systems with renewable energy resources, the accumulative devices are required, with a capacity of tens of MWh including devices that are capable to provide energy storage with duration about half a year. This allows abandoning the storage devices for smoothing the seasonal fluctuations in the energy balance.The analysis of operation modes of energy stores has shown that for a stock and delivery of energy on time intervals, lasting several hours, the accumulative devices with rather high values of charging and digit power aren't required. It allows using the lead-acid rechargeable batteries of the deep category for smoothing the daily peaks of surplus and a capacity shortage. Moreover, the analysis of operation modes of energy stores as a part of the hybrid complexes has demonstrated that in charging/digit currents of the energy store the low-frequency and high-frequency pulsations of big amplitude caused by changes of size of output power of the renewable power installations and loading are inevitable. If low-frequency pulsations (the period of tens of minutes) can partially be damped due to the restriction of size of the maximum charging current of rechargeable batteries, then it is essentially impossible to eliminate high-frequency pulsations (the period of tens of seconds) in the power systems with the only store of energy. The paper finds out that the combined energy store having characteristics of the accumulator in the modes of receiving and delivery of power on daily time intervals, and at the same time having properties of the supercondenser in the modes of reception and return of impulses of power on second intervals of time is best suited to requirements of the autonomous power complexes with renewable energy resources.


Electronics ◽  
2021 ◽  
Vol 10 (15) ◽  
pp. 1779
Author(s):  
Syed Rahman ◽  
Irfan Khan ◽  
Khaliqur Rahman ◽  
Sattam Al Otaibi ◽  
Hend I. Alkhammash ◽  
...  

This paper presents a novel, scalable, and modular multiport power electronic topology for the integration of multiple resources. This converter is not only scalable in terms of the integration of multiple renewable energy resources (RES) and storage devices (SDs) but is also scalable in terms of output ports. Multiple dc outputs of a converter are designed to serve as input to the stacking modules (SMs) of the modular multilevel converter (MMC). The proposed multiport converter is bidirectional in nature and superior in terms of functionality in a way that a modular universal converter is responsible for the integration of multiple RES/SDs and regulates multiple dc output ports for SMs of MMC. All input ports can be easily integrated (and controlled), and output ports also can be controlled independently in response to any load variations. An isolated active half-bridge converter with multiple secondaries acts as a central hub for power processing with multiple renewable energy resources that are integrated at the primary side. To verify the proposed converter, a detailed design of the converter-based system is presented along with the proposed control algorithm for managing power on the individual component level. Additionally, different modes of power management (emulating the availability/variability of renewable energy sources (RES)) are exhibited and analyzed here. Finally, detailed simulation results are presented in detail for the validation of the proposed concepts and design process.


2013 ◽  
Vol 2013 ◽  
pp. 1-8 ◽  
Author(s):  
Alexandros I. Nikolaidis ◽  
Francisco M. Gonzalez-Longatt ◽  
C. A. Charalambous

The continuous increase on the penetration levels of Renewable Energy Sources (RESs) in power systems has led to radical changes on the design, operation, and control of the electrical network. This paper investigates the influence of these changes on the operation of a transmission network by developing a set of indices, spanning from power losses to GHG emissions reduction. These indices are attempting to quantify any impacts therefore providing a tool for assessing the RES penetration in transmission networks, mainly for isolated systems. These individual indices are assigned an analogous weight and are mingled to provide a single multiobjective index that performs a final evaluation. These indices are used to evaluate the impact of the integration of RES into the classic WSCC 3-machine, 9-bus transmission network.


Author(s):  
Baba Dzhabrailovich Babaev ◽  
Vladimir Panchenko ◽  
Valeriy Vladimirovich Kharchenko

The main objective of the work is to develop principles for the formation of the optimal composition of the energy complex from all the given power plants based on renewable energy sources for an autonomous consumer, taking into account the variable energy loads of the consumer, changing climatic conditions and the possibility of using local fuel and energy resources. As a result of solving this optimization problem, in addition to the optimal configuration of the power complex, it is also necessary to solve the problem of optimizing the joint operation of different types of power plants from the selected optimal configuration, that is, it is necessary to determine the optimal modes of operation of power plants and the optimal share of their participation in providing consumers at every moment in time. A numerical method for analyzing and optimizing the parameters and operating mode of the energy complex with the most accurate consideration of the schedule of changes in consumer load and software that automates the solution of this optimization problem are also presented.


Author(s):  
NGO TUYET

The article presents the main steps of model of forming regional cluster of renewable energy sources in Vietnam, including method of evaluating the possibility of creating regional cluster of renewable energy resources in Vietnam. The approbation of model in region Ninh Thuan – Binh Thuan.


Sign in / Sign up

Export Citation Format

Share Document