scholarly journals Investigation of toughness of ultra high performance fibre reinforced concrete (UHPFRC) beam under impact loading

2017 ◽  
Vol 99 ◽  
pp. 26-38 ◽  
Author(s):  
L. Mao ◽  
S.J. Barnett
2019 ◽  
Vol 10 (2) ◽  
pp. 251-265 ◽  
Author(s):  
Petr Konrád ◽  
Radoslav Sovják

Research presented in this article is aimed to investigate the ability of ultra-high-performance fibre-reinforced concrete to absorb and dissipate mechanical energy at elevated strain rate loading. Specimens made of ultra-high-performance fibre-reinforced concrete were subjected to the low-velocity impact using the new testing procedure where no fixed supports that hold the sample during the impact were applied. The fibre volume fraction of the ultra-high-performance fibre-reinforced concrete was set as the main test variable in the framework of this study and the volumetric fraction of fibres was ranging from 0.125% to 2%. A high-speed camera was used to measure velocities of the impactor and the ultra-high-performance fibre-reinforced concrete specimen before and after the impact. Consequently, the energy dissipated by the ultra-high-performance fibre-reinforced concrete specimen during the impact was calculated using a simple energy balance equation. To determine the basic material properties of ultra-high-performance fibre-reinforced concrete, quasi-static loading rate was applied and conventional methods were used. A significant difference between the values of dissipated energies for different loading rates and various fibre volumetric fractions was observed. It can be noted that the new procedure shows a reasonable approach for testing the fibre-reinforced cementitious composites under localized impact loading and is worthy of further optimization.


2018 ◽  
Vol 183 ◽  
pp. 02005
Author(s):  
Ezio Cadoni ◽  
Matteo Dotta ◽  
Daniele Forni

The paper presents the results obtained on cylindrical Ultra High Performance Fibre Reinforced Concrete specimens with diameter of 30mm and a height of 60mm under compression at high stress rate (1.7–2.3 TPa/s). Four different percentages of fibre reinforcement are considered (1, 2, 3, and 4% fibre content) and compared with the results of the matrix (UHPC). A slight reduction of the strength and fracture time with the introduction of fibres is observed. The experimental results are analysed and discussed with the intent to better understand the mechanical behaviour of UHPFRC materials in case of dynamic event under service loading conditions.


2008 ◽  
Vol 17 (11) ◽  
pp. 316-317
Author(s):  
Daniel de MATTEIS ◽  
Pierre MARCHAND ◽  
Aude PETEL ◽  
Thierry THIBAUX ◽  
Nicolas FABRY ◽  
...  

Materials ◽  
2018 ◽  
Vol 11 (8) ◽  
pp. 1372 ◽  
Author(s):  
Krzysztof Ostrowski ◽  
Łukasz Sadowski ◽  
Damian Stefaniuk ◽  
Daniel Wałach ◽  
Tomasz Gawenda ◽  
...  

When understanding the effect of the morphology of coarse aggregate on the properties of a fresh concrete mixture, the strength and deformability of self-compacting high-performance fibre-reinforced concrete (SCHPFRC) can be seen to be critical for its performance. In this research, regular and irregular grains were separated from granite coarse aggregate. The morphology of these grains was described while using digital image analysis. As a result, the aspect ratio, roundness and area ratio were determined in order to better understand this phenomenon. Then, the principal rheological, physical, and mechanical properties of SCHPFRC were determined. The obtained results indicated that the morphology of the grains of coarse aggregate has an impact on the strength and stiffness properties of SCHPFRC. Moreover, significant differences in the transverse strain of concretes were observed. The morphology of the coarse aggregate also has an impact on the rheological parameters of a fresh concrete mixture. To better understand this phenomenon, the hypothesized mechanism of the formation of SCHPFRC caused by different morphology of coarse aggregate was proposed at the end of the article.


Sign in / Sign up

Export Citation Format

Share Document