Polymorphism in Ho2(MoO4)3

2013 ◽  
Vol 28 (S2) ◽  
pp. S33-S40 ◽  
Author(s):  
C. González-Silgo ◽  
C. Guzmán-Afonso ◽  
V. M. Sánchez-Fajardo ◽  
S. Acosta-Gutiérrez ◽  
A. Sánchez-Soares ◽  
...  

Two polymorphs of Holmium molybdate, known as β'-phase and γ-phase, were prepared by solid state reaction with different thermal treatments. These polycrystalline samples have been studied for the first time by X-ray thermodiffractometry from room temperature up to 1300 K. We found that the initial β'-phase undergoes a transition to a β-phase and then to a γ-phase. The γ (hydrated)-phase, turns to the γ (dehydrated)-phase and then to the β-phase. Each sequence involves a reversible and an irreversible phase transition for Ho2(MoO4)3. Both polymorphs have remarkable physical properties like nonlinear optics, ferroelectricity and negative thermal expansion. We have calculated the linear expansion coefficients of both phases. We have obtained a positive coefficient for the β'-phase and a negative one for the γ-phase. Moreover, we have made a comparison of the obtained coefficients with previous results for other rare earth molybdates.

2010 ◽  
Vol 663-665 ◽  
pp. 1008-1011
Author(s):  
Ling Hang Wang

The thermal expansion of a novel semiconductor material, mercury indium telluride (MIT) grown by vertical Bridgman (VB) method, was measured from room temperature till 573K by two methods, i.e. Macroscopic dilatometric and X-ray measurements. It is found that the macroscopic expansion is quite different from the expansion of the lattice (micro-expansion). The macroscopic expansion is lower than micro-expansion in the temperature range of 303-425.5K and has a minimum of -0.14% linear expansion, while the macro-expansion becomes larger than micro-expansion in the temperature higher than 425.5K. The former may be due to the effects of the existing neutral vacancies. The latter may result from the influence of thermal-activated vacancies on the lattice.


Barium titanium oxide, which is tetragonal at room temperature, changes about 120° C to a cubic structure. This change has been followed in detail by means of X-ray powder photo­graphs taken in a 19 cm. powder camera at intervals of a few degrees over a range covering the transition point. The unit cell, which contains the formula number of atoms, retains its identity throughout the transition, and the atomic parameters are unaltered. The change is simply in the axial lengths, and these vary continuously with the temperature, though not linearly, the varia­tion becoming more rapid near the transition point. While the linear expansion coefficients along and perpendicular to the tetrad axis are large and of opposite sign, the volume expan­sion coefficient is small and positive. There is no discontinuous change either of linear spacing or of volume detectable at the transition point, but there is a sharp discontinuity in the linear expansion coefficients, and a marked increase in the volume expansion coefficient which is probably, though not certainly, discontinuous. The transition suggests a typical λ-point change. The specific heat has not been deter­mined, but the thermal expansion curve has the characteristic λ shape. Co-existence of cubic and tetragonal structures, in proportions depending on the temperature, occurs over a range of some degrees near the transition point, and is attributed to the effect of local stresses in facilitating or hindering a change between two structures whose energy difference is very small in this temperature range. Below room temperature, observations made down to -183° C suggest that the structure may have a second transition point somewhere below this and become cubic again, the change being of the same nature as that at 120° C. It is argued that the room-temperature structure can only be explained by the existence of directed bonds, and that the breaking of these bonds with increasing temperature is respon­sible for the 120°C transition. The low-temperature transition is explained by postulating a more complete set of bonds, probably an octahedral complex, which partially breaks down at this temperature to give the square formation observed in the room-temperature structure. The possible nature of the directed bonds is discussed qualitatively. The condition which makes possible the formation of such bonds is likely to be the abnormal volume available to the Ti atom, which is due to the effect of the large Ba ion in forcing apart the oxygen lattice. The directed bond system will only contribute a small part to the attractive energy of the lattice, which is mainly ionic in character. The hypothesis that directed bonds exist, whatever their origin, is used for a tentative explanation of anomalous variations of intensity of the X-ray lines observed at temperatures near the transition point.


2011 ◽  
Vol 399-401 ◽  
pp. 80-84
Author(s):  
Yi Yuan Tang ◽  
Jie Li Meng ◽  
Kai Lian Huang ◽  
Jian Lie Liang

Phase transformation of the Zr-1.0Sn-0.39Nb-0.31Fe-0.05Cr alloy was investigated by high temperature X-ray diffraction (XRD). The XRD results revealed that the alloy contained two precipitates at room temperature, namely β-Nb and hexagonal Zr(Nb,Fe,Cr,)2. β-Nb was suggested to dissolve into the α-Zr matrix at the 580oC. Thin oxide film formed at the alloy’s surface was identified as mixture of the monoclinic Zr0.93O2and tetragonal ZrO2, when the temperature reached to 750oC and 850 oC. The thermal expansion coefficients of αZr in this alloy was of αa = 8.39×10-6/°C, αc = 2.48×10-6/°C.


2009 ◽  
Vol 23 (06n07) ◽  
pp. 1449-1454 ◽  
Author(s):  
HONGFEI LIU ◽  
ZHIPING ZHANG ◽  
XIAONONG CHENG ◽  
JUAN YANG

In this work, a series of ZrO 2/ ZrW 2 O 8 ceramic composites with different amounts of ZrW 2 O 8 were successfully prepared by calcining the precursors synthesized using co-precipitation route at 1150°C for 3 h. The X-ray diffraction (XRD) data confirmed that the composites only consisted of α- ZrW 2 O 8 phase and m - ZrO 2 phase. The scanning electron microscopy (SEM) analysis of the synthesized ZrO 2/ ZrW 2 O 8 composites showed that the specimens had good mixed-uniformities. In addition, the thermal expansion coefficients of the composites decreased with increased amounts of negative thermal expansion ZrW 2 O 8, specimen with 26wt% ZrW 2 O 8 shows almost zero thermal expansion and its average thermal expansion coefficient is -0.5897×10-6K-1 in the temperature range from 30°C to 600°C.


2009 ◽  
Vol 79-82 ◽  
pp. 1567-1570 ◽  
Author(s):  
Hai Tao Yang ◽  
Wei Lin Lin ◽  
Fu Liang Shang ◽  
Yuan Hui Huang ◽  
Ling Gao

In this research, powders of Y2Mo3O12 and Yb2Mo3O12 were successfully synthesized by liquid phase coprecipitation, followed with a heat treatment at 750°C for 6h. X-ray diffraction (XRD) analysis indicated that the Y2Mo3O12 and Yb2Mo3O12 were single orthorhombic structure with the space group of Pbcn. Negative thermal expansion properties of Y2Mo3O12 and Yb2Mo3O12 were studied with high temperature XRD analysis. The thermal expansion coefficients of Y2Mo3O12 and Yb2Mo3O12 were calculated to be -5.943×10-6K-1 and -6.237×10-6K-1 respectively.


2017 ◽  
Vol 36 (8) ◽  
pp. 763-769 ◽  
Author(s):  
Rayko Simura ◽  
Shohei Kawai ◽  
Kazumasa Sugiyama

AbstractHigh temperature powder X-ray diffraction measurements of Ba3RB3O9 (R=Sm–Yb, and Y) were carried out at temperatures ranging from room temperature to just below the corresponding melting temperatures (1,200–1,300 °C). No phase transition was found for the H-type phase (R$\overline 3 $) with R=Sm–Tb and the L-type phase (P63 cm) with R=Tm–Yb. On the other hand, phase transition from the L phase to the H phase was observed for R=Dy–Er, and Y at around 1,100–1,200 °C. The obtained axial thermal expansion coefficient (ATEC) of the a-axis was larger than that of the c-axis for the H phase, and the ATEC of the c-axis was larger than that of the a-axis for the L phase. The observed anisotropic nature of ATEC is attributed to the distribution of the BO3 anionic group with rigid boron–oxygen bonding in the structures of the H and L phases.


2016 ◽  
Vol 80 (7) ◽  
pp. 1205-1217 ◽  
Author(s):  
Ian E. Grey ◽  
Helen E. A. Brand ◽  
John Betterton

AbstractBettertonite, [Al6(AsO4)3(OH)9(H2O)5]•11H2O and penberthycroftite, [Al6(AsO4)3(OH)9(H2O)5].8H2O, two new minerals from the Penberthy Croft mine, Cornwall, have flexible layer structures based on corner-connected heteropolyhedral columns. Their response to dehydration on heating was studied using in situ synchrotron powder X-ray diffraction at temperatures in the range -53 to 157°C. The bettertonite sample transforms to penberthycroftite in a narrow temperature range of 67 to 97°C with a large (8%) contraction of the layer separation and a 6 Å sliding of adjacent layers relative to each other. Above 100°C a second phase transition occurs to a DL (displaced layer) phase, involving another 8% inter-layer contraction combined with a rotation of the columns. On heating the penberthycroftite sample the phase transition to the DL phase occurs at a lower temperature of ∼80°C. The DL phase is stable to a temperature of ∼120°C. At higher temperatures, increased rotation of the columns is accompanied by a progressive amorphization of the sample. Bettertonite, penberthycroftite and the DL phase exhibit negative thermal expansion (NTE) along all three axes with large NTE coefficients, of the order of-100 x 10 -6 °C-1.


2021 ◽  
Author(s):  
Chloe S. Coates ◽  
Claire A. Murray ◽  
Hanna L. B. Boström ◽  
Emily M. Reynolds ◽  
Andrew L. Goodwin

X-ray radiation induced unit-cell contraction and phase transition selection in the negative thermal expansion material cadmium cyanide.


Author(s):  
M.G. Isaenkova ◽  
◽  
A.V. Tenishev ◽  
Yu.A. Perlovich ◽  
S.D. Stolbov ◽  
...  

The temperature dependences of the periods a and c of the crystal structure of a-Zr and thermal linear expansion coefficients (TLEC) of textured cladding tubes and rods of E110opt Zr-based alloy in the axial direction in the temperature range of 293-873 K (20-600 °С) were determined. On the basis of Kearns’ integral texture parameters for cladding tubes and rods, TLEC values were calculated. The calculated values of the TLEC turned out to be significantly smaller than the values measured by the dilatometric method. Simulation of the process of thermal expansion of goods showed that the observed differences in the calculated and measured values of the TLEC can be due to layer-by-layer texture inhomogeneity of tubes and internal stresses arising between the layers.


Sign in / Sign up

Export Citation Format

Share Document