The Analysis of Pigment Dispersion in Rubber by Means of Light Microscopy, Microradiography, and Electron Microscopy

1962 ◽  
Vol 35 (1) ◽  
pp. 228-249 ◽  
Author(s):  
William M. Hess
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Light Microscopy ◽  
Cross Sections ◽  
Tensile Specimen ◽  
Complete Analysis ◽  
Pigment Dispersion ◽  
X Ray ◽  
The Common ◽  
Dispersion Quality

Abstract The significance of these dispersion studies can be summarized as follows: 1) A simple but highly versatile liquid nitrogen freeze technique makes it possible to microtome pigment loaded rubber stocks into thin (0.05–0.1 microns, e.g.) cross sections for examination by means of light microscopy, microradiography or electron microscopy. All of the common elastomers including polybutadiene and silicone rubber have been successfully sectioned for each of these techniques. Thus the state of dispersion can readily be traced from coarse pigment agglomerates, a few hundred microns in size, down to the ultimate particles which can be below 20 millimicrons. 2) Through the use of one of the techniques described or by the coordinated use of all of them (“dispersion in depth”), most dispersion problems can be resolved. A very complete analysis of this type is often necessary to explain pigment effects upon reinforcement. 3) The effects of varied dispersion quality can now be studied directly using special x-ray and electron microscope tensile specimen holders with which small rubber specimens can be examined under strain. Actually these procedures have a greater scope than simply measuring dispersion. The reinforcing capabilities of different pigments in a variety of polymers may be compared by the use of these techniques.

Selective Sampling and Orientation of Non-Homogeneous Tissues

1968 ◽  
Vol 26 ◽  
pp. 98-99
Author(s):  
C. C. Clawson ◽  
L. W. Anderson ◽  
R. A. Good
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Light Microscopy ◽  
Random Sampling ◽  
New Method ◽  
Microscope Examination ◽  
Small Areas ◽  
Selective Sampling ◽  
Large Numbers ◽  
Specific Orientation

Investigations which require electron microscope examination of a few specific areas of non-homogeneous tissues make random sampling of small blocks an inefficient and unrewarding procedure. Therefore, several investigators have devised methods which allow obtaining sample blocks for electron microscopy from region of tissue previously identified by light microscopy of present here techniques which make possible: 1) sampling tissue for electron microscopy from selected areas previously identified by light microscopy of relatively large pieces of tissue; 2) dehydration and embedding large numbers of individually identified blocks while keeping each one separate; 3) a new method of maintaining specific orientation of blocks during embedding; 4) special light microscopic staining or fluorescent procedures and electron microscopy on immediately adjacent small areas of tissue.

The Response of Testis Cells to Low Dose X-Irradiation

1981 ◽  
Vol 39 ◽  
pp. 542-543
Author(s):  
D. E. Philpott ◽  
W. Sapp ◽  
C. Williams ◽  
Joann Stevenson ◽  
S. Black
Keyword(s):  
Electron Microscopy ◽  
Stem Cell ◽  
Light Microscopy ◽  
Dose Level ◽  
Cross Sections ◽  
Low Dose ◽  
Light And Electron Microscopy ◽  
Cellular Responses ◽  
Post Irradiation ◽  
X Irradiation

The response of spermatogonial cells to X-irradiation is well documented. It has been shown that there is a radiation resistent stem cell (As) which, after irradiation, replenishes the seminiferous epithelium. Most investigations in this area have dealt with radiation dosages of 100R or more. This study was undertaken to observe cellular responses at doses less than 100R of X-irradiation utilizing a system in which the tissue can be used for light and electron microscopy.Brown B6D2F1 mice aged 16 weeks were exposed to X-irradiation (225KeV; 15mA; filter 0.35 Cu; 50-60 R/min). Four mice were irradiated at each dose level between 1 and 100 rads. Testes were removed 3 days post-irradiation, fixed, and embedded. Sections were cut at 2 microns for light microscopy. After staining, surviving spermatogonia were identified and counted in tubule cross sections. The surviving fraction of spermatogonia compared to control, S/S0, was plotted against dose to give the curve shown in Fig. 1.

Scanning Secondary Electron Microscopy of Myofibrils Using Transmission Techniques

1975 ◽  
Vol 33 ◽  
pp. 556-557
Author(s):  
M. K. Lamvik
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Carbon Films ◽  
Photographic Recording ◽  
Transmission Electron ◽  
Thin Carbon ◽  
The Common ◽  
Scanning Electron ◽  
Better Than ◽  
Cellular Organelles

When observing small objects such as cellular organelles by scanning electron microscopy, it is often valuable to use the techniques of transmission electron microscopy. The common practice of mounting and coating for SEM may not always be necessary. These possibilities are illustrated using vertebrate skeletal muscle myofibrils.Micrographs for this study were made using a Hitachi HFS-2 scanning electron microscope, with photographic recording usually done at 60 seconds per frame. The instrument was operated at 25 kV, with a specimen chamber vacuum usually better than 10-7 torr. Myofibrils were obtained from rabbit back muscle using the method of Zak et al. To show the component filaments of this contractile organelle, the myofibrils were partially disrupted by agitation in a relaxing medium. A brief centrifugation was done to clear the solution of most of the undisrupted myofibrils before a drop was placed on the grid. Standard 3 mm transmission electron microscope grids covered with thin carbon films were used in this study.

Characterization of submicrometer fluid Inclusions in minerals by Analytical/Transmission Electron Microscopy and electron diffraction

1990 ◽  
Vol 48 (4) ◽  
pp. 424-424
Author(s):  
George Guthrie ◽  
David Veblen
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Electron Microscope ◽  
Electron Diffraction ◽  
Light Microscopy ◽  
Fluid Inclusions ◽  
Energy Dispersive Spectrometer ◽  
Analytical Transmission Electron Microscopy ◽  
Transmission Electron

The nature of a geologic fluid can often be inferred from fluid-filled cavities (generally <100 μm in size) that are trapped during the growth of a mineral. A variety of techniques enables the fluids and daughter crystals (any solid precipitated from the trapped fluid) to be identified from cavities greater than a few micrometers. Many minerals, however, contain fluid inclusions smaller than a micrometer. Though inclusions this small are difficult or impossible to study by conventional techniques, they are ideally suited for study by analytical/ transmission electron microscopy (A/TEM) and electron diffraction. We have used this technique to study fluid inclusions and daughter crystals in diamond and feldspar.Inclusion-rich samples of diamond and feldspar were ion-thinned to electron transparency and examined with a Philips 420T electron microscope (120 keV) equipped with an EDAX beryllium-windowed energy dispersive spectrometer. Thin edges of the sample were perforated in areas that appeared in light microscopy to be populated densely with inclusions. In a few cases, the perforations were bound polygonal sides to which crystals (structurally and compositionally different from the host mineral) were attached (Figure 1).

Microtexture of shock reaction products of niobium and silica mixtures

1999 ◽  
Vol 14 (7) ◽  
pp. 3169-3174 ◽  
Author(s):  
Reiko Murao ◽  
Masae Kikuchi ◽  
Kiyoto Fukuoka ◽  
Eiji Aoyagi ◽  
Toshiyuki Atou ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Electron Microscope ◽  
Shock Compression ◽  
Pressure Range ◽  
Reaction Products ◽  
Small Particles ◽  
Powder Mixtures ◽  
X Ray ◽  
Transmission Electron

Shock compression experiments on powder mixtures of niobium metal and quartz were conducted for the pressure range of 30–40 GPa by a 25-mm single-stage propellant gun. Chemical reaction occurred above 35 GPa, and products were found to be mainly so-called “Cu3Au-type” Nb3Si, which contained a small amount of oxygen. Microtextures of the specimen were examined by scanning and transmission electron microscopy. A field-emission transmission electron microscope was used for energy-dispersive x-ray analysis of microtextures in small particles found in the SiO2 matrix, and various species with different Nb/Si ratio and oxygen content were shown to be produced through the nonequilibrium process of shock compression.

Relative Reactivity Trends OP High Temperature Superconductor Phases

1992 ◽  
Vol 275 ◽  
Author(s):  
David R. Riley ◽  
Ji-Ping Zhou ◽  
A. Manthiram ◽  
John T. McDevitt
Keyword(s):  
Electron Microscopy ◽  
Carbon Dioxide ◽  
High Temperature ◽  
High Temperature Superconductor ◽  
Relative Reactivity ◽  
Complete Understanding ◽  
High Tc ◽  
X Ray ◽  
The Common ◽  
Scanning Electron

ABSTRACTMany of the high temperature superconductor phases degrade rapidly when in the presence of water, acids, carbon dioxide or carbon monoxide. In order to foster more rapid developments in the area of high-Tc research, it will be necessary to acquire a more complete understanding of the surface chemistry of these superconducting materials. In this paper, the relative reactivity of the common cuprate phases toward water is reported. X-ray powder diffraction and scanning electron microscopy measurements are utilized here to establish the reactivity trends.

In vitro development of isolated ectoderm from axolotl gastrulae

Development ◽  
1984 ◽  
Vol 80 (1) ◽  
pp. 321-330
Author(s):  
Jonathan M. W. Slack
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Light Microscopy ◽  
Outer Layer ◽  
Microscope Examination ◽  
Animal Pole ◽  
In Vitro Development ◽  
Electron Microscope Examination ◽  
Vitro Development

The development of ectoderm isolated from the animal pole of axolotl gastrulae is monitored by light microscopy, electron microscopy and analysis of newly synthesized proteins, glycoproteins and glycolipids. When control embryos are undergoing neurulation it is shown that the explants autonomously begin to express epidermal markers and do not express mesodermal markers. However the results suggest that not all the cells become epidermal and electron microscope examination shows that only the outer layer does so, the inner cells remaining undifferentiated.

Field-Emission Scanning Electron Microscopy and Energy-Dispersive X-Ray Analysis to Understand the Role of Tannin-Based Dyes in the Degradation of Historical Wool Textiles

2014 ◽  
Vol 20 (5) ◽  
pp. 1534-1543 ◽  
Author(s):  
Annalaura Restivo ◽  
Ilaria Degano ◽  
Erika Ribechini ◽  
Josefina Pérez-Arantegui ◽  
Maria Perla Colombini
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Elemental Composition ◽  
Field Emission ◽  
Cross Sections ◽  
Morphological Changes ◽  
Energy Dispersive ◽  
X Ray ◽  
Edx Analysis ◽  
Scanning Electron

Abstract:An innovative approach, combining field-emission scanning electron microscopy (FESEM) with energy dispersive X-ray spectroscopy (EDX) analysis, is presented to investigate the degradation mechanisms affecting tannin-dyed wool. In fact, tannin-dyed textiles are more sensitive to degradation then those dyed with other dyestuffs, even in the same conservation conditions.FESEM-EDX was first used to study a set of 48 wool specimens (artificially aged) dyed with several raw materials and mordants, and prepared according to historical dyeing recipes. EDX analysis was performed on the surface of wool threads and on their cross-sections. In addition, in order to validate the model formulated by the analysis of reference materials, several samples collected from historical and archaeological textiles were subjected to FESEM-EDX analysis.FESEM-EDX investigations enabled us to reveal the correlation between elemental composition and morphological changes. In addition, aging processes were clarified by studying changes in the elemental composition of wool from the protective cuticle to the fiber core in cross-sections. Morphological and elemental analysis of wool specimens and of archaeological and historical textiles showed that the presence of tannins increases wool damage, primarily by causing a sulfur decrease and fiber oxidation.

scholarly journals The use of scanning electron microscopy to the study of the painting from the Church in Radcze

2013 ◽  
Vol 12 (4) ◽  
pp. 095-105
Author(s):  
Beata Klimek
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Electron Microscope ◽  
Historic Buildings ◽  
X Ray ◽  
Composition And Structure ◽  
The Church ◽  
Diagnosis Technique ◽  
Scanning Electron

One of the main tasks in the study of historic buildings is the need to identify the original materials and extensions, which often have historic character. The next task concerns the determination of the composition and structure of the historical, diagnosis technique to develop original paint. The article presents the preliminary results of paintings. Methods were used with the scanning electron microscope was equipped with an energy dispersive X-ray spectrometer (SEM-EDS).

Sign in / Sign up

Export Citation Format

Share Document