scholarly journals Groundwater Potential Assessment Using 2-D Resistivity Method In Kluang, Johor (Malaysia)

Warta Geologi ◽  
2020 ◽  
Vol 46 (3) ◽  
pp. 220-224
Author(s):  
Nazrin Rahman ◽  
◽  
Edy Tonnizam Mohamad ◽  
Rosli Saad ◽  
◽  
...  

Sources of clean water are decreasing due to rapid usage, contaminated surface waters, pollution and dry season. The dependence on the existing water source is not enough to fulfil the increasing demand of population in Malaysia. In order to overcome the problem, groundwater source is the most suitable alternative. 2-D resistivity method was carried out in a granitic area of Kluang, Johor to delineate and locate groundwater resource. 5 survey lines were conducted by using ABEM SAS4000 terrameter and electrode selector which were connected to 41 electrodes through lund cables. Pole-dipole array was chosen in this study for deeper penetration. Collected data were processed by using RES2DINV software to produce inversion model which was then exported to Surfer8 software for visualisation and interpretation. The result shows that most of the study area consist of granite with different level of fracturing. Unconfined aquifer was found at depths of 0 to 50 m. Confined aquifers can be seen at two different zones. They exhibit same properties at three parallel lines, R1-R3 and show continuity between them. It is predicted that the aquifers flow in the southwest to northeast direction. The hard rock aquifers are highly recommended to be drilled as they contain a large amount of fresh water for further usage.

Author(s):  
Dian Darisma ◽  
Ferdy Fernanda ◽  
Muhammad Syukri

Lam Apeng is a village with a majority of people living as farmers, which causes the need of water for agriculture is increasing. The water demand in this area continues to increase as the population increases, for various purposes. The objective of this study is to determine the distribution of the groundwater layer using the electrical resistivity method and to determine groundwater potential using hydraulic parameters. This research is conducted using 2 measurement line with a length of each line is 112 meters and distances of each electrode is 2 meters. The data invert using Res2Dinv software to obtain 2D subsurface lithology subsurface. At line 1, the aquifer (sand) layer is located in the second layer with a rock resistivity value of 12 Ωm - 18.6 Ωm at a depth of 8 m - 18 m. At line 2, the aquifer (sand) layer is also located in the second layer with a resistivity value of 4.6 Ωm - 18 Ωm at a depth of 5 m – 12 m. Based on the interpretation of the two measurement lines, it can be concluded that the type of aquifer in the research site is a semi unconfined aquifer. In this study, hydraulic parameters (hydraulic conductivity, longitudinal conductance, transverse resistance, and transmissivity) was calculated based on the resistivity value and the thickness of the aquifer layer. The average resistivity of the aquifer layer used is 15.3 Ωm and 11.3 Ωm, respectively for line 1 and line 2, indicating that the aquifer was moderately corrosive. Longitudinal conductance values are 0.65 Ω-1 and 0.62 Ω-1 which indicated moderate protective capacity. The transmissivity values are 6.78 m2/dayand 4.77 m2/day, which indicates that the designation in this area is low and the groundwater potential is local or only for personal consumption.


1983 ◽  
Vol 14 (1) ◽  
pp. 33-40 ◽  
Author(s):  
P. N. Ballukraya ◽  
R. Sakthivadivel ◽  
R. Baratan

In a previous paper (Nordic Hydrology, Vol. 12, 1981), the authors have discussed the inadequacies in the technique of resistivity method for location of sites for constructing deep water walls in hard rock areas. It was pointed out that the water bearing fracture zones in the bed rock could not be identified by merely considering geoelectrical parameters such as layer resistivity. An empirical study based on the correlation of minor irregularities or deviations – “BREAKS” – in the normally smooth sounding curves with the actual driller's logs reveals that under normal geo-electric conditions these water bearing zones (hard rock aquifers) are indicated in the curve by a perceptible lowering of apparent resistivity and hence could be used as a guide for locating well sites. As such breaks may also be caused by other conditions such as lateral inhomogeneities, certain methods for distinguishing them are discussed.


Geophysics ◽  
1991 ◽  
Vol 56 (7) ◽  
pp. 1051-1054 ◽  
Author(s):  
H. V. Ram Babu ◽  
N. Kameswara Rao ◽  
V. Vijay Kumar

The role of the magnetic method in groundwater exploration is to locate structures such as dikes, faults, fractures, etc., that control the accumulation and movement of groundwater. In hard‐rock terrains, the thickness of the weathered layer is an important parameter that determines the quantity of groundwater accumulated in the unconfined aquifer above the basement. The basement rock, in the process of weathering, loses its magnetic properties and becomes much less magnetic. Therefore, the magnetic response is mostly due to the unweathered hard basement rock, and the depths of magnetic sources obtained from the analysis give us the top of the basement. Information about the thickness of the weathered layer would help in assessing the groundwater potential of the region.


2018 ◽  
Vol 7 (1) ◽  
Author(s):  
Heru Sri Naryanto ◽  
Nurhidayat Nurhidayat

Groundwater is water that occurs naturally in the subsurface, and is contained in the aquifer. Groundwater is the water source of the most widely used by the public for purposes of clean water. To determine the condition of the aquifer configuration one of the methods that can be used is the 2D electrical resistivity. Exploration drilling is one effective way to determine directly the presence of groundwater, but to determine the location of the drilling necessary geophysical approach to describe subsurface conditions prior to drilling. 2D electrical resistivity method is a geophysical method that utilizes dynamic electrical properties of the media path. 2D electrical resistivity measurements have been carried out in Kapuas, Central Kalimantan using Wenner configuration, the distance between the electrodes 10 meters, penetration depth reaches 80 meters, and and measuring some 21 track. Water potential zones were identified based on having resistivity range 15-25 ohm.m, contained in the sandstone layer, which is covered in a layer of impermeable mudstone layers. Location that has a high potential for groundwater recommended drilling done on the track P-07 and P-13, with an estimated depth of the aquifer between 25 meters and 30 meters. The highest groundwater potential lies between the drilling data PH-23 and PH-24, with the resistivity at that point reaches 300 ohm.m. Keywords : Groundwater, aquifer, sandstone, 2D electrical resistivity, resistivity, Kapuas


2017 ◽  
Vol 12 (2) ◽  
pp. 105-116
Author(s):  
Pulung A. Pranantya ◽  
Nurlia Sadikin

In terms of geology, most areas in south of the Gunungkidul District in Central Java consist of the Wonosari formation limestone. The land is generally very dry and source of raw water is also difficult to reach. Findings on the existence of underground river in caves, however, indicate the potential amount of water within the area, especially in the eastern part of the Gunungkidul District. Although limited information available, some fishermen have discovered that Seropan cave contains fresh water source. This cave is situated at 65 m below the cliff. Initial exploration, which done using a multichannel resistivity method, confirmed the availability of freshwater in the cave and underground river. The isopach of cave depth is found in ranges of 80 200 m below the ground surface. The water of Seropan cave can be utilized by implementing pipeline or by drilling at the suggested point based on the interpretation results, i.e. 110o2223.6388 EL 8o42.874 SL. [DY1][PP2][DY1]Perbaiki grammarIn terms of geology, most areas in south of Gunungkidul District in Central Java consist of the Wonosari formation limestone. The land is generally very dry and source of raw water is also difficult to reach. Findings on the exixtence of underground river in caves, however, indicate potential amount of water within the area especially in eastern part of Gunungkidul District. Although limited information available, some fishermans has discovered that Seropan cave contain fresh water source. This cave is situated at 65 m below the cliff. Initial exploration, which done using multichannel resistivity method, confirmed the availability of freshwater in the cave and underground river. The iso pach of cave depth is found in ranges of 80 200 m below the ground surface. The water of Seropan cave can be utilized by implementing pipeline or by drilling at the suggested point based on the interpretation results i.e. 110o2223.6388 EL 8o42.874 SL.[PP2]Sudah diperbaiki


2018 ◽  
Vol 2 (1) ◽  
pp. 16-27 ◽  
Author(s):  
Vaishnavi Mundalik ◽  
Clinton Fernandes ◽  
Ajaykumar Kadam ◽  
Bhavana Umrikar

Groundwater is an important source of drinking water in rural parts of India. Because of the increasing demand for water, it is essential to identify new sources for the sustainable development of this resource. The potential mapping and exploration of groundwater resources have become a breakthrough in the field of hydrogeological research. In the present paper, a groundwater prospects map is delineated for the assessment of groundwater availability in Kar basin on basaltic terrain, using remote sensing and Geographic Information System (GIS) techniques. Various thematic layers such as geology, slope, soil, geomorphology, drainage density and rainfall are prepared using satellite data, topographic maps and field data. The ranks and weights were assigned to each thematic layer and various categories of those thematic layers using AHP technique respectively. Further, a weighted overlay analysis was performed by reclassifying them in the GIS environment to prepare the groundwater potential map of the study area. The results show that groundwater prospects map classified into three classes low, moderate and high having area 17.12%, 38.26%, 44.62%, respectively. The overlay map with the groundwater potential zones in the study area has been found to be helpful for better planning and managing the resources.


Author(s):  
Stefano Segadelli ◽  
Maria Filippini ◽  
Anna Monti ◽  
Fulvio Celico ◽  
Alessandro Gargini

AbstractEstimation of aquifer recharge is key to effective groundwater management and protection. In mountain hard-rock aquifers, the average annual discharge of a spring generally reflects the vertical aquifer recharge over the spring catchment. However, the determination of average annual spring discharge requires expensive and challenging field monitoring. A power-law correlation was previously reported in the literature that would allow quantification of the average annual spring discharge starting from only a few discharge measurements in the low-flow season, in a dry summer climate. The correlation is based upon the Maillet model and was previously derived by a 10-year monitoring program of discharge from springs and streams in hard-rock aquifers composed of siliciclastic and calcareous turbidites that did not have well defined hydrogeologic boundaries. In this research, the same correlation was applied to two ophiolitic (peridotitic) hard-rock aquifers in the Northern Apennines (Northern Italy) with well-defined hydrogeologic boundaries and base-outflow springs. The correlation provided a reliable estimate of the average annual spring discharge thus confirming its effectiveness regardless of bedrock lithology. In the two aquifers studied, the measurable annual outputs (i.e. sum of average annual spring discharges) could be assumed equal to the annual inputs (i.e. vertical recharge) based on the clear-cut aquifer boundaries and a quick groundwater circulation inferable from spring water parameters. Thus, in such setting, the aforementioned correlation also provided an estimate of the annual aquifer recharge allowing the assessment of coefficients of infiltration (i.e. ratio between aquifer recharge and total precipitation) ranging between 10 and 20%.


Sign in / Sign up

Export Citation Format

Share Document