Triple-deck solutions for supersonic flows past flared cylinders

1987 ◽  
Vol 179 ◽  
pp. 469-487 ◽  
Author(s):  
Ph. Gittler ◽  
A. Kluwick
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Asymptotic Expansions ◽  
Numerical Solutions ◽  
Reynolds Numbers ◽  
Hysteresis Phenomenon ◽  
Two Dimensional ◽  
Planar Flow ◽  
Laminar Boundary Layers ◽  
External Flows

Using the method of matched asymptotic expansions, the interaction between axisymmetric laminar boundary layers and supersonic external flows is investigated in the limit of large Reynolds numbers. Numerical solutions to the interaction equations are presented for flare angles α that are moderately large. If α > 0 the boundary layer separates upstream of the corner and the formation of a plateau structure similar to the two-dimensional case is observed. In contrast to the case of planar flow, however, separation can occur also if α < 0, owing to the axisymmetric effect of overexpansion and recompression. The separation point then is located downstream of the corner and, most remarkable, a hysteresis phenomenon is observed.

Effect of longitudinal surface curvature on boundary layers

1967 ◽  
Vol 29 (1) ◽  
pp. 187-199 ◽  
Author(s):  
Roddam Narasimha ◽  
S. K. Ojha
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Asymptotic Expansions ◽  
Order Effect ◽  
Similarity Solutions ◽  
Surface Curvature ◽  
Pressure Gradients ◽  
Two Dimensional ◽  
Laminar Boundary Layers ◽  
Critical Comparison

We consider here the higher order effect of moderate longitudinal surface curvature on steady, two-dimensional, incompressible laminar boundary layers. The basic partial differential equations for the problem, derived by the method of matched asymptotic expansions, are found to possess similarity solutions for a family of surface curvatures and pressure gradients. The similarity equations obtained by this anaylsis have been solved numerically on a computer, and show a definite decrease in skin friction when the surface has convex curvature in all cases including zero pressure gradient. Typical velocity profiles and some relevant boundary-layer characteristics are tabulated, and a critical comparison with previous work is given.

Effects of Curvature on Laminar Boundary Layers in Sink-Type Flows

1969 ◽  
Vol 91 (3) ◽  
pp. 353-358 ◽  
Author(s):  
W. A. Gustafson ◽  
I. Pelech
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Momentum Equation ◽  
Similarity Solutions ◽  
Momentum Thickness ◽  
Two Dimensional ◽  
Thickness Increase ◽  
Laminar Boundary Layers ◽  
Converging Channel ◽  
Special Case

The two-dimensional, incompressible laminar boundary layer on a strongly curved wall in a converging channel is investigated for the special case of potential velocity inversely proportional to the distance along the wall. Similarity solutions of the momentum equation are obtained by two different methods and the differences between the methods are discussed. The numerical results show that displacement and momentum thickness increase linearly with curvature while skin friction decreases linearly.

A Reference Temperature Method for Compressible Laminar Boundary Layers

1973 ◽  
Vol 2 (4) ◽  
pp. 201-204
Author(s):  
R. Camarero
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Wall Temperature ◽  
Reference Temperature ◽  
Integral Approach ◽  
Pressure Gradients ◽  
Two Dimensional ◽  
Laminar Boundary Layers ◽  
Temperature Method ◽  
Compressibility Effects

A calculation procedure for the solution of two-dimensional and axi-symmetric laminar boundary layers in compressible flow has been developed. The method is an extension of the integral approach of Tani to include compressibility effects by means of a reference temperature. Arbitrary pressure gradients and wall temperature can be specified. Comparisons with experiments obtained for supersonic flows over a flat plate indicate that the method yields adequate results. The method is then applied to the solution of the boundary layer on a Basemann inlet.

scholarly journals Planar flows past thin multi-blade configurations

1996 ◽  
Vol 324 ◽  
pp. 355-377 ◽  
Author(s):  
F. T. Smith ◽  
S. N. Timoshin
Keyword(s):  
Boundary Layer ◽  
Numerical Solutions ◽  
Reynolds Numbers ◽  
Laminar Flows ◽  
Two Dimensional ◽  
Boundary Layer Equations ◽  
Require Solution ◽  
Lift And Drag ◽  
Planar Flows ◽  
Steady Laminar

Two-dimensional steady laminar flows past multiple thin blades positioned in near or exact sequence are examined for large Reynolds numbers. Symmetric configurations require solution of the boundary-layer equations alone, in parabolic fashion, over the successive blades. Non-symmetric configurations in contrast yield a new global inner–outer interaction in which the boundary layers, the wakes and the potential flow outside have to be determined together, to satisfy pressure-continuity conditions along each successive gap or wake. A robust computational scheme is used to obtain numerical solutions in direct or design mode, followed by analysis. Among other extremes, many-blade analysis shows a double viscous structure downstream with two streamwise length scales operating there. Lift and drag are also considered. Another new global interaction is found further downstream. All the interactions involved seem peculiar to multi-blade flows.

scholarly journals Turbulent boundary layers and channels at moderate Reynolds numbers

2010 ◽  
Vol 657 ◽  
pp. 335-360 ◽  
Author(s):  
JAVIER JIMÉNEZ ◽  
SERGIO HOYAS ◽  
MARK P. SIMENS ◽  
YOSHINORI MIZUNO
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Turbulent Flows ◽  
Pressure Fluctuations ◽  
Reynolds Numbers ◽  
Streamwise Velocity ◽  
Rotational Flow ◽  
Mean Velocity ◽  
The Mean ◽  
External Flows

The behaviour of the velocity and pressure fluctuations in the outer layers of wall-bounded turbulent flows is analysed by comparing a new simulation of the zero-pressure-gradient boundary layer with older simulations of channels. The 99 % boundary-layer thickness is used as a reasonable analogue of the channel half-width, but the two flows are found to be too different for the analogy to be complete. In agreement with previous results, it is found that the fluctuations of the transverse velocities and of the pressure are stronger in the boundary layer, and this is traced to the pressure fluctuations induced in the outer intermittent layer by the differences between the potential and rotational flow regions. The same effect is also shown to be responsible for the stronger wake component of the mean velocity profile in external flows, whose increased energy production is the ultimate reason for the stronger fluctuations. Contrary to some previous results by our group, and by others, the streamwise velocity fluctuations are also found to be higher in boundary layers, although the effect is weaker. Within the limitations of the non-parallel nature of the boundary layer, the wall-parallel scales of all the fluctuations are similar in both the flows, suggesting that the scale-selection mechanism resides just below the intermittent region, y/δ = 0.3–0.5. This is also the location of the largest differences in the intensities, although the limited Reynolds number of the boundary-layer simulation (Reθ ≈ 2000) prevents firm conclusions on the scaling of this location. The statistics of the new boundary layer are available from http://torroja.dmt.upm.es/ftp/blayers/.

The Interaction of Thermal Radiation in Optically Thick Boundary Layers

1967 ◽  
Vol 89 (4) ◽  
pp. 309-312 ◽  
Author(s):  
J. L. Novotny ◽  
Kwang-Tzu Yang
Keyword(s):  
Boundary Layer ◽  
Flow Field ◽  
Boundary Layers ◽  
Optical Thickness ◽  
Asymptotic Expansions ◽  
Energy Equation ◽  
Two Dimensional ◽  
Small Temperature ◽  
Dimensional Boundary

An analysis is presented to examine the role of the Rosseland or optically thick approximation in convection-radiation interaction situations. The analysis is formulated for the flow of a gray gas in a laminar two-dimensional boundary layer under the restriction of small temperature differences within the flow field. The boundary-layer energy equation is treated using the method of matched asymptotic expansions based on a parameter which characterizes the optical thickness of the gas. Two illustrative examples of the resulting equations are presented.

Approximate Methods of Solving the Laminar Boundary-Layer Equations

1962 ◽  
Vol 13 (3) ◽  
pp. 285-290 ◽  
Author(s):  
R. M. Terrill
Keyword(s):  
Boundary Layer ◽  
Circular Cylinder ◽  
Skin Friction ◽  
Boundary Layers ◽  
Laminar Boundary Layer ◽  
Numerical Solutions ◽  
Approximate Methods ◽  
Boundary Layer Equations ◽  
Laminar Boundary Layers ◽  
Remarkable Agreement

SummaryCurie and Skan have modified the approximate methods of Thwaites and Stratford to predict separation properties of laminar boundary layers for flow over an impermeable surface. The work of Curie and Skan has been extended by Curle to include the estimation of laminar skin friction for the whole flow. The purpose of the following note is to compare the approximate methods of Curie and Skan and Curle with the numerical results given by the author for flow past a circular cylinder. It is found that there is remarkable agreement between these approximate methods and the exact numerical solutions. This indicates that these methods can be used widely, both on account of their simplicity and their accuracy.

The Departure from Equilibrium of Turbulent Boundary Layers

1968 ◽  
Vol 19 (1) ◽  
pp. 1-19 ◽  
Author(s):  
H. McDonald
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Kinetic Energy ◽  
Stress Distribution ◽  
Boundary Layers ◽  
Turbulent Boundary Layers ◽  
Two Dimensional ◽  
Pressure Distributions ◽  
Momentum Integral ◽  
State Examination

SummaryRecently two authors, Nash and Goldberg, have suggested, intuitively, that the rate at which the shear stress distribution in an incompressible, two-dimensional, turbulent boundary layer would return to its equilibrium value is directly proportional to the extent of the departure from the equilibrium state. Examination of the behaviour of the integral properties of the boundary layer supports this hypothesis. In the present paper a relationship similar to the suggestion of Nash and Goldberg is derived from the local balance of the kinetic energy of the turbulence. Coupling this simple derived relationship to the boundary layer momentum and moment-of-momentum integral equations results in quite accurate predictions of the behaviour of non-equilibrium turbulent boundary layers in arbitrary adverse (given) pressure distributions.

Laminar boundary layers behind detonation waves

1983 ◽  
Vol 387 (1793) ◽  
pp. 331-349 ◽  
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Boundary Layers ◽  
Flow Analysis ◽  
Time Dependent ◽  
Detonation Waves ◽  
Planar Geometry ◽  
Laminar Boundary Layers ◽  
Spherical Detonation ◽  
Layer Flow

New solutions are presented for non-stationary boundary layers induced by planar, cylindrical and spherical Chapman-Jouguet (C-J) detonation waves. The numerical results show that the Prandtl number ( Pr ) has a very significant influence on the boundary-layer-flow structure. A comparison with available time-dependent heat-transfer measurements in a planar geometry in a 2H 2 + O 2 mixture shows much better agreement with the present analysis than has been obtained previously by others. This lends confidence to the new results on boundary layers induced by cylindrical and spherical detonation waves. Only the spherical-flow analysis is given here in detail for brevity.

Essential Ingredients for the Computation of Steady and Unsteady Blade Boundary Layers

1991 ◽  
Vol 113 (4) ◽  
pp. 608-616 ◽  
Author(s):  
H. M. Jang ◽  
J. A. Ekaterinaris ◽  
M. F. Platzer ◽  
T. Cebeci
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Stokes Equations ◽  
Inviscid Flow ◽  
Reynolds Numbers ◽  
Navier Stokes ◽  
Transitional Region ◽  
Low Reynolds Numbers ◽  
Flow Equations ◽  
Low Reynolds

Two methods are described for calculating pressure distributions and boundary layers on blades subjected to low Reynolds numbers and ramp-type motion. The first is based on an interactive scheme in which the inviscid flow is computed by a panel method and the boundary layer flow by an inverse method that makes use of the Hilbert integral to couple the solutions of the inviscid and viscous flow equations. The second method is based on the solution of the compressible Navier–Stokes equations with an embedded grid technique that permits accurate calculation of boundary layer flows. Studies for the Eppler-387 and NACA-0012 airfoils indicate that both methods can be used to calculate the behavior of unsteady blade boundary layers at low Reynolds numbers provided that the location of transition is computed with the en method and the transitional region is modeled properly.

Sign in / Sign up

Export Citation Format

Share Document