scholarly journals Negative Resistance and Its Impact on a RC-DC Driven Electric Circuit

2021 ◽  
Vol 13 (07) ◽  
pp. 103-110
Author(s):  
Haiduke Sarafian
Keyword(s):  
Electric Circuit ◽  
Negative Resistance

Automation of Two-Stage Factor VIII Assay

1978 ◽  
Vol 39 (02) ◽  
pp. 455-465 ◽  
Author(s):  
Yvonne Stirling ◽  
D J Howarth ◽  
Marguerite Vickers ◽  
W R S North ◽  
T W Meade
Keyword(s):  
Factor Viii ◽  
Optical Density ◽  
Electric Circuit ◽  
Clotting Time ◽  
Two Stage ◽  
Laboratory Error ◽  
Premature Closure ◽  
Factor Viii Concentrates ◽  
Experimental Findings ◽  
Automated Methods

SummaryTwo automated methods for two-stage factor VIII assays have been compared with one another, and evaluated in practice. The Depex method records the clotting time when an electric circuit is completed by the formation of a fibrin thread across a hook-type electrode; the Electra method is based on an optical density technique of clot detection. The two methods gave comparable results for measured levels of factor VIII when haemophilic or “normal” plasmas were assayed. Results from the two methods in practice also suggest that both are valid at low and “normal” factor VIII levels. The Electra method is also probably suitable for assays of concentrates; however, the Depex method appears to give falsely high values in these circumstances, and experimental findings suggest that the reason may be that increased viscosity due to the high fibrinogen levels in factor VIII concentrates causes premature closure of the circuit between the two ends of the Depex electrode. The main advantage of the Depex method is that, provided 3 or 4 machines are available, a given number of assays can be completed more quickly than on Electra. The main advantages of Electra are that it is probably subject to less laboratory error than Depex, and that it is suitable for assaying concentrates as well as haemophilic and “normal” plasmas.

An hourglass-type electromagnetic isolator with negative resistance electromagnetic shunt circuit

2020 ◽  
Vol 64 (1-4) ◽  
pp. 549-556
Author(s):  
Yajun Luo ◽  
Linwei Ji ◽  
Yahong Zhang ◽  
Minglong Xu ◽  
Xinong Zhang
Keyword(s):  
Vibration Isolation ◽  
Electromechanical Coupling ◽  
Coupling Effect ◽  
Negative Resistance ◽  
Isolation System ◽  
Amplitude Vibration ◽  
Vibration Responses ◽  
The Stability ◽  
Isolation Performance ◽  
Shunt Circuit

The present work proposed an hourglass-type electromagnetic isolator with negative resistance (NR) shunt circuit to achieve the effective suppression of the micro-amplitude vibration response in various advanced instruments and equipment. By innovatively design of combining the displacement amplifier and the NR electromagnetic shunt circuit, the current new type of vibration isolator not only can effectively solve the problem of micro-amplitude vibration control, but also has significant electromechanical coupling effect, to obtain excellent vibration isolation performance. The design of the isolator and motion relationship is presented firstly. The electromechanical coupling dynamic model of the isolator is also given. Moreover, the optimal design of the NR electromagnetic shunt circuit and the stability analysis of the vibration isolation system are carried out. Finally, the simulation results about the transfer function and vibration responses demonstrated that the isolator has a significant isolation performance.

Low Current Consumption of Multiple-Valued SRAM Using Λ-Shaped Negative Resistance Devices

2011 ◽  
Vol 131 (3) ◽  
pp. 528-534
Author(s):  
Katsutoshi Saeki ◽  
Yoshiki Sasaki ◽  
Yoshifumi Sekine
Keyword(s):  
Negative Resistance ◽  
Current Consumption

Degradation Analysis of Thick Film Chip Resistors

2009 ◽  
Author(s):  
Bhanu Sood ◽  
Diganta Das ◽  
Michael H. Azarian ◽  
Michael Pecht
Keyword(s):  
Thick Film ◽  
Printed Circuit Board ◽  
Negative Resistance ◽  
Circuit Board ◽  
High Humidity ◽  
Circuit Boards ◽  
Chemical Modifications ◽  
Current Leakage ◽  
Printed Circuit ◽  
Degradation Analysis

Abstract Negative resistance drift in thick film chip resistors in high temperature and high humidity application conditions was investigated. This paper reports on the investigation of possible causes including formation of current leakage paths on the printed circuit board, delamination between the resistor protective coating and laser trim, and the possibility of silver migration or copper dendrite formation. Analysis was performed on a set of circuit boards exhibiting failures due to this phenomenon. Electrical tests after mechanical and chemical modifications showed that the drift was most likely caused by moisture ingress that created a conductive path across the laser trim.

Thin-film magnetoresistive current sensors

2019 ◽  
pp. 59-64
Author(s):  
V. I. Sukhanov ◽  
A. B. Grabov
Keyword(s):  
Thin Film ◽  
Electric Circuit ◽  
Current Control ◽  
Electronic Apparatus ◽  
Current Sensors

The article presents some features of thin-film magnetoresistive current sensors and detectors that was developed in JSC NPO IT for noncontact current control in electric circuit aviation and cosmic electronic apparatus.

МАКРОМОДЕЛИРОВАНИЕ СХЕМЫ ФАПЧ С ИСПОЛЬЗОВАНИЕМ ПОЛНОЙ ПРИНЦИПИАЛЬНОЙ СХЕМЫ ФАЗОВОГО ДЕТЕКТОРА

2020 ◽  
Vol 96 (3s) ◽  
pp. 295-299
Author(s):  
М.М. Гурарий ◽  
М.М. Жаров ◽  
Л.П. Ионов ◽  
И.И. Мухин ◽  
С.Г. Русаков ◽  
...  
Keyword(s):  
Electric Circuit ◽  
Schematic Diagram ◽  
Equivalent Electric Circuit ◽  
Phase Frequency Detector ◽  
Frequency Detector ◽  
A Current

В работе рассмотрены проблемы анализа схем ФАПЧ с учетом наличия неидеальностей в схеме частотно-фазового детектора с токовым ключом. Для снижения затрат на моделирование предложено использовать эквивалентную электрическую схему, содержащую полную принципиальную схему ЧФД и схемные эквиваленты макромоделей остальных блоков ФАПЧ. The paper considers the problems of analyzing the PLL circuit taking into account the presence of nonidealities in the phase-frequency detector with a current key. To reduce the simulation efforts, it has been proposed to apply an equivalent electric circuit containing the complete schematic diagram of the PFD and circuit equivalents of the macromodels of other PLL blocks.

Two-Phase Short Circuit in the Power Grid Powered by a Transformer with a Y/Δ-11 Winding Connection

2020 ◽  
pp. 25-30
Author(s):  
Aleksandr S. Serebryakov ◽  
Vladimir L. Osokin ◽  
Sergey A. Kapustkin
Keyword(s):  
High Speed ◽  
Short Circuit ◽  
Relay Protection ◽  
Electric Circuit ◽  
Operational Reliability ◽  
Research Purpose ◽  
Industrial Complex ◽  
Two Phase ◽  
Short Circuit Currents ◽  
Secondary Winding

The article describes main provisions and relations for calculating short-circuit currents and phase currents in a three-phase traction transformer with a star-triangle-11 connection of windings, which feeds two single-phase loads in AC traction networks with a nominal voltage of 25 kilovolts. These transformers provide power to the enterprises of the agro-industrial complex located along the railway line. (Research purpose) The research purpose is in substantiating theoretical equations for digital intelligent relay protection in two-phase short circuits. (Materials and methods) It was found that since the sum of instantaneous currents in each phase is zero, each phase of the transformer works independently. We found that this significantly simplifies the task of analyzing processes with a two-phase short circuit. In this case, the problem of calculating short-circuit currents in the traction network can be simplified by reducing it to the calculation of an ordinary electric circuit with three unknown currents. (Results and discussion) The article describes equations for calculating short-circuit resistances for one phase of the transformer when connecting the secondary winding as a star or a triangle. The currents in the phases of the transformer winding at short circuit for the star-triangle-11 and star-star-with-ground schemes are compared. It was found that when calculating short-circuit currents, there is no need to convert the secondary winding of the traction transformer from a triangle to a star. (Conclusions) It was found that the results of the research can be used in the transition of relay protection systems from electromagnetic relays to modern high-speed digital devices, which will increase the operational reliability of power supply systems for traction and non-traction power consumers.

Sign in / Sign up

Export Citation Format

Share Document