Electromagnetic Method for Resonance Tuning of a Mechatronic System

2015 ◽  
Vol 770 ◽  
pp. 572-578
Author(s):  
A.K. Tomilin ◽  
G.A. Bayzakova

Process of vertical vibrations of the weight suspended on a spring at harmonic kinematic excitation is examined. It is shown that the resonance tuning of a system can be done with the use of magnetic force which occurs if the coil turns while moving cross external magnetic field lines.

Author(s):  
K. Mendelssohn ◽  
J. D. Babbitt ◽  
Frederick Alexander Lindemann

Until a year ago it was generally accepted that if a body is made supraconducting while in a magnetic field the lines of magnetic force were "frozen in," i. e ., whatever lines of force passed through the body at the time when it became supraconducting remained there afterwards, unaffected by any change in the external field, so long as the body was supraconducting. Meissner and Ochsenfeld, however, showed that this supposition was not true. They measured field strengths in the immediate neighbourhood of cylinders which had been cooled to supraconductivity in an external magnetic field, and found that the field of force was then of the same nature as that to be expected in the neighbourhood of perfectly diamagnetic bodies. Thus it appeared that when a body becomes supraconducting in a magnetic field the lines of force are all pressed out of the body, and the induction inside the body falls to zero. At the same time, however, these authors report on another experiment, the result of which appears to us not entirely in accordance with the assumption that the induction in the whole body became zero. They measured the field strengths inside and outside a hollow cylinder, after it had become supraconducting in a field perpendicular to its axis, and found again that the field strength outside was as if the cylinder were almost perfectly diamagnetic, but the field inside was appreciably the same as if the cylinder were non-supraconducting. We therefore made a number of experiments, hoping to find out more exactly the nature of the phenomenon.


1996 ◽  
Vol 436 ◽  
Author(s):  
Shin-Ichi Yamamoto ◽  
Hirofumi Yamada ◽  
Suzanne P. Jarvis ◽  
Makoto Motomatsu ◽  
Hiroshi Tokumoto

AbstractWe have investigated regional variations of elastic properties using a magnetic force controlled AFM. A piece of small magnet was fixed at the end of the backside of the AFM cantilever so as to apply forces directly to the tip through the external magnetic field of an electromagnet. By modulating the applied forces to the tip and measuring the resulting amplitude of oscillation, a sensitive measurement of the local contact stiffness can be made. We have applied this technique to phase-separated films of polystyrene/polymethylmethacrylate (PS-PMMA) which have almost identical Young's moduli.


2015 ◽  
Vol 107 (10) ◽  
pp. 103110 ◽  
Author(s):  
Dongzi Liu ◽  
Kangxin Mo ◽  
Xidong Ding ◽  
Liangbing Zhao ◽  
Guocong Lin ◽  
...  

2005 ◽  
Vol 492-493 ◽  
pp. 665-672 ◽  
Author(s):  
A. Ozieblo ◽  
Tomasz Wejrzanowski ◽  
K. Konopka ◽  
Mikolaj Szafran ◽  
Krzysztof Jan Kurzydlowski

This paper describes the technology and microstructure of Al2O3-Fe functionally graded composites, FGM, obtained by slip-casting under magnetic field. Alumina a-Al2O3, provided by Alcoa (symbol A16SG), with average grain size of 0.5 µm, and iron powder, (symbol Distaloy AB) from Hoganas, with average grain size of 35 µm, were used to produce a series of specimens which differed in contents of Fe particles in Al2O3. As a source of magnetic force a permanent magnet was used. Preforms were sintered in a vacuum at temp. 1470oC. The microstructures of the specimens were quantitatively described via stereological methods. Sections, parallel to the magnetic field lines were analyzed using special image analysis software. Stereological methods presented in this work have been used to determine gradient in the volume fraction of the Fe particles and variation in their size and dispersion. These parameters are essential for controlling the technological process of interest and to design microstructure for needed properties (fracture toughness).


2000 ◽  
Vol 10 (04) ◽  
pp. 539-553 ◽  
Author(s):  
E. FRÉNOD ◽  
E. SONNENDRÜCKER

When charged particles are submitted to a large external magnetic field, their movement in first approximation occurs along the magnetic field lines and obeys a one-dimensional Vlasov equation along these field lines. However, when observing the particles on a sufficiently long time scale, a drift phenomenon perpendicular to the magnetic field lines superposes to this first movement. In this paper, we present a rigorous asymptotic analysis of the two-dimensional Vlasov equation when the magnetic field tends to infinity, the observation time scale increases accordingly. Techniques based on the two-scale convergence and the introduction of a second problem enable us to find an equation verified by the weak limit of the distribution function.


2011 ◽  
Vol 78 (4) ◽  
pp. 323-326
Author(s):  
C. M. WANG

AbstractOne of the main limitations of energy gain in laser wakefield accelerators is the electron dephasing, In order to resolve the dephasing problem, a tapered plasma channel is proposed and tested numerically. The tapered density is created by means of a laser heating, combining an axially increased external magnetic field. The locally strong magnetic field prevents the thermal energy transport crossing the field lines, and leads to a pressure buildup. The pressure gradient expels the plasma radially and tapers the density axially. A tapered plasma with a density contrast of 2.2 within a 6-cm channel is established. Propagating in the tapered plasma channel, the energy of an accelerated electron is expected to be enhanced greatly.


Sign in / Sign up

Export Citation Format

Share Document