Study of Surface Hardening to Injectors of Gasoline

2012 ◽  
Vol 538-541 ◽  
pp. 239-242 ◽  
Author(s):  
Noe López-Perrusquia ◽  
Marco Antonio Doñu-Ruíz ◽  
J.V. Cortes-Suarez ◽  
L. D. Rosado-Cruz ◽  
David Sanchez-Huitron
Keyword(s):  
Surface Treatment ◽  
Surface Hardening ◽  
Boride Layer ◽  
Fuel Injector ◽  
X Ray Diffraction ◽  
Aisi 304 ◽  
X Ray ◽  
Type Layer ◽  
Useful Life

This paper studies the formation of boride layers on substrate injector combustion AISI 304 per nozzle surface treatment in addition the formation of hard layers and FeB type Fe2B were obtained in a temperature range of 1223 and 1273 K with exposure times of 1/2, 1, 3 and 5 h. The study consisted boride type layer formed on the surface and the characterization of the boride layer were evaluated by the method by analysis of X-ray diffraction (XRD), the distribution of the alloying elements were detected by spectrometry energy Dispersive (EDS) inside the surface, the evaluation of adhesion of the layers was determined by the technique Rockwell-C hardness was also evaluated and the Young's modulus of the layer by the nanoindentation technique with the load of 200 mN. Finally this study hardening fuel injector; is desired increase its useful life.

Boriding of Binary Ni–Ti Shape Memory Alloys

2016 ◽  
Vol 71 (11) ◽  
pp. 1017-1020
Author(s):  
Nazim Ucar ◽  
Sule Dogan ◽  
Mustafa Serdar Karakas ◽  
Adnan Calik
Keyword(s):  
Shape Memory Alloys ◽  
Shape Memory ◽  
Solid Medium ◽  
High Hardness ◽  
Boride Layer ◽  
Growth Rate Constant ◽  
X Ray Diffraction ◽  
X Ray ◽  
Parabolic Relationship

AbstractBoriding of binary Ni–Ti shape memory alloys was carried out in a solid medium at 1273 K for 2, 4, 6, and 8 h using the powder pack method with proprietary Ekabor–Ni powders. Characterization of the boride layer formed on the surface of alloys was done by optical microscopy and scanning electron microscopy. The presence of boride, silicide, and borosilicide phases in the boride layers was confirmed by X-ray diffraction analysis. The thickness and microhardness of the boride layers increased with increasing boriding time. Hardness profiles showed a rapid decrease in hardness moving from the boride layer to the main structure. The high hardness of the boride layer was attributed mainly to the formation of TiB2. A parabolic relationship was observed between layer thickness and boriding time, and the growth rate constant for the boriding treatment was calculated as 0.62×10−8 cm2 s−1.

The Use of Advanced Analytical Techniques for Characterization of the Chemical, Physical, and Crystallographic Nature of a Surface

1973 ◽  
Vol 31 ◽  
pp. 132-133 ◽  
Author(s):  
R. E. Herfert
Keyword(s):  
Surface Characterization ◽  
Analytical Techniques ◽  
X Ray Diffraction ◽  
Depth Of Penetration ◽  
X Ray ◽  
The Past ◽  
Transmission Electron ◽  
Scanning Electron

Studies of the nature of a surface, either metallic or nonmetallic, in the past, have been limited to the instrumentation available for these measurements. In the past, optical microscopy, replica transmission electron microscopy, electron or X-ray diffraction and optical or X-ray spectroscopy have provided the means of surface characterization. Actually, some of these techniques are not purely surface; the depth of penetration may be a few thousands of an inch. Within the last five years, instrumentation has been made available which now makes it practical for use to study the outer few 100A of layers and characterize it completely from a chemical, physical, and crystallographic standpoint. The scanning electron microscope (SEM) provides a means of viewing the surface of a material in situ to magnifications as high as 250,000X.

High Resolution Replication of Organoclay Surfaces

1982 ◽  
Vol 40 ◽  
pp. 576-577
Author(s):  
W. W. Barker ◽  
W. E. Rigsby ◽  
V. J. Hurst ◽  
W. J. Humphreys
Keyword(s):  
Clay Mineral ◽  
Organic Molecule ◽  
Organic Molecules ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
X Ray ◽  
Naturally Occurring ◽  
Silicate Layers ◽  
Mineral Identification

Experimental clay mineral-organic molecule complexes long have been known and some of them have been extensively studied by X-ray diffraction methods. The organic molecules are adsorbed onto the surfaces of the clay minerals, or intercalated between the silicate layers. Natural organo-clays also are widely recognized but generally have not been well characterized. Widely used techniques for clay mineral identification involve treatment of the sample with H2 O2 or other oxidant to destroy any associated organics. This generally simplifies and intensifies the XRD pattern of the clay residue, but helps little with the characterization of the original organoclay. Adequate techniques for the direct observation of synthetic and naturally occurring organoclays are yet to be developed.

Synthesis and characterization of TiN / Ti / AISI 410 coatings

2018 ◽  
Vol 2 (1) ◽  
pp. 7
Author(s):  
S Chirino ◽  
Jaime Diaz ◽  
N Monteblanco ◽  
E Valderrama
Keyword(s):  
Synthesis And Characterization ◽  
Photoemission Spectroscopy ◽  
X Ray Diffraction ◽  
X Ray ◽  
Columnar Grains ◽  
Tin Thin Films ◽  
Steel Aisi ◽  
Interacting Surfaces ◽  
Stainless Steel Aisi

The synthesis and characterization of Ti and TiN thin films of different thicknesses was carried out on a martensitic stainless steel AISI 410 substrate used for tool manufacturing. The mechanical parameters between the interacting surfaces such as thickness, adhesion and hardness were measured. By means of the scanning electron microscope (SEM) the superficial morphology of the Ti/TiN interface was observed, finding that the growth was of columnar grains and by means of EDAX the existence of titanium was verified.  Using X-ray diffraction (XRD) it was possible to observe the presence of residual stresses (~ -3.1 GPa) due to the different crystalline phases in the coating. Under X-ray photoemission spectroscopy (XPS) it was possible to observe the molecular chemical composition of the coating surface, being Ti-N, Ti-N-O and Ti-O the predominant ones.

Studies on the Preparation, Characterization and Solubility of -Cyclodextrin-Roxythromycin Inclusion Complexes

2009 ◽  
Vol 2 (2) ◽  
pp. 523-530
Author(s):  
D. Nagasamy Venkatesh ◽  
S. Karthick ◽  
M. Umesh ◽  
G. Vivek ◽  
R.M. Valliappan ◽  
...  
Keyword(s):  
Dissolution Rate ◽  
Inclusion Complexes ◽  
Phase Solubility ◽  
X Ray Diffraction ◽  
Scanning Calorimetry ◽  
X Ray ◽  
Ir Studies ◽  
Poorly Soluble ◽  
Poorly Soluble Drug

Roxythromycin/ β-cyclodextrin (Roxy/ β-CD) dispersions were prepared with a view to study the influence of β-CD on the solubility and dissolution rate of this poorly soluble drug. Phase-solubility profile indicated that the solubility of roxythromycin was significantly increased in the presence of β-cyclodextrin and was classified as AL-type, indicating the 1:1 stoichiometric inclusion complexes. Physical characterization of the prepared systems was carried out by differential scanning calorimetry (DSC), X-ray diffraction studies (XRD) and IR studies. Solid state characterization of the drug β-CD binary system using XRD, FTIR and DSC revealed distinct loss of drug crystallinity in the formulation, ostensibly accounting for enhancement of dissolution rate.

New Coordination Compounds of Fe(III) with Organic Ligands

2009 ◽  
Vol 59 (12) ◽  
Author(s):  
Mihaela Flondor ◽  
Ioan Rosca ◽  
Doina Sibiescu ◽  
Mihaela-Aurelia Vizitiu ◽  
Daniel-Mircea Sutiman ◽  
...  
Keyword(s):  
Chemical Analysis ◽  
Complex Compounds ◽  
Organic Ligands ◽  
X Ray Diffraction ◽  
X Ray ◽  
Elemental Chemical Analysis ◽  
Structural Formulae ◽  
Paramagnetic Properties

In this paper the synthesis and the study of some complex compounds of Fe(III) with ligands derived from: 2-(4-chloro-phenylsulfanyl)-1-(2-hydroxy-3,5-diiodo-phenyl)-ethanone (HL1), 1-(3,5-dibromo-2-hydroxy-phenyl)-2-phenylsulfanyl-ethanone(HL2), and 2-(4-chloro-phenylsulfanyl)-1-(3,5-dibromo-2-hydroxy-phenyl)-ethanone (HL3) is presented. The characterization of these complexes is based on method as: the elemental chemical analysis, IR and ESR spectroscopy, M�ssbauer, the thermogravimetric analysis and X-ray diffraction. Study of the IR and chemical analysis has evidenced that the precipitates form are a complexes and the combination ratio of M:L is 1:2. The central atoms of Fe(III) presented paramagnetic properties and a octaedric hybridization. Starting from this precipitation reactions, a method for the gravimetric determination of Fe(III) with this organic ligands has been possible. Based on the experimental data on literature indications, the structural formulae of the complex compounds are assigned.

scholarly journals New Insights into the Crystal Chemistry of Elpidite, Na2Zr[Si6O15]·3H2O and (Na1+YCax□1−X−Y)Σ=2Zr[Si6O15]·(3−X)H2O, and Ab Initio Modeling of IR Spectra

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2160
Author(s):  
Alexander Bogdanov ◽  
Ekaterina Kaneva ◽  
Roman Shendrik
Keyword(s):  
Ir Spectra ◽  
Structural Models ◽  
Chemical Characterization ◽  
Chemical Compositions ◽  
X Ray Diffraction ◽  
Special Group ◽  
X Ray ◽  
Influence Of Water ◽  
Radioactive Species

Elpidite belongs to a special group of microporous zirconosilicates, which are of great interest due to their capability to uptake various molecules and ions, e.g., some radioactive species, in their structural voids. The results of a combined electron probe microanalysis and single-crystal X-ray diffraction study of the crystals of elpidite from Burpala (Russia) and Khan-Bogdo (Mongolia) deposits are reported. Some differences in the chemical compositions are observed and substitution at several structural positions within the structure of the compounds are noted. Based on the obtained results, a detailed crystal–chemical characterization of the elpidites under study was carried out. Three different structure models of elpidite were simulated: Na2ZrSi6O15·3H2O (related to the structure of Russian elpidite), partly Ca-replaced Na1.5Ca0.25ZrSi6O15·2.75H2O (close to elpidite from Mongolia), and a hypothetical CaZrSi6O15·2H2O. The vibration spectra of the models were obtained and compared with the experimental one, taken from the literature. The strong influence of water molecule vibrations on the shape of IR spectra of studied structural models of elpidite is discussed in the paper.

Sign in / Sign up

Export Citation Format

Share Document