Study of Interaction of Glycerol Cryoprotectant and Its Derivatives with Dimethylacetamide in Aqueous Solution Using Fluorescent Probes

In this paper we have studied the interaction of the mixtures of glycerol (GL) and its oxyethylated derivatives (OEG) with polymerization degree n = 3, 25 and 30 with dimethylacetamide (DMAc) in aqueous solution using 3-hydroxy-4´-(N, N dimethylaminoflavone) fluorescent probe. The combination of GL and its oxyethylated derivatives with DMAc was found to reduce the membranotropy of certain cryoprotective agents, forming a mixture. The combination of both GL and its low molecular weight derivative (OEGn=3) with DMAc reduced the membranotropy of the latter. At the same time, combining GL derivatives of high molecular weight (OEGn=25 and OEGn=30) with DMAc diminished the membranotropy of OEG. The OEGn=30 at concentrations above 1 wt.% was shown to form the micellar-type structures or micellar associates in aqueous solution. This enabled suggesting the membranotropic ability of high molecular weight OEG associates to be stipulated by possible interaction of their nonpolar segments with nonpolar sites on biomembrane surface. Structural rearrangements of molecular associates in aqueous solutions of low and high molecular weight cryoprotectant mixtures were designated as the experimentally established mechanism of cytotoxicity reduction in combined cryoprotective media.

STUDY OF SEDIMENTS OF COLLECTING AGENTS IN ELEMENTARY FLOTATION ACT

The operating mechanism of physically sorbed derivatives of collector obtained at a nonstoichiometric ratio between collecting agents with heavy metal salts is proposed. It is found that by changing the ratio of the components, it is possible to adjust their surface-active properties with respect to the gas-liquid interface and, consequently, the ability to remove the kinetic restriction to the formation of flotation contact. The physical form of sorption on a mineral can be represented by collector sediments and ion-molecular associates. The research results show that when the interlayer breaks through, these forms can desorb from the mineral and spread over the bubble surface, dragging the liquid from the interlayer into motion, thereby “drying” the mineral surface. In turn, the removal of liquid from the interlayer leads to a reduction in the induction time, which affects the efficiency of flotation. The results make it possible to reveal the mechanism of flotation activation with heavy metal salts and can be used in the development of fundamentally new engineering solutions.

Dynamics of molecular associates in methanol/water mixtures

The dynamics of molecular associates in methanol/water mixtures was investigated using quasielastic neutron scattering. By measuring the signal from four methanol/water samples differing only by their isotopic composition, the relative...

Adsorption Mechanism of Pb2+ Activator for the Flotation of Rutile

In general, the flotation of minerals containing titanium needs to be activated by metal ions due to a lack of activating sites on their surface. However, the activating process is indirectly inferred due to the lack of direct experimental observation. In this study, atomic force microscopy (AFM) was used to observe the activation process. The results revealed that the hydroxyl compounds of Pb2+ ions were adsorbed on the rutile surface in the form of multiple molecular associates, rather than through single molecule adsorption. Styryl phosphoric acid (SPA) could largely be adsorbed on the activated rutile surface with a single and double layer rather than on the un-activated rutile surface. The results of contact angle measurements also revealed that the hydrophobicity of the activated rutile surface was significantly greater than that of the un-activated rutile surface after SPA was adsorbed. This study will be helpful to understanding the activating process from the microscale.

Adducts of Trimeric Perfluro-o-Phenylene Mercury with TTF or DTT

Since the discovery of metallic conductivity in the TTF-TCNQ complex, the charge transfer (CT) complex materials have been studied for such properties as semiconductivity or superconductivity. The synthesis of new CT materials using trimeric perfluoro-ortho-phenylene mercury (Hg3) as electron acceptor compound was done first by Haneline and Gabaï [1]. A series of studies of CT materials containing Hg3 and tetrathiafulvalene (TTF) or dithieno thiophene (DTT) as an electron donor compounds was carried out by different methods. Co-crystalzation with TTF gave a larger variety of co-crystals than with DTT, producing three polymorphs and one pseudo-polymorph. One pot crystal growth of TTF and Hg3 in a 1:1 mixture of solvents dichloromethane (DCM) and dichloroethane (DCA) has led to the formation of TTF polymorphs 1 and 2 with same 1:1 donor acceptor ratio [Hg3·TTF] as well a pseudopolymorph [Hg3·TTF·DCA] 3 that contains the solvent DCA in the asymmetric unit. Slow evaporation in a 1:1 mixture of dichloromethane and carbon disulfide was used to obtain the previously reported CT [(Hg3)2·TTF] (4)1. By slow evaporation as well in pure dichloromethane was obtained the CT material [Hg3·DTT·DCM] 5. All these five CT co-crystals contain mixed donor acceptor stacks, however only in 3, 4 and 5 these stacks are parallel to each other. In the packing of 1 and 2 these stacks are in herringbone arrangement. Polymorphs 1 and 2 differ in crystal shape and color. Contacts Hg···S shorter than the sum of the Van Der Walls radii were observed in the five CTs materials reported, however only 1, 2, 3, and 5 have extended short donor acceptor molecular associates. Moreover only 3, and 5 has these extended donor acceptor associates along one direction.