scholarly journals Tunable Floating Resistor Based on Current Inverting Differential Input Transconductance Amplifier

2020 ◽  
Vol 11 (05) ◽  
pp. 51-56
Author(s):  
Zainab Haseeb ◽  
Dinesh Prasad ◽  
Mainuddin   ◽  
M. W. Akram
Keyword(s):  
Differential Input ◽  
Transconductance Amplifier

HIGH-FREQUENCY LINEAR MULTIPLE-OUTPUT CMOS TRANSCONDUCTANCE AMPLIFIER FOR CURRENT-MODE FILTERS

2006 ◽  
Vol 15 (05) ◽  
pp. 701-717 ◽  
Author(s):  
HSIAO WEI SU ◽  
YICHUANG SUN
Keyword(s):  
High Frequency ◽  
Dynamic Range ◽  
Low Voltage ◽  
Filter Design ◽  
Current Mode ◽  
Cmos Process ◽  
Common Mode ◽  
Differential Input ◽  
Transconductance Amplifier ◽  
Linear Differential

A high-frequency highly linear tunable CMOS multiple-output operational transconductance amplifier (MO-OTA) for fully balanced current-mode OTA and capacitor (OTA-C) filters is presented. The MO-OTA is based on the cross-coupled pairs at the input and provides two pairs of differential outputs. A simple common-mode feedback (CMFB) circuit to stabilize the DC output levels of the MO-OTA is also proposed and two such CMFB circuits are used by the MO-OTA. The proposed MO-OTA is suitable for relatively low voltage (2.5 V) applications as its circuit has only two MOS transistors between the supply and ground rails. Simulated in a TSMC 0.25 μm CMOS process using PSpice, the MO-OTA has at least ± 0.3 V linear differential input signal swing with a single 2.5 V power supply and operates up to 1 GHz frequency. The MO-OTA has a THD less than -46 dB for a differential input voltage of 0.9 Vp-p at 10 MHz, dynamic range (DR) at THD = -46 dB is over 50 dB, and power consumption (with the common-mode feedback circuit) is below 8 mW for the whole tuning range. A fully balanced multiple loop feedback current-mode OTA-C filter example using the proposed MO-OTA is presented. This example also shows that the current-mode follow-the-leader-feedback (FLF) structure can achieve good performances for OTA-C filter design.

scholarly journals The voltage-mode first order universal filter using single voltage differencing differential input buffered amplifier with electronic controllability

2022 ◽  
Vol 12 (2) ◽  
pp. 1308
Author(s):  
Danupat Duangmalai ◽  
Peerawut Suwanjan
Keyword(s):  
Integrated Circuit ◽  
Universal Filter ◽  
Differential Input ◽  
First Order ◽  
Voltage Mode ◽  
Transconductance Amplifier ◽  
Low Pass ◽  
Simulation And Experiment ◽  
Electronically Tunable ◽  
High Pass

In this research contribution, the electronically tunable first-order universal filter employing a single voltage differencing differential input buffered amplifier (VD-DIBA) (constructed from two commercially available integrated circuit (IC): the operational transconductance amplifier, IC number LT1228, and the differential voltage input buffer, IC number AD830), one capacitor and two resistors. The features of the designed first order universal filter are as follows. Three voltage-mode first-order functions, low-pass (LP), all-pass (AP) and high-pass (HP) responses are given. The natural frequency (𝜔0) of the presented configuration can be electronically adjusted by setting the DC bias current. Moreover, the voltage gain of the LP and HP filters can be controllable. The phase responses of an AP configuration can be varied from 00 to −1800 and 1800 to 00. The power supply voltages were set at ±5 𝑉. Verification of the theoretically described performances of the introduced electronically tunable universal filter was proved by the PSpice simulation and experiment.

Novel CMOS Current Inverting Differential Input Transconductance Amplifier and Its Application

2016 ◽  
Vol 26 (01) ◽  
pp. 1750010 ◽  
Author(s):  
Atul Kumar ◽  
Bhartendu Chaturvedi
Keyword(s):  
Active Element ◽  
Complementary Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Operating Voltage ◽  
Performance Parameters ◽  
Quadrature Oscillator ◽  
Differential Input ◽  
Transconductance Amplifier ◽  
Electronically Controllable ◽  
Cmos Implementation

This paper presents the complementary metal oxide semiconductor (CMOS) implementation of active building block, namely, current inverting differential input transconductance amplifier (CIDITA) along with its performance parameters. The detailed study of the proposed CMOS CIDITA has been incorporated. The presented study shows the good performance of CIDITA in terms of good bandwidth range, good linear range of input current, high accuracy and low operating voltage. A new circuit of single active element-based quadrature oscillator is further realized to explore the workability of CIDITA. The proposed circuit of quadrature oscillator employs two grounded capacitors, one resistor and single CIDITA. The proposed quadrature oscillator provides both quadrature current outputs and quadrature voltage outputs simultaneously. The frequency of oscillation of the proposed quadrature oscillator is electronically controllable. The possible practical realization of the CIDITA using commercially available ICs is also given. HSPICE simulation results using 0.18[Formula: see text][Formula: see text]m CMOS parameters are given to validate the proposed theory.

Sign in / Sign up

Export Citation Format

Share Document