scholarly journals ACTIVATION OF WATER USED IN THE PREPARATION OF WHEAT GRAIN FOR VARIETAL MILLING

2021 ◽  
pp. 60-63
Keyword(s):  
Drinking Water ◽  
Electric Conductivity ◽  
Acoustic Waves ◽  
Water Resistance ◽  
Frequency Range ◽  
Wheat Grain ◽  
Optimal Range ◽  
Water Activation ◽  
Technological Indicator ◽  
Dissolved Salts

The purpose of the study is to change the properties of water in order to achieve the optimum impact on wheat grain in preparation for variety milling. The results of influence on the properties of drinking water by acoustic waves in the frequency range of 10-1000 Hz for 1 minute were determined. It is established that the optimal range of exposure is the interval of 80-100 Hz. At the same time water activation is achieved, leading to changes in its properties, such as specific water resistance, electric conductivity, content of dissolved salts, which positively affects the technological indicator - the amount of conductometric ash.

scholarly journals Classification Maps for TDS Concentrations in the GIS Along Euphrates River, Iraq

2021 ◽  
Vol 232 (8) ◽  
Author(s):  
Ali Chabuk ◽  
Zahraa Ali Hammood ◽  
Nadhir Al-Ansari ◽  
Salwan Ali Abed ◽  
Jan Laue
Keyword(s):  
Water Quality ◽  
Drinking Water ◽  
World Health Organization ◽  
World Health ◽  
Euphrates River ◽  
Poor Water Quality ◽  
Quality Category ◽  
Health Organization ◽  
Dissolved Salts

AbstractIraq currently undergoing the problem of water shortage, although Iraq has two Rivers (Euphrates and Tigris) pass throughout most of its areas, and they have represented a major source of water supply. In the current research, to evaluate the quality of the Euphrates river in Iraq based on the values of total dissolved salts (TDS), the TDS concentrations were collected from sixteen sections along the river in the three succeeding years (2011, 2012, and 2013). The evaluation of the river was done depending on the classification of (W.H.O. (World Health Organization). (2003). Total Dissolved Salts in Drinking-water: Background document for development of W.H.O. Guidelines for Drinking-water Quality. World Health Organization, 20 Avenue Appia, 1211 Geneva 27, Switzerland). of rivers for drinking uses. Inverse Distance Weighting Technique (IDWT) as a tool in the GIS was employed to establish the maps of the river that using interpolation/prediction for the TDS concentrations to each selected year and the average values of TDS for these 3 years. Based on the five categories of rivers’ classification of the TDS concentrations according to the (W.H.O. (World Health Organization). (2003). Total Dissolved Salts in Drinking-water: Background document for development of W.H.O. Guidelines for Drinking-water Quality. World Health Organization, 20 Avenue Appia, 1211 Geneva 27, Switzerland), the Euphrates river was classified, and the maps of classification for the years 2011, 2012 and 2013 and the average values for 3 years were created. The average values for 3 years of TDS along the Euphrates river indicated that the sections from SC-1 to SC-4 as moderate-water-quality-Category-3, the sections from SC-5 to SC-10 as poor-water-quality-Category-4, while the sections between SC-11 to SC-16 as very poor-water-quality-Category-5. The interpolation maps showed that the Euphrates river in Iraq was ranged from moderate water quality (Category-3) to very poor water quality (Category-5).

ANISOTROPY OF ATTENUATION OF ACOUSTIC WAVES IN PHOTOREFRACTIVE BSO AND BGO CRYSTALS

2018 ◽  
Vol 20 (4) ◽  
pp. 232-235
Author(s):  
F.R. Akhmedzhanov ◽  
U.A. Saidvaliev ◽  
J.O. Kurbanov
Keyword(s):  
Dielectric Loss ◽  
Acoustic Waves ◽  
Frequency Range ◽  
Anisotropy Parameters

Anisotropy of attenuation of acoustic waves in photorefractive BSO and BGO crystals has been studied in the frequency range of 0.4−1.6 GHz. The anisotropy parameters determined by the imaginary constants of BSO and BGO crystals are equal 0.58 and 0.52, respectively. It is shown that the most contribution of dielectric loss to the attenuation of acoustic waves is observed for the piezoactive transversal waves propagating in the (100) plane.

HIGH-PERFORMANCE SURFACE TRANSVERSE WAVE RESONATORS IN THE LOWER GHz FREQUENCY RANGE

2000 ◽  
Vol 10 (03) ◽  
pp. 735-792 ◽  
Author(s):  
IVAN D. AVRAMOV
Keyword(s):  
Phase Noise ◽  
Transverse Wave ◽  
High Power ◽  
Acoustic Waves ◽  
Power Efficiency ◽  
Surface Acoustic Waves ◽  
Low Noise ◽  
Propagation Loss ◽  
Range Data ◽  
Frequency Range

Since the first successful surface transverse wave (STW) resonator was demonstrated by Bagwell and Bray in 1987, STW resonant devices on temperature stable cut orientations of piezoelectric quartz have enjoyed a spectacular development. The tremendous interest in these devices is based on the fact that, compared to the widely used surface acoustic waves (SAW), the STW acoustic mode features some unique properties which makes it very attractive for low-noise microwave oscillator applications in the 1.0 to 3.0 GHz frequency range in which SAW based or dielectric resonator oscillators (DRO) fail to provide satisfactory performance. These STW properties include: high propagation velocity, material Q-values exceeding three times those of SAW and bulk acoustic waves (BAW) on quartz, low propagation loss, unprecedented 1/f device phase noise, extremely high power handling ability, as well as low aging and low vibration sensitivity. This paper reviews the fundamentals of STW propagation in resonant geometries on rotated Y-cuts of quartz and highlights important design aspects necessary for achieving desired STW resonator performance. Different designs of high- and low-Q, low-loss resonant devices and coupled resonator filters (CRF) in the 1.0 to 2.5 GHz range are characterized and discussed. Design details and data on state-of-the-art STW based fixed frequency and voltage controlled oscillators (VCO) with low phase noise and high power efficiency are presented. Finally, several applications of STW devices in GHz range data transmitters, receivers and sensors are described and discussed.

A novel acoustic imaging tool for monitoring the state of rapid sand filters

2013 ◽  
Vol 14 (1) ◽  
pp. 107-118
Author(s):  
Nihed Allouche ◽  
Dick G. Simons ◽  
Paul Keijzer ◽  
Luuk C. Rietveld ◽  
Joost Kappelhof
Keyword(s):  
Drinking Water ◽  
Water Treatment ◽  
Acoustic Waves ◽  
Vertical Direction ◽  
Drinking Water Treatment ◽  
The State ◽  
Acoustic Response ◽  
Sand Filters ◽  
Cleaning Procedure ◽  
Filter Bed

A new technology based on acoustic waves is developed to monitor the state of sand filters used in drinking water treatment. Changes in the sand filter, due to the removal of suspended particles from the water and their accumulation in the pores, result in an increase of the bulk density and acoustic speed of the granular material. Consequently, the reflected acoustic response changes as the filter is in use. To monitor these changes, an instrument composed of an omnidirectional transmitter and an array of hydrophones was built. With frequencies ranging between 10 and 110 kHz, high resolution is achieved in the vertical direction enabling the detectability of clogged layers with a minimum thickness of 1 cm. The novel instrument is tested by conducting a monitoring experiment in a filter used in practice. A 2D scan over a part of the filter was performed and repeated every 2 hours over a period of 10 days. An analysis of the data revealed a local increase of the reflected acoustic response with increasing filter run time. The changes in acoustic signal are mainly observed at the upper 5 cm of the sand bed. It is also clear that the filter bed is slowly compacting as a function of time. The total compaction after a period of 10 days reached 3.5 cm. The filter bed is expanded again during the cleaning procedure. Once the procedure is completed, the upper 30 cm of the filter becomes more transparent, showing small accumulations of material at greater depth. The observed changes in the filter bed demonstrate the potential of this acoustic-based tool to monitor the state of rapid sand filters and optimise their performance. The new tool can be used to evaluate the cleaning procedure and is valuable in detecting lateral variations in the filter bed. These variations may indicate local clogging that needs to be removed effectively to avoid deterioration of the overall performance in the long term. This type of information is difficult to obtain from the monitoring techniques currently used in drinking water treatment.

Ion- and electron-acoustic waves in sheet plasmas

1989 ◽  
Vol 41 (2) ◽  
pp. 281-287
Author(s):  
M. B. Chaudhry ◽  
M. D. Tahir
Keyword(s):  
Acoustic Waves ◽  
Cyclotron Frequency ◽  
Larmor Radius ◽  
Frequency Range ◽  
Ion Temperature ◽  
Temperature Ratio ◽  
Ion Acoustic Waves ◽  
Poisson Equations ◽  
Electron Acoustic Waves ◽  
Electron Acoustic

Ion-acoustic waves in sheet plasmas, which are of thickness of order of the ion Larmor radius ρi, have been investigated numerically. The frequency range considered is less than the ion cyclotron frequency ωci. An integral equation in wavenumber space is derived from the linearized Vlasov-Poisson equations and analysed numerically. Eigenfrequencies and eigenfunctions of the wave have been studied systematically by varying the plasma thickness, plasma density, electron-to-ion temperature ratio and parallel wavenumber. Electron-acoustic waves are found when the parallel wavenumber is very small (e.g. k∥ρi = 0·005) and the electron and ion temperatures are comparable.

Concealed Weapon Detection Using Acoustic Spectral Characterisation

2009 ◽  
Author(s):  
George A. Vadakkel ◽  
S. Olutunde Oyadiji
Keyword(s):  
Acoustic Signal ◽  
Acoustic Waves ◽  
Natural Frequencies ◽  
Sound Waves ◽  
Frequency Range ◽  
Ultrasonic Sound ◽  
Audible Frequency ◽  
Spectral Characterisation ◽  
Concealed Weapon Detection ◽  
Experimental Trials

This paper focuses on showing how one could identify a component by using acoustic waves within the audible frequency range. The purpose of this study is to incorporate the findings from this paper in concealed weapon detection (CWD) where objects hidden behind a person’s clothing could be detected using acoustic or ultrasonic sound waves. Experimental trials are carried out using a directional speaker which generates a highly directional acoustic beam. This can then be pointed at any target and the sound reflected from it analyzed. Initially, a sound source is selected based on the maximum frequency range. The characteristic of the acoustic signal produced by the source is then recorded to be used as reference. Different objects are selected to be used as targets. The sound reflected from these objects is recorded. The spectrograms from these targets reveal that the incident sound waves have been modulated. By taking the ratio of the reflected and the incident sound signals one could obtain the natural frequencies of the object and the spectrogram of the reflected acoustic signal could give indication of the object’s shape.

scholarly journals A diverse group of echogenic particles observed with a broadband, high frequency echosounder

2017 ◽  
Vol 75 (2) ◽  
pp. 471-482 ◽  
Author(s):  
Christian Briseño-Avena ◽  
Peter J S Franks ◽  
Paul L D Roberts ◽  
Jules S Jaffe
Keyword(s):  
Acoustic Waves ◽  
High Frequency ◽  
Sound Speed ◽  
Diverse Group ◽  
Marine Snow ◽  
Frequency Range ◽  
Coastal Regions ◽  
The Past ◽  
Potential Sources ◽  
Acoustic Surveys

Abstract In 1980, Holliday and Pieper stated: “Most sound scattering in the ocean volume can be traced to a biotic origin.” However, most of the bioacoustics research in the past three decades has focused on only a few groups of organisms. Targets such as small gelatinous organisms, marine snow, and phytoplankton, e.g. have been generally to be considered relatively transparent to acoustic waves due to their sizes and relatively low sound speed and density contrasts relative to seawater. However, using a broadband system (ZOOPS-O2) we found that these targets contributed significantly to acoustic returns in the 1.5–2.5 MHz frequency range. Given that phytoplankton and marine snow layers are ubiquitous features of coastal regions; this works suggests that they should be considered as potential sources of backscatter in biological acoustic surveys.

Sign in / Sign up

Export Citation Format

Share Document