Thermal stability and characteristic properties of pressureless sintered Ag layers formed with Ag nanoparticles for power device applications

2020 ◽  
Vol 31 (20) ◽  
pp. 17173-17182
Author(s):  
Tomofumi Watanabe ◽  
Masafumi Takesue ◽  
Tomoki Matsuda ◽  
Tomokazu Sano ◽  
Akio Hirose
Polymers ◽  
2021 ◽  
Vol 13 (12) ◽  
pp. 1954
Author(s):  
Yang Liu ◽  
Xun Zhang ◽  
Quanxin Gao ◽  
Hongliang Huang ◽  
Yongli Liu ◽  
...  

In the present study, silver (Ag) nanoparticles and maleic anhydride-grafted polyolefin elastomer (MAH-g-POE) were used as enhancement additives to improve the performance of the polyoxymethylene (POM) homopolymer. Specifically, the POM/Ag/MAH-g-POE ternary nanocomposites with varying Ag nanoparticles and MAH-g-POE contents were prepared by a melt mixing method. The effects of the additives on the microstructure, thermal stability, crystallization behavior, mechanical properties, and dynamic mechanical thermal properties of the ternary nanocomposites were studied. It was found that the MAH-g-POE played a role in the bridging of the Ag nanoparticles and POM matrix and improved the interfacial adhesion between the Ag nanoparticles and POM matrix, owing to the good compatibility between Ag/MAH-g-POE and the POM matrix. Moreover, it was found that the combined addition of Ag nanoparticles and MAH-g-POE significantly enhanced the thermal stability, crystallization properties, and mechanical properties of the POM/Ag/MAH-g-POE ternary nanocomposites. When the Ag/MAH-g-POE content was 1 wt.%, the tensile strength reached the maximum value of 54.78 MPa. In addition, when the Ag/MAH-g-POE content increased to 15wt.%, the elongation at break reached the maximum value of 64.02%. However, when the Ag/MAH-g-POE content further increased to 20 wt.%, the elongation at break decreased again, which could be attributed to the aggregation of excessive Ag nanoparticles forming local defects in the POM/Ag/MAH-g-POE ternary nanocomposites. Furthermore, when the Ag/MAH-g-POE content was 20 wt.%, the maximum decomposition temperature of POM/Ag/MAH-g-POE ternary nanocomposites was 398.22 °C, which was 71.39 °C higher than that of pure POM. However, compared with POM, the storage modulus of POM/Ag/MAH-g-POE ternary nanocomposites decreased with the Ag/MAH-g-POE content, because the MAH-g-POE elastomer could reduce the rigidity of POM.


2009 ◽  
Vol 94 (9) ◽  
pp. 092102 ◽  
Author(s):  
Pierre-Nicolas Volpe ◽  
Julien Pernot ◽  
Pierre Muret ◽  
Franck Omnès

2013 ◽  
Vol 561 ◽  
pp. 26-35 ◽  
Author(s):  
Konstantinos Chrissafis ◽  
Eleni Pavlidou ◽  
Dimitra Gkogkou ◽  
Dimitrios Bikiaris

2003 ◽  
Vol 216 (1-4) ◽  
pp. 483-489 ◽  
Author(s):  
Yoko Yokoyama ◽  
Xueqing Li ◽  
Kuang Sheng ◽  
Andrei Mihaila ◽  
Tanija Traikovic ◽  
...  

2018 ◽  
Vol 775 ◽  
pp. 144-148 ◽  
Author(s):  
Bethel Faith Y. Rezaga ◽  
Mary Donnabelle L. Balela

Silver (Ag) nanoparticles synthesized in an aqueous system was sintered at room temperature using NaCl solution. The Ag nanoparticles have an average diameter of about 24 nm. After dispersing the Ag nanoparticles in 50mM NaCl solution, a significant increase in particle size to about 206 nm was observed. On the other hand, the particle size was also increased to about 175 nm when the Ag nanoparticles were printed and then 50mM NaCl solution was dropped onto the printed Ag nanoparticles. The enlargement of particle size was accompanied by the increase in conductivity of the Ag nanoparticle ink. The resistance was reduced from 57.7 to 6.5 and 6.7 ohms for the as-prepared and sintered Ag nanoparticles using two different treatments, respectively. The sintered Ag nanoparticle ink formulation exhibit high conductivity when drawn on both cellulose acetate film and bond paper even after bending and folding of the substrates.


2020 ◽  
Vol 833 ◽  
pp. 181-185 ◽  
Author(s):  
Bethel Faith Y. Rezaga ◽  
Mary Donnabelle L. Balela

Fusing of silver (Ag) nanoparticles synthesized in an aqueous system was observed at room temperature using halide solutions. The as-synthesized Ag nanoparticles have an average diameter of about 24 nm. After dispersing the Ag nanoparticles in a halide solution, a significant increase in particle size to about 188-197 nm was observed. The enlargement of particle size was accompanied by the increase in conductivity of the Ag nanoparticle ink. The resistance was reduced from 110 kiloohms to 35 and 9.3 ohms for the as-prepared and sintered Ag nanoparticles using NaBr and NaCl solution, respectively.


2019 ◽  
Vol 66 (8) ◽  
pp. 3441-3446 ◽  
Author(s):  
Chia-Hsun Wu ◽  
Jian-You Chen ◽  
Ping-Cheng Han ◽  
Ming-Wen Lee ◽  
Kun-Sheng Yang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document