Preparation and characterization of semi-hydrophobic cryogels for culture of Lactobacillus strains and bioconversion towards phenyllactic acid bioproduction

2021 ◽  
pp. 108312
Author(s):  
Xiaoling Lou ◽  
Yibin Jiang ◽  
Feng Zhao ◽  
Yixian Zhang ◽  
Xing Qu ◽  
...  
Keyword(s):  
3 Biotech ◽  
2020 ◽  
Vol 10 (3) ◽  
Author(s):  
Xi Luo ◽  
Yingying Zhang ◽  
Fengwei Yin ◽  
Gaowei Hu ◽  
Qiang Jia ◽  
...  

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Katarzyna Kozłowicz ◽  
Renata Różyło ◽  
Bożena Gładyszewska ◽  
Arkadiusz Matwijczuk ◽  
Grzegorz Gładyszewski ◽  
...  

Abstract This work aimed at the chemical and structural characterization of powders obtained from chestnut flower honey (HFCh) and honey with Inca berry (HBlu). Honey powders were obtained by spray drying technique at low temperature (80/50 °C) with dehumidified air. Maltodextrin (DE 15) was used as a covering agent. The isolation and evaluation of phenolic compounds and sugars were done by gas chromatography–mass spectrometry analysis. Scanning electron microscopy, Fourier-transform infrared (FTIR) spectroscopy, and X-ray diffraction were performed to determine the morphology of the studied honey powders. The obtained results showed that the content of simple sugars amounted to 72.4 and 90.2 g × 100 g−1 in HFCh and HBlu, respectively. Glucose was found to be the dominant sugar with a concentration of 41.3 and 51.6 g × 100 g−1 in HFCh and HBlu, respectively. 3-Phenyllactic acid and ferulic acid were most frequently found in HFCh powder, whereas m-coumaric acid, benzoic acid, and cinnamic acid were the most common in HBlu powder. The largest changes in the FTIR spectra occurred in the following range of wavenumbers: 3335, 1640, and below 930 cm−1. The X-ray diffraction profiles revealed wide peaks, suggesting that both honey powders are amorphous and are characterized by a short-range order only.


1998 ◽  
Vol 64 (2) ◽  
pp. 800-803 ◽  
Author(s):  
V. Dieuleveux ◽  
D. Van Der Pyl ◽  
J. Chataud ◽  
M. Gueguen

ABSTRACT Geotrichum candidum can produce and excrete compounds that inhibit Listeria monocytogenes. These were purified by ultrafiltration, centrifugal partition chromatography, thin-layer chromatography, gel filtration, and high-pressure liquid chromatography, and analyzed by liquid chromatography-mass spectrometry, infrared spectrometry, nuclear magnetic resonance spectrometry, and optical rotation. Two inhibitors were identified:d-3-phenyllactic acid and d-3-indollactic acid.


1987 ◽  
Vol 65 (3) ◽  
pp. 635-639 ◽  
Author(s):  
F. C. Campbell ◽  
Jon G. Houseman ◽  
P. E. Morrison

Alkaline proteases in the posterior midgut of the face fly, Musca autumnalis De Geer, were identified using specific synthetic substrates and nonspecific substrate azocasein. Identification was confirmed with potential protease activators and inhibitors. Optimal azocasein hydrolysis occurred at pH 8.0 and substrate hydrolysis was inhibited by EGTA (ethyleneglycol-bis-(2-aminoethyl ether)-N,N-tetraacetic acid), tosyl-L-lysine chloromethyl ketone (TLCK), and soybean trypsin inhibitor (STI). Tryptic proteolysis was identified by maximal hydrolysis, at pH 8.0, of trypsin specific substrates BAPNA (benzoyl-DL-arginine-p-nitroanilide) and TAME (tosyl-L-arginine methyl ester). TAME hydrolysis was inhibited by PMSF (phenylmethylsulfonyl fluoride), STI, pepstatin A, and dithiothreitol (DTT), but BAPNA hydrolysis was inhibited only by STI and DTT. Chymotrypsin was demonstrated by maximal hydrolysis of BTEE (benzoyl-L-tyrosine ethyl ester) at pH 8.0 and DTT, PMSF, and STI inhibited hydrolysis of this substrate. Aminopeptidase activity was demonstrated by maximal hydrolysis of leucine-p-nitro-anilide at pH 8.0 and the peptidase was inhibited by o-phenanthroline. Carboxypeptidase A-like enzyme hydrolyzed hippuryl-DL-phenyllactic acid maximally at pH 7.5 and carboxypeptidase B showed maximum hydrolysis of hippuryl-L-arginine at pH 7.0. Both carboxypeptidases were inhibited by EDTA (ethylene diamine tetraacetic acid), EGTA, and DTT and carboxypeptidase A was also inhibited by PMSF.


Author(s):  
B. L. Soloff ◽  
T. A. Rado

Mycobacteriophage R1 was originally isolated from a lysogenic culture of M. butyricum. The virus was propagated on a leucine-requiring derivative of M. smegmatis, 607 leu−, isolated by nitrosoguanidine mutagenesis of typestrain ATCC 607. Growth was accomplished in a minimal medium containing glycerol and glucose as carbon source and enriched by the addition of 80 μg/ ml L-leucine. Bacteria in early logarithmic growth phase were infected with virus at a multiplicity of 5, and incubated with aeration for 8 hours. The partially lysed suspension was diluted 1:10 in growth medium and incubated for a further 8 hours. This permitted stationary phase cells to re-enter logarithmic growth and resulted in complete lysis of the culture.


Author(s):  
A.R. Pelton ◽  
A.F. Marshall ◽  
Y.S. Lee

Amorphous materials are of current interest due to their desirable mechanical, electrical and magnetic properties. Furthermore, crystallizing amorphous alloys provides an avenue for discerning sequential and competitive phases thus allowing access to otherwise inaccessible crystalline structures. Previous studies have shown the benefits of using AEM to determine crystal structures and compositions of partially crystallized alloys. The present paper will discuss the AEM characterization of crystallized Cu-Ti and Ni-Ti amorphous films.Cu60Ti40: The amorphous alloy Cu60Ti40, when continuously heated, forms a simple intermediate, macrocrystalline phase which then transforms to the ordered, equilibrium Cu3Ti2 phase. However, contrary to what one would expect from kinetic considerations, isothermal annealing below the isochronal crystallization temperature results in direct nucleation and growth of Cu3Ti2 from the amorphous matrix.


Author(s):  
B. H. Kear ◽  
J. M. Oblak

A nickel-base superalloy is essentially a Ni/Cr solid solution hardened by additions of Al (Ti, Nb, etc.) to precipitate a coherent, ordered phase. In most commercial alloy systems, e.g. B-1900, IN-100 and Mar-M200, the stable precipitate is Ni3 (Al,Ti) γ′, with an LI2structure. In A lloy 901 the normal precipitate is metastable Nis Ti3 γ′ ; the stable phase is a hexagonal Do2 4 structure. In Alloy 718 the strengthening precipitate is metastable γ″, which has a body-centered tetragonal D022 structure.Precipitate MorphologyIn most systems the ordered γ′ phase forms by a continuous precipitation re-action, which gives rise to a uniform intragranular dispersion of precipitate particles. For zero γ/γ′ misfit, the γ′ precipitates assume a spheroidal.


Author(s):  
R. E. Herfert

Studies of the nature of a surface, either metallic or nonmetallic, in the past, have been limited to the instrumentation available for these measurements. In the past, optical microscopy, replica transmission electron microscopy, electron or X-ray diffraction and optical or X-ray spectroscopy have provided the means of surface characterization. Actually, some of these techniques are not purely surface; the depth of penetration may be a few thousands of an inch. Within the last five years, instrumentation has been made available which now makes it practical for use to study the outer few 100A of layers and characterize it completely from a chemical, physical, and crystallographic standpoint. The scanning electron microscope (SEM) provides a means of viewing the surface of a material in situ to magnifications as high as 250,000X.


Sign in / Sign up

Export Citation Format

Share Document