Effects of Different Working Fluid by Using of Waste Heat Obtained from Coal-Fired Units in Organic Rankine Cycles

2014 ◽  
Vol 1070-1072 ◽  
pp. 1790-1793
Author(s):  
Wei Ting Jiang ◽  
Xin Zhao ◽  
Wei Guo Pan ◽  
Xiao Yong Zhang ◽  
Jian Wen Xiong ◽  
...  
Keyword(s):  
Power Plant ◽  
Flue Gas ◽  
Thermal Efficiency ◽  
Waste Heat ◽  
Thermodynamic Cycle ◽  
Working Fluid ◽  
Power Ratio ◽  
First Law Of Thermodynamics ◽  
Working Medium ◽  
Organic Rankine Cycles

The characteristics of working medium is one of the important factors for organic Rankine cycle.The study is based on the waste heat of power plant,7 kinds working medium are selected,include R245fa, R600, R600a, R601a, R236fa, R236ea and RC318.ORC's thermodynamic cycle characteristics are calculated based on the first law of thermodynamics,then,compared the thermal efficiency,evaporating pressure and power ratio of different working medium.Results show that R245fa and R601a as the ORC system working medium have higher thermal efficiency and power ratio,and lower evaporating pressure than other five working medium,are ideal organic working medium to recycle flue gas waste heat of power plant.Secondly,R600 as system cycle working medium also has relatively good performance,can be the appropriate choice of working medium.

scholarly journals Perancangan Siklus Rankine Organik Untuk Pemanfaatan Gas Buang Pada PLTU di Indonesia

2017 ◽  
Vol 1 (2) ◽  
Author(s):  
Mohammad Azis M
Keyword(s):  
Power Plant ◽  
Flue Gas ◽  
Alternative Energy ◽  
Waste Heat ◽  
Human Life ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Coal Power Plant ◽  
Coal Power

ABSTRAKEnergi merupakan kebutuhan pada kehidupan manusia. Sumber energi fossil yang digunakan untuk memenuhi kebutuhan energi semakin lama semakin menipis. Sehingga diperlukan sumber energi alternatif atau peningkatan efisiensi dalam pemanfaatan energi. Panas buang merupakan salah satu sumber energi alternatif. Pemanfaatan panas buang salah satunya adalah dengan menggunakan siklus rankine organik. PLTU memiliki panas buang yang berpotensi untuk dimanfaatkan. Temperatur gas buang pada PLTU yang rata-rata sebesar 150 oC. Proses perancangan dilakukan untuk memanfaatkan panas buang hasil pembakaran. Hasil perancangan sistem siklus rankine organik mampu menghasilkan daya sebesar 6053 kW (R142b), 5705 kW (R123), dan 5502 (Isopentane) serta efisiensi sebesar 18.54%, 18.51%, dan 17.85% untuk fluida kerja R142b, R123, dan Isopentane.Kata kunci: siklus rankine organik, gas buang, panas sisa ABSTRACTEnergy is needeed for human life. Fossil energy which used to fulfill our needs is diminished. So, alternative energy source is used. Waste heat are one of a kind energy alternative source. Organic rankine cycle can be used to utilitze waste heat. Coal power plant which have flue gas to utilized. Average flue gas temperature in coal power plant are 150 oC. Design process to utilize waste heat has been conducted. The power produced in the system are 6053 kW, 5705 kW, and 5502 kWalso the efficiency are 18.54%, 18,51%, and 17,85% for working fluid R142b, R123, and Isopentane respectively.Keyword: organic rankine cycle, waste heat, flue gas 

Optimization of a Novel Combined Power/Refrigeration Thermodynamic Cycle

Solar Energy ◽  
2002 ◽  
Author(s):  
Shaoguang Lu ◽  
D. Yogi Goswami
Keyword(s):  
Waste Heat ◽  
Thermodynamic Cycle ◽  
Cycle Performance ◽  
Working Fluid ◽  
Second Law ◽  
Optimum Conditions ◽  
Ambient Temperatures ◽  
Reduced Gradient ◽  
Generalized Reduced Gradient ◽  
Performance Conditions

A novel combined power/refrigeration thermodynamic cycle is optimized for thermal performance in this paper. The cycle uses ammonia-water binary mixture as a working fluid and can be driven by various heat sources, such as solar, geothermal and low temperature waste heat. It could produce power as well as refrigeration with power output as a primary goal. The optimization program, which is based on the Generalized Reduced Gradient (GRG) algorithm, can be used to optimize for different objective functions. Examples that maximize second law efficiency, work output and refrigeration output are presented, showing the cycle may be optimized for any desired performance parameter. In addition, cycle performance over a range of ambient temperatures was investigated. It was found that for a source temperature of 360K, which is in the range of flat plate solar collectors, both power and refrigeration outputs are achieved under optimum conditions. All performance parameters, including first and second law efficiencies, power and refrigeration output decrease as the ambient temperature goes up. On the other hand, for a source of 440K, optimum conditions do not provide any refrigeration. However, refrigeration can be obtained even for this temperature under non-optimum performance conditions.

Novel Combined Power and Cooling Thermodynamic Cycle for Low Temperature Heat Sources, Part II: Experimental Investigation

2003 ◽  
Vol 125 (2) ◽  
pp. 223-229 ◽  
Author(s):  
Gunnar Tamm ◽  
D. Yogi Goswami
Keyword(s):  
Low Temperature ◽  
System Analysis ◽  
Waste Heat ◽  
Thermal Power ◽  
Experimental System ◽  
Thermodynamic Cycle ◽  
Operating Conditions ◽  
Working Fluid ◽  
Water Mixture ◽  
Theoretical Simulation

A combined thermal power and cooling cycle proposed by Goswami is under intensive investigation, both theoretically and experimentally. The proposed cycle combines the Rankine and absorption refrigeration cycles, producing refrigeration while power is the primary goal. A binary ammonia-water mixture is used as the working fluid. This cycle can be used as a bottoming cycle using waste heat from a conventional power cycle or as an independent cycle using low temperature sources such as geothermal and solar energy. An experimental system was constructed to demonstrate the feasibility of the cycle and to compare the experimental results with the theoretical simulation. Results showed that the vapor generation and absorption condensation processes work experimentally, exhibiting expected trends, but with deviations from ideal and equilibrium modeling. The potential for combined turbine work and refrigeration output was evidenced in operating the system. Analysis of losses showed where improvements could be made, in preparation for further testing over a broader range of operating conditions.

scholarly journals Failure analysis of bolt fracture in GGH guide bearing end cover pressure plate in a thermal power plant

2021 ◽  
Vol 2125 (1) ◽  
pp. 012038
Author(s):  
Le Chen ◽  
Song Wang ◽  
Yang Xu ◽  
Siyuan Liu
Keyword(s):  
Power Plant ◽  
Flue Gas ◽  
Thermal Power Plant ◽  
Waste Heat ◽  
Thermal Power ◽  
Optical Microscope ◽  
Mechanical Analysis ◽  
Sem Analysis ◽  
Gas Purification ◽  
Fracture Failure

Abstract Gas gas reheater is an important device for waste heat recovery and flue gas purification in thermal power plant. In this paper, the fracture failure reason of pressing plate bolt of guide bearing end cover of flue gas reheater in thermal power plant is analyzed. The results of optical microscope analysis show that there is no obvious abnormality in the metallographic structure of the two guide bearing bolts. The mechanical analysis results show that the hardness value, tensile strength and yield strength meet the requirements of relevant standards. SEM analysis showed that the fracture began at the root of the thread. The research results can provide reference for the operation and maintenance of flue gas reheater in relevant enterprises.

scholarly journals Thermal and Economic Analysis of Multi-Effect Concentration System by Utilizing Waste Heat of Flue Gas for Magnesium Desulfurization Wastewater

Energies ◽  
2020 ◽  
Vol 13 (20) ◽  
pp. 5384 ◽  
Author(s):  
Mingwei Yan ◽  
Yuetao Shi
Keyword(s):  
Wastewater Treatment ◽  
Power Plant ◽  
Economic Analysis ◽  
Magnesium Sulfate ◽  
Flue Gas ◽  
Power Plants ◽  
Waste Heat ◽  
Optimization System ◽  
Benchmark System ◽  
Better Than

Compared with limestone-based wet flue gas desulfurization (WFGD), magnesia-based WFGD has many advantages, but it is not popular in China, due to the lack of good wastewater treatment schemes. This paper proposes the wastewater treatment scheme of selling magnesium sulfate concentrate, and makes thermal and economic analysis for different concentration systems in the scheme. Comparisons of different concentration systems for 300 MW power plant were made to determine which system is the best. The results show that the parallel-feed benchmark system is better than the forward-feed benchmark system, and the parallel-feed optimization system with the 7-process is better than other parallel-feed optimization systems. Analyses of the parallel-feed optimization system with 7-process were made in 300, 600, and 1000 MW power plants. The results show that the annual profit of concentration system for a 300, 600, and 1000 MW power plant is about 2.58 million, 5.35 million, and 7.89 million Chinese Yuan (CNY), respectively. In different concentration systems of the scheme for selling magnesium sulfate concentrate, the parallel-feed optimization system with the 7-process has the best performance. The scheme can make a good profit in 300, 600, and 1000 MW power plants, and it is very helpful for promoting magnesia-based WFGD in China.

A Novel Combined Power and Cooling Thermodynamic Cycle for Low Temperature Heat Sources: Part II — Experimental Investigation

Solar Energy ◽  
2002 ◽  
Author(s):  
Gunmar Tamm ◽  
D. Yogi Goswami
Keyword(s):  
Low Temperature ◽  
System Analysis ◽  
Waste Heat ◽  
Thermal Power ◽  
Experimental System ◽  
Thermodynamic Cycle ◽  
Working Fluid ◽  
Water Mixture ◽  
Theoretical Simulation ◽  
Intensive Investigation

A combined thermal power and cooling cycle proposed by Goswami is under intensive investigation, both theoretically and experimentally. The proposed cycle combines the Rankine and absorption refrigeration cycles, producing refrigeration while power is the primary goal. A binary ammonia-water mixture is used as the working fluid. This cycle can be used as a bottoming cycle using waste heat from a conventional power cycle or an independent cycle using low temperature sources such as geothermal and solar energy. An experimental system was constructed to demonstrate the feasibility of the cycle and to compare the experimental results with the theoretical simulation. Results showed that the vapor generation and absorption condensation processes work experimentally, exhibiting expected trends, but with deviations from ideal and equilibrium modeling. The potential for combined turbine work and refrigeration output was evidenced in operating the system. Analysis of losses showed where improvements could be made, in preparation for further testing over a broader range of operating parameters.

Application of a low pressure economizer for waste heat recovery from the exhaust flue gas in a 600 MW power plant

Energy ◽  
2012 ◽  
Vol 48 (1) ◽  
pp. 196-202 ◽  
Author(s):  
Chaojun Wang ◽  
Boshu He ◽  
Shaoyang Sun ◽  
Ying Wu ◽  
Na Yan ◽  
...  
Keyword(s):  
Power Plant ◽  
Flue Gas ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Low Pressure

Discussion and Analysis on Effect of Hot Secondary Air Governance Gypsum Rain on the Power Plant Unit

2013 ◽  
Vol 864-867 ◽  
pp. 1798-1803 ◽  
Author(s):  
Kun Lu ◽  
Da Wei Chen ◽  
Zhuang Li
Keyword(s):  
Power Plant ◽  
Flue Gas ◽  
Thermal Efficiency ◽  
Exhaust Gas ◽  
Coal Consumption ◽  
Hot Air ◽  
Secondary Air

For gypsum rain phenomenon in limestone-gypsum wet desulfurization system. This article made programme that has used unit existing equipment allowance. Extracted hot secondary air to heat purified flue gas to eliminate "gypsum rain". This programme is implemented which makes temperature of purified flue gas rising to 70 °C. That almost eliminate "gypsum rain" phenomenon. While temperature of boiler exhaust gas declined, and temperature of hot air reduced, and boiler thermal efficiency declined, unit of power coal consumption rosed. Comparing to other programmes, this programme has a larger advantage in technology, economic, and security aspects.

Sign in / Sign up

Export Citation Format

Share Document