Modification of the AMX membrane surface by polyethyleneimine: Effect of ionic strength on the membrane ion exchange selectivity

2016 ◽  
Vol 94 (12) ◽  
pp. 2386-2393 ◽  
Author(s):  
Islem Louati ◽  
Fatma Guesmi ◽  
Chiraz Hannachi ◽  
Béchir Hamrouni
2002 ◽  
Vol 2 (5-6) ◽  
pp. 445-450 ◽  
Author(s):  
D.H. Kim ◽  
S.-H. Moon ◽  
J. Cho

A series of adsorption experiments were performed to investigate the factors affecting the transport of natural organic matter (NOM) in an ion-exchange (IX) membrane. In this study, the structure of the NOM was hypothesized to be an important factor in terms of the organic fouling of IX membrane. It was found that the adsorbed mass of hydrophobic NOM constituent on the membrane surface was higher than that of either the hydrophilic or transphilic NOM constituent. NOM adsorption was seriously affected by the apparent charge of the NOM. As the apparent charge increased, NOM adsorption also significantly increased. Moreover, the molecular mass of the hydrophobic NOM acids was too high to enable them to pass through the IX membrane, and this caused an accumulated adsorption of solutes on the membrane surface, i.e. NOM fouling. In addition, both pH and ionic strength affected NOM adsorption on the surface of the IX membrane. Lower NOM adsorption resulted from a lower pH and a higher ionic strength.


SPE Journal ◽  
2017 ◽  
Vol 23 (01) ◽  
pp. 84-101 ◽  
Author(s):  
Maxim P. Yutkin ◽  
Himanshu Mishra ◽  
Tadeusz W. Patzek ◽  
John Lee ◽  
Clayton J. Radke

Summary Low-salinity waterflooding (LSW) is ineffective when reservoir rock is strongly water-wet or when crude oil is not asphaltenic. Success of LSW relies heavily on the ability of injected brine to alter surface chemistry of reservoir crude-oil brine/rock (COBR) interfaces. Implementation of LSW in carbonate reservoirs is especially challenging because of high reservoir-brine salinity and, more importantly, because of high reactivity of the rock minerals. Both features complicate understanding of the COBR surface chemistries pertinent to successful LSW. Here, we tackle the complex physicochemical processes in chemically active carbonates flooded with diluted brine that is saturated with atmospheric carbon dioxide (CO2) and possibly supplemented with additional ionic species, such as sulfates or phosphates. When waterflooding carbonate reservoirs, rock equilibrates with the injected brine over short distances. Injected-brine ion speciation is shifted substantially in the presence of reactive carbonate rock. Our new calculations demonstrate that rock-equilibrated aqueous pH is slightly alkaline quite independent of injected-brine pH. We establish, for the first time, that CO2 content of a carbonate reservoir, originating from CO2-rich crude oil and gas, plays a dominant role in setting aqueous pH and rock-surface speciation. A simple ion-complexing model predicts the calcite-surface charge as a function of composition of reservoir brine. The surface charge of calcite may be positive or negative, depending on speciation of reservoir brine in contact with the calcite. There is no single point of zero charge; all dissolved aqueous species are charge determining. Rock-equilibrated aqueous composition controls the calcite-surface ion-exchange behavior, not the injected-brine composition. At high ionic strength, the electrical double layer collapses and is no longer diffuse. All surface charges are located directly in the inner and outer Helmholtz planes. Our evaluation of calcite bulk and surface equilibria draws several important inferences about the proposed LSW oil-recovery mechanisms. Diffuse double-layer expansion (DLE) is impossible for brine ionic strength greater than 0.1 molar. Because of rapid rock/brine equilibration, the dissolution mechanism for releasing adhered oil is eliminated. Also, fines mobilization and concomitant oil release cannot occur because there are few loose fines and clays in a majority of carbonates. LSW cannot be a low-interfacial-tension alkaline flood because carbonate dissolution exhausts all injected base near the wellbore and lowers pH to that set by the rock and by formation CO2. In spite of diffuse double-layer collapse in carbonate reservoirs, surface ion-exchange oil release remains feasible, but unproved.


2017 ◽  
Vol 523 ◽  
pp. 36-44 ◽  
Author(s):  
K.A. Nebavskaya ◽  
V.V. Sarapulova ◽  
K.G. Sabbatovskiy ◽  
V.D. Sobolev ◽  
N.D. Pismenskaya ◽  
...  

2007 ◽  
Vol 17 (46) ◽  
pp. 4839 ◽  
Author(s):  
Aaron J. Celestian ◽  
Abraham Clearfield

2010 ◽  
Vol 10 (2) ◽  
pp. 193-200 ◽  
Author(s):  
Wuthikorn Saikaew ◽  
Supatpong Mattaraj ◽  
Ratana Jiraratananon

Nanofiltration performance (i.e. rejection and flux decline) of lead solutions was investigated using a dead-end test cell at room temperature. An aromatic polyamide NF-90 membrane was chosen to determine the impacts of solution chemistry. The experimental results revealed that solution flux decline was dependent on solution pH, ionic strength, and type of lead solutions. Solution flux conducted with different types of lead solutions (i.e. PbCl2 and Pb(NO3)2) decreased with increased solution pH. Solutions having high pH exhibited greater flux decline than those having low solution pH, while lead ion rejections were relatively high. Increased ionic strengths resulted in a greater flux decline, while lead ion rejections decreased with decreasing solution pH and increasing ionic strengths. Such results were related to low solution pH, suggesting an increase in fixed charge of proton (H+), decreasing electrical double layer thickness within membrane, thus allowing increased lead concentration passing through the membrane surface. Solution flux and rejection decreased further at higher ionic strengths, which caused a reduced negatively charged membrane, and thus decreased rejections. It was also found that lead ion for PbCl2 solution exhibited higher rejections than that of Pb(NO3)2 solution.


2010 ◽  
Vol 25 (2) ◽  
pp. 178-184 ◽  
Author(s):  
Ola Sundman ◽  
Per Persson ◽  
Lars-Olof Öhman

Abstract A compilation of the applied experimental conditions when studying metal ion adsorption onto kraft fibres, and the resulting conclusion, revealed that the ionic strength conditions used during the experiments were an important dividing factor. At low ionic strengths, the conclusion has regularly been that the Donnan ion-exchange model could correctly predict the adsorption while, at higher ionic strengths, it has often been concluded that the formation of specific metal-ion fibre complexes must be assumed. To study this apparent influence from the presence of monovalent sodium ions, Cu K-edge EXAFS spectra of Cu2+ ions adsorbed to kraft fibres were collected in media of “0” to 100 mM NaCl. Combined with previous data, these measurements confirmed that at very low ionic strength, the importance of specific interactions between the chemically modified cellulose fibres and the Cu(II) ions significantly decreased. For a detailed description of the adsorption phenomenon, both types of interactions must be considered simultaneously. For most technical and engineering applications, however, the Donnan model can be used at low ionic strength conditions, i.e. I ≲ 10 mM. At higher ionic strengths, though, the inclusion of specific complexes in the model is necessary for correctly describing the adsorption of di- and trivalent cations with strong complex forming properties.


Sign in / Sign up

Export Citation Format

Share Document