L‐ andCORNER‐arrays for 3D electric resistivity tomography: an alternative for geophysical surveys in urban zones

2015 ◽  
Vol 13 (4) ◽  
pp. 355-368 ◽  
Author(s):  
Andrés Tejero‐Andrade ◽  
Gerardo Cifuentes ◽  
René E. Chávez ◽  
Aideé E. López‐González ◽  
Cecilia Delgado‐Solórzano
Geosciences ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 167 ◽  
Author(s):  
Cesare Comina ◽  
Nicolò Giordano ◽  
Giulia Ghidone ◽  
Federico Fischanger

A borehole thermal energy storage living lab was built nearby Torino (Northern Italy). The aim of this living lab is to test the ability of the alluvial deposits of the north-western Po Plain to store the thermal energy collected by solar panels. Monitoring the temperature distribution induced in the underground and the effectiveness of the heat storage in this climatic context is not an easy task. For this purpose, different temperature evolution strategies are compared in this paper: Local temperature measurements, numerical simulations and geophysical surveys. These different approaches were compared during a single day of operation of the living lab. The results of this comparison allowed to underline the effectiveness of time-lapse 3D electric resistivity tomography as a non-invasive and cost-effective qualitative heat monitoring tool. This was obtained even in a test site with unfavorable thermo-hydrogeological conditions and high-level anthropic noise. Moreover, the present study demonstrated that, if properly calibrated with local temperature values, time-lapse 3D electric resistivity tomography also provides a quantitative estimation of the underground temperature.


2014 ◽  
Vol 53 (4) ◽  
pp. 425-434 ◽  
Author(s):  
René E. Chávez ◽  
Gerardo Cifuentes-Nava ◽  
J. Esteban Hernández-Quintero ◽  
Diana Vargas ◽  
Andrés Tejero

2019 ◽  
Vol 67 (6) ◽  
pp. 2015-2030
Author(s):  
Tomisław Gołębiowski ◽  
Elżbieta Jarosińska

Abstract This paper presents the selected results of GPR (ground penetrating radar) and ERT (electrical resistivity tomography) surveys carried out on the sites in Poland where shallow karst forms were found in gypsum deposits. The aim of the surveys was the noninvasive detection of karst forms as well as weathered and fractured bedrock which may threaten the stability of the surface and, consequently, may cause damage to buildings, as well as overground and underground infrastructure. The geophysical surveys were conducted at a depth of only a few meters, i.e., to the depth of buildings foundations. GPR surveys were carried out in short-offset reflection profiling mode with standard orientation of the antennae set; however, on one site, different orientations of antennae were tested. During ERT surveys, different measurement arrays were applied in order to analyze which array was optimal for the detection of karst forms as well as weathered and fractured bedrock. Complex interpretation of geophysical surveys resulted in reduced ambiguity and revealed some regions, dangerous for surface stability. Due to the fact that gypsum deposits were investigated to the depth of maximum 10 m; therefore, hydrological processes were analyzed in the paper instead of hydrogeological processes.


2021 ◽  
Vol 593 ◽  
pp. 125810
Author(s):  
Matthias Leopold ◽  
Conrad Gupanis-Broadway ◽  
Andy Baker ◽  
Stuart Hankin ◽  
Pauline Treble

2019 ◽  
Vol 265 ◽  
pp. 03005
Author(s):  
Dmitriy Gorbach ◽  
Valeriya Yakimenko ◽  
Olga Konovalova

The paper reviews methods of engineering geophysics which can be applied to sections of railway tracks. The method of electrical resistivity tomography is used to study the properties of the geological situation under an engineering structure. In the course of practical work, two-dimensional geoelectric sections were obtained. Interpretation of the sections allowed to understand the structure of the near-surface zone.


Solid Earth ◽  
2019 ◽  
Vol 10 (6) ◽  
pp. 1951-1969 ◽  
Author(s):  
Tobias Nickschick ◽  
Christina Flechsig ◽  
Jan Mrlina ◽  
Frank Oppermann ◽  
Felix Löbig ◽  
...  

Abstract. The Cheb Basin, a region of ongoing swarm earthquake activity in the western Czech Republic, is characterized by intense carbon dioxide degassing along two known fault zones – the N–S-striking Počatky–Plesná fault zone (PPZ) and the NW–SE-striking Mariánské Lázně fault zone (MLF). The fluid pathways for the ascending CO2 of mantle origin are one of the subjects of the International Continental Scientific Drilling Program (ICDP) project “Drilling the Eger Rift” in which several geophysical surveys are currently being carried out in this area to image the topmost hundreds of meters to assess the structural situation, as existing boreholes are not sufficiently deep to characterize it. As electrical resistivity is a sensitive parameter to the presence of conductive rock fractions as liquid fluids, clay minerals, and also metallic components, a large-scale dipole–dipole experiment using a special type of electric resistivity tomography (ERT) was carried out in June 2017 in order to image fluid-relevant structures. We used permanently placed data loggers for voltage measurements in conjunction with moving high-power current sources to generate sufficiently strong signals that could be detected all along the 6.5 km long profile with 100 and 150 m dipole spacings. After extensive processing of time series for voltage and current using a selective stacking approach, the pseudo-section is inverted, which results in a resistivity model that allows for reliable interpretations depths of up than 1000 m. The subsurface resistivity image reveals the deposition and transition of the overlying Neogene Vildštejn and Cypris formations, but it also shows a very conductive basement of phyllites and granites that can be attributed to high salinity or rock alteration by these fluids in the tectonically stressed basement. Distinct, narrow pathways for CO2 ascent are not observed with this kind of setup, which hints at wide degassing structures over several kilometers within the crust instead. We also observed gravity and GPS data along this profile in order to constrain ERT results. A gravity anomaly of ca. −9 mGal marks the deepest part of the Cheb Basin where the ERT profile indicates a large accumulation of conductive rocks, indicating a very deep weathering or alteration of the phyllitic basement due to the ascent of magmatic fluids such as CO2. We propose a conceptual model in which certain lithologic layers act as caps for the ascending fluids based on stratigraphic records and our results from this experiment, providing a basis for future drillings in the area aimed at studying and monitoring fluids.


2010 ◽  
Vol 40 (6) ◽  
pp. 1189-1193 ◽  
Author(s):  
Dirk Bieker ◽  
Steffen Rust

Electric resistivity tomograms of English oak ( Quercus robur L.) show a very distinct pattern of electric resistivity that has not been found in any other tree species yet and that cannot be related to the distribution of wood moisture content over the stem cross section. To reveal the factors underlying this two-dimensional pattern of electric resistivity, the variation of specific gravity and wood moisture content was analyzed in 18 cross sections of six roadside English oak trees after electric resistivity tomography. pH and electrolyte content were analyzed in two representative cross sections. Results show that electric resistivity correlates neither with wood moisture content nor density. The steep increase in electric resistivity at the sapwood–heartwood boundary correlates well with decreasing pH, potassium, and magnesium. The decreasing electric resistivity within the heartwood of English oak correlates with potassium and magnesium, increasing from the sapwood–heartwood boundary to the pith. More research is needed to identify species-specific electric resistivity patterns and their main factors if the method is to be used to detect wood fungal decay, historical ground water contamination, or other influences that may change the pattern of electric resistivity in the stem cross section.


2012 ◽  
Vol 42 (2) ◽  
pp. 201-211 ◽  
Author(s):  
René Putiška ◽  
Maroš Nikolaj ◽  
Ivan Dostál ◽  
David Kušnirák

Abstract Geophysical surveys for cavity detection are one of the most common nearsurface applications. The usage of resistivity methods is also very straightforward for the air-filled underground voids, which should have theoretically infinite resistivity in the ERT image. In the first part of the paper, we deal with the comparison of detectability of the cavity by several types of the electrode arrays, the second part discusses the effect of a thin layer around the cavity itself, by means of 2D modelling. The presence of this layer deforms the resistivity image significantly as the resistive anomaly could be turned into a conductive one, in the case when the thin layer is more conductive than the background environment. From the electrical array analysis for the model situation a dipole-dipole and combined pole-dipole shows the best results among the other involved electrical arrays.


Geophysics ◽  
2012 ◽  
Vol 77 (1) ◽  
pp. B11-B21 ◽  
Author(s):  
Thomas Hermans ◽  
Alexander Vandenbohede ◽  
Luc Lebbe ◽  
Frédéric Nguyen

Groundwater resources are increasingly used around the world for geothermal exploitation systems. To monitor such systems and to estimate their governing parameters, we rely mainly on borehole observations of the temperature field at a few locations. Bulk electric resistivity variations can bring important information on temperature changes in aquifers. We have used surface electric resistivity tomography to monitor spatially temperature variations in a sandy aquifer during a thermal injection test. Heated water (48°C) was injected for 70 hours at the rate of [Formula: see text] in a 10.5°C aquifer. Temperature changes derived from time-lapse electric images were in agreement with laboratory water electric conductivity-temperature measurements. In parallel, a coupled hydrogeologic saturated flow and heat transport model was calibrated on geophysical data for the conceptual model, and on hydrogeologic and temperature data for the parameters. The resistivity images showed an upper flow of heated water along the well above the injection screens and led to a new conceptualization of the hydrogeologic source term. The comparison between the temperature models derived from resistivity images and from the simulations was satisfactory. Quantitatively, resistivity changes allowed estimating temperature changes within the aquifer, and qualitatively, the heated plume evolution was successfully monitored. This work demonstrates the ability of electric resistivity tomography to study heat and storage experiments in shallow aquifers. These results could potentially lead to a number of practical applications, such as the monitoring or the design of shallow geothermal systems.


Sign in / Sign up

Export Citation Format

Share Document