Microdiffraction Patterns of Small Metallic Particles II; Theoretical Analysis

1982 ◽  
Vol 40 ◽  
pp. 668-669
Author(s):  
A. Gómez ◽  
P. Schabes-Retchkiman ◽  
M. José-Yacamán ◽  
T. Ocaña
Keyword(s):  
Experimental Data ◽  
Electron Diffraction ◽  
Theoretical Analysis ◽  
Size Range ◽  
Dynamical Theory ◽  
Metallic Particles ◽  
Splitting Effect

The splitting effect that is observed in microdiffraction pat-terns of small metallic particles in the size range 50-500 Å can be understood using the dynamical theory of electron diffraction for the case of a crystal containing a finite wedge. For the experimental data we refer to part I of this work in these proceedings.

Microdiffraction Studies of Small Gold Metallic Particles

1983 ◽  
Vol 31 ◽  
Author(s):  
Miguel Jose-Yacaman ◽  
Alfredo Gomez ◽  
Krystyna Truszkowska
Keyword(s):  
Diffraction Pattern ◽  
Crystalline Structure ◽  
Size Range ◽  
Hexagonal Lattice ◽  
Anomalous Diffraction ◽  
Single Crystalline ◽  
Gold Particles ◽  
Metallic Particles ◽  
Splitting Effect

ABSTRACTThe crystalline structure of small gold particles in the size range between 50–200 Å is studied using STEM in microdiffraction.It is found that some single-crystalline particles showed an anomalous diffraction pattern. In some cases these pattern be indexed as an hexagonal lattice with a ratio c/a= 2.46. A number of models to explain the hexagonal diffraction are discussed. In some other cases the patterns correspond to fcc structures but with a large splitting effect. The results reveal the strong dynamical character of the diffraction by small gold particles.

Evidence for ordered Fe3Ni

1987 ◽  
Vol 45 ◽  
pp. 216-217
Author(s):  
K.B. Reuter ◽  
D.B. Williams ◽  
J.I. Goldstein
Keyword(s):  
Experimental Data ◽  
Martensitic Transformation ◽  
Electron Diffraction ◽  
Room Temperature ◽  
Direct Evidence ◽  
Transformation Product ◽  
Iron Meteorites ◽  
X Ray ◽  
Ni Content ◽  
Temperature Transformation

In the Fe-Ni system, although ordered FeNi and ordered Ni3Fe are experimentally well established, direct evidence for ordered Fe3Ni is unconvincing. Little experimental data for Fe3Ni exists because diffusion is sluggish at temperatures below 400°C and because alloys containing less than 29 wt% Ni undergo a martensitic transformation at room temperature. Fe-Ni phases in iron meteorites were examined in this study because iron meteorites have cooled at slow rates of about 10°C/106 years, allowing phase transformations below 400°C to occur. One low temperature transformation product, called clear taenite 2 (CT2), was of particular interest because it contains less than 30 wtZ Ni and is not martensitic. Because CT2 is only a few microns in size, the structure and Ni content were determined through electron diffraction and x-ray microanalysis. A Philips EM400T operated at 120 kV, equipped with a Tracor Northern 2000 multichannel analyzer, was used.

A Dynamic Test of Fully Prestressed Concrete Beams

2011 ◽  
Vol 368-373 ◽  
pp. 2483-2490
Author(s):  
Yao Ting Zhang ◽  
Yi Zheng ◽  
Hong Jian Li
Keyword(s):  
Experimental Data ◽  
Elastic Modulus ◽  
Theoretical Analysis ◽  
Natural Frequency ◽  
Axial Force ◽  
Prestressed Concrete ◽  
Concrete Beams ◽  
Dynamic Test ◽  
Modified Formula

A dynamic test of two unbonded fully prestressed concrete beams has been conducted. The results indicate that the natural frequency of beams increases with the prestress force, which is opposite to the analytical arguments for homogeneous and isotropic beams subject to axial force. This paper explains the change in frequencies by discussing the change in the elastic modulus. A modified formula is also proposed, and the experimental data agree well with the theoretical analysis.

Dynamical Theory of Diffraction. I. Electron Diffraction

1966 ◽  
Vol 21 (2) ◽  
pp. 326-335 ◽  
Author(s):  
Y. H. Ohtsuki ◽  
S. Yanagawa
Keyword(s):  
Electron Diffraction ◽  
Dynamical Theory

scholarly journals Comparative analysis of methods to determine deflection in steel beams: theoretical analysis, finite element and experimental

2020 ◽  
pp. 32-37
Author(s):  
Gabriela Alor-Saavedra ◽  
Francisco Alejandro Alaffita-Hernández ◽  
Beatris Adriana Escobedo-Trujillo ◽  
Oscar Fernando Silva-Aguilar
Keyword(s):  
Differential Equation ◽  
Experimental Data ◽  
Finite Element ◽  
Comparative Analysis ◽  
Theoretical Analysis ◽  
Comparative Study ◽  
Steel Beams ◽  
Physical Systems ◽  
Theoretical Part ◽  
Made In

This work makes a comparative study of two methods to determine deflection in steel beams: (a) Theoretical and (b) Finite element. For method (a) the solution of the differential equation associated with the modeling of the deflection of a beam is found, while for method (b) a simulation is made in Solidworks. Both methods are compared with experimental data in order to analyze which of the methods presents less uncertainty and show the usefulness of the theoretical part in the modeling of physical systems.

Sign in / Sign up

Export Citation Format

Share Document