Effect of LPG Intake Temperature, Pilot Fuel and Injection Timing on the Combustion Characteristics and Emission of a LPG - Diesel Dual Fuel Engine

2001 ◽  
Author(s):  
P. Mohanan ◽  
Y Suresh Kumar
Keyword(s):  
Combustion Characteristics ◽  
Dual Fuel ◽  
Injection Timing ◽  
Pilot Fuel

Performance of Dual Fuel Engine Running on Jojoba Oil as Pilot Fuel and CNG or LPG

2007 ◽  
Author(s):  
Mohamed Y. E. Selim ◽  
M. S. Radwan ◽  
H. E. Saleh
Keyword(s):  
Methyl Ester ◽  
Natural Gas ◽  
Pressure Rise ◽  
Combustion Noise ◽  
Dual Fuel ◽  
Maximum Pressure ◽  
Injection Timing ◽  
Pressure Rise Rate ◽  
Rise Rate ◽  
Pilot Fuel

The use of Jojoba Methyl Ester as a pilot fuel was investigated for almost the first time as a way to improve the performance of dual fuel engine running on natural gas or LPG at part load. The dual fuel engine used was Ricardo E6 variable compression diesel engine and it used either compressed natural gas (CNG) or liquefied petroleum gas (LPG) as the main fuel and Jojoba Methyl Ester as a pilot fuel. Diesel fuel was used as a reference fuel for the dual fuel engine results. During the experimental tests, the following have been measured: engine efficiency in terms of specific fuel consumption, brake power output, combustion noise in terms of maximum pressure rise rate and maximum pressure, exhaust emissions in terms of carbon monoxide and hydrocarbons, knocking limits in terms of maximum torque at onset of knocking, and cyclic data of 100 engine cycle in terms of maximum pressure and its pressure rise rate. The tests examined the following engine parameters: gaseous fuel type, engine speed and load, pilot fuel injection timing, pilot fuel mass and compression ratio. Results showed that using the Jojoba fuel with its improved properties has improved the dual fuel engine performance, reduced the combustion noise, extended knocking limits and reduced the cyclic variability of the combustion.

scholarly journals Assessment of late pilot injection effect in dual-fuel combustion

2020 ◽  
Vol 197 ◽  
pp. 06010
Author(s):  
Antonio Caricato ◽  
Antonio Paolo Carlucci ◽  
Antonio Ficarella ◽  
Luciano Strafella
Keyword(s):  
Injection Pressure ◽  
Dual Fuel ◽  
Injection Timing ◽  
Pilot Injection ◽  
Compression Ignition Engine ◽  
Engine Load ◽  
Pilot Fuel ◽  
Dual Fuel Combustion ◽  
Cylinder Compression ◽  
Injection Effect

In this paper, the effect of late injection on combustion and emission levels has been investigated on a single cylinder compression ignition engine operated in dual-fuel mode injecting methane along the intake duct and igniting it through a pilot fuel injected directly into the combustion chamber. During the tests, the amount of pilot fuel injected per cycle has been kept constant, while the amount of methane has been varied on three levels. Therefore, three levels of engine load have been tested, while speed has been kept constant equal to 1500rpm. Pilot injection pressure has been varied on three set points, namely 500, 1000 and 1500 bar. For each engine load and injection pressure, pilot injection timing has been swept on a very broad range of values, spanning from very advanced to very late values. The analysis of heat release rate indicates that MK-like conditions are established in dual-fuel mode with late pilot injection. In these conditions, pollutant species, and NOx levels in particular, are significantly reduced without penalization – and in several conditions with improvement – on fuel conversion efficiency.

scholarly journals Comparison of performance of biodiesels of mahua oil and gingili oil in dual fuel engine

2008 ◽  
Vol 12 (1) ◽  
pp. 151-156 ◽  
Author(s):  
Kapilan Nadar ◽  
Pratap Reddy ◽  
Rao Anjuri
Keyword(s):  
Carbon Monoxide ◽  
Methyl Ester ◽  
Dual Fuel ◽  
Injection Timing ◽  
Nox Emissions ◽  
Test Results ◽  
Liquefied Petroleum Gas ◽  
Mahua Oil ◽  
Hydro Carbon ◽  
Pilot Fuel

In this work, an experimental work was carried out to compare the performance of biodiesels made from non edible mahua oil and edible gingili oil in dual fuel engine. A single cylinder diesel engine was modified to work in dual fuel mode and liquefied petroleum gas was used as primary fuel. Biodiesel was prepared by transesterification process and mahua oil methyl ester (MOME) and gingili oil methyl ester (GOME) were used as pilot fuels. The viscosity of MOME is slightly higher than GOME. The dual fuel engine runs smoothly with MOME and GOME. The test results show that the performance of the MOME is close to GOME, at the pilot fuel quantity of 0.45 kg/h and at the advanced injection timing of 30 deg bTDC. Also it is observed that the smoke, carbon monoxide and unburnt hydro carbon emissions of GOME lower than the MOME. But the GOME results in slightly higher NOx emissions. From the experimental results it is concluded that the biodiesel made from mahua oil can be used as a substitute for diesel in dual fuel engine.

scholarly journals A Numerical Study on the Pilot Injection Conditions of a Marine 2-Stroke Lean-Burn Dual Fuel Engine

Processes ◽  
2020 ◽  
Vol 8 (11) ◽  
pp. 1396
Author(s):  
Hao Guo ◽  
Song Zhou ◽  
Jiaxuan Zou ◽  
Majed Shreka
Keyword(s):  
Natural Gas ◽  
Fuel Injection ◽  
Numerical Study ◽  
Pollutant Emissions ◽  
Dual Fuel ◽  
Injection Timing ◽  
Pilot Injection ◽  
Lean Burn ◽  
Injection Duration ◽  
Pilot Fuel

The global demand for clean fuels is increasing in order to meet the requirements of the International Maritime Organization (IMO) of 0.5% global Sulphur cap and Tier III emission limits. Natural gas has begun to be popularized on liquefied natural gas (LNG) ships because of its low cost and environment friendly. In large-bore marine engines, ignition with pilot fuel in the prechamber is a good way to reduce combustion variability and extend the lean-burn limit. However, the occurrence of knock limits the increase in power. Therefore, this paper investigates the effect of pilot fuel injection conditions on performance and knocking of a marine 2-stroke low-pressure dual-fuel (LP-DF) engine. The engine simulations were performed under different pilot fuel parameters. The results showed that the average in-cylinder temperature, the average in-cylinder pressure, and the NOx emissions gradually decreased with the delay of the pilot injection timing. Furthermore, the combustion situation gradually deteriorated as the pilot injection duration increased. A shorter pilot injection duration was beneficial to reduce NOx pollutant emissions. Moreover, the number of pilot injector orifices affected the ignition of pilot fuel and the flame propagation speed inside the combustion chamber.

Improving the Performance of a Biogas Powered Dual Fuel Diesel Engine Using Emulsified Rice Bran Biodiesel as Pilot Fuel Through Adjustment of Compression Ratio and Injection Timing

2015 ◽  
Vol 137 (9) ◽  
Author(s):  
Bhaskor J. Bora ◽  
Ujjwal K. Saha
Keyword(s):  
Diesel Engine ◽  
Rice Bran ◽  
Compression Ratio ◽  
Droplet Diameter ◽  
Dual Fuel ◽  
Injection Timing ◽  
Two Phase ◽  
Water Emulsion ◽  
Hydrophilic Lipophilic Balance ◽  
Pilot Fuel

Emulsification is one of the proven techniques to control the pollutants of the diesel engines. The present work attempts to explore the effect of injection timing (IT) of pilot fuel and compression ratio (CR) for an emulsified rice bran biodiesel (RBB)–biogas powered dual fuel diesel engine. A two-phase stable water emulsion of rice bran methyl ester has been prepared by optimizing the factors such as water content (5% and 10%), surfactants (3%), and hydrophilic lipophilic balance (HLB) values (4.3, 5, and 6). The stability of the emulsions is determined on the basis of measurement of mean droplet diameter and stability test. For experimentation, a 3.5 kW single cylinder, direct injection (DI), water cooled, variable CR diesel engine is converted into a biogas run dual fuel diesel engine by connecting a venturi gas mixer at the inlet manifold. A set of combinations comprising CRs of 18, 17.5, and 17, and ITs of 23 deg, 26 deg, 29 deg, and 32 deg before top dead centers (BTDC) at different loading conditions are considered. The investigation demonstrates a maximum brake thermal efficiency (BTE) of 23.62% along with a liquid fuel replacement of 82.22% at pilot fuel IT of 29 deg BTDC and CR of 18. For the same combination, CO and HC emissions are found to be least in all the test cases.

scholarly journals Effects of Injection Timing and Pilot Fuel on the Combustion of a Kerosene-diesel/Ammonia Dual Fuel Engine: A Numerical Study

2017 ◽  
Vol 105 ◽  
pp. 4621-4626 ◽  
Author(s):  
Kun Lin Tay ◽  
Wenming Yang ◽  
Siaw Kiang Chou ◽  
Dezhi Zhou ◽  
Jing Li ◽  
...  
Keyword(s):  
Numerical Study ◽  
Dual Fuel ◽  
Injection Timing ◽  
Pilot Fuel
Sign in / Sign up

Export Citation Format

Share Document