Fabrication of high-performance pervaporation membrane for sulfuric acid recovery via interfacial polymerization

2021 ◽  
Vol 624 ◽  
pp. 119108
Author(s):  
Huaqing Liu ◽  
Jianzhong Xia ◽  
Kangjie Cui ◽  
Junquan Meng ◽  
Rui Zhang ◽  
...  
Keyword(s):  
Sulfuric Acid ◽  
High Performance ◽  
Interfacial Polymerization ◽  
Pervaporation Membrane ◽  
Acid Recovery

scholarly journals Hydrothermal Pretreatment of Wheat Straw: Effects of Temperature and Acidity on Byproduct Formation and Inhibition of Enzymatic Hydrolysis and Ethanolic Fermentation

Agronomy ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 487
Author(s):  
Dimitrios Ilanidis ◽  
Stefan Stagge ◽  
Leif J. Jönsson ◽  
Carlos Martín
Keyword(s):  
Mass Spectrometry ◽  
Sulfuric Acid ◽  
Wheat Straw ◽  
High Performance ◽  
Enzymatic Saccharification ◽  
Hydrothermal Pretreatment ◽  
Gas Chromatography Mass Spectrometry ◽  
Enzymatic Digestibility ◽  
Acid Catalyzed ◽  
Pretreatment Conditions

Biochemical conversion of wheat straw was investigated using hydrothermal pretreatment, enzymatic saccharification, and microbial fermentation. Pretreatment conditions that were compared included autocatalyzed hydrothermal pretreatment at 160, 175, 190, and 205 °C and sulfuric-acid-catalyzed hydrothermal pretreatment at 160 and 190 °C. The effects of using different pretreatment conditions were investigated with regard to (i) chemical composition and enzymatic digestibility of pretreated solids, (ii) carbohydrate composition of pretreatment liquids, (iii) inhibitory byproducts in pretreatment liquids, (iv) furfural in condensates, and (v) fermentability using yeast. The methods used included two-step analytical acid hydrolysis combined with high-performance anion-exchange chromatography (HPAEC), HPLC, ultra-high performance liquid chromatography-electrospray ionization-triple quadrupole-mass spectrometry (UHPLC-ESI-QqQ-MS), and pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS). Lignin recoveries in the range of 108–119% for autocatalyzed hydrothermal pretreatment at 205 °C and sulfuric-acid-catalyzed hydrothermal pretreatment were attributed to pseudolignin formation. Xylose concentration in the pretreatment liquid increased with temperature up to 190 °C and then decreased. Enzymatic digestibility was correlated with the removal of hemicelluloses, which was almost quantitative for the autocatalyzed hydrothermal pretreatment at 205 °C. Except for the pretreatment liquid from the autocatalyzed hydrothermal pretreatment at 205 °C, the inhibitory effects on Saccharomyces cerevisiae yeast were low. The highest combined yield of glucose and xylose was achieved for autocatalyzed hydrothermal pretreatment at 190 °C and the subsequent enzymatic saccharification that resulted in approximately 480 kg/ton (dry weight) raw wheat straw.

High-performance porous anion exchange membranes for efficient acid recovery from acidic wastewater by diffusion dialysis

2021 ◽  
Vol 624 ◽  
pp. 119116
Author(s):  
Jiuyang Lin ◽  
Junming Huang ◽  
Jing Wang ◽  
Junwei Yu ◽  
Xinqiang You ◽  
...  
Keyword(s):  
Anion Exchange ◽  
High Performance ◽  
Anion Exchange Membranes ◽  
Acid Recovery ◽  
Diffusion Dialysis ◽  
Acidic Wastewater

A redox mediator doped gel polymer as an electrolyte and separator for a high performance solid state supercapacitor

2015 ◽  
Vol 3 (7) ◽  
pp. 4035-4041 ◽  
Author(s):  
Guofu Ma ◽  
Miaomiao Dong ◽  
Kanjun Sun ◽  
Enke Feng ◽  
Hui Peng ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Sulfuric Acid ◽  
Solid State ◽  
Polyvinyl Alcohol ◽  
High Performance ◽  
Indigo Carmine ◽  
Polymer System ◽  
Redox Mediator ◽  
Gel Electrolyte

A stable and effective redox-mediator gel electrolyte has been prepared by doping indigo carmine (IC) into a polyvinyl alcohol sulfuric acid polymer system (PVA–H2SO4), and a high performance solid state supercapacitor is fabricated by utilizing activated carbon as electrodes and the prepared gel polymer (PVA–H2SO4–IC) as an electrolyte and separator.

scholarly journals Simultaneous Determination and Quantification of Triterpene Saponins from Camellia sinensis Seeds Using UPLC-PDA-QTOF-MS/MS

Molecules ◽  
2019 ◽  
Vol 24 (20) ◽  
pp. 3794 ◽  
Author(s):  
Xuejin Wu ◽  
Lingyan Jia ◽  
Jiafan Wu ◽  
Yawen Liu ◽  
Hyunuk Kang ◽  
...  
Keyword(s):  
Sulfuric Acid ◽  
Camellia Sinensis ◽  
High Performance ◽  
Biological Properties ◽  
Array Detector ◽  
Fragmentation Pattern ◽  
Triterpene Saponins ◽  
Chemical Structures ◽  
Flight Mass Spectrometry ◽  
Saponin Content

Saponins in the Camellia sinensis seeds have a broad spectrum of biological properties and application potentials. However, up to now, no chromatographic methods have been developed to provide full fingerprinting and quality assurance for these saponins. This research aimed to develop a novel method to tentatively identify and quantify saponins in C. sinensis seeds by ultra-high-performance liquid chromatography coupled with photo-diode array detector and quadrupole time-of-flight mass spectrometry (UPLC-PDA-QTOF-MS/MS), and compare it with the classic vanillin-sulfuric acid assay. Fifty-one triterpene saponins, including six potentially new compounds, were simultaneously detected by UPLC-PDA-MS/MS, and their chemical structures were speculated according to the retention behavior and fragmentation pattern. The total saponin content in the crude extract and the purified saponin fraction of C. sinensis seeds were quantified to be 19.57 ± 0.05% (wt %) and 41.68 ± 0.09% (wt %) respectively by UPLC-PDA at 210 nm, while the corresponding values were determined to be 43.11 ± 3.17% (wt %) and 56.60 ± 5.79% (wt %) respectively by the vanillin-sulfuric acid assay. The developed UPLC-PDA -MS/MS method could determine specified saponins, and is more reliable for quantifying the C. sinensis seed saponins than the classic spectrophotometric method. It is of great significance for the future investigations and applications of these saponins.

scholarly journals Ionization behavior of nanoporous polyamide membranes

2020 ◽  
Vol 117 (48) ◽  
pp. 30191-30200
Author(s):  
Cody L. Ritt ◽  
Jay R. Werber ◽  
Mengyi Wang ◽  
Zhongyue Yang ◽  
Yumeng Zhao ◽  
...  
Keyword(s):  
High Performance ◽  
Interfacial Polymerization ◽  
Carboxyl Groups ◽  
Structure Property ◽  
Nanoconfined Water ◽  
Fundamental Understanding ◽  
Ionization Behavior ◽  
Water Salt ◽  
Low Permittivity ◽  
Polyamide Membranes

Escalating global water scarcity necessitates high-performance desalination membranes, for which fundamental understanding of structure–property–performance relationships is required. In this study, we comprehensively assess the ionization behavior of nanoporous polyamide selective layers in state-of-the-art nanofiltration (NF) membranes. In these films, residual carboxylic acids and amines influence permeability and selectivity by imparting hydrophilicity and ionizable moieties that can exclude coions. We utilize layered interfacial polymerization to prepare physically and chemically similar selective layers of controlled thickness. We then demonstrate location-dependent ionization of carboxyl groups in NF polyamide films. Specifically, only surface carboxyl groups ionize under neutral pH, whereas interior carboxyl ionization requires pH >9. Conversely, amine ionization behaves invariably across the film. First-principles simulations reveal that the low permittivity of nanoconfined water drives the anomalous carboxyl ionization behavior. Furthermore, we report that interior carboxyl ionization could improve the water–salt permselectivity of NF membranes over fourfold, suggesting that interior charge density could be an important tool to enhance the selectivity of polyamide membranes. Our findings highlight the influence of nanoconfinement on membrane transport properties and provide enhanced fundamental understanding of ionization that could enable novel membrane design.

Sign in / Sign up

Export Citation Format

Share Document