Strain relaxation and surface morphology of nickel oxide nanolayers

2006 ◽  
Vol 600 (5) ◽  
pp. 1099-1106 ◽  
Author(s):  
J. Schoiswohl ◽  
W. Zheng ◽  
S. Surnev ◽  
M.G. Ramsey ◽  
G. Granozzi ◽  
...  
1999 ◽  
Vol 594 ◽  
Author(s):  
M. E. Ware ◽  
R. J. Nemanich

AbstractThis study explores stress relaxation of epitaxial SiGe layers grown on Si substrates with unique orientations. The crystallographic orientations of the Si substrates used were off-axis from the (001) plane towards the (111) plane by angles, θ = 0, 10, and 22 degrees. We have grown 100nm thick Si(1−x) Ge(x) epitaxial layers with x=0.3 on the Si substrates to examine the relaxation process. The as-deposited films are metastable to the formation of strain relaxing misfit dislocations, and thermal annealing is used to obtain highly relaxed films for comparison. Raman spectroscopy has been used to measure the strain relaxation, and atomic force microscopy has been used to explore the development of surface morphology. The Raman scattering indicated that the strain in the as-deposited films is dependent on the substrate orientation with strained layers grown on Si with 0 and 22 degree orientations while highly relaxed films were grown on the 10 degree substrate. The surface morphology also differed for the substrate orientations. The 10 degree surface is relatively smooth with hut shaped structures oriented at predicted angles relative to the step edges.


2004 ◽  
Vol 809 ◽  
Author(s):  
Klara Lyutovich ◽  
Erich Kasper ◽  
Michael Oehme

ABSTRACTVirtual substrates with ultra-thin SiGe strain relaxed buffers have been grown on Si substrates by a method employing point defect supersaturation in the growing layers. A concept of the point defect influence on the strain relaxation and on defect interactions in layers has been proposed. A method is developed to increase the degree of relaxation in sub-100 nm SiGe buffer layers and to provide a smooth surface morphology. Layer growth has been realized by solid source molecular beam epitaxy in a chamber equipped with an in situ monitoring system. One of the growth stages, performed at a very low temperature, serves the generation of point defects. Strain relaxation tunable up to the high degree and a crosshatch-free surface morphology are demonstrated in 40nm thick SiGe buffers which contain 40-45% Ge.Growth monitoring enables the control of the process window and the layer crystallization by a chosen mechanism.Virtual substrates produced by the described method were successfully tested in nMODFET structures.


2004 ◽  
Vol 831 ◽  
Author(s):  
D.I. Florescu ◽  
D.S. Lee ◽  
J.C. Ramer ◽  
V.N. Merai ◽  
A. Parekh ◽  
...  

ABSTRACTIn this study, we investigate the dependence of GaN surface morphology on the absolute strain values for thin (<10 μm) epitaxial films grown by MOCVD on c-plane sapphire substrates of various miscut angles towards the m-plane. Results indicate an excellent correlation between the surface roughness observed employing an AFM tool and epilayer strain values. An overall increase of surface roughness (decrease of atomic terrace width) is found with decreasing compressive strain (epilayer vs. bulk value). In addition, sapphire substrates with increasing miscut angle (0.30 deg) appear to relax the inherent, built-in strain differently in the vertical (growth) direction when compared to just (0.00 deg) substrates. Strain relaxation by typical V-shaped, hexagonal pits is directly imaged through the comparison of surface features inside and outside of pits in the thin GaN epilayer films.


Author(s):  
M. Mynbaeva ◽  
A. Titkov ◽  
A. Kryzhanovski ◽  
I. Kotousova ◽  
A.S. Zubrilov ◽  
...  

We have studied epitaxial GaN layers grown by hydride vapour phase epitaxy (HVPE) on porous GaN sublayers formed on SiC substrates. It was shown that these layers can be grown with good surface morphology and high crystalline quality. X-ray, Raman and photoluminescent (PL) measurements showed that the stress in the layers grown on porous GaN was reduced to 0.1-0.2 GPa, while the stress in the layers grown directly on 6H-SiC substrates remains at its usual level of about 1 GPa. Thus, we have shown that growth on porous GaN sublayer is a promising method for fabrication of high quality epitaxial layers of GaN with low strain values.


1996 ◽  
Vol 350 (1-3) ◽  
pp. 113-122 ◽  
Author(s):  
Estrella Escalona Platero ◽  
Domenica Scarano ◽  
Adriano Zecchina ◽  
Giancarlo Meneghini ◽  
Roberto De Franceschi

1998 ◽  
Vol 410 (1) ◽  
pp. 82-98 ◽  
Author(s):  
J.G Belk ◽  
D.W Pashley ◽  
C.F McConville ◽  
B.A Joyce ◽  
T.S Jones

Sign in / Sign up

Export Citation Format

Share Document